Barosaim Sung
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Barosaim Sung has a total of 31 co-authors. Here are the top co-authors by number of shared publications:
Anna Yu
System LSI Business, Samsung Electronics, Hwaseong-si, South Korea
2 shared publicationsBeomkon Kim
System LSI Business, Samsung Electronics, Hwaseong-si, South Korea
2 shared publicationsEuiyoung Park
System LSI Business, Samsung Electronics, Hwaseong-si, South Korea
2 shared publications- Hyun-Gi Seok
Samsung Electronics
2 shared publications Jeongyeol Bae
System LSI Business, Samsung Electronics, Hwaseong-si, South Korea
2 shared publicationsJong-Hyun Jang
System LSI Business, Samsung Electronics, Hwaseong-si, South Korea
2 shared publications
Latest Publications
- 18 October 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Solid-State Circuits
- Vol. 57 (12) , 3646-3655
A Single Path Digital-IF Receiver Supporting Inter/Intra 5-CA With a Single Integer LO-PLL in 14-nm CMOS FinFET
The world’s first 5-carrier aggregation (CA) supporting digital-intermediate frequency (IF) receiver (RX) to support 5G sub-6 GHz new radio (NR) and CA/E-UTRA NR dual connectivity (CA/EN-DC) maintaining 2G and 3G in 14-nm FinFET CMOS technology is presented. Three digital-IF RXs with a shared local oscillator-phase-locked loop (LO-PLL) are integrated for supporting inter-/intra-band 5-CA to reduce power consumption and area of the massive number of RX paths. The RX features nine single-ended low-noise amplifiers (LNAs) with low/mid/high band (L/M/HB) characteristics. It achieves noise figure (NF) of 1.5 dB with 18 dB external LNA gain and $+$ 7.6-dBm out-of-band (OOB) input intercept point 3 (IIP3), and input intercept point 2 (IIP2) calibration is not required thanks to IF planning. The RX achieves an error vector magnitude (EVM) of 2.5% by intra-4CA for B1 LTE10MHz and LTE20MHz in one single RX path, as well as inter-3CA for B3, B5, and B7 long-term evolution (LTE) 20 MHz with a shared LO-PLL. The estimated power saving by sharing a single LO-PLL is 17% compared to 3-CA RXs with three separate LO-PLLs.
- 18 October 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Solid-State Circuits
- Vol. 57 (12) , 3646-3655
A Single Path Digital-IF Receiver Supporting Inter/Intra 5-CA With a Single Integer LO-PLL in 14-nm CMOS FinFET
The world’s first 5-carrier aggregation (CA) supporting digital-intermediate frequency (IF) receiver (RX) to support 5G sub-6 GHz new radio (NR) and CA/E-UTRA NR dual connectivity (CA/EN-DC) maintaining 2G and 3G in 14-nm FinFET CMOS technology is presented. Three digital-IF RXs with a shared local oscillator-phase-locked loop (LO-PLL) are integrated for supporting inter-/intra-band 5-CA to reduce power consumption and area of the massive number of RX paths. The RX features nine single-ended low-noise amplifiers (LNAs) with low/mid/high band (L/M/HB) characteristics. It achieves noise figure (NF) of 1.5 dB with 18 dB external LNA gain and $+$ 7.6-dBm out-of-band (OOB) input intercept point 3 (IIP3), and input intercept point 2 (IIP2) calibration is not required thanks to IF planning. The RX achieves an error vector magnitude (EVM) of 2.5% by intra-4CA for B1 LTE10MHz and LTE20MHz in one single RX path, as well as inter-3CA for B3, B5, and B7 long-term evolution (LTE) 20 MHz with a shared LO-PLL. The estimated power saving by sharing a single LO-PLL is 17% compared to 3-CA RXs with three separate LO-PLLs.
- 20 February 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 65, 440-442
A Single-Path Digital-IF Receiver Supporting Inter/Intra 5-CA with a Single Integer LO-PLL in 14nm CMOS FinFET
The expansion of information and communication technologies has led us to the invention of 5 th -generation (5G) communications. However, as an effort to overcome the insufficient frequency-band resource in FR1, telecommunication companies are continuously securing additional re-farming bands in FR1, and they are extending maximum throughput by applying Carrier Aggregation/E-UTRA NR Dual connectivity (CA/EN-DC) based on many fragment bands as shown in Fig. 27.5.1. For example, a major telecommunication company supports CA/EN-DC of the B1, B3, B5, B7 (1), B7 (2), and n78 bands, which require more than 20 RX paths considering the antenna diversity and 4x4 MIMO needed for maximum throughput. As the demands for spectrum re-farming increase, more fragment bands are used, and the required numbers of RX paths also increase accordingly in a conventional direct-conversion-receiver (DCR) architecture. In addition, to support the various fragment bands, multiple front-end modules (FEMs) are required and each FEM needs to be highly complexed with higher-performance multiplexers such as octaplexers or hexaplexers to maintain TX-RX isolation for TX desensitization from IIP2 as shown in Fig. 27.5.1. When B1 TX and RX are activated with B3 RX simultaneously, the isolation between the B1 TX and B3 RX path is more difficult to achieve than that between the B1 TX and RX path due to the reduced duplex spacing (i.e., 40MHz from 130MHz). Also, a local-oscillator (LO) leakage power from in-band LO frequency as well as leakage powers from the adjacent LO harmonics are added to the DC offset of receiver chains. These issues can be relaxed by a multiple-channel-processing receiver with IF conversion such as a software-defined-radio (SDR) receiver or by cognitive radio (CR) receivers that can break through the shortage of FR1 band by searching and adapting unoccupied bands in real time.
- 20 February 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 65, 440-442
A Single-Path Digital-IF Receiver Supporting Inter/Intra 5-CA with a Single Integer LO-PLL in 14nm CMOS FinFET
The expansion of information and communication technologies has led us to the invention of 5 th -generation (5G) communications. However, as an effort to overcome the insufficient frequency-band resource in FR1, telecommunication companies are continuously securing additional re-farming bands in FR1, and they are extending maximum throughput by applying Carrier Aggregation/E-UTRA NR Dual connectivity (CA/EN-DC) based on many fragment bands as shown in Fig. 27.5.1. For example, a major telecommunication company supports CA/EN-DC of the B1, B3, B5, B7 (1), B7 (2), and n78 bands, which require more than 20 RX paths considering the antenna diversity and 4x4 MIMO needed for maximum throughput. As the demands for spectrum re-farming increase, more fragment bands are used, and the required numbers of RX paths also increase accordingly in a conventional direct-conversion-receiver (DCR) architecture. In addition, to support the various fragment bands, multiple front-end modules (FEMs) are required and each FEM needs to be highly complexed with higher-performance multiplexers such as octaplexers or hexaplexers to maintain TX-RX isolation for TX desensitization from IIP2 as shown in Fig. 27.5.1. When B1 TX and RX are activated with B3 RX simultaneously, the isolation between the B1 TX and B3 RX path is more difficult to achieve than that between the B1 TX and RX path due to the reduced duplex spacing (i.e., 40MHz from 130MHz). Also, a local-oscillator (LO) leakage power from in-band LO frequency as well as leakage powers from the adjacent LO harmonics are added to the DC offset of receiver chains. These issues can be relaxed by a multiple-channel-processing receiver with IF conversion such as a software-defined-radio (SDR) receiver or by cognitive radio (CR) receivers that can break through the shortage of FR1 band by searching and adapting unoccupied bands in real time.