Vijayakumar Govindaraj
Vijayakumar Govindaraj has a total of 22 co-authors. Here are the top co-authors by number of shared publications:
- Mayakrishnan Sujith
Sanjivani College of Engineering
3 shared publications - Shanmugasundaram Venkatarajan
Sona College of Technology
3 shared publications - Raja Raman
Muthayammal Engineering College
2 shared publications - Ramesh Sundar
Muthayammal Engineering College
2 shared publications - Dhinesh Vasudevan
Department of Electrical and Electronics Engineering, Muthayammal Engineering College (Autonomous), Rasipuram, Namakkal, India
1 shared publication - Dipesh B. Pardeshi1 shared publication
Latest Publications
- 16 September 2025
- Published by Springer Nature in Electrical Engineering
- p. 1-17
Enhancing grid stability through CLOA-HMPGNN-based electric vehicle charging system
- 16 September 2025
- Published by Springer Nature in Electrical Engineering
- p. 1-17
Enhancing grid stability through CLOA-HMPGNN-based electric vehicle charging system
- 22 April 2025
- Published by Springer Nature
- p. 247-257
Quasi Z-Source Inverter with Simple Boost and Maximum Boost Pulse Width Modulation Techniques for PV Grid Connection
- 22 April 2025
- Published by Springer Nature
- p. 247-257
Quasi Z-Source Inverter with Simple Boost and Maximum Boost Pulse Width Modulation Techniques for PV Grid Connection
- Open Access
- 1 February 2024
- Published by Institute of Advanced Engineering and Science in Bulletin of Electrical Engineering and Informatics
- Vol. 13 (1) , 58-66
Design and development of photovoltaic solar system based single phase seven level inverter
For solar photovoltaic (PV) systems, an upgraded triple gain seven-level inverter that works both independently and while connected to the grid is proposed. The two-stage configuration of the system is boost cascaded. The first stage has a one switch improved gain converter (OSIGC) to increase and normalize the input direct current (DC) voltage, and the second stage includes a unique seven level alternating current (AC) is produced via a multilevel inverter (MLI) design with triple voltage gain. The proposed OSIGC is appropriate for a broad range of conversions. The voltage gain in MLI was achieved using switched capacitor techniques. The DC-DC converter can achieve a maximum voltage gain of twelve and the MLI can achieve a maximum voltage gain of three, resulting in a DC-DC-AC voltage that can reach 36. Maximum power point tracking (MPPT) technique based on modified perturb and observe (PO) is used in OSIGC to maximise PV module power utilisation, and MLI control utilises sinusoidal pulse width modulation (SPWM) realistically. For the purpose of analysing the suggested system, a 200 Watt prototype statel is created. With a total harmonic distortion (THD) of 0.181%, up to 92.12% of the converter system’s overall efficiency is possible.
- 1 February 2024
- Published by Institute of Advanced Engineering and Science in Bulletin of Electrical Engineering and Informatics
- Vol. 13 (1) , 58-66
Open AccessDesign and development of photovoltaic solar system based single phase seven level inverter
For solar photovoltaic (PV) systems, an upgraded triple gain seven-level inverter that works both independently and while connected to the grid is proposed. The two-stage configuration of the system is boost cascaded. The first stage has a one switch improved gain converter (OSIGC) to increase and normalize the input direct current (DC) voltage, and the second stage includes a unique seven level alternating current (AC) is produced via a multilevel inverter (MLI) design with triple voltage gain. The proposed OSIGC is appropriate for a broad range of conversions. The voltage gain in MLI was achieved using switched capacitor techniques. The DC-DC converter can achieve a maximum voltage gain of twelve and the MLI can achieve a maximum voltage gain of three, resulting in a DC-DC-AC voltage that can reach 36. Maximum power point tracking (MPPT) technique based on modified perturb and observe (PO) is used in OSIGC to maximise PV module power utilisation, and MLI control utilises sinusoidal pulse width modulation (SPWM) realistically. For the purpose of analysing the suggested system, a 200 Watt prototype statel is created. With a total harmonic distortion (THD) of 0.181%, up to 92.12% of the converter system’s overall efficiency is possible.
