Lei Shi
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Lei Shi has a total of 41 co-authors. Here are the top co-authors by number of shared publications:
Deliang Xu
Joint International Research Laboratory of Biomass Energy and Materials, Co-Innovation Center of Efficient Processing and Utilization of Forest Resources, College of Materials Science and Engineering, Nanjing Forestry University, Nanjing, China
2 shared publications- Hongqi Sun
School of Molecular Sciences The University of Western Australia Perth Western Australia Australia
2 shared publications Hui Sun
Joint International Research Laboratory of Biomass Energy and Materials, Co-Innovation Center of Efficient Processing and Utilization of Forest Resources, College of Materials Science and Engineering, Nanjing Forestry University, Nanjing, China
2 shared publicationsJie Zhang
Joint International Research Laboratory of Biomass Energy and Materials, Co-Innovation Center of Efficient Processing and Utilization of Forest Resources, College of Materials Science and Engineering, Nanjing Forestry University, Nanjing, China
2 shared publicationsShaobin Wang
School of Chemical Engineering The University of Adelaide 5005 Adelaide SA Australia
2 shared publicationsShu Zhang
Joint International Research Laboratory of Biomass Energy and Materials, Co-Innovation Center of Efficient Processing and Utilization of Forest Resources, College of Materials Science and Engineering, Nanjing Forestry University, Nanjing, China
2 shared publications
Latest Publications
- Open Access
Hydroxylated Hexagonal Boron Nitride-Assisted Retention of Phenol-Derived Self-Catalysts in Fe(III)/H2O2 System for Sequential Diethyl Phthalate (DEP) Degradation
Fe(III)-mediated Fenton-like oxidation is widely used for refractory organic pollutants, but its efficiency is often constrained by slow Fe(III)/Fe(II) cycling. Phenolic pollutants can partly overcome this limitation because oxidation-derived hydroquinone/quinone species promote Fe(III) reduction and generate self-catalytic feedback. Here, hydroxylated boron nitride (BN) nanoplates were used as a recoverable interface to regulate phenol self-catalysis and to transfer the resulting redox activity to the non-self-catalytic pollutant diethyl phthalate (DEP) in an Fe(NO3)3/H2O2 system. BN surface chemistry was tuned by calcination from 500 °C to 900 °C (BN500 to BN900). Phenol degradation exhibited two-stage kinetics in the BN/Fe(NO3)3/H2O2 system. The initial rate constant was 0.004 min−1, whereas the accelerated stage depended strongly on BN surface state. BN700 exhibited the highest second-stage rate constant (0.23 min−1) compared with pristine BN (0.11 min−1), while further heating to 800–900 °C decreased it to 0.15 min−1. This activity maximum is consistent with a favorable B–OH/boron–oxygen interfacial environment rather than a greater total surface oxygen content; more severe thermal treatment was associated with removable boric-acid-related species. BN recovered after phenol oxidation markedly promoted DEP degradation, with two-stage rate constants of 0.044/0.0095 min−1 for phenol-used BN and 0.033/0.011 min−1 for phenol-used BN700. The activity-transfer results are consistent with a reaction-derived, multicomponent redox-active interfacial state and support a strategy for sequential treatment of phenolic and non-phenolic contaminants.
