Sora-At Tanusilp
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Sora-At Tanusilp has a total of 19 co-authors. Here are the top co-authors by number of shared publications:
- Ken Kurosaki
Kyoto University
2 shared publications Methus Suwannaruang
2 shared publicationsTheeranuch Nachaithong
2 shared publications- Yifan Sun
Kyoto University
2 shared publications - Amnart Suksri
Khon Kaen University
1 shared publication Dulyawich Palaporn
Department of Physics, Faculty of Science, Khon Kaen University, 123 Moo 16 Mittapap Rd., Muang District Khon Kaen 40002, Thailand
1 shared publication
Latest Publications
- Open Access
- 9 March 2026
- Published by Elsevier in SSRN Electronic Journal
Low Solubility and Transport Consequences of Europium Addition in AgSbTe2 Thermoelectrics
AgSbTe2 is a promising thermoelectric material due to its intrinsically low lattice thermal conductivity. Here, Eu was introduced into AgSbTe2 (0–8 wt%) to examine its effects on structure and transport. XRD and SEM/EDX indicate very limited Eu solubility (≤2 wt% under the present synthesis conditions); at higher Eu contents, Eu segregates and promotes secondary Ag2Te and EuTe phases. Hall measurements show that Eu markedly reduces carrier concentration (by nearly one order of magnitude) with only modest mobility recovery, lowering electrical conductivity and power factor despite an increased Seebeck coefficient at low Eu levels. Unexpectedly, total and lattice thermal conductivities slightly increase with Eu content, attributed to coarse secondary phases that provide inefficient phonon scattering. Consequently, zT decreases upon Eu doping. These results define the Eu solubility limit in AgSbTe2 and clarify its coupled electronic/thermal effects, informing future co-doping and micro-alloying strategies in telluride thermoelectrics.
- 9 March 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessLow Solubility and Transport Consequences of Europium Addition in AgSbTe2 Thermoelectrics
AgSbTe2 is a promising thermoelectric material due to its intrinsically low lattice thermal conductivity. Here, Eu was introduced into AgSbTe2 (0–8 wt%) to examine its effects on structure and transport. XRD and SEM/EDX indicate very limited Eu solubility (≤2 wt% under the present synthesis conditions); at higher Eu contents, Eu segregates and promotes secondary Ag2Te and EuTe phases. Hall measurements show that Eu markedly reduces carrier concentration (by nearly one order of magnitude) with only modest mobility recovery, lowering electrical conductivity and power factor despite an increased Seebeck coefficient at low Eu levels. Unexpectedly, total and lattice thermal conductivities slightly increase with Eu content, attributed to coarse secondary phases that provide inefficient phonon scattering. Consequently, zT decreases upon Eu doping. These results define the Eu solubility limit in AgSbTe2 and clarify its coupled electronic/thermal effects, informing future co-doping and micro-alloying strategies in telluride thermoelectrics.
- 27 November 2025
- Published by Trans Tech Publications, Ltd. in Materials Science Forum
- Vol. 1169, 9-14
Nano-Titanium Dioxide Coatings for Enhanced Performance of Pantograph Support Insulators in Electric Railway Systems
Pantograph support insulators are critical for maintaining reliable power transmission in electric railway systems. However, conventional porcelain insulators suffer from contamination buildup, leading to leakage currents and flashover risks. This study investigates nanotitanium dioxide (TiO₂) coatings to enhance porcelain insulator performance. X-ray diffraction (XRD) analysis confirmed the transformation of P25 TiO₂ into the rutile phase at 1240°C, improving durability and electrical properties. Energy-dispersive X-ray spectroscopy (EDX) verified uniform TiO₂ distribution, while field emission scanning electron microscopy (FE-SEM) revealed a smooth glaze layer. Electrical testing demonstrated a 52.11% reduction in leakage current for nanoTiO₂-coated insulators under 11 kV conditions, attributed to enhanced hydrophobicity and photocatalytic self-cleaning. These results highlight the feasibility of integrating nanoTiO₂ coatings into insulator manufacturing for reduced maintenance and improved reliability.
- 27 November 2025
- Published by Trans Tech Publications, Ltd. in Materials Science Forum
- Vol. 1169, 9-14
Nano-Titanium Dioxide Coatings for Enhanced Performance of Pantograph Support Insulators in Electric Railway Systems
Pantograph support insulators are critical for maintaining reliable power transmission in electric railway systems. However, conventional porcelain insulators suffer from contamination buildup, leading to leakage currents and flashover risks. This study investigates nanotitanium dioxide (TiO₂) coatings to enhance porcelain insulator performance. X-ray diffraction (XRD) analysis confirmed the transformation of P25 TiO₂ into the rutile phase at 1240°C, improving durability and electrical properties. Energy-dispersive X-ray spectroscopy (EDX) verified uniform TiO₂ distribution, while field emission scanning electron microscopy (FE-SEM) revealed a smooth glaze layer. Electrical testing demonstrated a 52.11% reduction in leakage current for nanoTiO₂-coated insulators under 11 kV conditions, attributed to enhanced hydrophobicity and photocatalytic self-cleaning. These results highlight the feasibility of integrating nanoTiO₂ coatings into insulator manufacturing for reduced maintenance and improved reliability.
