Masato Imai
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Masato Imai has a total of 21 co-authors. Here are the top co-authors by number of shared publications:
Atsushi Miyazawa
Tosoh Corporation 2743‐1, Hayakawa Ayase‐shi Kanagawa 252‐1123 Japan
1 shared publicationHaruna Mori
Tosoh Finechem Corporation 4555 Kaisei‐cho Shunan‐shi Yamaguchi 746‐0006 Japan
1 shared publicationHimeka Tominaga
Department of Applied Physics and Electronics Engineering, Faculty of Engineering, University of Miyazaki 1‐1 Gakuen Kibanadai‐nishi Miyazaki 889‐2192 Japan
1 shared publicationKazuki Kashiwabara
Graduate School of Science and Engineering, Yamagata University, 4-3-16 Jonan, Yonezawa 992-8510, Japan
1 shared publicationKenji Yoshino
The Electrical and Electronic Engineering Program Faculty of Engineering University of Miyazaki 1‐1 Gakuen Kibanadai‐nishi Miyazaki 889‐2192 Japan
1 shared publication- Kenji Yoshino
Electrical and Electronic System Program, University of Miyazaki, Miyazaki 889-2192, Japan
1 shared publication
Latest Publications
- 18 December 2022
- Published by Wiley in Crystal Research and Technology
- Vol. 58 (3)
Ultra‐Thin Layer Inside Separator Deposited by Spray Pyrolysis Using Methylaluminoxane Solution
Depositions are conducted on monolayer porous membrane at 50 °C by spray pyrolysis using methylaluminoxanes diluted with N‐methylpyrrolidone. The solution penetrates the film during spraying and the ultra‐thin layers are deposited on the side wall of internal pores. It is suggested that these layers are fine polycrystalline of Al2O3. In the obtained film, most of the pores are exposed on the surface and there is no increase in film thickness. Further, the ionic conductivity is the same as that of the received film, and the thermal stability is improved. This method can be an effective technique for improving the function of the separator used in the lithium‐ion batteries.
- 18 December 2022
- Published by Wiley in Crystal Research and Technology
- Vol. 58 (3)
Ultra‐Thin Layer Inside Separator Deposited by Spray Pyrolysis Using Methylaluminoxane Solution
Depositions are conducted on monolayer porous membrane at 50 °C by spray pyrolysis using methylaluminoxanes diluted with N‐methylpyrrolidone. The solution penetrates the film during spraying and the ultra‐thin layers are deposited on the side wall of internal pores. It is suggested that these layers are fine polycrystalline of Al2O3. In the obtained film, most of the pores are exposed on the surface and there is no increase in film thickness. Further, the ionic conductivity is the same as that of the received film, and the thermal stability is improved. This method can be an effective technique for improving the function of the separator used in the lithium‐ion batteries.
- 13 June 2019
- Published by Taylor & Francis in Molecular Crystals and Liquid Crystals
- Vol. 686 (1) , 70-77
Substituent engineering of electrooptic chromophores to suppress their aggregation
Chromophores composed of 4-cyano-5-dicyanomethylene-2-oxo-3-pyrroline (CDCOP) and a donor have been synthsized for electrooptic applications. Three substituents of [5-(4-aminophenyl)-2-thienyl]-substituted CDCOP 1 and (4-aminophenyl)-substituted CDCOP 2 were modified to suppress the aggregation for effective poling. To 1, bulky and branched 2-ethylhexyl groups were introduced instead of linear alkyl groups. Less aggregation was confirmed in the polymer dispersion films, and the corona poling behaviors were examined. To 2, we introduced norbornyl epoxide groups as bulky and thermally crosslinkable moieties. The aggregation was suppressed as well, and the thermal crosslinking of the epoxide with acid anhydride in the presence of a base was investigated.
- 13 June 2019
- Published by Taylor & Francis in Molecular Crystals and Liquid Crystals
- Vol. 686 (1) , 70-77
Substituent engineering of electrooptic chromophores to suppress their aggregation
Chromophores composed of 4-cyano-5-dicyanomethylene-2-oxo-3-pyrroline (CDCOP) and a donor have been synthsized for electrooptic applications. Three substituents of [5-(4-aminophenyl)-2-thienyl]-substituted CDCOP 1 and (4-aminophenyl)-substituted CDCOP 2 were modified to suppress the aggregation for effective poling. To 1, bulky and branched 2-ethylhexyl groups were introduced instead of linear alkyl groups. Less aggregation was confirmed in the polymer dispersion films, and the corona poling behaviors were examined. To 2, we introduced norbornyl epoxide groups as bulky and thermally crosslinkable moieties. The aggregation was suppressed as well, and the thermal crosslinking of the epoxide with acid anhydride in the presence of a base was investigated.
- 7 November 2017
- Published by Wiley in Physica Status Solidi (a)
- Vol. 215 (4)
Growth Mechanism of ZnO Thin Films Grown by Spray Pyrolysis Using Diethylzinc Solution
Non‐doped ZnO thin films are deposited on glass by spray pyrolysis using Diethylzinc diluted with diisopropyl ether. The droplet impacts are observed and the structural properties of films are studied as deposition temperature dependence. The shape of a droplet impacts changes from a hemisphere to a flat plane with increasing the deposition temperature. The images of cross sectional transmittance electron microscopy show granular non‐crystalline for RT (room temperature) sample and columnar polycrystalline for 150 °C sample as shown on the right‐side. The growth mechanism of ZnO thin films is discussed by considering the relationship between the shape of droplet impacts and the morphology of the deposited films. Also, the presence of the crystal formed by precursor is suggested for the films deposited at lower temperature.
- 7 November 2017
- Published by Wiley in Physica Status Solidi (a)
- Vol. 215 (4)
Growth Mechanism of ZnO Thin Films Grown by Spray Pyrolysis Using Diethylzinc Solution
Non‐doped ZnO thin films are deposited on glass by spray pyrolysis using Diethylzinc diluted with diisopropyl ether. The droplet impacts are observed and the structural properties of films are studied as deposition temperature dependence. The shape of a droplet impacts changes from a hemisphere to a flat plane with increasing the deposition temperature. The images of cross sectional transmittance electron microscopy show granular non‐crystalline for RT (room temperature) sample and columnar polycrystalline for 150 °C sample as shown on the right‐side. The growth mechanism of ZnO thin films is discussed by considering the relationship between the shape of droplet impacts and the morphology of the deposited films. Also, the presence of the crystal formed by precursor is suggested for the films deposited at lower temperature.