Open AccessHydroxylated Hexagonal Boron Nitride-Assisted Retention of Phenol-Derived Self-Catalysts in Fe(III)/H2O2 System for Sequential Diethyl Phthalate (DEP) Degradation
Fe(III)-mediated Fenton-like oxidation is widely used for refractory organic pollutants, but its efficiency is often constrained by slow Fe(III)/Fe(II) cycling. Phenolic pollutants can partly overcome this limitation because oxidation-derived hydroquinone/quinone species promote Fe(III) reduction and generate self-catalytic feedback. Here, hydroxylated boron nitride (BN) nanoplates were used as a recoverable interface to regulate phenol self-catalysis and to transfer the resulting redox activity to the non-self-catalytic pollutant diethyl phthalate (DEP) in an Fe(NO3)3/H2O2 system. BN surface chemistry was tuned by calcination from 500 °C to 900 °C (BN500 to BN900). Phenol degradation exhibited two-stage kinetics in the BN/Fe(NO3)3/H2O2 system. The initial rate constant was 0.004 min−1, whereas the accelerated stage depended strongly on BN surface state. BN700 exhibited the highest second-stage rate constant (0.23 min−1) compared with pristine BN (0.11 min−1), while further heating to 800–900 °C decreased it to 0.15 min−1. This activity maximum is consistent with a favorable B–OH/boron–oxygen interfacial environment rather than a greater total surface oxygen content; more severe thermal treatment was associated with removable boric-acid-related species. BN recovered after phenol oxidation markedly promoted DEP degradation, with two-stage rate constants of 0.044/0.0095 min−1 for phenol-used BN and 0.033/0.011 min−1 for phenol-used BN700. The activity-transfer results are consistent with a reaction-derived, multicomponent redox-active interfacial state and support a strategy for sequential treatment of phenolic and non-phenolic contaminants.
- 15 September 2026
- Published by Springer Nature in Science China Chemistry
- Vol. 69 (11) , 6689-6695
Dynamically regulated electron supply within dual-atom Mn sites for enhanced electrocatalytic nitrate conversion into ammonia
- 15 September 2026
- Published by Springer Nature in Science China Chemistry
- Vol. 69 (11) , 6689-6695
Dynamically regulated electron supply within dual-atom Mn sites for enhanced electrocatalytic nitrate conversion into ammonia
- Open Access
- 1 November 2025
- Published by Tsinghua University Press in Nano Research
- Vol. 18 (11)
Hollow carbon sphere nanoreactor decorated with uniformly dispersed Cu nanoparticles: Tunable interfacial electronic structures for enhanced nitroarene reduction
An efficient catalytic hydrogenation of nitroarenes into their derived anilines is of critical importance for fine chemicals industry and environmental remediation. Herein, a Cu decorated hollow carbon nanosphere (Cu/h-CS) was demonstrated as a promising nanoreactor to achieve enhanced hydrogenation toward nitroarene reduction. The unique hollow configuration of h-CS provided sufficient binding sites for Cu anchoring on interior and exterior surfaces, effectively preventing Cu agglomeration. The resulting homogenously dispersed Cu nanoparticles on h-CS exhibited a strong electronic interaction at the interface, leading to the generation of favorable electrophilic Cuδ+ sites. Meanwhile, thin shells with nanoporous channels enabled rapid electron migration, and regulated the mass transfer to boost reactant enrichment due to the void-confinement effect. Compared with its counterpart of Cu loaded solid carbon nanosphere (Cu/s-CS), the desirable structural and electronic configurations of Cu/h-CS offered a preferable micro-environment to achieve markedly enhanced catalytic activity in hydrogenation reactions. As an exemplary verification, the Cu/h-CS demonstrated a high turnover frequency of 740.74 h-1 for 4-nitrophenol reduction (~3-fold that of Cu/s-CS), an impressive reduction applicability toward a series of nitroarenes and azo-dyes, as well as an acceptable stability after 10 catalytic cycles. This work sheds new light on the design and construction of low-cost and high-performance catalysts for wide hydrogenation applications.
