Laura Landwehr

The use of gas diffusion electrodes (GDEs) in microbial fuel cells (MFCs) can improve their cell performance, but tends to cause fouling. In order to allow long-term stable operation, the search for antifouling methods is necessary. Therefore, an antibacterial coating with ammonium compounds is investigated. Within the first 30 days of operation, the maximum measured power density of a GDE with antibacterial ionomer was 606 mW m⁻². The GDE without an antifouling treatment could only reach a maximum of 284 mW m⁻². Furthermore, there was an optimum in the loading amount with ionomer below 2.6 mg cm⁻². Further investigations showed that additional aeration of the GDEs by a fan had a negative effect on their performance. Despite the higher performance, the antibacterial coating could not prevent biofilm growth at the surface of the GDE. The thickness of the biofilm was only reduced by 14–16%. However, the weight of the biofilm on the treated GDEs was 62–80% less than on a GDE without an antifouling treatment. Consequently, the coating cannot completely prevent fouling, but possibly leads to a lower density of the biofilm or prevents clogging of the pores inside the electrodes and improves their long-term stability.

Microbial fuel cells are a promising technology for future wastewater treatment, as it allows cleaning and power generation simultaneously. The bottleneck of microbial fuel cells is often its cathodes because they determine the power output. Gas diffusion electrodes might overcome this bottleneck due to their low production costs and high oxygen reduction rates. However, biofilm formation on the gas diffusion electrodes reduces their performance over time. In this work, a new reactor design of the microbial fuel cell using rotating gas diffusion electrodes is presented. The biofilm growth on the electrode during operation was observed and its effect on the performance of the microbial fuel cell was examined. In addition, different antifouling strategies were investigated over a period of 80 days. It was found that already after 7 days of operation a complete biofilm had grown on an untreated gas diffusion electrode. However, this does not seem to affect the performance of the cells in the beginning. Differences in the performance of the reactors with and without an antifouling strategy only become apparent from day 15 onwards. The use of UV radiation and antibacterial membranes leads to the best results with maximum power densities of approx. 200 mW m⁻² while the untreated microbial fuel cell only achieves a maximum power density of approx. 20 mW m⁻².