Luan Nguyen Thanh
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Luan Nguyen Thanh has a total of 20 co-authors. Here are the top co-authors by number of shared publications:
- Ha Nguyen Minh
Faculty of Mechanical Engineering, University of Transport and Communications, Hanoi, Vietnam
4 shared publications - Minh Ha Nguyen
University of Transport and Communications
4 shared publications An Quoc Hoang
3 shared publicationsNguyen Minh Ha
Trường Đại học Giao thông vận tải phân hiệu tại TP.HCM, Việt Nam
3 shared publications- Hong Son Le Nguyen
Ho Chi Minh City University of Technology and Education
2 shared publications - Hong Son Nguyen Le
Faculty of Vehicle and Energy Engineering, Ho Chi Minh City University of Technology and Education (HCMUTE), Vietnam
2 shared publications
Latest Publications
- Open Access
- 14 May 2026
- Published by Elsevier in International Journal of Thermofluids
- Vol. 34
Thermohydraulic characteristics and entropy generation in a dimpled flat tube: Numerical investigation and Pareto-based multi-objective optimization
- 14 May 2026
- Published by Elsevier in International Journal of Thermofluids
- Vol. 34
Open AccessThermohydraulic characteristics and entropy generation in a dimpled flat tube: Numerical investigation and Pareto-based multi-objective optimization
- Open Access
- 14 April 2026
- Published by Elsevier in Case Studies in Thermal Engineering
- Vol. 82
A CFD analysis of factors affecting the performance of natural convection solar air heater
- 14 April 2026
- Published by Elsevier in Case Studies in Thermal Engineering
- Vol. 82
Open AccessA CFD analysis of factors affecting the performance of natural convection solar air heater
- Open Access
- 10 April 2026
- Published by Elsevier in South African Journal of Chemical Engineering
- Vol. 57
Thermohydraulic characteristics and entropy generation in a heat exchanger tube with teardrop-shaped dimples: A CFD approach
- 10 April 2026
- Published by Elsevier in South African Journal of Chemical Engineering
- Vol. 57
Open AccessThermohydraulic characteristics and entropy generation in a heat exchanger tube with teardrop-shaped dimples: A CFD approach
- 1 December 2025
- Published by International Centre for Applied Thermodynamics (ICAT) in International Journal of Thermodynamics
- Vol. 28 (4) , 243-249
The Effect of Inlet Baffle on the Skin Friction Coefficient and Turbulence Intensity in an Air-Cooled Channel
This study addresses the impact of an inlet baffle mounted opposite a hot surface on the properties of turbulence and flow resistance in an air-cooled channel. This study focuses on analyzing the variation in the skin friction coefficient and air turbulence intensity along the hot surface. The influence of an inclined baffle angle α = 15−60° and relative baffle length Ln = 0.625−0.875 under the Reynolds number spectrum Re = 4000−16000 was considered. Results indicated that turbulence intensity increased when the Reynolds number increased, the baffle length increased, or the inclined baffle angle decreased. The skin friction coefficient increased when the Reynolds number decreased, the baffle length increased, or the inclined baffle angle decreased. The maximum heat transfer rate occurs at α = 15°, Ln = 0.875, and Re = 16000, and vice versa at α = 60°, Ln = 0.625, and Re = 4000. In comparing the lowest and highest heat transfer configurations, the skin friction coefficient decreased by 77.9 %, and turbulence intensity decreased by 97 %. This means that heat transfer can be increased at the cost of higher pump power. The results of this study contribute to a more comprehensive understanding of the effect of an inlet baffle on fluid chaotic motion and flow resistance, as well as the mechanism that leads to the variation in heat transfer ability and pressure loss in the channel under the impact of the inlet baffle.
- 1 December 2025
- Published by International Centre for Applied Thermodynamics (ICAT) in International Journal of Thermodynamics
- Vol. 28 (4) , 243-249
The Effect of Inlet Baffle on the Skin Friction Coefficient and Turbulence Intensity in an Air-Cooled Channel
This study addresses the impact of an inlet baffle mounted opposite a hot surface on the properties of turbulence and flow resistance in an air-cooled channel. This study focuses on analyzing the variation in the skin friction coefficient and air turbulence intensity along the hot surface. The influence of an inclined baffle angle α = 15−60° and relative baffle length Ln = 0.625−0.875 under the Reynolds number spectrum Re = 4000−16000 was considered. Results indicated that turbulence intensity increased when the Reynolds number increased, the baffle length increased, or the inclined baffle angle decreased. The skin friction coefficient increased when the Reynolds number decreased, the baffle length increased, or the inclined baffle angle decreased. The maximum heat transfer rate occurs at α = 15°, Ln = 0.875, and Re = 16000, and vice versa at α = 60°, Ln = 0.625, and Re = 4000. In comparing the lowest and highest heat transfer configurations, the skin friction coefficient decreased by 77.9 %, and turbulence intensity decreased by 97 %. This means that heat transfer can be increased at the cost of higher pump power. The results of this study contribute to a more comprehensive understanding of the effect of an inlet baffle on fluid chaotic motion and flow resistance, as well as the mechanism that leads to the variation in heat transfer ability and pressure loss in the channel under the impact of the inlet baffle.
- Open Access
- 31 August 2025
- Published by International Information and Engineering Technology Association in International Journal of Heat and Technology
- Vol. 43 (4)
The Drying Kinetics of Arctium Lappa Roots in a Combined Infrared–Vacuum Dryer: An Experiment
- 31 August 2025
- Published by International Information and Engineering Technology Association in International Journal of Heat and Technology
- Vol. 43 (4)
Open AccessThe Drying Kinetics of Arctium Lappa Roots in a Combined Infrared–Vacuum Dryer: An Experiment
- Open Access
- 17 July 2025
- Published by Elsevier in International Journal of Thermofluids
- Vol. 29
The effect of geometrical parameters on thermohydraulic characteristics of plain fin-and-flat tube heat exchangers: A CFD and Taguchi approach
- 17 July 2025
- Published by Elsevier in International Journal of Thermofluids
- Vol. 29
Open AccessThe effect of geometrical parameters on thermohydraulic characteristics of plain fin-and-flat tube heat exchangers: A CFD and Taguchi approach
- Open Access
- 10 April 2025
- Published by Elsevier in Results in Engineering
- Vol. 26
The effect of the baffle on heat transfer and entropy generation of water near its density maximum in a cavity: Numerical simulation
- 10 April 2025
- Published by Elsevier in Results in Engineering
- Vol. 26
Open AccessThe effect of the baffle on heat transfer and entropy generation of water near its density maximum in a cavity: Numerical simulation
- Open Access
- 9 January 2025
- Published by Elsevier in International Journal of Thermofluids
- Vol. 26
Heat transfer and flow characteristics in horizontal spiral coils with flat tubes and rectangular ribs: CFD and optimization
- 9 January 2025
- Published by Elsevier in International Journal of Thermofluids
- Vol. 26
Open AccessHeat transfer and flow characteristics in horizontal spiral coils with flat tubes and rectangular ribs: CFD and optimization
- Open Access
- 31 December 2024
- Published by International Information and Engineering Technology Association in International Journal of Heat and Technology
- Vol. 42 (6) , 2001-2007
The Mass Transfer Coefficient of Pseudapocryptes Elongatus Fish Dried in a Hot Air Dryer
- 31 December 2024
- Published by International Information and Engineering Technology Association in International Journal of Heat and Technology
- Vol. 42 (6) , 2001-2007
Open AccessThe Mass Transfer Coefficient of Pseudapocryptes Elongatus Fish Dried in a Hot Air Dryer