Felix Endriss
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Felix Endriss has a total of 20 co-authors. Here are the top co-authors by number of shared publications:
- Harald Thorwarth
University of Applied Forest Sciences Rottenburg , Schadenweilerhof
6 shared publications Harald Thorwarth
University of Applied Forest Sciences Rottenburg Schadenweilerhof 72108 Rottenburg am Neckar Germany
3 shared publications- Andreas Kappler
Geomicrobiology, Department of Geosciences, University of Tübingen
2 shared publications Daniel Kuptz
Technology and Support Center in the Center of Excellence for Renewable Resources, Schulgasse 18, Straubing 94315, Germany
2 shared publicationsDirk Wissmann
SPECTRO Analytical Instruments GmbH, Boschstraße 10, Kleve 47533, Germany
2 shared publicationsElke Dietz
Bavarian State Institute of Forestry, Hans-Carl-von-Carlowitz-Platz 1, Freising 85354, Germany
2 shared publications
Latest Publications
- Open Access
- 20 December 2024
- Published by Wiley in Chemie Ingenieur Technik
- Vol. 97 (3) , 218-225
Verhalten ausgewählter Elemente in Kleinfeuerungsanlagen
Zusammenfassung: Die Konzentrationen ausgewählter Elemente in Holzhackschnitzeln und in deren Aschen wurden nach der Verbrennung in einer Holzfeuerungsanlage mit einer Leistung von 300 kWth mittels ICP‐OES (induktiv gekoppeltes Plasma‐optische Emissionsspektroskopie) bestimmt. Mit den Analysenergebnissen wurden Massebilanzen für die einzelnen Elemente berechnet. Die Wiederfindungsraten der Elemente wurden mit Literaturdaten zur Flüchtigkeit verglichen.
- 20 December 2024
- Published by Wiley in Chemie Ingenieur Technik
- Vol. 97 (3) , 218-225
Open AccessVerhalten ausgewählter Elemente in Kleinfeuerungsanlagen
Zusammenfassung: Die Konzentrationen ausgewählter Elemente in Holzhackschnitzeln und in deren Aschen wurden nach der Verbrennung in einer Holzfeuerungsanlage mit einer Leistung von 300 kWth mittels ICP‐OES (induktiv gekoppeltes Plasma‐optische Emissionsspektroskopie) bestimmt. Mit den Analysenergebnissen wurden Massebilanzen für die einzelnen Elemente berechnet. Die Wiederfindungsraten der Elemente wurden mit Literaturdaten zur Flüchtigkeit verglichen.
- Open Access
- 23 August 2024
- Published by Wiley in Chemie Ingenieur Technik
- Vol. 97 (1-2) , 101-109
Online Water Content Determination in Wood Chips Using a Microwave Sensor
The water content is an essential parameter for assessing the quality of solid biofuels. In terms of economic, technical and environmental aspects a continuous determination of the solid fuel water content is sought. This article investigates the use of microwave technology for the continuous measurement of fuel water content. For this purpose, a microwave sensor was evaluated with five different types of wood chips (forest residues, beech, pine, and ash). The results of the online measurements showed a strong correlation with the reference method r < 0.9 for most materials. This means that continuous water content determination of wood fuels using microwave technology is fundamentally possible.
- 23 August 2024
- Published by Wiley in Chemie Ingenieur Technik
- Vol. 97 (1-2) , 101-109
Open AccessOnline Water Content Determination in Wood Chips Using a Microwave Sensor
The water content is an essential parameter for assessing the quality of solid biofuels. In terms of economic, technical and environmental aspects a continuous determination of the solid fuel water content is sought. This article investigates the use of microwave technology for the continuous measurement of fuel water content. For this purpose, a microwave sensor was evaluated with five different types of wood chips (forest residues, beech, pine, and ash). The results of the online measurements showed a strong correlation with the reference method r < 0.9 for most materials. This means that continuous water content determination of wood fuels using microwave technology is fundamentally possible.
- Open Access
- 8 August 2024
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 38 (17) , 16426-16440
Evaluation and Optimization of an X-ray Fluorescence Analyzer for Rapid Analysis of Chemical Elements in Solid Biofuels
- 8 August 2024
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 38 (17) , 16426-16440
Open AccessEvaluation and Optimization of an X-ray Fluorescence Analyzer for Rapid Analysis of Chemical Elements in Solid Biofuels
- Open Access
- 28 December 2023
- Published by Elsevier in Renewable Energy
- Vol. 222
Impacts on X-ray fluorescence measurements for rapid determination of the chemical composition of renewable solid biofuels
- 28 December 2023
- Published by Elsevier in Renewable Energy
- Vol. 222
Open AccessImpacts on X-ray fluorescence measurements for rapid determination of the chemical composition of renewable solid biofuels
- Open Access
- 31 May 2023
- Published by Wiley in Chemie Ingenieur Technik
- Vol. 95 (10) , 1503-1525
Analytical Methods for the Rapid Determination of Solid Biofuel Quality
Fuel properties of solid biofuels are essential aspects for the energy‐efficient and low‐emission operation of biomass heat and power plants. Hence, fuel quality parameters are often defined and used for pricing in supply contracts. To simplify and accelerate analytical approaches, rapid analysis devices are required to determine fuel properties such as water‐ and ash content, calorific value, and chemical composition on‐site. This article gives an overview about available technologies and, if applicable, their current state of use as rapid analysis devices for solid biofuels.
