Chanadda Phawachalotorn
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Chanadda Phawachalotorn has a total of 26 co-authors. Here are the top co-authors by number of shared publications:
- Aree Choodum
Integrated Science and Technology Research Center, Faculty of Technology and Environment, Prince of Songkla University, Phuket Campus, Kathu, Phuket, 83120, Thailand
6 shared publications Worawit Wongniramaikul
6 shared publicationsTarawee Taweekarn
Integrated Science and Technology Research Center, Faculty of Technology and Environment, Prince of Songkla University, Phuket Campus, Kathu, Phuket, 83120, Thailand
3 shared publications- Wadcharawadee Limsakul
Integrated Science and Technology Research Center, Faculty of Technology and Environment, Prince of Songkla University, Phuket Campus, Kathu, Phuket 83120, Thailand
3 shared publications Wilasinee Sriprom
Integrated Science and Technology Research Center, Faculty of Technology and Environment, Prince of Songkla University, Phuket Campus, Kathu, Phuket, 83120, Thailand
3 shared publicationsAree Choodum
2 shared publications
Latest Publications
- Open Access
- 6 September 2026
- Published by Elsevier in Environmental Technology & Innovation
- Vol. 44
Resource-efficient conversion of durian shell waste into a magnetically recoverable adsorbent for methylene blue removal: Multi-response optimization, mechanistic insights, and practical wastewater treatment
- 6 September 2026
- Published by Elsevier in Environmental Technology & Innovation
- Vol. 44
Open AccessResource-efficient conversion of durian shell waste into a magnetically recoverable adsorbent for methylene blue removal: Multi-response optimization, mechanistic insights, and practical wastewater treatment
- Open Access
- 23 December 2025
- Published by Elsevier in Water Research X
- Vol. 30
Calcium silicate hydrate–embedded porous concrete for efficient phosphate removal and recovery in concentrated eluates
- 23 December 2025
- Published by Elsevier in Water Research X
- Vol. 30
Open AccessCalcium silicate hydrate–embedded porous concrete for efficient phosphate removal and recovery in concentrated eluates
- Open Access
Continuous Phosphate Removal and Recovery Using a Calcium Silicate Hydrate Composite Monolithic Cryogel Column
Toward the development of a practical and green approach for removing phosphate from water, a monolithic cryogel based on starch and calcium silicate hydrate (Cry–CSH) was employed as a phosphate adsorbent in a continuous flow system for the first time. The influence of flow rate, initial phosphate concentration, and adsorbent height on the adsorption efficiency was investigated. As the rate of flow and the initial concentration of phosphate increased, the total quantity of adsorbed phosphate dropped; however, the performance of the column was greatly enhanced by an increase in adsorbent height. The experimental data fit the Adams–Bohart model better than the Thomas and Yoon–Nelson models at the beginning of the adsorption process. To evaluate its applicability, the continuous flow system based on the monolithic Cry–CSH column was applied for the removal of phosphate from the discharge effluent of the Patong Municipality Wastewater Treatment Plant (Phuket, Thailand), achieving an excellent total adsorption of 94.61%.
Open AccessContinuous Phosphate Removal and Recovery Using a Calcium Silicate Hydrate Composite Monolithic Cryogel Column
Toward the development of a practical and green approach for removing phosphate from water, a monolithic cryogel based on starch and calcium silicate hydrate (Cry–CSH) was employed as a phosphate adsorbent in a continuous flow system for the first time. The influence of flow rate, initial phosphate concentration, and adsorbent height on the adsorption efficiency was investigated. As the rate of flow and the initial concentration of phosphate increased, the total quantity of adsorbed phosphate dropped; however, the performance of the column was greatly enhanced by an increase in adsorbent height. The experimental data fit the Adams–Bohart model better than the Thomas and Yoon–Nelson models at the beginning of the adsorption process. To evaluate its applicability, the continuous flow system based on the monolithic Cry–CSH column was applied for the removal of phosphate from the discharge effluent of the Patong Municipality Wastewater Treatment Plant (Phuket, Thailand), achieving an excellent total adsorption of 94.61%.
