Olga M. Tatsenko
Research Subjects
Olga M. Tatsenko has a total of 36 co-authors. Here are the top co-authors by number of shared publications:
- Viktor V. Platonov
Krylov State Research Centre, Saint-Petersburg, Russia
3 shared publications Alexander N. Moiseenko
Scientific and Technical Center of High-Energy Density Physics and Directed Radiation Fluxes of All-Russia Scientific and Research Institute of Experimental Physics, 607188, Sarov, Nizhny Novgorod region, Russia
2 shared publicationsAlexey V. Filippov
Scientific and Technical Center of High-Energy Density Physics and Directed Radiation Fluxes of All-Russia Scientific and Research Institute of Experimental Physics, 607188, Sarov, Nizhny Novgorod region, Russia
2 shared publicationsEkaterina A. Bychkova
Scientific and Technical Center of High-Energy Density Physics and Directed Radiation Fluxes of All-Russia Scientific and Research Institute of Experimental Physics, 607188, Sarov, Nizhny Novgorod region, Russia
2 shared publicationsA Kirste
Humboldt-University at Berlin, D-10115 Berlin, Germany
1 shared publicationA.I. Golovashkin
P.N. Lebedev Physical Institute, Academy of Sciences of the USSR, 117924 Moscow, USSR
1 shared publication
Latest Publications
- 20 September 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Plasma Science
- Vol. 45 (10) , 2674-2677
Test of Device Based on Disk Magnetocumulative Generator DMCG480 With Explosive Current Opening Switch
One of the perspective directions in high-energy-density physics is the creation of powerful electro physical facilities capable to form megampere current pulses with short front. This paper presents test results of the device based on five-element disk magnetocumulative generator DMCG480 and an explosive current opening switch. The current pulse of 15 MA with characteristic rise time of $~$0.8 μs was obtained in the equivalent multiwire array load of 17 nH at circuit breaking with the current of 32 MA.
- 20 September 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Plasma Science
- Vol. 45 (10) , 2674-2677
Test of Device Based on Disk Magnetocumulative Generator DMCG480 With Explosive Current Opening Switch
One of the perspective directions in high-energy-density physics is the creation of powerful electro physical facilities capable to form megampere current pulses with short front. This paper presents test results of the device based on five-element disk magnetocumulative generator DMCG480 and an explosive current opening switch. The current pulse of 15 MA with characteristic rise time of $~$0.8 μs was obtained in the equivalent multiwire array load of 17 nH at circuit breaking with the current of 32 MA.
- 2 May 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Plasma Science
- Vol. 45 (6) , 990-996
Optical Absorption of Quartz Fibers at Pulsed Irradiation With High-Energy $\gamma $ -QuantaThis paper presents the investigation results on light absorption of silica optical fibers under effect of ɣ -quanta with the energy of 2.5 MeV. Exposure radiation doses were 100-300 R, ɣ -quanta had the energy of should be a space13.5 MeV with the exposure radiation dose of 20-40 kR. Influence of the electron beam having the energy of 2.5 MeV at absorbed dose up to should be a space200 krad at rise time up to should be a space 10¹³ rad/s, and pulselength τ1/2-20 ns in the wavelength range from 0.53 to 1.30 μm was also studied. This paper describes investigation of the fibers with pure silica cores and the silica cores with different dopants. One could observe difference in behavior of the fibers absorption at exposure dose of 40 kR and absorbed dose of 200 krad. Increasing the light wavelength from 0.53 to 1.3 μm, we observed the decrease of the optical absorption that was caused by radiation exposure for all studied fiber samples. We also studied optical characteristics of a single-mode fiber (pure SiO₂ core and F doped cladding) fabricated using low-birefringence technology. One can also see that radiation exposure did not cause depolarization of the linearly polarized light and did not result to polarization plane angle change for the specified fiber. This allows using of the specified fiber as the fiber-optical probe for current (tens of megamperes) and magnetic field (tens of megagauss) measurements in the conditions of high-power radiation exposure. The presented results allow selecting of the optimum light wavelength and composition of the dopants for the fibers in order to minimize the optical losses.
- 2 May 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Plasma Science
- Vol. 45 (6) , 990-996
Optical Absorption of Quartz Fibers at Pulsed Irradiation With High-Energy $\gamma $ -QuantaThis paper presents the investigation results on light absorption of silica optical fibers under effect of ɣ -quanta with the energy of 2.5 MeV. Exposure radiation doses were 100-300 R, ɣ -quanta had the energy of should be a space13.5 MeV with the exposure radiation dose of 20-40 kR. Influence of the electron beam having the energy of 2.5 MeV at absorbed dose up to should be a space200 krad at rise time up to should be a space 10¹³ rad/s, and pulselength τ1/2-20 ns in the wavelength range from 0.53 to 1.30 μm was also studied. This paper describes investigation of the fibers with pure silica cores and the silica cores with different dopants. One could observe difference in behavior of the fibers absorption at exposure dose of 40 kR and absorbed dose of 200 krad. Increasing the light wavelength from 0.53 to 1.3 μm, we observed the decrease of the optical absorption that was caused by radiation exposure for all studied fiber samples. We also studied optical characteristics of a single-mode fiber (pure SiO₂ core and F doped cladding) fabricated using low-birefringence technology. One can also see that radiation exposure did not cause depolarization of the linearly polarized light and did not result to polarization plane angle change for the specified fiber. This allows using of the specified fiber as the fiber-optical probe for current (tens of megamperes) and magnetic field (tens of megagauss) measurements in the conditions of high-power radiation exposure. The presented results allow selecting of the optimum light wavelength and composition of the dopants for the fibers in order to minimize the optical losses.
- 1 January 2016
- Published by Pleiades Publishing Ltd in Technical Physics
- Vol. 61 (1) , 125-129
Effect of strong magnetic fields on gas adsorption
The effect of strong pulsed magnetic fields on gas adsorption at dielectric surfaces is demonstrated. We describe the experimental technique and the results indicating a considerable increase in the...
- 1 January 2016
- Published by Pleiades Publishing Ltd in Technical Physics
- Vol. 61 (1) , 125-129
Effect of strong magnetic fields on gas adsorption
The effect of strong pulsed magnetic fields on gas adsorption at dielectric surfaces is demonstrated. We describe the experimental technique and the results indicating a considerable increase in the...
- 29 May 2003
- Published by Elsevier in Physica B: Condensed Matter
- Vol. 336 (3-4) , 335-343
Crossover in the Van Vleck paramagnet TmPO4
- 29 May 2003
- Published by Elsevier in Physica B: Condensed Matter
- Vol. 336 (3-4) , 335-343
Crossover in the Van Vleck paramagnet TmPO4
- 1 March 1992
- Published by Elsevier in Physica B: Condensed Matter
- Vol. 177 (1-4) , 105-108
Low temperature measurements of Hc2 in HTSC using megagauss magnetic fields
- 1 March 1992
- Published by Elsevier in Physica B: Condensed Matter
- Vol. 177 (1-4) , 105-108
Low temperature measurements of Hc2 in HTSC using megagauss magnetic fields