YSYixin Shi

Yixin Shi

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Yixin Shi has a total of 19 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Nitrogen Enables Superior Strength–Ductility Synergy in Ultra-Low Carbon Steel via Copious Interphase Precipitation and Grain Refinement

    by Qing Zhu, Rui Cao, Shuai Xu, Junheng Gao, Haitao Zhao, Qingxiao Feng, Hualong Li, Yixin Shi, Honghui Wu, Chaolei Zhang, et al.

    The increasing use of electric arc furnace (EAF) in steelmaking inevitably elevates nitrogen (N) levels, which are traditionally regarded as a detrimental element to the formability of ultra-low carbon (ULC) steels due to the formation of Lüders band. Here, we demonstrate that N could act as a beneficial microalloying element in strip casting ULC steels by promoting V(C, N) precipitation and grain refinement of ferrite. Thermodynamic calculations reveal that N significantly increases both the equilibrium volume fraction and equilibrium precipitation temperature of V(C, N), enabling copious interphase nanoprecipitation during ferrite transformation. Microstructural characterization confirms the enhanced formation of V(C, N) within interphase rows in the N-containing steels, leading to greater Zener pinning effect and smaller ferrite grain size (from 7.50 μm of 0N to 4.67 μm of 96 ppm N and 3.84 μm of 139 ppm N). As a result, owing to the enhanced nanoprecipitation and grain refinement, the N-containing ULC strip casting steels exhibit a superior strength–ductility synergy, with tensile strength increased from 666 MPa (0N) to 805 MPa (96 ppm N) and 825 MPa (139 ppm N), and a slight decrease in total elongation from 29.8% (0N) to 27.3% (96 ppm N) and 22.0% (139 ppm N). In addition, no Lüders plateau was observed in the tensile stress-strain curves as the extensive formation of V(C, N) consumed the N atoms in solid solution. These findings highlight that microalloying V in the steels produced by EAF can effectively leverage the high N content for achieving superior strength–ductility synergy.

  • Open Access

    Effects of Rare Earth Elements on Microstructure and Corrosion Resistance of Low Alloy Steel Based on Ultra-Thin Cast Strip Process

    by Xintong Lian, Hongshan Zhao, Long Chen, Tengshi Liu, Qingxiao Feng, Hualong Li, Yixin Shi, Han Dong

    This laboratory study aimed to reveal the inner connects between the microstructure and corrosion properties of a RE microalloyed ultra-thin cast strip (UCS) steel. The microstructure mainly consisted of homogeneous polygonal ferrite (PF) with a small amount of pearlite (P), while adding multiple alloying elements led to the appearance of granular bainite (GB) and bainitic ferrite (BF). RE elements strongly promoted the homogenization and refinement of microstructure by segregating towards the solid–liquid interface. Potentiodynamic polarization, EIS, and weight loss curves under wet–dry immersion test confirmed that the corrosion behavior was significantly improved by RE, while the addition of RE had no obvious change on tensile strength. The corrosion resistance of the homogeneous single-phase microstructure was proved to be better than that of multiphase microstructure. Hence, RE had a remarkable influence on improving corrosion resistance when the experimental steels processed single-phase microstructures.