Issam Trrad
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Issam Trrad has a total of 41 co-authors. Here are the top co-authors by number of shared publications:
- Hashem Al-Mattarneh
Yarmouk University
10 shared publications - Rabah Ismail
Jadara University
10 shared publications - Jamal Alsadi
Faculty of Engineering, Jadara University, Irbid 21110, Jordan
7 shared publications - Faten Albtoush
Jadara University
6 shared publications - Amer Al-Canaan
Jadara University
5 shared publications - Musab Abuaddous
Yarmouk University
5 shared publications
Latest Publications
- Open Access
- 24 July 2026
- Published by MDPI AG in Future Internet
- Vol. 18 (8) , 386
Comparative Study of Ground-Slot Geometries for 5G Microstrip Antenna Performance Enhancement
This research paper investigates the impact of inserting a ground slot on the frequency performance of a monopole-type microstrip patch antenna. To examine this, a reference antenna, which is a simple rectangular monopole with the dimensions 2.4 × 2.04 mm2, was mounted on a 12 × 12 mm2 Rogers RT 5880 substrate with a thickness of 0.254 mm and a dielectric constant of εᵣ = 2.2. It was also fed by a 50 Ω microstrip line. This work compares the effects of four different geometries of rectangular ground slots: rectangular, triangular, half-ring, and half-circle, on the performance of the microstrip patch antenna. The no-slot baseline antenna showed a resonance of 12.55 GHz and a reflection coefficient of −15.9 dB. Adding a ground slot allowed the advent of single or dual-resonant frequencies, which significantly enhanced the appropriateness of the antenna in 5G usage. Notably, the rectangular slot with b1 = 3 mm achieved a resonance of 22.5 GHz, with a reflection coefficient of −33.7 dB, while b1 = 1 mm enabled dual-band operation at 11.77 GHz and 38.3 GHz. Triangular slots provided strong single-frequency operation between 26 GHz and 31 GHz, and the half-circle slot with r3 = 1 mm resonated at 12 GHz with a reflection coefficient of −39.5 dB. Although the half-ring slot had a comparatively lower reflection coefficient, it still showed dual-band potential at 11.1 GHz and 34.14 GHz. The simulation results were validated using HFSS, demonstrating good alignment. The gain of the selected antennas was also investigated, where the highest gain of 4.2 dBi was achieved by the half-ring slot design, and the lowest gain of 3.09 dBi was obtained with the half-circle slot. These findings confirm that ground-slot integration is an effective technique for frequency tuning and performance enhancement in 5G antenna design.
- 24 July 2026
- Published by MDPI AG in Future Internet
- Vol. 18 (8) , 386
Open AccessComparative Study of Ground-Slot Geometries for 5G Microstrip Antenna Performance Enhancement
This research paper investigates the impact of inserting a ground slot on the frequency performance of a monopole-type microstrip patch antenna. To examine this, a reference antenna, which is a simple rectangular monopole with the dimensions 2.4 × 2.04 mm2, was mounted on a 12 × 12 mm2 Rogers RT 5880 substrate with a thickness of 0.254 mm and a dielectric constant of εᵣ = 2.2. It was also fed by a 50 Ω microstrip line. This work compares the effects of four different geometries of rectangular ground slots: rectangular, triangular, half-ring, and half-circle, on the performance of the microstrip patch antenna. The no-slot baseline antenna showed a resonance of 12.55 GHz and a reflection coefficient of −15.9 dB. Adding a ground slot allowed the advent of single or dual-resonant frequencies, which significantly enhanced the appropriateness of the antenna in 5G usage. Notably, the rectangular slot with b1 = 3 mm achieved a resonance of 22.5 GHz, with a reflection coefficient of −33.7 dB, while b1 = 1 mm enabled dual-band operation at 11.77 GHz and 38.3 GHz. Triangular slots provided strong single-frequency operation between 26 GHz and 31 GHz, and the half-circle slot with r3 = 1 mm resonated at 12 GHz with a reflection coefficient of −39.5 dB. Although the half-ring slot had a comparatively lower reflection coefficient, it still showed dual-band potential at 11.1 GHz and 34.14 GHz. The simulation results were validated using HFSS, demonstrating good alignment. The gain of the selected antennas was also investigated, where the highest gain of 4.2 dBi was achieved by the half-ring slot design, and the lowest gain of 3.09 dBi was obtained with the half-circle slot. These findings confirm that ground-slot integration is an effective technique for frequency tuning and performance enhancement in 5G antenna design.
