Xiao Liu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Xiao Liu has a total of 10 co-authors. Here are the top co-authors by number of shared publications:
- Rui Zhao
Beijing Institute of Technology
4 shared publications - Chih-Yung Wen
The Hong Kong Polytechnic University
3 shared publications - Yuxiang Fan
Beijing Institute of Technology
2 shared publications - Jiaao Hao
The Hong Kong Polytechnic University
1 shared publication - Peixu Guo
The Hong Kong Polytechnic University
1 shared publication - Tiehan Long
China Academy of Aerospace Aerodynamics 1 , Beijing 100074
1 shared publication
Latest Publications
- 1 January 2024
- Published by AIP Publishing in Physics of Fluids
- Vol. 36 (1)
Local correlation, compressibility, and crossflow corrections of γ-Reθ transition model for high-speed flows
Based on the original γ-Reθ transition model framework, in this work, an improved local correlation-based transition closure model is developed for high-speed flows. The local correlation between the vorticity Reynolds number and the momentum thickness Reynolds number obtained by compressible boundary-layer self-similar solutions, local compressibility correction including the pressure gradient parameter and momentum thickness Reynolds number, and local crossflow correlation are applied to improve the original γ-Reθ model for hypersonic transition predictions. The function Fonset1 used to control the transition onset and several relevant model parameters are also modified to make the improved model suitable for high-speed flow. The improved transition model is validated through several basic test cases under a wide range of flow conditions, including high-speed flat plates, sharp cones, double ramp, Hypersonic International Flight Research Experimentation, and complex hypersonic configuration X-33 vehicles. The numerical results show that the transition onset locations and the changes of heat transfer rate predicted by the present improved transition model are reasonably consistent with experimental results. The proposed model predicts the high-speed boundary layer transition behaviors induced by streamwise and crossflow instabilities with reasonable precision.
- 1 January 2024
- Published by AIP Publishing in Physics of Fluids
- Vol. 36 (1)
Local correlation, compressibility, and crossflow corrections of γ-Reθ transition model for high-speed flows
Based on the original γ-Reθ transition model framework, in this work, an improved local correlation-based transition closure model is developed for high-speed flows. The local correlation between the vorticity Reynolds number and the momentum thickness Reynolds number obtained by compressible boundary-layer self-similar solutions, local compressibility correction including the pressure gradient parameter and momentum thickness Reynolds number, and local crossflow correlation are applied to improve the original γ-Reθ model for hypersonic transition predictions. The function Fonset1 used to control the transition onset and several relevant model parameters are also modified to make the improved model suitable for high-speed flow. The improved transition model is validated through several basic test cases under a wide range of flow conditions, including high-speed flat plates, sharp cones, double ramp, Hypersonic International Flight Research Experimentation, and complex hypersonic configuration X-33 vehicles. The numerical results show that the transition onset locations and the changes of heat transfer rate predicted by the present improved transition model are reasonably consistent with experimental results. The proposed model predicts the high-speed boundary layer transition behaviors induced by streamwise and crossflow instabilities with reasonable precision.
- 1 October 2023
- Published by AIP Publishing in Physics of Fluids
- Vol. 35 (10)
Stabilization mechanisms of various acoustic metasurfaces on the second mode in hypersonic boundary-layer flows
Acoustic metasurfaces have been shown to stabilize the Mack second mode in the hypersonic boundary layer through various acoustic wave manipulations, but the stabilization mechanisms still lack unified clarification. In the present work, momentum potential theory is used to develop a physics-based analysis of the perturbance flow field above three kinds of acoustic metasurfaces: the absorptive, impedance-near-zero, and reflection-controlled metasurfaces. It found the thermal-acoustic source term Pta contributes the most to the instability, and the main differences in the stabilization mechanisms of the various metasurfaces can be derived from the distributions of Pta. The absorptive metasurface largely restrains the negative Pta term near the surface and slightly attenuates it near the critical layer. The impedance-near-zero metasurface generates a positive contour under the critical layer, while the reflection-controlled metasurface induces additional positive Pta intertwining along the critical layer. In addition, a uniform macroslit surface without particular acoustic characteristic is verified to stabilize the Mack second mode because the recirculation zones inside the macroslits attenuate the near-surface negative Pta. By deflecting the reflective waves, additional larger positive Pta could be produced and wrapped along the critical layer and that achieves a more prominent stabilization performance by designing a reflection-controlled macroslit surface.