- Open Access
Starch Biocryogel for Removal of Methylene Blue by Batch Adsorption
A green monolithic starch cryogel was prepared and applied for the removal of methylene blue (MB) using a batch system. The influence of various experimental parameters on MB adsorption was investigated. High removal efficiency (81.58 ± 0.59%) and adsorption capacity (34.84 mg g−1) were achieved. The Langmuir model better fitted the experimental data (determination coefficient (R2) = 0.9838) than the Freundlich one (R2 = 0.8542), while the kinetics of MB adsorption on the cryogel followed a pseudo-second-order model. The adsorption process was spontaneous and endothermic with an activation energy of 37.8 kJ mol−1 that indicated physical adsorption. The starch cryogel was used for MB removal from a wastewater sample collected from a local Batik production community enterprise in Phuket, Thailand, and a removal efficiency of 75.6% was achieved, indicating that it has a high potential as a green adsorbent for MB removal.
Open AccessStarch Biocryogel for Removal of Methylene Blue by Batch Adsorption
A green monolithic starch cryogel was prepared and applied for the removal of methylene blue (MB) using a batch system. The influence of various experimental parameters on MB adsorption was investigated. High removal efficiency (81.58 ± 0.59%) and adsorption capacity (34.84 mg g−1) were achieved. The Langmuir model better fitted the experimental data (determination coefficient (R2) = 0.9838) than the Freundlich one (R2 = 0.8542), while the kinetics of MB adsorption on the cryogel followed a pseudo-second-order model. The adsorption process was spontaneous and endothermic with an activation energy of 37.8 kJ mol−1 that indicated physical adsorption. The starch cryogel was used for MB removal from a wastewater sample collected from a local Batik production community enterprise in Phuket, Thailand, and a removal efficiency of 75.6% was achieved, indicating that it has a high potential as a green adsorbent for MB removal.
- Open Access
- 1 January 2021
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 1719 (1) , 012061
The efficiency of mangosteen peel for dye removal
Mangosteen peel, an agricultural waste to be used as an adsorbent, was prepared by a simple and eco-friendly method. The dried mangosteen peel (DMP) was initially studied its surface charge by using the pH drift method. The adsorption experiments were performed using the batch technique to explore the efficiency of methylene blue (MB) removal. Fourier Transform Infrared (FTIR) spectroscopy and Field Emission Scanning Electron Microscopy (FE-SEM) were used to characterise the DMP before and after the adsorption process. The results revealed that MB could be adsorbed onto the DMP surface via the electrostatic interaction between the cationic dyes and surface functional groups of the DMP. To explore the MB adsorption efficiency of DMP adsorbent, the factors of the initial pH of MB solution, particle sizes of the DMP, DMP dosage, and contact time were investigated by using Ultraviolet-Visible (UV-Vis) spectrophotometer. It was found that the percentage of MB removal was 99.7% by using 5 g/L of DMP at particle sizes of lower than 75 μm within ten minutes under the initial pH condition of MB solution. Moreover, the experimental equilibrium adsorption data were fitted to the Freundlich isotherm model with R 2 = 0.9869.
- 1 January 2021
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 1719 (1) , 012061
Open AccessThe efficiency of mangosteen peel for dye removal
Mangosteen peel, an agricultural waste to be used as an adsorbent, was prepared by a simple and eco-friendly method. The dried mangosteen peel (DMP) was initially studied its surface charge by using the pH drift method. The adsorption experiments were performed using the batch technique to explore the efficiency of methylene blue (MB) removal. Fourier Transform Infrared (FTIR) spectroscopy and Field Emission Scanning Electron Microscopy (FE-SEM) were used to characterise the DMP before and after the adsorption process. The results revealed that MB could be adsorbed onto the DMP surface via the electrostatic interaction between the cationic dyes and surface functional groups of the DMP. To explore the MB adsorption efficiency of DMP adsorbent, the factors of the initial pH of MB solution, particle sizes of the DMP, DMP dosage, and contact time were investigated by using Ultraviolet-Visible (UV-Vis) spectrophotometer. It was found that the percentage of MB removal was 99.7% by using 5 g/L of DMP at particle sizes of lower than 75 μm within ten minutes under the initial pH condition of MB solution. Moreover, the experimental equilibrium adsorption data were fitted to the Freundlich isotherm model with R 2 = 0.9869.
