Miguel Pérez-Saborid
Miguel Pérez-Saborid has a total of 15 co-authors. Here are the top co-authors by number of shared publications:
- Jose Manuel Gordillo
Universidad de Sevilla
5 shared publications - Alfonso Miguel Gañán-Calvo
Universidad de Sevilla
3 shared publications - Javier Rivero-Rodriguez
Departamento de Ingeniería Mecánica, Térmica y de Fluidos, Universidad de Málaga, 29071 Málaga, Andalucía, Spain
3 shared publications A. Barrero
Escuela Superior de Ingenieros, Universidad de Sevilla, 41092 Sevilla, Spain
2 shared publications- José María López-Herrera
Universidad de Sevilla
2 shared publications - Manuel Colera
Dpto. Ingeniería Energética ETSII Universidad Politécnica de Madrid
2 shared publications
Latest Publications
- Open Access
- 1 June 2018
- Published by Elsevier in Journal of Sound and Vibration
- Vol. 423, 442-458
Numerical investigation of the effects of compressibility on the flutter of a cantilevered plate in an inviscid, subsonic, open flow
- 1 June 2018
- Published by Elsevier in Journal of Sound and Vibration
- Vol. 423, 442-458
Open AccessNumerical investigation of the effects of compressibility on the flutter of a cantilevered plate in an inviscid, subsonic, open flow
- 1 September 2017
- Published by Elsevier in Journal of Computational Physics
- Vol. 345, 596-617
An efficient finite differences method for the computation of compressible, subsonic, unsteady flows past airfoils and panels
- 1 September 2017
- Published by Elsevier in Journal of Computational Physics
- Vol. 345, 596-617
An efficient finite differences method for the computation of compressible, subsonic, unsteady flows past airfoils and panels
- 1 January 2016
- Published by Springer Nature
- p. 979-984
Homotopy Method for Viscous Cosserat Rod Model Describing Electrospinning
- 1 January 2016
- Published by Springer Nature
- p. 979-984
Homotopy Method for Viscous Cosserat Rod Model Describing Electrospinning
- 1 January 2016
- Published by Springer Nature
- p. 985-992
Setup of Viscous Cosserat Rod Model Describing Electrospinning
- 1 January 2016
- Published by Springer Nature
- p. 985-992
Setup of Viscous Cosserat Rod Model Describing Electrospinning
- Open Access
- 8 September 2014
- Published by National Academy of Sciences in Proceedings of the National Academy of Sciences
- Vol. 111 (38) , 13763-13767
Whipping of electrified liquid jets
Significance: Whipping is a lateral instability experienced by charged jets and exploited in electrospinning to make polymer fibers. In contrast to its axisymmetric, Rayleigh–Plateau counterpart, which induces jet breakup and drop formation, whipping is nonaxisymmetric and manifests itself in a chaotic fashion, with the jet moving in uncontrolled and hardly quantifiable ways. As a result and despite its physical significance, we still do not know its detailed structure and properties. Here we perform microfluidics experiments to generate and study steady-state whipping. Remarkably, when the longest characteristic time scale in the problem is that of the surrounding liquid, the whipping structure is steady and helicoidal. Otherwise, it is as chaotic as it was in all previous studies.
- 8 September 2014
- Published by National Academy of Sciences in Proceedings of the National Academy of Sciences
- Vol. 111 (38) , 13763-13767
Open AccessWhipping of electrified liquid jets
Significance: Whipping is a lateral instability experienced by charged jets and exploited in electrospinning to make polymer fibers. In contrast to its axisymmetric, Rayleigh–Plateau counterpart, which induces jet breakup and drop formation, whipping is nonaxisymmetric and manifests itself in a chaotic fashion, with the jet moving in uncontrolled and hardly quantifiable ways. As a result and despite its physical significance, we still do not know its detailed structure and properties. Here we perform microfluidics experiments to generate and study steady-state whipping. Remarkably, when the longest characteristic time scale in the problem is that of the surrounding liquid, the whipping structure is steady and helicoidal. Otherwise, it is as chaotic as it was in all previous studies.
- 14 March 2011
- Published by American Association of Physics Teachers (AAPT) in American Journal of Physics
- Vol. 79 (4) , 401-408
Acoustic scattering from a spherical lens irradiated by a finite transducer: Focusing effect and refraction
We carry out a spatio-temporal analysis of the scattering from a spherical inhomogeneity irradiated by a finite transducer. We show that when the inhomogeneity behaves as a focusing acoustic lens, the gain and position of the focus depend strongly on the ratio of the lens size to the irradiation width. We also analyze the refraction through the lens which takes place for off-axis incidence using a two-dimensional approach. The results of the wave formulation reproduce those predicted by the law of refraction for the behavior of a ray and for the trajectory of a wave packet.