- 1 October 2023
- Published by AIP Publishing in Physics of Fluids
- Vol. 35 (10)
Stabilization mechanisms of various acoustic metasurfaces on the second mode in hypersonic boundary-layer flows
Acoustic metasurfaces have been shown to stabilize the Mack second mode in the hypersonic boundary layer through various acoustic wave manipulations, but the stabilization mechanisms still lack unified clarification. In the present work, momentum potential theory is used to develop a physics-based analysis of the perturbance flow field above three kinds of acoustic metasurfaces: the absorptive, impedance-near-zero, and reflection-controlled metasurfaces. It found the thermal-acoustic source term Pta contributes the most to the instability, and the main differences in the stabilization mechanisms of the various metasurfaces can be derived from the distributions of Pta. The absorptive metasurface largely restrains the negative Pta term near the surface and slightly attenuates it near the critical layer. The impedance-near-zero metasurface generates a positive contour under the critical layer, while the reflection-controlled metasurface induces additional positive Pta intertwining along the critical layer. In addition, a uniform macroslit surface without particular acoustic characteristic is verified to stabilize the Mack second mode because the recirculation zones inside the macroslits attenuate the near-surface negative Pta. By deflecting the reflective waves, additional larger positive Pta could be produced and wrapped along the critical layer and that achieves a more prominent stabilization performance by designing a reflection-controlled macroslit surface.
- Open Access
- 1 September 2023
- Published by AIP Publishing in Physics of Fluids
- Vol. 35 (9)
Effect of acoustic metasurface on hypersonic-boundary-layer wave packet
Effect of the acoustic metasurface on a broadband wave packet in a Mach 6 boundary layer is studied. Direct numerical simulations (DNSs) with time-domain impedance boundary condition (TDIBC) and metasurface with microstructures are performed. It is shown that DNS with TDIBC resolves the amplitude and phase information of the wave packet satisfactorily. The minor prediction discrepancy arises from the modeling error in the acoustic impedance. The interesting finding of this paper is that the metasurface behaves as an equivalent unsteady blowing-suction model to perturb the wall-normal velocity and then passively the pressure field. Although both pressure and wall-normal velocity appear in the characteristic-wave variable, the pressure can be decoupled to be updated by the Neumann condition, as usually employed in Navier–Stokes solvers. The dominant frequency scale that enables reproducing the stabilization effect of the metasurface is found to be slightly smaller than the energetic frequency maximum of the wave packet. This observation indicates that the high-frequency unsteadiness nature of the blowing-suction behavior is indispensable, which is induced by the interaction of the metasurface and the wave packet. For the stabilization mechanism, energy analysis reveals that a dilatation-related work near the wall is significantly suppressed by the metasurface, which agrees with the wall-normal location where the wave-packet fluctuation gets attenuated.
- 1 September 2023
- Published by AIP Publishing in Physics of Fluids
- Vol. 35 (9)
Open AccessEffect of acoustic metasurface on hypersonic-boundary-layer wave packet
Effect of the acoustic metasurface on a broadband wave packet in a Mach 6 boundary layer is studied. Direct numerical simulations (DNSs) with time-domain impedance boundary condition (TDIBC) and metasurface with microstructures are performed. It is shown that DNS with TDIBC resolves the amplitude and phase information of the wave packet satisfactorily. The minor prediction discrepancy arises from the modeling error in the acoustic impedance. The interesting finding of this paper is that the metasurface behaves as an equivalent unsteady blowing-suction model to perturb the wall-normal velocity and then passively the pressure field. Although both pressure and wall-normal velocity appear in the characteristic-wave variable, the pressure can be decoupled to be updated by the Neumann condition, as usually employed in Navier–Stokes solvers. The dominant frequency scale that enables reproducing the stabilization effect of the metasurface is found to be slightly smaller than the energetic frequency maximum of the wave packet. This observation indicates that the high-frequency unsteadiness nature of the blowing-suction behavior is indispensable, which is induced by the interaction of the metasurface and the wave packet. For the stabilization mechanism, energy analysis reveals that a dilatation-related work near the wall is significantly suppressed by the metasurface, which agrees with the wall-normal location where the wave-packet fluctuation gets attenuated.
- 1 December 2022
- Published by AIP Publishing in Physics of Fluids
- Vol. 34 (12)
Stabilization effect of acoustic metasurfaces on broadband disturbances in a Mach 6 boundary-layer flow
In this study, acoustic metasurfaces are optimized to suppress broadband frequencies of unstable modes in a Mach 6 boundary-layer flow. The metasurface is cut into five pieces, and geometrical parameters of each piece are optimized to afford a comprehensive admittance response to the local frequencies of the first and second modes. It shows the designed broadband metasurface not only is advantageous for stabilizing disturbances above the metasurface region but also inhibits the fast growth rate of low-frequency disturbances on the downstream smooth wall.
- 1 December 2022
- Published by AIP Publishing in Physics of Fluids
- Vol. 34 (12)
Stabilization effect of acoustic metasurfaces on broadband disturbances in a Mach 6 boundary-layer flow
In this study, acoustic metasurfaces are optimized to suppress broadband frequencies of unstable modes in a Mach 6 boundary-layer flow. The metasurface is cut into five pieces, and geometrical parameters of each piece are optimized to afford a comprehensive admittance response to the local frequencies of the first and second modes. It shows the designed broadband metasurface not only is advantageous for stabilizing disturbances above the metasurface region but also inhibits the fast growth rate of low-frequency disturbances on the downstream smooth wall.