Yuri V. Rodin
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Yuri V. Rodin has a total of 28 co-authors. Here are the top co-authors by number of shared publications:
- Alexey V. Palitsin
A. V. Gaponov-Grekhov Institute of Applied Physics of the Russian Academy of Sciences (IAP RAS), Nizhny Novgorod, Russia
4 shared publications - Alexander N. Panin
Institute for Physics of Microstructures, Russian Academy of Sciences, Nizhny Novgorod, Russia
3 shared publications - Mikhail Goykhman
Enrico Fermi Institute University of Chicago 5620 S. Ellis Av. 60637 Chicago IL USA
3 shared publications - Naum S. Ginzburg
A.V. Gaponov-Grekhov Institute of Applied Physics, Russian Academy of Sciences
3 shared publications - Vladislav Yur'EVich Zaslavsky
Institute of Applied Physics, Russian Academy of Sciences, 603950 Nizhny Novgorod, Russia
3 shared publications - Alexander V. Gromov
Institute of Applied Physics of Russian Academy of Sciences 1 , 46 Ulyanov Str., Nizhny Novgorod 603950, Russia
2 shared publications
Latest Publications
- 11 March 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Electron Device Letters
- Vol. 46 (5) , 848-851
High-Power G-Band Relativistic Surface-Wave Oscillator With 2D-Periodic Slow-Wave Structure of Planar Geometry
Comparative theoretical and experimental studies of G-band surface-wave oscillators (SWOs) with one-dimensional (1D) and two-dimensional (2D) planar slow-wave structures (SWSs) has been carried out. These oscillators have been driven by a sheet electron beam with a cross-section of 0.3 mm × 20 mm formed by the SINUKI accelerator 650 keV / 1 kA / 17 ns. At the oversize factor of ~ 15 (the ratio of the transverse size to the radiation wavelength), in the case of 1D SWS, a multistable generation with excitation of various transverse modes was observed, characterized by a jitter of the radiation frequency. In contrast, 2D SWS ensures a single-mode generation regime stable to variations of beam parameters. In accordance with the simulations, narrowband generation with excitation of the fundamental mode of 2D SWS was observed in the experiment at an operating frequency of 160 GHz with an output power of 30 MW and an electron efficiency of 5%.
- 11 March 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Electron Device Letters
- Vol. 46 (5) , 848-851
High-Power G-Band Relativistic Surface-Wave Oscillator With 2D-Periodic Slow-Wave Structure of Planar Geometry
Comparative theoretical and experimental studies of G-band surface-wave oscillators (SWOs) with one-dimensional (1D) and two-dimensional (2D) planar slow-wave structures (SWSs) has been carried out. These oscillators have been driven by a sheet electron beam with a cross-section of 0.3 mm × 20 mm formed by the SINUKI accelerator 650 keV / 1 kA / 17 ns. At the oversize factor of ~ 15 (the ratio of the transverse size to the radiation wavelength), in the case of 1D SWS, a multistable generation with excitation of various transverse modes was observed, characterized by a jitter of the radiation frequency. In contrast, 2D SWS ensures a single-mode generation regime stable to variations of beam parameters. In accordance with the simulations, narrowband generation with excitation of the fundamental mode of 2D SWS was observed in the experiment at an operating frequency of 160 GHz with an output power of 30 MW and an electron efficiency of 5%.
- Open Access
- 1 April 2023
- Published by AIP Publishing in Physics of Plasmas
- Vol. 30 (4)
Theoretical and experimental studies of W-band relativistic surface-wave oscillator of planar geometry
This paper presents the results of theoretical and experimental studies of a surface-wave oscillator (SWO) of planar geometry excited by a ribbon high-current relativistic electron beam. Within the framework of the quasi-optical approach and direct three-dimensional particle-in-cell modeling, we demonstrate the advantages of open transverse edged configuration against the closed one for effective mode selection at a fairly large oversize factor. In the experiments carried out on the basis of the SINUKI accelerator (Institute of Applied Physics of the Russian Academy of Sciences, Nizhny Novgorod, 1 kA/650 keV/17 ns), we form a magnetically guided ribbon electron beam with a cross-section of 0.3 × 20 mm2, which moves parallel to a slow-wave structure with a period of 1.75 mm. A planar W-band SWO both of open and closed edged configuration has been experimentally tested. In full agreement with modeling, the open configuration exhibits much more stable operation, where at a frequency of 75 GHz, we observe pulse generation with duration of about 7 ns. The output power measured by the calorimetric method reaches 25 MW.
