Hassan Zarabadipour
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Hassan Zarabadipour has a total of 7 co-authors. Here are the top co-authors by number of shared publications:
- Abbas Kariminia
Department of Electrical Engineering, Imam Khomeini International University, Qazvin, Iran
1 shared publication - Hamid Emadi
Department of Applied Chemistry, Faculty of Chemistry, University of Mazandaran, Babolsar, Iran
1 shared publication - Hossein Sadegh Lafmejani
University of Parma,Department of Engineering and Architecture,Parma,Italy
1 shared publication - Mahdi Aliyari Shoorehdeli
K. N. Toosi University of Technology
1 shared publication Mahdieh Adeli
Department of Engineering, Imam Khomeini International University, Norouzian street, Qazvin, Iran
1 shared publicationMasoud Salehi Borujeni
Eelectrical and Electronic Department Semnan University Semnan, Iran
1 shared publication
Latest Publications
- 13 December 2022
- Published by Springer Nature in International Journal of Dynamics and Control
- Vol. 11 (4) , 1736-1750
A projection recurrent neural network based sliding mode control to stabilize unknown fractional-order chaotic systems
- 13 December 2022
- Published by Springer Nature in International Journal of Dynamics and Control
- Vol. 11 (4) , 1736-1750
A projection recurrent neural network based sliding mode control to stabilize unknown fractional-order chaotic systems
- 1 February 2014
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 51, 1-5
Fuel cell voltage control using neural network based on model predictive control
In this paper, a neural network based model predictive control (NNMPC) algorithm was implemented to control the voltage of a proton exchange membrane fuel cell (PEMFC). In this approach, a neural network model is trained to predict the future process response over the specified horizon. The predictions are passed to a numerical optimization routine which attempts to minimize a specified cost function to calculate a suitable control signal at each sample instant. The performance results of the NNMPC were compared with a fuzzy controller.
- 1 February 2014
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 51, 1-5
Fuel cell voltage control using neural network based on model predictive control
In this paper, a neural network based model predictive control (NNMPC) algorithm was implemented to control the voltage of a proton exchange membrane fuel cell (PEMFC). In this approach, a neural network model is trained to predict the future process response over the specified horizon. The predictions are passed to a numerical optimization routine which attempts to minimize a specified cost function to calculate a suitable control signal at each sample instant. The performance results of the NNMPC were compared with a fuzzy controller.
- Open Access
- 29 September 2013
- Published by Institute of Advanced Engineering and Science in Indonesian Journal of Electrical Engineering and Informatics (IJEEI)
- Vol. 1 (4) , 127-132
Fuzzy Control of Yaw and Roll Angles of a Simulated Helicopter Model Includes Articulated Manipulators
Fuzzy logic controller (FLC) is a heuristic method by If-Then Rules which resembles human intelligence and it is a good method for designing Non-linear control systems. In this paper, an arbitrary helicopter model includes articulated manipulators has been simulated with Matlab SimMechanics toolbox and then we designed a fuzzy controller for its yaw and roll angles when the manipulators are moving for a task. Results reveal that a simple FLC can control this complex system well.
- 29 September 2013
- Published by Institute of Advanced Engineering and Science in Indonesian Journal of Electrical Engineering and Informatics (IJEEI)
- Vol. 1 (4) , 127-132
Open AccessFuzzy Control of Yaw and Roll Angles of a Simulated Helicopter Model Includes Articulated Manipulators
Fuzzy logic controller (FLC) is a heuristic method by If-Then Rules which resembles human intelligence and it is a good method for designing Non-linear control systems. In this paper, an arbitrary helicopter model includes articulated manipulators has been simulated with Matlab SimMechanics toolbox and then we designed a fuzzy controller for its yaw and roll angles when the manipulators are moving for a task. Results reveal that a simple FLC can control this complex system well.
- 1 November 2011
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 62-67
Design of a parallel distributed fuzzy LQR controller for double-pendulum-type overhead cranes
One of the common industrial structures that are used widely in many harbors and factories and buildings is overhead crane. Overhead cranes are usually operated manually or by some conventional control methods. In this paper, we propose a hybrid controller includes both position regulation and anti-swing control. According to Takagi-Sugeno fuzzy model of an overhead crane, a fuzzy controller designed with parallel distributed compensation and Linear Quadratic Regulation. With the Takagi-Sugeno fuzzy modeling, the nonlinear system is approximated by the combination of several linear subsystems in the corresponding fuzzy state space region. Then by constructing a linear quadratic regulation subcontroller according to each linear subsystem, a parallel distributed fuzzy LQR controller is designed. Further, the stability of the overhead crane with the parallel distributed fuzzy LQR controller is discussed. Simulation results illustrated the validity of the proposed control algorithm and it is compared with a similar method parallel distributed fuzzy controller.
- 1 November 2011
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 62-67
Design of a parallel distributed fuzzy LQR controller for double-pendulum-type overhead cranes
One of the common industrial structures that are used widely in many harbors and factories and buildings is overhead crane. Overhead cranes are usually operated manually or by some conventional control methods. In this paper, we propose a hybrid controller includes both position regulation and anti-swing control. According to Takagi-Sugeno fuzzy model of an overhead crane, a fuzzy controller designed with parallel distributed compensation and Linear Quadratic Regulation. With the Takagi-Sugeno fuzzy modeling, the nonlinear system is approximated by the combination of several linear subsystems in the corresponding fuzzy state space region. Then by constructing a linear quadratic regulation subcontroller according to each linear subsystem, a parallel distributed fuzzy LQR controller is designed. Further, the stability of the overhead crane with the parallel distributed fuzzy LQR controller is discussed. Simulation results illustrated the validity of the proposed control algorithm and it is compared with a similar method parallel distributed fuzzy controller.
- 1 October 2011
- Published by Institute for Project Management Pvt. Ltd in International Journal of Applied Research in Mechanical Engineering
- p. 84-86
Reduced optimal controller design for the nuclear reactor power control system
The power control system of a nuclear reactor is one of the key systems that concern the safe operation of the plant. Much attention is paid to the power control systems’ performance of nuclear reactor in engineering. The goal of this paper is apply balance model reductionto derive reduced order model and then design the reduced optimal controller for nuclear reactor power system.The simulation results with reduced-order model and with optimized controller show that the proposed technique is improved .
- 1 October 2011
- Published by Institute for Project Management Pvt. Ltd in International Journal of Applied Research in Mechanical Engineering
- p. 84-86
Reduced optimal controller design for the nuclear reactor power control system
The power control system of a nuclear reactor is one of the key systems that concern the safe operation of the plant. Much attention is paid to the power control systems’ performance of nuclear reactor in engineering. The goal of this paper is apply balance model reductionto derive reduced order model and then design the reduced optimal controller for nuclear reactor power system.The simulation results with reduced-order model and with optimized controller show that the proposed technique is improved .