Genkuo Nie
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Genkuo Nie has a total of 53 co-authors. Here are the top co-authors by number of shared publications:
Hongyu Wang
State Key Laboratory of Safety and Control for Chemicals
4 shared publicationsShitao Yu
College of Chemical Engineering, Qingdao University of Science and Technology, 53 Zhengzhou Road, Qingdao 266042, China
4 shared publicationsHailong Yu
Key Laboratory of Multiphase Flow Reaction and Separation Engineering of Shandong Province, College of Chemical Engineering, Qingdao University of Science and Technology, Qingdao, China
3 shared publicationsYu Liu
College of Chemical Engineering, Qingdao University of Science and Technology, 53 Zhengzhou Road, Qingdao 266042, China
3 shared publicationsFengru Song
2 shared publicationsGuihua Yang
Key Laboratory of Pulp and Paper Science & Technology of Ministry of Education, Qilu University of Technology (Shandong Academy of Sciences), Jinan, China
2 shared publications
Latest Publications
- Open Access
- 1 August 2026
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 3298 (1)
Conversion of 5-hydroxymethylfurfural to 1,6-hexanediol over metals supported Al-MCM-41
This research realizes the direct transformation of biomass-based 5-hydroxymethylfurfural (HMF) into high-value 1,6-hexanediol (1,6-HDO) over a bifunctional Pd/Al-MCM-41 catalyst. Various metals (Pd, Pt, and Ni) supported on Al-MCM-41 catalysts were synthesized through the incipient wetness impregnation method. Experimental findings indicated that the 7%Pd/Al-MCM-41 system demonstrates the optimized performance at 160 °C, 3 MPa H 2 and 3 h, successfully achieving an HMF conversion of 99.08% and a maximum 1,6-HDO yield of 39.45%. Characterizations via XRD, BET, and NH 3 -TPD revealed that such efficiency stems from well-dispersed Pd nanoparticles and the proper acidic properties of Al-MCM-41 support, the cooperation of metal-acid dual sites (1.29 mmol/g), facilitating the selective hydrogenolysis and opening of the furan structure. Furthermore, the as-prepared catalyst exhibited favorable stability and recyclability. This work offers significant strategic guidance for the sustainable and high-efficiency synthesis of 1,6-HDO.
- 1 August 2026
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 3298 (1)
Open AccessConversion of 5-hydroxymethylfurfural to 1,6-hexanediol over metals supported Al-MCM-41
This research realizes the direct transformation of biomass-based 5-hydroxymethylfurfural (HMF) into high-value 1,6-hexanediol (1,6-HDO) over a bifunctional Pd/Al-MCM-41 catalyst. Various metals (Pd, Pt, and Ni) supported on Al-MCM-41 catalysts were synthesized through the incipient wetness impregnation method. Experimental findings indicated that the 7%Pd/Al-MCM-41 system demonstrates the optimized performance at 160 °C, 3 MPa H 2 and 3 h, successfully achieving an HMF conversion of 99.08% and a maximum 1,6-HDO yield of 39.45%. Characterizations via XRD, BET, and NH 3 -TPD revealed that such efficiency stems from well-dispersed Pd nanoparticles and the proper acidic properties of Al-MCM-41 support, the cooperation of metal-acid dual sites (1.29 mmol/g), facilitating the selective hydrogenolysis and opening of the furan structure. Furthermore, the as-prepared catalyst exhibited favorable stability and recyclability. This work offers significant strategic guidance for the sustainable and high-efficiency synthesis of 1,6-HDO.
- 24 February 2026
- Published by Elsevier in Chemical Engineering Science
- Vol. 327
Synthesis of asymmetric jet-fuel precursors from bio-cycloketones over Nb modified HPW
- 24 February 2026
- Published by Elsevier in Chemical Engineering Science
- Vol. 327
Synthesis of asymmetric jet-fuel precursors from bio-cycloketones over Nb modified HPW
- 11 December 2025
- Published by American Chemical Society (ACS) in ACS Sustainable Chemistry & Engineering
- Vol. 13 (50) , 21556-21567
Direct Conversion of Furfural to 1,5-Pentanediol over Zr-Doped CuCo-Based Catalyst
- 11 December 2025
- Published by American Chemical Society (ACS) in ACS Sustainable Chemistry & Engineering
- Vol. 13 (50) , 21556-21567
Direct Conversion of Furfural to 1,5-Pentanediol over Zr-Doped CuCo-Based Catalyst
- Open Access
- 1 September 2025
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 3102 (1)
One-pot conversion of furfural to 1,5-pentanediol over CuCoOx
This work investigates the one-pot conversion of furfural to 1,5-pentanediol using Cu-Co bimetallic oxide catalysts. The Cu4.5Co3.5Ox catalyst was prepared via co-precipitation, achieving a 1,5-pentanediol yield of 27.2%. Characterization techniques revealed that the activity of the catalyst is due to the synergistic interaction between Cu and Co, the electronic transfer between Cu and Co, along with a high density of medium-strength and strong acid sites. This work provides a basic data reference for rational catalyst design in the selective hydrogenation of biomass compounds, contributing to sustainable and green chemistry.