- Open Access
Detection and Classification of Hot Spots in Photovoltaic Panels Using Thermal Image Processing Techniques
Photovoltaic systems have recently attracted significant attention for the free, clean, and sustainable energy they generate. In this work, thermal image processing techniques were developed and utilized to classify hot spots on solar photovoltaic panels. Thermal images were classified into three categories: (a) ideal images, where images do not contain hot spots; (b) images affected by shadow; and (c) images affected by bird drops. The proposed classification was developed using image processing techniques, including histogram analysis, contrast enhancement, and filtering tools. The attained classes are then matched to the decrease in electrical power output. The proposed method was applied to thermal images to detect and classify the target hot spot. Experimental results showed that the estimated error was approximately 6.3% of the total number of images used in the research, with error rates of 6.57% for the shadow hot spot type and 6.67% for the bird drops (mud-like class). Moreover, the accuracy of the proposed method was around 93.7%.
Open AccessDetection and Classification of Hot Spots in Photovoltaic Panels Using Thermal Image Processing Techniques
Photovoltaic systems have recently attracted significant attention for the free, clean, and sustainable energy they generate. In this work, thermal image processing techniques were developed and utilized to classify hot spots on solar photovoltaic panels. Thermal images were classified into three categories: (a) ideal images, where images do not contain hot spots; (b) images affected by shadow; and (c) images affected by bird drops. The proposed classification was developed using image processing techniques, including histogram analysis, contrast enhancement, and filtering tools. The attained classes are then matched to the decrease in electrical power output. The proposed method was applied to thermal images to detect and classify the target hot spot. Experimental results showed that the estimated error was approximately 6.3% of the total number of images used in the research, with error rates of 6.57% for the shadow hot spot type and 6.67% for the bird drops (mud-like class). Moreover, the accuracy of the proposed method was around 93.7%.
- Top Cited Papers
- 17 January 2026
- Published by Springer Nature in International Journal of Information Technology
- p. 1-8
Energy-efficient 5G-enabled sensor networks for smart environmental monitoring in sustainable cities
- 17 January 2026
- Published by Springer Nature in International Journal of Information Technology
- p. 1-8
Top Cited PapersEnergy-efficient 5G-enabled sensor networks for smart environmental monitoring in sustainable cities
- Open Access
- 3 April 2025
- Published by Engineering, Technology & Applied Science Research in Engineering, Technology & Applied Science Research
- Vol. 15 (2) , 21373-21382
Design and Optimization of a Compact Inset Feed Microstrip Antenna for 5G Applications with Enhanced MIMO Performance
This study presents the design, simulation, and optimization of a compact inset feed microstrip antenna for fifth-generation (5G) applications. With dimensions of 6.2 × 8.4 × 1.57 mm³, the proposed antenna utilizes a Rogers RT5880 substrate (εr = 2.2, loss tangent = 0.0013) and operates at resonant frequencies of 28 GHz and 26 GHz. The design, performed using CST Microwave Suite 2018, achieves an operational bandwidth of 5.368 GHz (25.144–30.512 GHz), with a relative bandwidth of 19.3%. At 28 GHz, the antenna exhibits a return loss of -25.166 dB and a gain of 7.33 dB, while at 26 GHz, it achieves a return loss of -13.2 dB and a gain of 7.88 dB. Enhancements using a 2-by-1 MIMO configuration, including inverted, mirrored, and nearby arrangements, were investigated. The inverted configuration demonstrated the highest gains of 8.15 dB and 7.96 dB at 26 and 28 GHz, respectively. The proposed antenna demonstrates applicability in compact mobile devices, Internet of Things (IoT) systems, and smart city infrastructure, underlining its practical relevance.
- 3 April 2025
- Published by Engineering, Technology & Applied Science Research in Engineering, Technology & Applied Science Research
- Vol. 15 (2) , 21373-21382
Open AccessDesign and Optimization of a Compact Inset Feed Microstrip Antenna for 5G Applications with Enhanced MIMO Performance
This study presents the design, simulation, and optimization of a compact inset feed microstrip antenna for fifth-generation (5G) applications. With dimensions of 6.2 × 8.4 × 1.57 mm³, the proposed antenna utilizes a Rogers RT5880 substrate (εr = 2.2, loss tangent = 0.0013) and operates at resonant frequencies of 28 GHz and 26 GHz. The design, performed using CST Microwave Suite 2018, achieves an operational bandwidth of 5.368 GHz (25.144–30.512 GHz), with a relative bandwidth of 19.3%. At 28 GHz, the antenna exhibits a return loss of -25.166 dB and a gain of 7.33 dB, while at 26 GHz, it achieves a return loss of -13.2 dB and a gain of 7.88 dB. Enhancements using a 2-by-1 MIMO configuration, including inverted, mirrored, and nearby arrangements, were investigated. The inverted configuration demonstrated the highest gains of 8.15 dB and 7.96 dB at 26 and 28 GHz, respectively. The proposed antenna demonstrates applicability in compact mobile devices, Internet of Things (IoT) systems, and smart city infrastructure, underlining its practical relevance.