- 1 April 2023
- Published by AIP Publishing in Physics of Plasmas
- Vol. 30 (4)
Open AccessTheoretical and experimental studies of W-band relativistic surface-wave oscillator of planar geometry
This paper presents the results of theoretical and experimental studies of a surface-wave oscillator (SWO) of planar geometry excited by a ribbon high-current relativistic electron beam. Within the framework of the quasi-optical approach and direct three-dimensional particle-in-cell modeling, we demonstrate the advantages of open transverse edged configuration against the closed one for effective mode selection at a fairly large oversize factor. In the experiments carried out on the basis of the SINUKI accelerator (Institute of Applied Physics of the Russian Academy of Sciences, Nizhny Novgorod, 1 kA/650 keV/17 ns), we form a magnetically guided ribbon electron beam with a cross-section of 0.3 × 20 mm2, which moves parallel to a slow-wave structure with a period of 1.75 mm. A planar W-band SWO both of open and closed edged configuration has been experimentally tested. In full agreement with modeling, the open configuration exhibits much more stable operation, where at a frequency of 75 GHz, we observe pulse generation with duration of about 7 ns. The output power measured by the calorimetric method reaches 25 MW.
- 9 December 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Electron Device Letters
- Vol. 44 (2) , 317-320
75 GHz Relativistic Surface-Wave Oscillator of Planar Geometry
We present the results of simulations and experimental studies of a W-band surface-wave oscillator powered by a ribbon high-current relativistic electron beam produced by SINUKI accelerator (IAP RAS, Nizhny Novgorod, 1 kA / 650 keV / 17 ns). Planar geometry of the interaction space facilitates efficient mode selection over wide transverse coordinate by using open waveguide at fairly large oversize factor (the width of the waveguide is ~ 8 wavelengths). Stable oscillation regime is obtained at frequency of 75 GHz with a pulse duration of about 5 ns. The output power measured by the calorimetric method reaches 25 MW.
- 9 December 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Electron Device Letters
- Vol. 44 (2) , 317-320
75 GHz Relativistic Surface-Wave Oscillator of Planar Geometry
We present the results of simulations and experimental studies of a W-band surface-wave oscillator powered by a ribbon high-current relativistic electron beam produced by SINUKI accelerator (IAP RAS, Nizhny Novgorod, 1 kA / 650 keV / 17 ns). Planar geometry of the interaction space facilitates efficient mode selection over wide transverse coordinate by using open waveguide at fairly large oversize factor (the width of the waveguide is ~ 8 wavelengths). Stable oscillation regime is obtained at frequency of 75 GHz with a pulse duration of about 5 ns. The output power measured by the calorimetric method reaches 25 MW.
- 1 September 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-2
Tunable Notch Filter for Measurements of Rogue Waves in Gyrotrons
- 1 September 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-2
Tunable Notch Filter for Measurements of Rogue Waves in Gyrotrons
- 1 April 2011
- Published by Pleiades Publishing Ltd in Technical Physics Letters
- Vol. 37 (4) , 368-370
Optically controlled semiconductor microwave modulator with nanosecond response
A microwave modulator optically controlled by laser pulses has been theoretically studied, constructed, and tested. Results of numerical simulations performed by the finite-difference method are presented, design parameters are reported, and coincidence between the calculated and experimentally measured characteristics is demonstrated. The switching time of the modulator is about 1 ns, the characteristic energy of control laser pulses sufficient for the optimum switching is 10 mJ, and the range of mechanical tuning of the microwave frequency is about 10% (66–72 GHz). It is experimentally demonstrated that the modulator reliably operates when the control laser radiation parameters vary within broad limits.
- 1 April 2011
- Published by Pleiades Publishing Ltd in Technical Physics Letters
- Vol. 37 (4) , 368-370
Optically controlled semiconductor microwave modulator with nanosecond response
A microwave modulator optically controlled by laser pulses has been theoretically studied, constructed, and tested. Results of numerical simulations performed by the finite-difference method are presented, design parameters are reported, and coincidence between the calculated and experimentally measured characteristics is demonstrated. The switching time of the modulator is about 1 ns, the characteristic energy of control laser pulses sufficient for the optimum switching is 10 mJ, and the range of mechanical tuning of the microwave frequency is about 10% (66–72 GHz). It is experimentally demonstrated that the modulator reliably operates when the control laser radiation parameters vary within broad limits.