- 1 September 2025
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 3102 (1)
Open AccessOne-pot conversion of furfural to 1,5-pentanediol over CuCoOx
This work investigates the one-pot conversion of furfural to 1,5-pentanediol using Cu-Co bimetallic oxide catalysts. The Cu4.5Co3.5Ox catalyst was prepared via co-precipitation, achieving a 1,5-pentanediol yield of 27.2%. Characterization techniques revealed that the activity of the catalyst is due to the synergistic interaction between Cu and Co, the electronic transfer between Cu and Co, along with a high density of medium-strength and strong acid sites. This work provides a basic data reference for rational catalyst design in the selective hydrogenation of biomass compounds, contributing to sustainable and green chemistry.
- Open Access
- 1 August 2025
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 3092 (1)
Preparation of high-density fuel precursors via aldol condensation of cyclopentanone and cyclohexanone catalyzed by phosphotungstic acid metal oxide catalysts
In recent years, the production of bio-based high-density fuels using renewable biomass resources has attracted increasing attention. This study investigates the physical structure and acidic properties of phosphotungstic acid (HPW) doped with various metal oxides (HfO2, ZrO2, Al2O3, SnO2) for the aldol condensation of cyclopentanone and cyclohexanone to prepare bio-based high-density fuel precursors. Characterized by N2 adsorption-desorption and NH3-TPD, significant changes in surface area, pore volume, and acid site distribution were observed. The HPW-SnO2 catalyst exhibited the highest specific surface area (40 m2/g) and moderate total acidity (1.18 mmol⋅g−1), while HPW-Al2O3 showed the highest total acidity (1.53 mmol⋅g−1) with a balanced distribution of weak, medium, and strong acid sites. The conversion rates of cyclopentanone and cyclohexanone for HPW-SnO2 were 74.4% and 90.9%, respectively, and the yields of 2-rings and 3-rings were 65.1% and 70.9%, respectively. The superior performance of HPW-SnO2 is attributed to its large acid amount and the largest specific surface area, which are conducive to the good dispersion of active sites of the catalyst. In contrast, HPW-HfO2 exhibited the lowest acidity (0.17 mmol⋅g−1) and low surface area (5 m2/g), with conversion rates of cyclopentanone and cyclohexanone both less than 5%, and yields of 2-rings and 3-rings at 2.0%. The experimental results demonstrate the synergistic effect of the structural characteristics and acid strength of the catalysts in promoting ketone aldol condensation. These findings provide insights into the rational design of catalysts used in acid-driven aldol condensation reactions for the preparation of high-density fuel precursors.
- 1 August 2025
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 3092 (1)
Open AccessPreparation of high-density fuel precursors via aldol condensation of cyclopentanone and cyclohexanone catalyzed by phosphotungstic acid metal oxide catalysts
In recent years, the production of bio-based high-density fuels using renewable biomass resources has attracted increasing attention. This study investigates the physical structure and acidic properties of phosphotungstic acid (HPW) doped with various metal oxides (HfO2, ZrO2, Al2O3, SnO2) for the aldol condensation of cyclopentanone and cyclohexanone to prepare bio-based high-density fuel precursors. Characterized by N2 adsorption-desorption and NH3-TPD, significant changes in surface area, pore volume, and acid site distribution were observed. The HPW-SnO2 catalyst exhibited the highest specific surface area (40 m2/g) and moderate total acidity (1.18 mmol⋅g−1), while HPW-Al2O3 showed the highest total acidity (1.53 mmol⋅g−1) with a balanced distribution of weak, medium, and strong acid sites. The conversion rates of cyclopentanone and cyclohexanone for HPW-SnO2 were 74.4% and 90.9%, respectively, and the yields of 2-rings and 3-rings were 65.1% and 70.9%, respectively. The superior performance of HPW-SnO2 is attributed to its large acid amount and the largest specific surface area, which are conducive to the good dispersion of active sites of the catalyst. In contrast, HPW-HfO2 exhibited the lowest acidity (0.17 mmol⋅g−1) and low surface area (5 m2/g), with conversion rates of cyclopentanone and cyclohexanone both less than 5%, and yields of 2-rings and 3-rings at 2.0%. The experimental results demonstrate the synergistic effect of the structural characteristics and acid strength of the catalysts in promoting ketone aldol condensation. These findings provide insights into the rational design of catalysts used in acid-driven aldol condensation reactions for the preparation of high-density fuel precursors.
