SKSergey D. Komarov

Sergey D. Komarov

*This is an algorithmically generated author record based on publicly available information.

Sergey D. Komarov has a total of 79 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Excitation-dependent photoluminescence and room-temperature whispering gallery mode lasing in InGaN/GaN microdisks on sapphire

    by S.D. Komarov, D.A. Masyutin, E.I. Moiseev, E.A. Beliaeva, K.A. Ivanov, A.F. Tsatsul'NIkov, E.V. Lutsenko, A.G. Vainilovich, A.V. Sakharov, D.S. Arteev, et al.

  • Small area quantum-dot stripe lasers with focused-ion-beam-etched mirrors

    by Anna Obraztsova, Nikita Fominykh, Sergey Komarov, Veronica Voitovich, Ivan Melnichenko, Ivan Makhov, Konstantin Ivanov, Nikita Shandyba, Natalia Solodovnik, Maxim Solodovnik, et al.

    Miniaturization of edge-emitting quantum-dot lasers is hampered by increased mirror losses in ultra-short Fabry–Pérot cavities and limited modal gain of quantum dots (QDs). Here, we demonstrate electrically injected InGaAs/GaAs quantum-dot stripe lasers with an 8-μm stripe width and focused-ion-beam (FIB)-etched mirrors defining cavity lengths from 300 to 77 μm. The laser cavities were fabricated using techniques that allow for group fabrication and integration of lasers with other elements. The stripes were formed by deep reactive ion etching, and the laser mirrors were made using FIB etching technique. Five planes of InGaAs QDs grown in the non-Stranski–Krastanov mode were used as the laser active region. QDs of this type are responsible for high optical gain capable of compensating for losses in short cavities. Lasing is observed down to 77 μm, while the minimum threshold current of 23–26 mA is achieved for cavities 130–250 μm long. Comparison with 50-μm-wide lasers demonstrated previously shows that the threshold current approximately scales with stripe width, indicating a route toward further current reduction in narrower devices. However, the rapid increase in threshold current density in the shortest cavities reveals that further length scaling is limited by carrier accumulation and recombination in the GaAs waveguide. A threshold current model based on dominant waveguide recombination reproduces the nonmonotonic dependence of the threshold current on cavity length. These results identify lateral narrowing as an effective route to low-current short-cavity quantum-dot lasers and waveguide recombination as the key limitation for further miniaturization.

  • Ultra-short stripe microlasers fabricated with a focused ion beam etching technique

    by Ivan Makhov, Sergey Komarov, Nikita Fominykh, Anna Obraztsova, Veronica Voitovich, Nikolay Derkach, Ivan Melnichenko, Nikita Shandyba, Natalia Chernenko, Maxim Solodovnik, et al.

    Fabry–Perot (FP) lasers with a cavity length shorten down to 50 µm were investigated. One or two laser mirrors were formed by focused ion beam etching. InGaAs quantum dots of high density were used as the laser active region. The lasers operate in a pulsed regime up to at least 105°С. A comparison with lasers formed by the facet cleaving method (minimum length is 100 µm) reveals the similarity of the emission wavelength and the threshold current depending on the cavity length. This allows us to conclude that the etched facets do not significantly affect the non-radiative recombination rate and provide a reflection coefficient close to that of the cleaved facet. The maximum modal gain was estimated to be not less than 240 cm−1. No evidence of the excited-state lasing was found.


  • Output Power of III-V Injection Microdisk and Microring Lasers

    by Natalia V. Kryzhanovskaya, Eduard I. Moiseev, Alexey M. Nadtochiy, Ivan A. Melnichenko, Nikita A. Fominykh, Konstantin A. Ivanov, Sergey D. Komarov, Ivan S. Makhov, Evgenii V. Lutsenko, Aliaksei G. Vainilovich, et al.

    Technological progress makes it possible to significantly reduce the size of semiconductor laser emitters to microscales and sizes commensurate with the emission wavelength. Extreme laser miniaturization can be achieved using disk or ring resonators supporting high-Q whispering gallery modes (WGM). WGM lasers are interesting not only due to small sizes (small mode volume) but also for their long times of light-matter interaction, unique capabilities of sensing and studying of quantum chaos and so on. On the other hand, small losses for the output of emission in high-Q resonators can negate the practical benefits of the laser or even completely hide the peculiarities of the light physics inside the cavity. In this review, we attempted to summarize the published data on the achieved optical output power in different III-V injection microlasers and analyzed the key characteristics that limit the maximum output power, especially influence of the active region self-heating at cw operation and impeded light extraction out of WGM cavities. We compared various III-V materials and fabrication methods developed for improving emission output. We also observe very low relative intensity noise in microdisk lasers and harmonics of the resonance frequency in the relative intensity noise spectrum.


