Ersin Cicek
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Ersin Cicek has a total of 49 co-authors. Here are the top co-authors by number of shared publications:
- Kenta Futatsukawa
High Energy Accelerator Research Organization (KEK)
4 shared publications - Yuga Nakazawa
High Energy Accelerator Research Organization (KEK)
4 shared publications - Hiromi Iinuma
Ibaraki University
3 shared publications - Masashi Otani
Accelerator Laboratory, High Energy Accelerator Research Organization (KEK), Tsukuba, Japan
3 shared publications - Satoshi Mizobata
High Energy Accelerator Research Organization (KEK), Ibaraki, 305-0801, Japan
3 shared publications - Takatoshi Morishita
Japan Atomic Energy Agency (JAEA), Tokai, Naka, Ibaraki 319-1195, Japan
3 shared publications
Latest Publications
- Open Access
- 1 September 2026
- Published by American Physical Society (APS) in Physical Review Accelerators and Beams
- Vol. 29 (9) , 093201
324-MHz interdigital H -mode drift tube linac for muon acceleration
We have constructed a 324-MHz interdigital H -mode drift tube linear accelerator (IH-DTL) with an alternating phase focusing method. This IH-DTL will be part of a muon linear accelerator (linac) being developed at the Japan Proton Accelerator Research Complex for a precise measurement of the muon anomalous magnetic moment and a search for the muon electric dipole moment. The IH-DTL is 1.45 m long and accelerates muons from β = v / c = 0.08 to 0.28. Low-power tuning was performed using six slug tuners, which reduced the peak-to-peak on-axis field error to 1.4 % . Following 94 h of high-power conditioning, the IH-DTL demonstrated stable operation at the nominal peak power of 390 kW and a duty factor of 0.1%, corresponding to the designed accelerating field ( E 0 ) of 3.6 MV / m . This paper presents the construction, low-power rf tuning, and high-power performance of the 324-MHz IH-DTL.
- 1 September 2026
- Published by American Physical Society (APS) in Physical Review Accelerators and Beams
- Vol. 29 (9) , 093201
Open Access324-MHz interdigital H -mode drift tube linac for muon acceleration
We have constructed a 324-MHz interdigital H -mode drift tube linear accelerator (IH-DTL) with an alternating phase focusing method. This IH-DTL will be part of a muon linear accelerator (linac) being developed at the Japan Proton Accelerator Research Complex for a precise measurement of the muon anomalous magnetic moment and a search for the muon electric dipole moment. The IH-DTL is 1.45 m long and accelerates muons from β = v / c = 0.08 to 0.28. Low-power tuning was performed using six slug tuners, which reduced the peak-to-peak on-axis field error to 1.4 % . Following 94 h of high-power conditioning, the IH-DTL demonstrated stable operation at the nominal peak power of 390 kW and a duty factor of 0.1%, corresponding to the designed accelerating field ( E 0 ) of 3.6 MV / m . This paper presents the construction, low-power rf tuning, and high-power performance of the 324-MHz IH-DTL.
- Open Access
- 24 July 2023
- Published by MDPI AG in Physical Sciences Forum
- Vol. 8 (1) , 20
Interdigital H-Mode Drift Tube Linear Accelerator for a Muon Linear Accelerator
The muon anomalous magnetic moment () measurement at the Fermilab National Accelerator Laboratory (FNAL-E989) is consistent with a previous experiment at the Brookhaven National Laboratory (BNL-E821), and these results show a deviation of 4.2 standard deviations from the prediction of the Standard Model. This deviation may suggest the existence of unknown particles, and a completely different approach from previous experiments is needed for further verification. The J-PARC experiment’s objective is to measure the muon g-2 and the electric dipole moment (EDM) with high precision using a new method with a low-emittance muon beam generated by RF linear acceleration. In this paper, the development of an interdigital H-mode drift tube linac (IH-DTL) for the muon linear accelerator is described.- 24 July 2023
- Published by MDPI AG in Physical Sciences Forum
- Vol. 8 (1) , 20
Open AccessInterdigital H-Mode Drift Tube Linear Accelerator for a Muon Linear Accelerator
The muon anomalous magnetic moment () measurement at the Fermilab National Accelerator Laboratory (FNAL-E989) is consistent with a previous experiment at the Brookhaven National Laboratory (BNL-E821), and these results show a deviation of 4.2 standard deviations from the prediction of the Standard Model. This deviation may suggest the existence of unknown particles, and a completely different approach from previous experiments is needed for further verification. The J-PARC experiment’s objective is to measure the muon g-2 and the electric dipole moment (EDM) with high precision using a new method with a low-emittance muon beam generated by RF linear acceleration. In this paper, the development of an interdigital H-mode drift tube linac (IH-DTL) for the muon linear accelerator is described. - Open Access
- 7 November 2022
- Published by American Physical Society (APS) in Physical Review Accelerators and Beams
- Vol. 25 (11) , 110101
