Shahabeddin Mohin
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Shahabeddin Mohin has a total of 5 co-authors. Here are the top co-authors by number of shared publications:
- Negar Reiskarimian
Department of Electrical Engineering and Computer Science, Massachusetts Institute of Technology, Cambridge, MA, USA
2 shared publications - Soroush Araei
Department of Electrical Engineering and Computer Science, Massachusetts Institute of Technology, Cambridge, MA, USA
2 shared publications Fatemeh Tavana
Department of Electrical Engineering, Sharif University of Technology, Tehran, Iran
1 shared publicationMehrdad Sharif Bakhtiar
Department of Electrical Engineering, Sharif University of Technology, Tehran, Iran
1 shared publication- Reza Ehsani Alashti
Department of Electrical Engineering, Sharif University of Technology, Tehran, Iran
1 shared publication
Latest Publications
- 3 October 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Solid-State Circuits
- Vol. 58 (12) , 3396-3407
Harmonic-Resilient Fully Passive Mixer-First Receiver for Software-Defined Radios
This article presents a low-loss fully passive harmonic rejection (HR) and blocker-tolerant mixer-first receiver (RX) for 5G new radio (NR) applications. This design exploits the codesign of charge-sharing and capacitor stacking to offer early HR and high- Q filtering at the antenna interface using only switches and capacitors. A prototype RX in 45-nm partially depleted silicon-on-insulator (PD-SOI) occupies 0.65 mm 2 and operates from 250 MHz to 2.5 GHz while consuming 32.4–54 mW. The proposed design exhibits a noise figure (NF) of 3.5–5.5 dB, an out-of-band (OOB) input-referred third-order intercept point (IIP3) of 13–27 dBm, and an H3/H5-blocker 1-dB compression point (B1dB) of 10/4 dBm. With a $-$ 5 dBm third-harmonic blocker, the design experiences less than 1 dB of NF degradation. This notable high degree of harmonic blocker tolerance is achieved by passively rejecting harmonic blockers before they undergo any voltage gain.
- 3 October 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Solid-State Circuits
- Vol. 58 (12) , 3396-3407
Harmonic-Resilient Fully Passive Mixer-First Receiver for Software-Defined Radios
This article presents a low-loss fully passive harmonic rejection (HR) and blocker-tolerant mixer-first receiver (RX) for 5G new radio (NR) applications. This design exploits the codesign of charge-sharing and capacitor stacking to offer early HR and high- Q filtering at the antenna interface using only switches and capacitors. A prototype RX in 45-nm partially depleted silicon-on-insulator (PD-SOI) occupies 0.65 mm 2 and operates from 250 MHz to 2.5 GHz while consuming 32.4–54 mW. The proposed design exhibits a noise figure (NF) of 3.5–5.5 dB, an out-of-band (OOB) input-referred third-order intercept point (IIP3) of 13–27 dBm, and an H3/H5-blocker 1-dB compression point (B1dB) of 10/4 dBm. With a $-$ 5 dBm third-harmonic blocker, the design experiences less than 1 dB of NF degradation. This notable high degree of harmonic blocker tolerance is achieved by passively rejecting harmonic blockers before they undergo any voltage gain.
- 8 May 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Microwave and Wireless Technology Letters
- Vol. 33 (6) , 823-826
Realization of Low-Loss Fully Passive Harmonic Rejection N-Path Filters
This work presents a low-loss fully passive harmonic rejection (HR) N-path filter that performs finite impulse response (FIR) filtering within its core by sequentially charging the baseband capacitors and exploiting combined charge sharing and capacitor stacking techniques. The proposed HR N-path filter achieves an in-band (IB) gain of $-$ 2 to $+$ 0.5 dB across the 0.25-2 GHz frequency range while consuming 2.3–15.7 mW of power. It achieves an HR ratio (HRR) of $>$ 46/48 dB with $>$ $+$ 8/ $+$ 11 dBm third/ fifth-order harmonic blocker P1dB.