  • III–V microdisk lasers coupled to planar waveguides

    by N. V. Kryzhanovskaya, K. A. Ivanov, N. A. Fominykh, S. D. Komarov, I. S. Makhov, E. I. Moiseev, J. A. Guseva, M. M. Kulagina, S. A. Mintairov, N. A. Kalyuzhnyy, et al.

    We report on InGaAs/GaAs quantum dot injection microdisk lasers laterally connected with a bus waveguide fabricated by planar technology from the same epi-structure. Various coupling schemes of microlaser with waveguide are studied including a microlaser attached to a waveguide (zero gap), a 100 nm gap for evanescence light outcoupling, and with a waveguide surrounding the resonator. The modes outcoupling and microlaser's loss (Q-factor) are analyzed by simulation of the lasers. A strong decrease in the number of the microdisk resonance lines associated with an increase in loss in the resonator due to the coupling with waveguide is observed in modeling and experimentally. We study the spectral and lasing parameters of the microdisk lasers, as well as characteristics of the outcoupled emission, and demonstrate efficient light outcoupling for 30 and 40 μm diameter continuous wave operating microdisk laser up to 96 °C.


  • Open Access

    Influence of the Arsenic Pressure during Rapid Overgrowth of InAs/GaAs Quantum Dots on Their Photoluminescence Properties

    by Sergey Balakirev, Danil Kirichenko, Natalia Chernenko, Nikita Shandyba, Sergey Komarov, Anna Dragunova, Natalia Kryzhanovskaya, Alexey Zhukov, Maxim Solodovnik

    In this paper, for the first time, we report a strong effect of the arsenic pressure used for the high-rate GaAs capping of self-assembled InAs quantum dots on their optical properties. A 140 nm red shift of the photoluminescence peak position is observed when the overgrowth arsenic pressure increases threefold. We explain this behavior in terms of different intensities of quantum dot decomposition, which occurs during the overgrowth under different conditions. When the arsenic pressure is sufficiently high, a GaAs capping layer is formed by deposited species with a low impact on initial quantum dots. At a low arsenic pressure, arsenic deficiency leads to the intensive intermixing caused both by the enhanced Ga/In atom exchange and by the consumption of arsenic atoms belonging to quantum dots for the GaAs capping layer formation. As a result of the overgrowth, quantum dots are divided into families with a large (high pressure) and a small (low pressure) average size, yielding long-wave (1.23 µm) and short-wave (1.09 µm) photoluminescence peaks, respectively. Thus, a significant influence of the overgrowth arsenic pressure on the characteristics of InAs quantum dots is evidenced in this study.


  • Open Access

    Photoluminescence Redistribution of InGaN Nanowires Induced by Plasmonic Silver Nanoparticles

    by Talgat Shugabaev, Vladislav O. Gridchin, Sergey D. Komarov, Demid A. Kirilenko, Natalia V. Kryzhanovskaya, Konstantin P. Kotlyar, Rodion R. Reznik, Yelizaveta I. Girshova, Valentin V. Nikolaev, Michael A. Kaliteevski, et al.

    Hybrid nanostructures based on InGaN nanowires with decorated plasmonic silver nanoparticles are investigated in the present study. It is shown that plasmonic nanoparticles induce the redistribution of room temperature photoluminescence between short-wavelength and long-wavelength peaks of InGaN nanowires. It is defined that short-wavelength maxima decreased by 20%, whereas the long-wavelength maxima increased by 19%. We attribute this phenomenon to the energy transfer and enhancement between the coalesced part of the NWs with 10–13% In content and the tips above with an In content of about 20–23%. A proposed Fröhlich resonance model for silver NPs surrounded by a medium with refractive index of 2.45 and spread 0.1 explains the enhancement effect, whereas the decreasing of the short-wavelength peak is associated with the diffusion of charge carriers between the coalesced part of the NWs and the tips above.