High-power test of an interdigital -mode drift tube linac for the J-PARC muon and electric dipole moment experimentWe conducted a high-power test of a prototype cavity of a 324-MHz interdigital H-mode drift tube linac (IH-DTL) for the precise measurement of the muon anomalous magnetic moment () and electric dipole moment (EDM). This prototype cavity (short IH) was developed to verify the fabrication methodology for the IH-DTL cavity with a monolithic drift tube structure. The electromagnetic field distribution was measured and compared with the finite element method simulation results, and the fabrication accuracy of the monolithic drift tube was confirmed to satisfy the requirements. After 40 h of conditioning, the short IH was stably operated with an rf power of 88 kW, which corresponds to a 10% higher accelerating field than the design field () of . In addition, the thermal characteristics and frequency response were measured, verifying that the experimental data were consistent with the three-dimensional model. In this paper, the design, fabrication, and low-power and high-power tests of this IH-DTL for muon acceleration are described.- 7 November 2022
- Published by American Physical Society (APS) in Physical Review Accelerators and Beams
- Vol. 25 (11) , 110101
Open AccessHigh-power test of an interdigital -mode drift tube linac for the J-PARC muon and electric dipole moment experimentWe conducted a high-power test of a prototype cavity of a 324-MHz interdigital H-mode drift tube linac (IH-DTL) for the precise measurement of the muon anomalous magnetic moment () and electric dipole moment (EDM). This prototype cavity (short IH) was developed to verify the fabrication methodology for the IH-DTL cavity with a monolithic drift tube structure. The electromagnetic field distribution was measured and compared with the finite element method simulation results, and the fabrication accuracy of the monolithic drift tube was confirmed to satisfy the requirements. After 40 h of conditioning, the short IH was stably operated with an rf power of 88 kW, which corresponds to a 10% higher accelerating field than the design field () of . In addition, the thermal characteristics and frequency response were measured, verifying that the experimental data were consistent with the three-dimensional model. In this paper, the design, fabrication, and low-power and high-power tests of this IH-DTL for muon acceleration are described. - 1 April 2021
- Published by IOP Publishing in Journal of Instrumentation
- Vol. 16 (04) , P04006
A tunable autocorrelator for pulse measurements at IR FEL-oscillator facilities
Radiation characteristics of a Free-Electron Laser (FEL) such as pulse length, time structure, intensity, bandwidth, wavelength, power, frequency, etc., which were measured on a diagnostics table, are thoroughly discussed. In this respect, pulse length measurements of an Infrared FEL (IR-FEL) beam are evaluated through an intensity autocorrelator, designed and installed as a diagnostics tool at the “Helmholtz-Zentrum Dresden-Rossendorf (HZDR)-Radiation Source ELBE” of Germany. In addition, the autocorrelator was designed as a unique, cost-effective, and in-house setup. It operates within the wavelength range of 3–35 microns, using Cadmium-Telluride (CdTe) crystals in the Second Harmonic Generation (SHG) medium. The intensity autocorrelation curves were obtained for the FEL beam with the wavelength of 26.2 microns, indicating an FWHM pulse duration ranging between 3.29–8.03 ps with different optical cavity detuning values. Furthermore, the pulse duration of Ti: sapphire laser beam is measured between 1–3 ps through the designed autocorrelator at the ELBE light source. On the other hand, the setup may pave the way for pulse length measurements of the Turkish infrared FEL-oscillator facility (TARLA) as well, which is currently under the hardware installation phase. Finally, it is elaborated in section 3 that the unique autocorrelator design fully meets all requirements for pulse length measurements of an infrared FEL source.
- 1 April 2021
- Published by IOP Publishing in Journal of Instrumentation
- Vol. 16 (04) , P04006
A tunable autocorrelator for pulse measurements at IR FEL-oscillator facilities
Radiation characteristics of a Free-Electron Laser (FEL) such as pulse length, time structure, intensity, bandwidth, wavelength, power, frequency, etc., which were measured on a diagnostics table, are thoroughly discussed. In this respect, pulse length measurements of an Infrared FEL (IR-FEL) beam are evaluated through an intensity autocorrelator, designed and installed as a diagnostics tool at the “Helmholtz-Zentrum Dresden-Rossendorf (HZDR)-Radiation Source ELBE” of Germany. In addition, the autocorrelator was designed as a unique, cost-effective, and in-house setup. It operates within the wavelength range of 3–35 microns, using Cadmium-Telluride (CdTe) crystals in the Second Harmonic Generation (SHG) medium. The intensity autocorrelation curves were obtained for the FEL beam with the wavelength of 26.2 microns, indicating an FWHM pulse duration ranging between 3.29–8.03 ps with different optical cavity detuning values. Furthermore, the pulse duration of Ti: sapphire laser beam is measured between 1–3 ps through the designed autocorrelator at the ELBE light source. On the other hand, the setup may pave the way for pulse length measurements of the Turkish infrared FEL-oscillator facility (TARLA) as well, which is currently under the hardware installation phase. Finally, it is elaborated in section 3 that the unique autocorrelator design fully meets all requirements for pulse length measurements of an infrared FEL source.