Nur Oral
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Nur Oral has a total of 1 co-authors. Here are the top co-authors by number of shared publications:
- Guldemet Basal
Department of Textile Engineering, Faculty of Engineering, Ege University, Izmir, Turkey
2 shared publications
Latest Publications
- 31 December 2022
- Published by Tekstil Ve Konfeksiyon in TEKSTİL VE KONFEKSİYON
- Vol. 32 (4) , 384-389
A Hydrophilic/Hydrophobic Composite Structure for Water Harvesting from the Air
The purpose of this study is to improve the water harvesting capacity of the traditional wire mesh from the fog by modifying its surface using a nature-inspired composite structure consisting of hydrophilic and hydrophobic zones. Hydrophilic zones were obtained by electrospinning or electrospraying of the polyamide 6 (PA6) / chitosan (CH) blend, and similarly hydrophobic zones were attained by electrospraying of polycaprolactone (PCL). The water harvesting capacity of the resulting meshes was tested and compared with each other. The highest water harvesting capacity was achieved with the PA6/CH nanofiber coated wire mesh as 87 mg / cm2/h. This mesh collected twice as much water compared to the uncoated mesh. However, its water collection rate decreased when nanofiber surface reached the saturation level. The addition of hydrophobic PCL particles onto nanofibers reduced the amount of water captured. In this case, the water collection rate of the mesh continued to increase.
- 31 December 2022
- Published by Tekstil Ve Konfeksiyon in TEKSTİL VE KONFEKSİYON
- Vol. 32 (4) , 384-389
A Hydrophilic/Hydrophobic Composite Structure for Water Harvesting from the Air
The purpose of this study is to improve the water harvesting capacity of the traditional wire mesh from the fog by modifying its surface using a nature-inspired composite structure consisting of hydrophilic and hydrophobic zones. Hydrophilic zones were obtained by electrospinning or electrospraying of the polyamide 6 (PA6) / chitosan (CH) blend, and similarly hydrophobic zones were attained by electrospraying of polycaprolactone (PCL). The water harvesting capacity of the resulting meshes was tested and compared with each other. The highest water harvesting capacity was achieved with the PA6/CH nanofiber coated wire mesh as 87 mg / cm2/h. This mesh collected twice as much water compared to the uncoated mesh. However, its water collection rate decreased when nanofiber surface reached the saturation level. The addition of hydrophobic PCL particles onto nanofibers reduced the amount of water captured. In this case, the water collection rate of the mesh continued to increase.
- 24 December 2022
- Published by Springer Nature in Journal of Polymer Research
- Vol. 30 (1) , 1-11
The effects of crosslinker ratio and photoinitiator type on the properties of pnipam hydrogel
- 24 December 2022
- Published by Springer Nature in Journal of Polymer Research
- Vol. 30 (1) , 1-11
The effects of crosslinker ratio and photoinitiator type on the properties of pnipam hydrogel