- 8 May 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Microwave and Wireless Technology Letters
- Vol. 33 (6) , 823-826
Realization of Low-Loss Fully Passive Harmonic Rejection N-Path Filters
This work presents a low-loss fully passive harmonic rejection (HR) N-path filter that performs finite impulse response (FIR) filtering within its core by sequentially charging the baseband capacitors and exploiting combined charge sharing and capacitor stacking techniques. The proposed HR N-path filter achieves an in-band (IB) gain of $-$ 2 to $+$ 0.5 dB across the 0.25-2 GHz frequency range while consuming 2.3–15.7 mW of power. It achieves an HR ratio (HRR) of $>$ 46/48 dB with $>$ $+$ 8/ $+$ 11 dBm third/ fifth-order harmonic blocker P1dB.
- 15 December 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Solid-State Circuits
- Vol. 58 (7) , 1928-1944
Digital to RF Wideband Multi-Standard Multi-Path Transmitter
This article presents a multi-standard transmitter based on the eight-path architecture with a fully digital baseband (BB) input, covering the frequency band from 300 MHz to 1.5 GHz, while all harmonics and the distortion product of C-IMD3 are rejected to better than $-$ 40 dBc. The proposed architecture is based on the multipath technique in which the amplitude weighting algorithm is implemented in the digital domain. The fully digital input baseband section of the architecture eliminates the need for power-consuming circuit modules, such as mixers, high-frequency filters, and amplifiers, thus simplifying the required circuitry and improving the overall performance in terms of the operating frequency band, power consumption, and power efficiency. The power amplifier of this transmitter consists of an array of four pseudo-differential digital power amplifiers. A programmable first-order radio frequency (RF)-low pass filter (LPF), integrated within the DPAs, as well as an off-chip first-order RF-LPF, has been adopted in order to attenuate the seventh and ninth harmonics below the desired level, which are not rejected by the eight-path architecture. The chip is realized in 0.18- $\mu$ m CMOS with an active area of 0.58 mm 2 . Measurements verify an output power and overall power efficiency ranging from 10.6 to 17.6 dBm and 3.6% to 19.7%, respectively, within the entire RF bandwidth. The proposed transmitter also satisfies the requirements of the IEEE 802.11af and IEEE 802.11ah standards. An ANN-based calibration algorithm improves the error vector magnitude of 64-QAM data from $-$ 21.5 to $-$ 34.1 dB.
- 15 December 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Solid-State Circuits
- Vol. 58 (7) , 1928-1944
Digital to RF Wideband Multi-Standard Multi-Path Transmitter
This article presents a multi-standard transmitter based on the eight-path architecture with a fully digital baseband (BB) input, covering the frequency band from 300 MHz to 1.5 GHz, while all harmonics and the distortion product of C-IMD3 are rejected to better than $-$ 40 dBc. The proposed architecture is based on the multipath technique in which the amplitude weighting algorithm is implemented in the digital domain. The fully digital input baseband section of the architecture eliminates the need for power-consuming circuit modules, such as mixers, high-frequency filters, and amplifiers, thus simplifying the required circuitry and improving the overall performance in terms of the operating frequency band, power consumption, and power efficiency. The power amplifier of this transmitter consists of an array of four pseudo-differential digital power amplifiers. A programmable first-order radio frequency (RF)-low pass filter (LPF), integrated within the DPAs, as well as an off-chip first-order RF-LPF, has been adopted in order to attenuate the seventh and ninth harmonics below the desired level, which are not rejected by the eight-path architecture. The chip is realized in 0.18- $\mu$ m CMOS with an active area of 0.58 mm 2 . Measurements verify an output power and overall power efficiency ranging from 10.6 to 17.6 dBm and 3.6% to 19.7%, respectively, within the entire RF bandwidth. The proposed transmitter also satisfies the requirements of the IEEE 802.11af and IEEE 802.11ah standards. An ANN-based calibration algorithm improves the error vector magnitude of 64-QAM data from $-$ 21.5 to $-$ 34.1 dB.