- 1 November 2025
- Published by Tsinghua University Press in Nano Research
- Vol. 18 (11)
Open AccessHollow carbon sphere nanoreactor decorated with uniformly dispersed Cu nanoparticles: Tunable interfacial electronic structures for enhanced nitroarene reduction
An efficient catalytic hydrogenation of nitroarenes into their derived anilines is of critical importance for fine chemicals industry and environmental remediation. Herein, a Cu decorated hollow carbon nanosphere (Cu/h-CS) was demonstrated as a promising nanoreactor to achieve enhanced hydrogenation toward nitroarene reduction. The unique hollow configuration of h-CS provided sufficient binding sites for Cu anchoring on interior and exterior surfaces, effectively preventing Cu agglomeration. The resulting homogenously dispersed Cu nanoparticles on h-CS exhibited a strong electronic interaction at the interface, leading to the generation of favorable electrophilic Cuδ+ sites. Meanwhile, thin shells with nanoporous channels enabled rapid electron migration, and regulated the mass transfer to boost reactant enrichment due to the void-confinement effect. Compared with its counterpart of Cu loaded solid carbon nanosphere (Cu/s-CS), the desirable structural and electronic configurations of Cu/h-CS offered a preferable micro-environment to achieve markedly enhanced catalytic activity in hydrogenation reactions. As an exemplary verification, the Cu/h-CS demonstrated a high turnover frequency of 740.74 h-1 for 4-nitrophenol reduction (~3-fold that of Cu/s-CS), an impressive reduction applicability toward a series of nitroarenes and azo-dyes, as well as an acceptable stability after 10 catalytic cycles. This work sheds new light on the design and construction of low-cost and high-performance catalysts for wide hydrogenation applications.
- Open Access
- 11 January 2023
- Published by MDPI AG in International Journal of Environmental Research and Public Health
- Vol. 20 (2) , 1355
Preparation and Electrochemical Performance of Bio-Oil-Derived Hydrochar as a Supercapacitor Electrode Material
The rapid consumption of fossil energy and the urgent demand for sustainable development have significantly promoted worldwide efforts to explore new technology for energy conversion and storage. Carbon-based supercapacitors have received increasing attention. The use of biomass and waste as a carbon precursor is environmentally friendly and economical. In this study, hydrothermal pretreatment was used to synthetize coke from bio-oil, which can create a honeycomb-like structure that is advantageous for electrolyte transport. Furthermore, hydrothermal pretreatment, which is low in temperature, can create a low graphitization degree which can make heteroatom introduction and activation easier. Then, urea and KOH were used for doping and activation, which can improve conductivity and capacitance. Compared with no heteroatom and activation hydrothermal char (HC) (58.3 F/g at 1 A/g), the prepared carbon material nitrogen doping activated hydrothermal carbon (NAHC1) had a good electrochemical performance of 225.4 F/g at 1 A/g. The specific capacitance of the prepared NAHC1 was improved by 3.8 times compared with that of HC.
- 11 January 2023
- Published by MDPI AG in International Journal of Environmental Research and Public Health
- Vol. 20 (2) , 1355
Open AccessPreparation and Electrochemical Performance of Bio-Oil-Derived Hydrochar as a Supercapacitor Electrode Material
The rapid consumption of fossil energy and the urgent demand for sustainable development have significantly promoted worldwide efforts to explore new technology for energy conversion and storage. Carbon-based supercapacitors have received increasing attention. The use of biomass and waste as a carbon precursor is environmentally friendly and economical. In this study, hydrothermal pretreatment was used to synthetize coke from bio-oil, which can create a honeycomb-like structure that is advantageous for electrolyte transport. Furthermore, hydrothermal pretreatment, which is low in temperature, can create a low graphitization degree which can make heteroatom introduction and activation easier. Then, urea and KOH were used for doping and activation, which can improve conductivity and capacitance. Compared with no heteroatom and activation hydrothermal char (HC) (58.3 F/g at 1 A/g), the prepared carbon material nitrogen doping activated hydrothermal carbon (NAHC1) had a good electrochemical performance of 225.4 F/g at 1 A/g. The specific capacitance of the prepared NAHC1 was improved by 3.8 times compared with that of HC.
- 15 November 2022
- Published by Elsevier in Journal of Colloid and Interface Science
- Vol. 632 (Pt A) , 117-128
Versatile heterojunction of gold nanoparticles modified phosphorus doped carbon nitride for enhanced photo-electrocatalytic sensing and degradation of 4-chlorophenol
- 15 November 2022
- Published by Elsevier in Journal of Colloid and Interface Science
- Vol. 632 (Pt A) , 117-128
Versatile heterojunction of gold nanoparticles modified phosphorus doped carbon nitride for enhanced photo-electrocatalytic sensing and degradation of 4-chlorophenol