- Open Access
- 1 December 2023
- Published by Institute of Advanced Engineering and Science in Indonesian Journal of Electrical Engineering and Computer Science
- Vol. 32 (3) , 1288-1297
Reduced switch cascaded asymmetrical 27 level inverter-STATCOMwith fuzzy logic controller
In this study, a 27-levelinverter with a reduced switch asymmetrical cascaded H-bridge (CHB) with fuzzy logic controller (FLC) is proposed. With series connections, a low voltage converter, a middle level voltage converter, and a high voltage converter make up the static synchronous compensator (STATCOM). The configuration of the asymmetrical inverter uses trinary DCsources. To acquire switching signals for the trinary inverter-based STATCOM to compensate for real power, load voltage, reactive power, load current, and power factor under load changing conditions, FLC is constructed. With fewer switches, the suggested arrangement produces greater voltage levels. The performance of the reduced switch asymmetrical cascaded H-bridge inverter-STATCOM with FLCis simulated using the MATLAB Simulink platform under both static and dynamic load conditions. When compared to reduced switch asymmetrical cascaded H-bridge inverter-STATCOM with traditional proportional integral (PI) controller, the FLC result demonstrates efficient unbalanced load compensation. The FLC in the proposed inverter also lowers the total harmonic distortion.
- 1 December 2023
- Published by Institute of Advanced Engineering and Science in Indonesian Journal of Electrical Engineering and Computer Science
- Vol. 32 (3) , 1288-1297
Open AccessReduced switch cascaded asymmetrical 27 level inverter-STATCOMwith fuzzy logic controller
In this study, a 27-levelinverter with a reduced switch asymmetrical cascaded H-bridge (CHB) with fuzzy logic controller (FLC) is proposed. With series connections, a low voltage converter, a middle level voltage converter, and a high voltage converter make up the static synchronous compensator (STATCOM). The configuration of the asymmetrical inverter uses trinary DCsources. To acquire switching signals for the trinary inverter-based STATCOM to compensate for real power, load voltage, reactive power, load current, and power factor under load changing conditions, FLC is constructed. With fewer switches, the suggested arrangement produces greater voltage levels. The performance of the reduced switch asymmetrical cascaded H-bridge inverter-STATCOM with FLCis simulated using the MATLAB Simulink platform under both static and dynamic load conditions. When compared to reduced switch asymmetrical cascaded H-bridge inverter-STATCOM with traditional proportional integral (PI) controller, the FLC result demonstrates efficient unbalanced load compensation. The FLC in the proposed inverter also lowers the total harmonic distortion.
- Open Access
- 1 June 2023
- Published by Institute of Advanced Engineering and Science in International Journal of Power Electronics and Drive Systems (IJPEDS)
- Vol. 14 (2) , 863-871
PSO based optimized PI controller design for hybrid active power filter
This research study presents the design and simulation of a hybrid active power filter (HAPF) for reducing harmonics. The reference currents have been determined using the synchronous reference frame technique. To achieve its goals, the proposed HAPF employs AI algorithm known as particle swarm optimization (PSO) to fine-tune the proportional-integral PI controller's parameters. With the help of PI-PSO controller the DC link voltage is regulated in the HAPF-inverter. A non-linear current control strategy based on hysteresis employed here to construct the pulse gate by comparing the retrieved reference and real currents necessitated by the HAPF. Simulations were carried out in MATLAB and shown that the proposed method is extremely adaptable and efficient in reducing harmonic currents caused by non-linear loads.
- 1 June 2023
- Published by Institute of Advanced Engineering and Science in International Journal of Power Electronics and Drive Systems (IJPEDS)
- Vol. 14 (2) , 863-871
Open AccessPSO based optimized PI controller design for hybrid active power filter
This research study presents the design and simulation of a hybrid active power filter (HAPF) for reducing harmonics. The reference currents have been determined using the synchronous reference frame technique. To achieve its goals, the proposed HAPF employs AI algorithm known as particle swarm optimization (PSO) to fine-tune the proportional-integral PI controller's parameters. With the help of PI-PSO controller the DC link voltage is regulated in the HAPF-inverter. A non-linear current control strategy based on hysteresis employed here to construct the pulse gate by comparing the retrieved reference and real currents necessitated by the HAPF. Simulations were carried out in MATLAB and shown that the proposed method is extremely adaptable and efficient in reducing harmonic currents caused by non-linear loads.