- 29 March 2025
- Published by Springer Nature
- p. 180-193
Using Radio Wave Sensor for Assessment of Sustainable Road Pavement Incorporated Olive Waste Ash
- 29 March 2025
- Published by Springer Nature
- p. 180-193
Using Radio Wave Sensor for Assessment of Sustainable Road Pavement Incorporated Olive Waste Ash
- 29 March 2025
- Published by Springer Nature
- p. 241-251
Utilizing Biomass Olive Oil Waste Ash to Enhance Rutting Resistance of Asphalt Pavement Material
- 29 March 2025
- Published by Springer Nature
- p. 241-251
Utilizing Biomass Olive Oil Waste Ash to Enhance Rutting Resistance of Asphalt Pavement Material
- 29 March 2025
- Published by Springer Nature
- p. 277-288
Near and Far Field Radio and Microwave Sensors for Moisture Content Estimation in Concrete Material
- 29 March 2025
- Published by Springer Nature
- p. 277-288
Near and Far Field Radio and Microwave Sensors for Moisture Content Estimation in Concrete Material
- 29 March 2025
- Published by Springer Nature
- p. 46-55
Development of an Image Processing Method to Determine the Air Void Parameters of Concrete
- 29 March 2025
- Published by Springer Nature
- p. 46-55
Development of an Image Processing Method to Determine the Air Void Parameters of Concrete
- 29 March 2025
- Published by Springer Nature
- p. 95-105
Using Parallel Plate Electrode Engineering Techniques for Nondestructive Testing of Timber
- 29 March 2025
- Published by Springer Nature
- p. 95-105
Using Parallel Plate Electrode Engineering Techniques for Nondestructive Testing of Timber
- Open Access
- 31 December 2024
- Published by River Publishers in Applied Computational Electromagnetics Society Journal (ACES)
- p. 1092-1102
Performance Comparison Between Fingerprinting-based RSS Indoor Localization Techniques at WLAN Frequencies: Simulation Study
This paper presents a performance comparison between two fingerprinting-based received signal strength (RSS) indoor localization techniques at wireless local-area network (WLAN) frequencies: 2.4 GHz and 5.8 GHz. The investigated algorithms include the comparative RSS (CRSS) and vector algorithms. The study was conducted using Wireless InSite ray-tracer software. The simulation was conducted in a simulated environment on the 3rd floor of the Chesham Building, University of Bradford, UK. Also, we presented an estimator which looks at the correlation between the test point RSS and the reference point RSS. The estimator performance is compared to the root mean square error (RMSE) performance. It was found that the CRSS algorithm suffers from the similarity problem while constructing the radio map, and it also suffers from ambiguity problems during localization. The vector algorithm outperforms CRSS algorithms in both frequencies and does not suffer from similarity or ambiguity problems. The proposed estimator shows better performance at both frequencies.
- 31 December 2024
- Published by River Publishers in Applied Computational Electromagnetics Society Journal (ACES)
- p. 1092-1102
Open AccessPerformance Comparison Between Fingerprinting-based RSS Indoor Localization Techniques at WLAN Frequencies: Simulation Study
This paper presents a performance comparison between two fingerprinting-based received signal strength (RSS) indoor localization techniques at wireless local-area network (WLAN) frequencies: 2.4 GHz and 5.8 GHz. The investigated algorithms include the comparative RSS (CRSS) and vector algorithms. The study was conducted using Wireless InSite ray-tracer software. The simulation was conducted in a simulated environment on the 3rd floor of the Chesham Building, University of Bradford, UK. Also, we presented an estimator which looks at the correlation between the test point RSS and the reference point RSS. The estimator performance is compared to the root mean square error (RMSE) performance. It was found that the CRSS algorithm suffers from the similarity problem while constructing the radio map, and it also suffers from ambiguity problems during localization. The vector algorithm outperforms CRSS algorithms in both frequencies and does not suffer from similarity or ambiguity problems. The proposed estimator shows better performance at both frequencies.