  • Open Access

    Photoluminescence Properties of InAs Quantum Dots Overgrown by a Low-Temperature GaAs Layer under Different Arsenic Pressures

    by Sergey Balakirev, Natalia Chernenko, Natalia Kryzhanovskaya, Nikita Shandyba, Danil Kirichenko, Anna Dragunova, Sergey Komarov, Alexey Zhukov, Maxim Solodovnik

    We studied the influence of the arsenic pressure during low-temperature GaAs overgrowth of InAs quantum dots on their optical properties. In the photoluminescence spectrum of quantum dots overgrown at a high arsenic pressure, we observed a single broad line corresponding to unimodal size distribution of quantum dots. Meanwhile, two distinct peaks (~1080 and ~1150 nm) at larger wavelengths are found in the spectra of samples with quantum dots overgrown at a low arsenic pressure. We attributed this phenomenon to the high-pressure suppression of atom diffusion between InAs islands at the overgrowth stage, which makes it possible to preserve the initial unimodal size distribution of quantum dots. The same overgrowth of quantum dots at the low arsenic pressure induces intensive mass transfer, which leads to the formation of arrays of quantum dots with larger sizes. Integrated photoluminescence intensity at 300 K is found to be lower for quantum dots overgrown at the higher arsenic pressure. However, a difference in the photoluminescence intensity for the high- and low-pressure overgrowths is not so significant for a temperature of 77 K. This indicates that excess arsenic incorporates into the capping layer at high arsenic pressures and creates numerous nonradiative recombination centers, diminishing the photoluminescence intensity.


  • Comparative Analysis of InGaAs/GaAs Quantum Dots Produced by Various Epitaxial Techniques

    by Andrey V. Babichev, Sergey D. Komarov, Julia S. Tkach, Natalia V. Kryzhanovskaya, Alexey M. Nadtochiy, Alexey A. Blokhin, Sergei A. Blokhin, Vladimir N. Nevedomskiy, Nikolay A. Maleev, Andrey G. Gladyshev, et al.

    We present the results on the formation and micro-photoluminescence studies of In 0.63 Ga 0.37 As/GaAs quantum dots grown by metal-organic vapour-phase epitaxy and molecular-beam epitaxy by Stranski-Krastanow growth mode. The structure with single layer of quantum dots grown by the metal-organic vapour-phase epitaxy demonstrated a higher peak/integral photoluminescence intensity, as well as a smaller half-width of the photoluminescence spectrum from quantum dots in comparison with the structure with single layer of quantum dots grown by the molecular-beam epitaxy. Efficient low-temperature photoluminescence near 990 nm with a full width at half maximum of about 60 meV has been demonstrated for metal-organic vapour-phase epitaxy structure. The obtained results can be used for the formation of compact vertical micro cavity optically pumped laser arrays required for neuromorphic computation.

  • Open Access

    Influence of low temperatures and thermal annealing on the optical properties of InGaPAs quantum dots

    by Vladislav V. Andryushkin, Anna S. Dragunova, Sergey D. Komarov, Alexey M. Nadtochiy, Andrey G. Gladyshev, Andrey V. Babichev, Alexander V. Uvarov, Innokenty I. Novikov, Evgenii S. Kolodeznyi, Leonid Ya. Karachinsky, et al.

    The results of the study of the optical properties of low-density InGaPAs quantum dots, as well as the effect of low temperatures and thermal annealing parameters on their optical and structural properties were presented. InGaPAs quantum dots were formed by substituting phosphorus with arsenic in InGaP layer directly during epitaxial growth. The optical properties of InGaPAs quantum dots were studied by photoluminescence (PL) spectroscopy. Photoluminescence spectra at liquid nitrogen temperature (–196 °С) made it possible to determine the features of nonradiative recombination in heterostructures. The heterostructures were subjected to short-term thermal annealing at temperatures of 600 and 650 °C for 2 min to estimate the effect of annealing on the optical and structural properties of quantum dots. It was shown that at –196 °С the contribution of nonradiative recombination can be considered insignificant for the entire measured range of pumping power rage but at temperatures above –73 °С, the contribution of nonradiative Shockley-Reed recombination can be observed. Rapid thermal annealing of InGaPAs quantum dots led to reduce the number of point defects and growth of PL intensity. InGaPAs quantum dots and substitution method can find their application in the creation of single photon sources. The presented experimental results should be considered for implementing such sources, especially for optimizing the width and intensity of the radiation line.