- Open Access
- 1 December 2022
- Published by Institute of Advanced Engineering and Science in International Journal of Applied Power Engineering (IJAPE)
- Vol. 11 (4) , 294-303
Design and development of photovoltaic based grid interactive inverter
In order to trail and produce the power generated on the photovoltaic (PV) array to the grid, a PV exhibit coordinated double lift DC-AC converter used as a contained single-stage micro inverter is introduced in this research. The flowing association of a DC converter, rectifier, and an inverter is used in the single-stage micro inverter to provide high supporting rise with a minimal obligation proportion. Due to the utilization of a greater variety of force-exchanging devices, the flowing association of the converters, however, gives limited change efficacy. With fewer switches and hidden components, the suggested disengaged double lift small inverter is intended to provide high power from maximum power point tracking (MPPT) proficiency, high transformation proportion, and high change effectiveness. The stoop reflections and the small inverter's six distinct techniques are presented. To support the display of the double lift DC-AC converter worked small inverter, the recreation and results of the exploratory proto sort are presented.
- 1 December 2022
- Published by Institute of Advanced Engineering and Science in International Journal of Applied Power Engineering (IJAPE)
- Vol. 11 (4) , 294-303
Open AccessDesign and development of photovoltaic based grid interactive inverter
In order to trail and produce the power generated on the photovoltaic (PV) array to the grid, a PV exhibit coordinated double lift DC-AC converter used as a contained single-stage micro inverter is introduced in this research. The flowing association of a DC converter, rectifier, and an inverter is used in the single-stage micro inverter to provide high supporting rise with a minimal obligation proportion. Due to the utilization of a greater variety of force-exchanging devices, the flowing association of the converters, however, gives limited change efficacy. With fewer switches and hidden components, the suggested disengaged double lift small inverter is intended to provide high power from maximum power point tracking (MPPT) proficiency, high transformation proportion, and high change effectiveness. The stoop reflections and the small inverter's six distinct techniques are presented. To support the display of the double lift DC-AC converter worked small inverter, the recreation and results of the exploratory proto sort are presented.
- Open Access
- 1 December 2022
- Published by Institute of Advanced Engineering and Science in International Journal of Power Electronics and Drive Systems (IJPEDS)
- Vol. 13 (4) , 2269-2276
A novel SVPWM for 3-phase to 5-phase conversion using matrix converter
A novel matrix converter has been developed for 3-phase to 5-phase conversion using a novel space vector pulse width modulation. The matrix converter organized to generate 5-phase AC output voltage from 3-phase input voltage with help of SVPWM method; bidirectional power switches placed in matrix converter controlled by appropriate switching pulse. Space vector pulse width modulation (SVPWM) provides better utilization of applied input voltage, improved output voltage, reduced total harmonic distortion. The bidirectional switch used by the matrix converter decreases stress on the power switch and the influence of harmonic fluctuation in AC output voltage. When compared to traditional approaches, the suggested system offers improved output voltage and current control. Using MATLAB/Simulink and FPGA-cyclone controller, respectively, modelling and experimental results have been given to validate the proposed methodology.
- 1 December 2022
- Published by Institute of Advanced Engineering and Science in International Journal of Power Electronics and Drive Systems (IJPEDS)
- Vol. 13 (4) , 2269-2276
Open AccessA novel SVPWM for 3-phase to 5-phase conversion using matrix converter
A novel matrix converter has been developed for 3-phase to 5-phase conversion using a novel space vector pulse width modulation. The matrix converter organized to generate 5-phase AC output voltage from 3-phase input voltage with help of SVPWM method; bidirectional power switches placed in matrix converter controlled by appropriate switching pulse. Space vector pulse width modulation (SVPWM) provides better utilization of applied input voltage, improved output voltage, reduced total harmonic distortion. The bidirectional switch used by the matrix converter decreases stress on the power switch and the influence of harmonic fluctuation in AC output voltage. When compared to traditional approaches, the suggested system offers improved output voltage and current control. Using MATLAB/Simulink and FPGA-cyclone controller, respectively, modelling and experimental results have been given to validate the proposed methodology.