- 14 March 2011
- Published by American Association of Physics Teachers (AAPT) in American Journal of Physics
- Vol. 79 (4) , 401-408
Acoustic scattering from a spherical lens irradiated by a finite transducer: Focusing effect and refraction
We carry out a spatio-temporal analysis of the scattering from a spherical inhomogeneity irradiated by a finite transducer. We show that when the inhomogeneity behaves as a focusing acoustic lens, the gain and position of the focus depend strongly on the ratio of the lens size to the irradiation width. We also analyze the refraction through the lens which takes place for off-axis incidence using a two-dimensional approach. The results of the wave formulation reproduce those predicted by the law of refraction for the behavior of a ray and for the trajectory of a wave packet.
- 14 August 2006
- Published by Cambridge University Press (CUP) in Journal of Fluid Mechanics
- Vol. 562, 303-312
Axisymmetric breakup of bubbles at high Reynolds numbers
We have analysed the structure of the irrotational flow near the minimum radius of an axisymmetric bubble at the final instants before pinch-off. The neglect of gas inertia leads to the geometry of the liquid–gas interface near the point of minimum radius being slender and symmetric with respect to the plane $z\,{=}\,0$. The results reproduce our previous finding that the asymptotic time evolution for the minimum radius, $R_o(t)$, is $\tau\propto R^2_o\sqrt{-\,{\rm ln}\,R^2_o}$, $\tau$ being the time to breakup, and that the interface is locally described, for times sufficiently close to pinch-off, by $f(z,t)/R_o(t)\,{=}\,1\,{-}\,(6\,{\rm ln}\,R_o)^{-1}(z/R_o)^2$. These asymptotic solutions correspond to the attractor of a system of ordinary differential equations governing the flow during the final stages before pinch-off. However, we find that, depending on initial conditions, the solution converges to the attractor so slowly (with a logarithmic behaviour) that the universal laws given above may hold only for times so close to the singularity that they might not be experimentally observed.- 14 August 2006
- Published by Cambridge University Press (CUP) in Journal of Fluid Mechanics
- Vol. 562, 303-312
Axisymmetric breakup of bubbles at high Reynolds numbers
We have analysed the structure of the irrotational flow near the minimum radius of an axisymmetric bubble at the final instants before pinch-off. The neglect of gas inertia leads to the geometry of the liquid–gas interface near the point of minimum radius being slender and symmetric with respect to the plane $z\,{=}\,0$. The results reproduce our previous finding that the asymptotic time evolution for the minimum radius, $R_o(t)$, is $\tau\propto R^2_o\sqrt{-\,{\rm ln}\,R^2_o}$, $\tau$ being the time to breakup, and that the interface is locally described, for times sufficiently close to pinch-off, by $f(z,t)/R_o(t)\,{=}\,1\,{-}\,(6\,{\rm ln}\,R_o)^{-1}(z/R_o)^2$. These asymptotic solutions correspond to the attractor of a system of ordinary differential equations governing the flow during the final stages before pinch-off. However, we find that, depending on initial conditions, the solution converges to the attractor so slowly (with a logarithmic behaviour) that the universal laws given above may hold only for times so close to the singularity that they might not be experimentally observed.- 11 October 2005
- Published by Cambridge University Press (CUP) in Journal of Fluid Mechanics
- Vol. 541, 1-20
Aerodynamic effects in the break-up of liquid jets: on the first wind-induced break-up regime
We present both numerical and analytical results from a spatial stability analysis of the coupled gas–liquid hydrodynamic equations governing the first wind-induced (FWI) liquid-jet break-up regime. Our study shows that an accurate evaluation of the growth rate of instabilities developing in a liquid jet discharging into a still gaseous atmosphere requires gas viscosity to be included in the stability equations even for low ${\it We}_g$, where ${\it We}_g{=}\rho_gU_l^2R_0/\sigma$, and $\rho_g, U_l, R_0$ and $\sigma$ are the gas density, the liquid injection velocity, the jet radius and the surface tension coefficient, respectively. The numerical results of the complete set of equations, in which the effect of viscosity in the gas perturbations is treated self-consistently for the first time, are in accordance with recently reported experimental growth rates. This permits us to conclude that the simple stability analysis presented here can be used to predict experimental results. Moreover, in order to throw light on the physical role played by the gas viscosity in the liquid-jet break-up process, we have considered the limiting case of very high Reynolds numbers and performed an asymptotic analysis which provides us with a parameter, $\alpha$, that measures the relative importance of viscous effects in the gas perturbations. The criterion $|\alpha|{\ll} 1$, with $\alpha$ computed a priori using only the much simpler inviscid stability results is a guide to assess the accuracy of a stability analysis in which viscous diffusion is neglected. We have also been able to explain the origin of the ad hoc constant 0.175 introduced by Sterling & Sleicher (J. Fluid Mech. vol. 68, 1975, p. 477) to correct the discrepancies between Weber's results (Z. Angew. Math. Mech. vol. 11, 1931, p. 136) and the experimental ones.- 11 October 2005