- Open Access
- 17 July 2025
- Published by American Chemical Society (ACS) in ACS Omega
- Vol. 10 (29) , 32112-32121
Investigating Thermoelectric Properties of GeTe Alloys with Multi Element Doping: Insights from High-Entropy Engineering
High-entropy engineering provides an effective strategy to enhance thermoelectric properties through increased lattice disorder induced by multielement doping. Recent multielement doping of GeTe-based alloys have significantly improved their thermoelectric performance, yet the vast compositional space of high-entropy GeTe makes identifying optimal compositions challenging. In this work, we investigate high-entropy GeTe alloys derived from the state-of-the-art Ge0.61Ag0.11Sb0.13Pb0.12Bi0.01Te system by partially adding Au to increase elemental and structural complexity without significantly degrading the electrical properties. Transmission electron microscopy confirms the presence of nanoscale lattice distortions and stacking faults that promote mass and strain fluctuations by enhancing phonon scattering. The Ge0.59Au0.02Ag0.11Sb0.13Pb0.12Bi0.01Te composition exhibits an ultralow lattice thermal conductivity of 0.22 W m-1 K-1 and achieves a maximum zT of 2.0 at 780 K. These findings demonstrate the effectiveness of high-entropy doping in tuning thermoelectric performance and advancing the development of next-generation GeTe-based thermoelectric materials.
- 17 July 2025
- Published by American Chemical Society (ACS) in ACS Omega
- Vol. 10 (29) , 32112-32121
Open AccessInvestigating Thermoelectric Properties of GeTe Alloys with Multi Element Doping: Insights from High-Entropy Engineering
High-entropy engineering provides an effective strategy to enhance thermoelectric properties through increased lattice disorder induced by multielement doping. Recent multielement doping of GeTe-based alloys have significantly improved their thermoelectric performance, yet the vast compositional space of high-entropy GeTe makes identifying optimal compositions challenging. In this work, we investigate high-entropy GeTe alloys derived from the state-of-the-art Ge0.61Ag0.11Sb0.13Pb0.12Bi0.01Te system by partially adding Au to increase elemental and structural complexity without significantly degrading the electrical properties. Transmission electron microscopy confirms the presence of nanoscale lattice distortions and stacking faults that promote mass and strain fluctuations by enhancing phonon scattering. The Ge0.59Au0.02Ag0.11Sb0.13Pb0.12Bi0.01Te composition exhibits an ultralow lattice thermal conductivity of 0.22 W m-1 K-1 and achieves a maximum zT of 2.0 at 780 K. These findings demonstrate the effectiveness of high-entropy doping in tuning thermoelectric performance and advancing the development of next-generation GeTe-based thermoelectric materials.
- 1 December 2022
- Published by IOP Publishing in Japanese Journal of Applied Physics
- Vol. 62 (SD) , SD0802
Rare-earth silicides: the promising candidates for thermoelectric applications at near room temperature
Metal silicides are considered promising candidates for thermoelectric applications thanks to the advantages of low toxicity and high stability. The most well-known silicide is Mg2Si which exhibits high thermoelectric efficiency, determined by the dimensionless figure of merit (zT) at the temperature range of 600 to 800 K. Other conventional silicides such as FeSi2, CrSi2 Ru2Si3, and higher manganese silicides have their highest zT values at temperatures higher than 800 K. However, there are limited known silicide-based thermoelectric materials operating at near room temperature. Here, we focused on rare-Earth (RE) silicides, exhibiting special behaviors of heavy fermion or mixed valence. Such behaviors cause an uncommonly large Seebeck coefficient and thermoelectric power factor for metal at low temperatures, which are potential advantages for thermoelectric applications at low temperatures. Thus, we will review several reports on RE silicide-based thermoelectric materials and our recent work on Yb(Si1−x Ge x )2−δ , which is considered a promising thermoelectric material at near room temperature.
- 1 December 2022
- Published by IOP Publishing in Japanese Journal of Applied Physics
- Vol. 62 (SD) , SD0802
Rare-earth silicides: the promising candidates for thermoelectric applications at near room temperature
Metal silicides are considered promising candidates for thermoelectric applications thanks to the advantages of low toxicity and high stability. The most well-known silicide is Mg2Si which exhibits high thermoelectric efficiency, determined by the dimensionless figure of merit (zT) at the temperature range of 600 to 800 K. Other conventional silicides such as FeSi2, CrSi2 Ru2Si3, and higher manganese silicides have their highest zT values at temperatures higher than 800 K. However, there are limited known silicide-based thermoelectric materials operating at near room temperature. Here, we focused on rare-Earth (RE) silicides, exhibiting special behaviors of heavy fermion or mixed valence. Such behaviors cause an uncommonly large Seebeck coefficient and thermoelectric power factor for metal at low temperatures, which are potential advantages for thermoelectric applications at low temperatures. Thus, we will review several reports on RE silicide-based thermoelectric materials and our recent work on Yb(Si1−x Ge x )2−δ , which is considered a promising thermoelectric material at near room temperature.