- 29 April 2024
- Published by Springer Nature in Reaction Kinetics, Mechanisms and Catalysis
- Vol. 137 (4) , 1911-1925
Insight into the competitiveness of C–C coupling reactions of 5-hydroxymethylfurfural with lignocellulosic compounds in one pot
- 29 April 2024
- Published by Springer Nature in Reaction Kinetics, Mechanisms and Catalysis
- Vol. 137 (4) , 1911-1925
Insight into the competitiveness of C–C coupling reactions of 5-hydroxymethylfurfural with lignocellulosic compounds in one pot
- Open Access
- 31 March 2023
- Published by MDPI AG in Sustainability
- Vol. 15 (7) , 6057
Understanding the Inhibition Mechanism of Lignin Adsorption to Cellulase in Terms of Changes in Composition and Conformation of Free Enzymes
The adsorption of lignin to cellulase is the major obstacle in the sugar-platform conversion of lignocellulosic bioresources. In this study, the adsorption behavior of untreated and pretreated lignin samples from corn stover to cellulase was investigated, in particular the effects of lignin adsorption on the composition and spatial conformation of free enzymes were explored. The results showed that pretreatments decreased the hydrophobic groups contents of lignin, i.e., aromatic ring, ether and carbonyl, as well as the content of ionizable group, i.e., carboxyl, which reduced its hydrophobicity and negative charge density, thus weakening the adsorption ability of lignin to cellulase. The lignin samples mainly adsorbed the CBHII component of cellulase to inhibit the synergistic effect of free enzymes. Lignin adsorption altered the spatial position of tryptophan residues in free enzymes, exposing them to the protein surface. In addition, the secondary structure of free enzymes was altered, with a decrease in the alpha-helix content and an increase in the random coil content, thus loosening the spatial conformation of free enzymes. The change degree in the spatial structure of free enzymes correlated with the adsorption capacity of the lignin, i.e., lignin with low adsorption capacity caused the least damage to free enzyme, with NaOH pretreated lignin being the best. It appears that appropriate pretreatment and chemical modification of enzymes to resist lignin adsorption is a promising long-term pathway to overcome the lignin inhibition during sugar-platform conversion of lignocellulosic bioresources.
- 31 March 2023
- Published by MDPI AG in Sustainability
- Vol. 15 (7) , 6057
Open AccessUnderstanding the Inhibition Mechanism of Lignin Adsorption to Cellulase in Terms of Changes in Composition and Conformation of Free Enzymes
The adsorption of lignin to cellulase is the major obstacle in the sugar-platform conversion of lignocellulosic bioresources. In this study, the adsorption behavior of untreated and pretreated lignin samples from corn stover to cellulase was investigated, in particular the effects of lignin adsorption on the composition and spatial conformation of free enzymes were explored. The results showed that pretreatments decreased the hydrophobic groups contents of lignin, i.e., aromatic ring, ether and carbonyl, as well as the content of ionizable group, i.e., carboxyl, which reduced its hydrophobicity and negative charge density, thus weakening the adsorption ability of lignin to cellulase. The lignin samples mainly adsorbed the CBHII component of cellulase to inhibit the synergistic effect of free enzymes. Lignin adsorption altered the spatial position of tryptophan residues in free enzymes, exposing them to the protein surface. In addition, the secondary structure of free enzymes was altered, with a decrease in the alpha-helix content and an increase in the random coil content, thus loosening the spatial conformation of free enzymes. The change degree in the spatial structure of free enzymes correlated with the adsorption capacity of the lignin, i.e., lignin with low adsorption capacity caused the least damage to free enzyme, with NaOH pretreated lignin being the best. It appears that appropriate pretreatment and chemical modification of enzymes to resist lignin adsorption is a promising long-term pathway to overcome the lignin inhibition during sugar-platform conversion of lignocellulosic bioresources.