- Published by Cambridge University Press (CUP) in Journal of Fluid Mechanics
- Vol. 541, 1-20
Aerodynamic effects in the break-up of liquid jets: on the first wind-induced break-up regime
We present both numerical and analytical results from a spatial stability analysis of the coupled gas–liquid hydrodynamic equations governing the first wind-induced (FWI) liquid-jet break-up regime. Our study shows that an accurate evaluation of the growth rate of instabilities developing in a liquid jet discharging into a still gaseous atmosphere requires gas viscosity to be included in the stability equations even for low ${\it We}_g$, where ${\it We}_g{=}\rho_gU_l^2R_0/\sigma$, and $\rho_g, U_l, R_0$ and $\sigma$ are the gas density, the liquid injection velocity, the jet radius and the surface tension coefficient, respectively. The numerical results of the complete set of equations, in which the effect of viscosity in the gas perturbations is treated self-consistently for the first time, are in accordance with recently reported experimental growth rates. This permits us to conclude that the simple stability analysis presented here can be used to predict experimental results. Moreover, in order to throw light on the physical role played by the gas viscosity in the liquid-jet break-up process, we have considered the limiting case of very high Reynolds numbers and performed an asymptotic analysis which provides us with a parameter, $\alpha$, that measures the relative importance of viscous effects in the gas perturbations. The criterion $|\alpha|{\ll} 1$, with $\alpha$ computed a priori using only the much simpler inviscid stability results is a guide to assess the accuracy of a stability analysis in which viscous diffusion is neglected. We have also been able to explain the origin of the ad hoc constant 0.175 introduced by Sterling & Sleicher (J. Fluid Mech. vol. 68, 1975, p. 477) to correct the discrepancies between Weber's results (Z. Angew. Math. Mech. vol. 11, 1931, p. 136) and the experimental ones.- Open Access
- 12 May 2004
- Published by AIP Publishing in Physics of Fluids
- Vol. 16 (7) , 2147-2153
Nonparallel local spatial stability analysis of pipe entrance swirling flows
A spatial local viscous stability analysis of a swirling flow developing in a cylindrical pipe has been carried out numerically. Even at moderately low swirl strengths, we have found the existence of centrifugal modes in addition to the shear ones found in previous stability analysis of nonswirling flows developing in pipes. It is found that these centrifugal instabilities develop at Reynolds numbers that are much lower than those required for the growing of the shear instability. Moreover, the extent of the region where centrifugal instabilities appear is much larger than that where the shear layer instability grows. We have found from the analysis that the most unstable mode was the counter-rotating one (n=−1). The critical Reynolds number for which linear analysis predicts the growth of the convective instabilities is for the centrifugal modes one hundred times smaller than for the shear layer ones.
- 12 May 2004
- Published by AIP Publishing in Physics of Fluids
- Vol. 16 (7) , 2147-2153
Open AccessNonparallel local spatial stability analysis of pipe entrance swirling flows
A spatial local viscous stability analysis of a swirling flow developing in a cylindrical pipe has been carried out numerically. Even at moderately low swirl strengths, we have found the existence of centrifugal modes in addition to the shear ones found in previous stability analysis of nonswirling flows developing in pipes. It is found that these centrifugal instabilities develop at Reynolds numbers that are much lower than those required for the growing of the shear instability. Moreover, the extent of the region where centrifugal instabilities appear is much larger than that where the shear layer instability grows. We have found from the analysis that the most unstable mode was the counter-rotating one (n=−1). The critical Reynolds number for which linear analysis predicts the growth of the convective instabilities is for the centrifugal modes one hundred times smaller than for the shear layer ones.
- 1 May 2004
- Published by Springer Nature in The European Physical Journal B
- Vol. 39 (1) , 131-137
Steady high viscosity liquid micro-jet production and fiber spinning using co-flowing gas conformation
- 1 May 2004
- Published by Springer Nature in The European Physical Journal B
- Vol. 39 (1) , 131-137
Steady high viscosity liquid micro-jet production and fiber spinning using co-flowing gas conformation