Radosław Radoń

Conventional hydropower potential assessment (HPA) does not explicitly account for operational requirements and constraints affecting hydropower availability in multifunctional river systems (MRSs). This study introduces Operational Hydropower Potential Assessment (OHPA), a hierarchical framework integrating hydrological conditions, operational requirements, and constraints into conventional HPA. The framework distinguishes hydrological assessment from operational assessment and combines their outcomes to determine reference and operational hydropower potential (OHP). The methodology was applied to five operational reaches of the upper canalised Vistula River in Poland using hydrological observations, technical hydropower parameters, and documented operational information. Daily water discharge exhibited strong spatial coherence, with Spearman correlations of 0.815–0.972 and the first principal component explaining 92.38% of total variance. Annual hydro-technical reference energy ranged from 66.90 to 79.01 GWh. For the Smolice–Łączany reach, the OHPA index decreased from 0.752 to 0.390 under a very-low-flow scenario, demonstrating the sensitivity of hydropower availability to hydrological extremes. Documented high-water closures occurred near the 99th percentile of long-term discharge, highlighting additional operational limitations. OHPA provides a transferable framework for quantifying hydropower availability under variable hydrological conditions, operational constraints, and competing water uses in multifunctional river systems.

Wildfires significantly affect wood properties and usability, yet their impact on hardwood species remains insufficiently understood. This study presents an exploratory characterization of moderately fire-affected pedunculate oak (Quercus robur L.) wood, combining physical, mechanical, chemical, and thermal analyses to evaluate depth-related changes within outer stem zones. Samples were collected from bark and from wood originating approximately 1 cm and 1–2 cm beneath the cambial region to evaluate radial variation associated with moderate surface fire exposure. The oven-dry density of fire-affected wood reached 720 kg·m⁻³, corresponding to values marginally below the literature reference ranges reported for unaffected oak wood. Bending strength decreased to 85.56 MPa, while compressive strength remained within or marginally above the literature reference (71.16 MPa), and Brinell hardness (42.75 MPa) stayed within the typical range for oak. Chemical and elemental analyses revealed degradation of polysaccharides and carbon enrichment in surface layers. FTIR and DSC analyses suggested partial hemicellulose degradation, structural modification of cellulose, and reduced thermal reactivity in outer stem regions. Despite these changes, the higher heating value (19.09–19.56 MJ·kg⁻¹) remained within the literature reference ranges reported for oak wood. The results suggest that under moderate surface fire conditions, fire-induced changes were primarily concentrated in outer stem layers, while inner wood retained properties comparable to the literature reference values for unaffected oak wood. These findings indicate that moderately fire-affected oak wood may remain suitable for selected material or energy-related applications following appropriate quality assessment and removal of thermally altered surface zones.

The aim of the study was to assess the hardness and compressive strength of oak wood from various historical contexts, and to compare these properties with modern oak wood. The study utilized both radiocarbon and dendrochronological dating to determine the age of the wood. A total of five oak wood fragments analyzed i.e. bog oak, oak wood from the bell tower of the Collegiate Basilica of the Holy Spirit in Przeworsk; oak wood from the scaffolding of the St. Nicholas Church in Gniew, wood from a dismantled granary in Drawsko Pomorskie and sample from a water dam in Czaniec. The dating confirmed that the oak fragments varied in age, ranging from several centuries to over 900 years. The mechanical tests using the Brinell method and compressive strength tests indicated that wood of bog oak displayed statistically significant differences in compressive strength compared to the other wood samples, which could be attributed to the long-term mineral saturation of the wood from prolonged exposure to anaerobic conditions in the bog. This mineralization likely caused a reduction in its elasticity and overall strength. In contrast, other samples, which had been exposed to varying environmental conditions like periodic water immersion or protection from moisture, did not show significant differences in mechanical tests. Despite these challenges, the findings suggest that compressive strength could serve as a useful indicator for estimating the age of oak wood in archaeological contexts, particularly for assessing the influence of long-term environmental conditions on wood properties.

Multifunctional flood protection reservoirs of regional importance have been controversial for many years due to their significant environmental impact. The impact is especially observed at the implementation stage. Undeniably, properly managed large water reservoirs are the most effective element of active flood protection and significantly reduce the flood wave, thus limiting losses in housing, infrastructure, industry, or agriculture. At the same time, multifunctional reservoirs pursue other goals that are related to reducing shortages and counteracting the effects of drought, water supply, hydropower, or recreation. In the era of rapidly advancing climate and geopolitical changes, their role seems indispensable when it comes to responsible and coordinated water management in Poland. An open question is how to fully use the potential and to what extent it is possible for the system of reservoirs located on different watercourses to work together in the era of the progressive development of the country resulting in significant changes in land use (sealing large catchment areas) in relation to design assumptions. The article presents an analysis of the work of selected water reservoirs located in the basin of the upper Vistula during the floods that took place in the last decade. On the basis of the obtained conclusions, the authors present recommendations on how to effectively manage the network of reservoirs during a flood while minimizing losses of the water retained in them, which should be used to meet other goals of water management.