Marina F. Marcelli

The Central Valley of California is one of the most prolific agricultural regions in the world. Agriculture is reliant on the conjunctive use of surface-water and groundwater. The lack of available surface-water and land-use changes have led to pumping-induced groundwater-level and storage declines, land subsidence, changes to streamflow and the environment, and the degradation of water quality. As a result, in part, the Sustainable Groundwater Management Act (SGMA) was developed. An examination of the components of SGMA and contextualizing regional model applications within the SGMA framework was undertaken to better understand and quantify many of the components of SGMA. Specifically, the U.S. Geological Survey (USGS) updated the Central Valley Hydrologic Model (CVHM) to assess hydrologic system responses to climatic variation, surface-water availability, land-use changes, and groundwater pumping. MODFLOW-OWHM has been enhanced to simulate the timing of land subsidence and attribute its inelastic and elastic portions. In addition to extending CVHM through 2019, the new version, CVHM2, includes several enhancements as follows: managed aquifer recharge (MAR), pumping with multi-aquifer wells, inflows from ungauged watersheds, and more detailed water-balance subregions, streamflow network, diversions, tile drains, land use, aquifer properties, and groundwater level and land subsidence observations. Combined with historical approximations, CVHM2 estimates approximately 158 km³ of storage loss in the Central Valley from pre-development to 2019. About 15% of the total storage loss is permanent loss of storage from subsidence that has caused damage to infrastructure. Climate extremes will likely complicate the efforts of water managers to store more water in the ground. CVHM2 can provide data in the form of aggregated input datasets, simulate climatic variations and changes, land-use changes or water management scenarios, and resulting changes in groundwater levels, storage, and land subsidence to assist decision-makers in the conjunctive management of water supplies.

Hydrogeologic systems in the southern Cascade Range in California (USA) develop in volcanic rocks where morphology, stratigraphy, extensional structures, and attendant basin geometry play a central role in groundwater flow paths, groundwater/surface-water interactions, and spring discharge locations. High-volume springs (greater than 3 m³/s) flow from basin-filling (<800 ka) volcanic rocks in the Hat Creek and Fall River tributaries and contribute approximately half of the average annual flow of the Pit River, the largest tributary to Shasta Lake. A hydrogeologic conceptual framework is constructed for the Hat Creek basin combining new geologic mapping, water-well lithologic logs, a database of active faults, LiDAR mapping of faults and volcanic landforms, streamflow measurements and airborne thermal infrared remote sensing of stream temperature. These data are used to integrate the geologic structure and the volcanic and volcaniclastic stratigraphy to create a three-dimensional interpretation of the hydrogeology in the basin. Two large streamflow gains from focused groundwater discharge near Big Spring and north of Sugarloaf Peak result from geologic barriers that restrict lateral groundwater flow and force water into Hat Creek. The inferred groundwater-flow barriers divide the aquifer system into at least three leaky compartments. The two downstream compartments lose streamflow in the upstream reaches (immediately downstream of the groundwater-flow barriers) and gain in downstream reaches with the greatest inflows immediately upstream of the barriers.