- 6 November 2020
- Published by Springer Nature in Microchimica Acta
- Vol. 187 (12) , 1-13
A novel colorimetric sensor based on modified mesoporous silica nanoparticles for rapid on-site detection of nitrite
A novel colorimetric sheet based on Griess reagent–doped mesoporous silica nanoparticles was developed for nitrite detection. Griess reagent was adsorbed on long–range ordered hexagonal mesoporous silica nanoparticles and developed ink–bottle pores with some disorder. When the modified nanoparticles were bound using starch to fabricate a thin (~ 313 μm) colorimetric sheet, spherical particles with a rougher surface and some distortion of their mesoporosity were observed. The sheet was used in conjunction with digital image colorimetry (DIC) and provides a wide linear range of 0.05 to 2.50 mg L−1 with a low detection limit (15.0 μg L−1–NO2−, equal to 4.5 μg L−1 NO2−–N), good inter-day precision (1.93%RSD), and excellent precision (2.67% relative error). The colorimetric sensors produced from the sheet costs only 0.04 USD each, while the DIC uses a standard smartphone for photographic detection. The method developed offers an easier and cheaper means of conducting rapid on-site determination of nitrite in water with reliable quantitative results. Graphical abstract
- 6 November 2020
- Published by Springer Nature in Microchimica Acta
- Vol. 187 (12) , 1-13
A novel colorimetric sensor based on modified mesoporous silica nanoparticles for rapid on-site detection of nitrite
A novel colorimetric sheet based on Griess reagent–doped mesoporous silica nanoparticles was developed for nitrite detection. Griess reagent was adsorbed on long–range ordered hexagonal mesoporous silica nanoparticles and developed ink–bottle pores with some disorder. When the modified nanoparticles were bound using starch to fabricate a thin (~ 313 μm) colorimetric sheet, spherical particles with a rougher surface and some distortion of their mesoporosity were observed. The sheet was used in conjunction with digital image colorimetry (DIC) and provides a wide linear range of 0.05 to 2.50 mg L−1 with a low detection limit (15.0 μg L−1–NO2−, equal to 4.5 μg L−1 NO2−–N), good inter-day precision (1.93%RSD), and excellent precision (2.67% relative error). The colorimetric sensors produced from the sheet costs only 0.04 USD each, while the DIC uses a standard smartphone for photographic detection. The method developed offers an easier and cheaper means of conducting rapid on-site determination of nitrite in water with reliable quantitative results. Graphical abstract
- Open Access
- 10 October 2020
- Published by Springer Nature in Analytical Sciences
- Vol. 36 (10) , 1261-1267
Tetramethylammonium Hydroxide-doped Starch Film as a Colorimetric Sensor for Trinitrotoluene Detection
Japan's largest platform for academic e-journals: J-STAGE is a full text database for reviewed academic papers published by Japanese societies
- 10 October 2020
- Published by Springer Nature in Analytical Sciences
- Vol. 36 (10) , 1261-1267
Open AccessTetramethylammonium Hydroxide-doped Starch Film as a Colorimetric Sensor for Trinitrotoluene Detection
Japan's largest platform for academic e-journals: J-STAGE is a full text database for reviewed academic papers published by Japanese societies
- 1 January 2012
- Published by Elsevier in Sensors and Actuators B: Chemical
- Vol. 161 (1) , 635-640
Highly selective amperometric sensors for carbon monoxide detection in exhaust gas
- 1 January 2012
- Published by Elsevier in Sensors and Actuators B: Chemical
- Vol. 161 (1) , 635-640
Highly selective amperometric sensors for carbon monoxide detection in exhaust gas