- 31 May 2023
- Published by Wiley in Chemie Ingenieur Technik
- Vol. 95 (10) , 1503-1525
Open AccessAnalytical Methods for the Rapid Determination of Solid Biofuel Quality
Fuel properties of solid biofuels are essential aspects for the energy‐efficient and low‐emission operation of biomass heat and power plants. Hence, fuel quality parameters are often defined and used for pricing in supply contracts. To simplify and accelerate analytical approaches, rapid analysis devices are required to determine fuel properties such as water‐ and ash content, calorific value, and chemical composition on‐site. This article gives an overview about available technologies and, if applicable, their current state of use as rapid analysis devices for solid biofuels.
- Open Access
- 15 December 2022
- Published by Elsevier in Biomass and Bioenergy
- Vol. 168
Influence of milling on representative sample preparation for the analysis of trace elements in waste wood
- 15 December 2022
- Published by Elsevier in Biomass and Bioenergy
- Vol. 168
Open AccessInfluence of milling on representative sample preparation for the analysis of trace elements in waste wood
- Open Access
- 8 December 2022
- Published by Wiley in Chemie Ingenieur Technik
- Vol. 95 (10) , 1526-1533
Pollutants in Waste Wood
Gelegentlich wird angenommen, dass Holz einer endlosen Nutzungskaskade zugeführt werden kann. Diese Annahme wird basierend auf Daten von neuen und gebrauchten Spanplatten sowie Altholz der Kategorie AI–AIII untersucht. Die Ergebnisse zeigen basierend auf 468 Datensätzen, dass Schadstoffkonzentrationen in Altholz in einem weiten Bereich schwanken. Je nach Probenkollektiv wären 46 % bis 69 % der betrachteten Proben nach geltender AltholzV nicht für eine stoffliche Nutzung geeignet. Es muss davon ausgegangen werden, dass Altholz bereits nach einmaliger Nutzung Schadstoffe in relevanten Konzentrationen enthält und deshalb erst nach Vorliegen der Ergebnisse einer analytischen Überprüfung dem Stoffkreislauf ein weiteres Mal zugeführt werden kann. Eine organoleptische Untersuchung ist hierfür nicht ausreichend.
- 8 December 2022
- Published by Wiley in Chemie Ingenieur Technik
- Vol. 95 (10) , 1526-1533
Open AccessPollutants in Waste Wood
Gelegentlich wird angenommen, dass Holz einer endlosen Nutzungskaskade zugeführt werden kann. Diese Annahme wird basierend auf Daten von neuen und gebrauchten Spanplatten sowie Altholz der Kategorie AI–AIII untersucht. Die Ergebnisse zeigen basierend auf 468 Datensätzen, dass Schadstoffkonzentrationen in Altholz in einem weiten Bereich schwanken. Je nach Probenkollektiv wären 46 % bis 69 % der betrachteten Proben nach geltender AltholzV nicht für eine stoffliche Nutzung geeignet. Es muss davon ausgegangen werden, dass Altholz bereits nach einmaliger Nutzung Schadstoffe in relevanten Konzentrationen enthält und deshalb erst nach Vorliegen der Ergebnisse einer analytischen Überprüfung dem Stoffkreislauf ein weiteres Mal zugeführt werden kann. Eine organoleptische Untersuchung ist hierfür nicht ausreichend.
- Open Access
- 14 August 2021
- Published by Wiley in Chemie Ingenieur Technik
- Vol. 93 (10) , 1598-1609
Einfluss der Holzalterung auf die Brennstoffqualität und die Verbrennungschemie in einem Scheitholzofen
- 14 August 2021
- Published by Wiley in Chemie Ingenieur Technik
- Vol. 93 (10) , 1598-1609
Open AccessEinfluss der Holzalterung auf die Brennstoffqualität und die Verbrennungschemie in einem Scheitholzofen
- Open Access
- 29 December 2020
- Published by Wiley in Chemie Ingenieur Technik
- Vol. 93 (3) , 412-420
Impact of Chimney‐draught Conditions on Combustion and Emission Behavior of a Wood‐burning Stove
Pollutants from combustion in wood‐burning stoves are influenced by many factors, including the exhaust gas system. This is responsible for the air supply due to the draught generated. Contrary to results reported in literature the experiments in this study show no effect on temperature related to increasing air supply and a total dust decreasing at higher draughts. The results also show no significant impact of the draught on gaseous emissions (CO/OGC/NOx). The most significant loss was determined at thermal efficiency, which lost up to 13 % absolute with increasing draught.
- 29 December 2020
- Published by Wiley in Chemie Ingenieur Technik
- Vol. 93 (3) , 412-420
Open AccessImpact of Chimney‐draught Conditions on Combustion and Emission Behavior of a Wood‐burning Stove
Pollutants from combustion in wood‐burning stoves are influenced by many factors, including the exhaust gas system. This is responsible for the air supply due to the draught generated. Contrary to results reported in literature the experiments in this study show no effect on temperature related to increasing air supply and a total dust decreasing at higher draughts. The results also show no significant impact of the draught on gaseous emissions (CO/OGC/NOx). The most significant loss was determined at thermal efficiency, which lost up to 13 % absolute with increasing draught.