Shuai Zhang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Shuai Zhang has a total of 21 co-authors. Here are the top co-authors by number of shared publications:
- Wenping Geng
Science and Technology on Electronic Test and Measurement Laboratory, North University of China, Taiyuan 030051, China
3 shared publications - Xiujian Chou
State Key Laboratory of Extreme Environment Optoelectronic Dynamic Measurement Technology and Instrument, North University of China, Taiyuan 030051, China
3 shared publications - Kaixi Bi
School of Semiconductors and Physics, North University of China, Taiyuan 030051, China
2 shared publications - Linyu Mei
North University of China
2 shared publications - Qiannan Li
School of Mechanical Engineering, North University of China, Taiyuan 030051, China
2 shared publications - Shuqi Han
Shanxi Province Key Laboratory of Quantum Sensing and Precision Measurement, North University of China, Taiyuan, Shanxi, China
2 shared publications
Latest Publications
- 10 April 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Sensors Journal
- Vol. 24 (10) , 15918-15926
Flexoelectricity-Enabled Modulation of Fermi Level in Graphene/PZT Heterostructure for Weak Pressure Signals Sensor
The flexoelectricity polarization of nanoscale dimensions has a natural advantage in realizing highly sensitive pressure sensors in two-dimensional. Further, as typical Two-dimensional material materials, graphene was often combined for pressure sensors. As the result of a high dielectric constant, PZT nanofilm could produce large surface polarization potential when subjected to external weak force. Then fermi level graphene on the surface of PZT film can be regulated by polarization electric field, which weak pressure signals sensor. We report on a novel graphene-based PZT pressure sensor with high sensitivity, fast response time, and weak pressure signals based on the flexoelectricity enhancement effect. Simulation of the Graphene/PZT composite structure by COMSOL Multiphysics and MATLAB indicates that the strain gradient of the PZT film is as high as 10 5 . Combining the high flexoelectricity coefficient of PZT with outstanding carrier transport of graphene, graphene-based PZT pressure sensor except high sensor expect exhibition highly sensitive, with an average sensitivity of 0.01 kPa -1 , a faster response time as 0.06s, and signal-to-noise(S/N) ratio is 61.9 dB in the range of pressure from 0.098 kPa to 9.8kPa. When compared with conventional pressure sensors, the sensors have orders of magnitude higher sensitivity. This Graphene/PZT-based pressure sensor will have great potentials for highly sensitive weak pressure signal detection.
- 10 April 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Sensors Journal
- Vol. 24 (10) , 15918-15926
Flexoelectricity-Enabled Modulation of Fermi Level in Graphene/PZT Heterostructure for Weak Pressure Signals Sensor
The flexoelectricity polarization of nanoscale dimensions has a natural advantage in realizing highly sensitive pressure sensors in two-dimensional. Further, as typical Two-dimensional material materials, graphene was often combined for pressure sensors. As the result of a high dielectric constant, PZT nanofilm could produce large surface polarization potential when subjected to external weak force. Then fermi level graphene on the surface of PZT film can be regulated by polarization electric field, which weak pressure signals sensor. We report on a novel graphene-based PZT pressure sensor with high sensitivity, fast response time, and weak pressure signals based on the flexoelectricity enhancement effect. Simulation of the Graphene/PZT composite structure by COMSOL Multiphysics and MATLAB indicates that the strain gradient of the PZT film is as high as 10 5 . Combining the high flexoelectricity coefficient of PZT with outstanding carrier transport of graphene, graphene-based PZT pressure sensor except high sensor expect exhibition highly sensitive, with an average sensitivity of 0.01 kPa -1 , a faster response time as 0.06s, and signal-to-noise(S/N) ratio is 61.9 dB in the range of pressure from 0.098 kPa to 9.8kPa. When compared with conventional pressure sensors, the sensors have orders of magnitude higher sensitivity. This Graphene/PZT-based pressure sensor will have great potentials for highly sensitive weak pressure signal detection.
- Open Access
- 19 March 2023
- Published by MDPI AG in Nanomaterials
- Vol. 13 (6) , 1103
Nanoelectromechanical Temperature Sensor Based on Piezoresistive Properties of Suspended Graphene Film
The substrate impurities scattering will lead to unstable temperature-sensitive behavior and poor linearity in graphene temperature sensors. And this can be weakened by suspending the graphene structure. Herein, we report a graphene temperature sensing structure, with suspended graphene membranes fabricated on the cavity and non-cavity SiO2/Si substrate, using monolayer, few-layer, and multilayer graphene. The results show that the sensor provides direct electrical readout from temperature to resistance transduction by the nano piezoresistive effect in graphene. And the cavity structure can weaken the substrate impurity scattering and thermal resistance effect, which results in better sensitivity and wide-range temperature sensing. In addition, monolayer graphene is almost no temperature sensitivity. And the few-layer graphene temperature sensitivity, lower than that of the multilayer graphene cavity structure (3.50%/°C), is 1.07%/°C. This work demonstrates that piezoresistive in suspended graphene membranes can effectively enhance the sensitivity and widen the temperature sensor range in NEMS temperature sensors.
- 19 March 2023
- Published by MDPI AG in Nanomaterials
- Vol. 13 (6) , 1103
Open AccessNanoelectromechanical Temperature Sensor Based on Piezoresistive Properties of Suspended Graphene Film
The substrate impurities scattering will lead to unstable temperature-sensitive behavior and poor linearity in graphene temperature sensors. And this can be weakened by suspending the graphene structure. Herein, we report a graphene temperature sensing structure, with suspended graphene membranes fabricated on the cavity and non-cavity SiO2/Si substrate, using monolayer, few-layer, and multilayer graphene. The results show that the sensor provides direct electrical readout from temperature to resistance transduction by the nano piezoresistive effect in graphene. And the cavity structure can weaken the substrate impurity scattering and thermal resistance effect, which results in better sensitivity and wide-range temperature sensing. In addition, monolayer graphene is almost no temperature sensitivity. And the few-layer graphene temperature sensitivity, lower than that of the multilayer graphene cavity structure (3.50%/°C), is 1.07%/°C. This work demonstrates that piezoresistive in suspended graphene membranes can effectively enhance the sensitivity and widen the temperature sensor range in NEMS temperature sensors.
- Open Access
Patterned Graphene-Based Metamaterials for Terahertz Wave Absorption
Graphene-based metamaterials have been widely applied in optoelectronic devices, optical modulators, and chemical sensors due to the outstanding tunability and optical response in the terahertz (THz) region. Here, tunable THz metamaterial absorbers based on patterned graphene are designed, fabricated, and modulated. The proposed metamaterial absorbers are constructed by the top layer of patterned graphene arrays and the aluminum (Al) film separated by polyimide (PI). The different THz absorption spectra can be acquired by changing the patterns of graphene. In order to verify the simulation results, a series of tests were conducted by THz time-domain spectrometer (THz-TDS) systems. The proposed absorbers are able to be insensitive to the angle of the incident wave. Besides, chemical doping is applied to turn the Fermi level of graphene and the absorption performance is promoted with the increase of the Fermi level. The experimental results have been demonstrated to have associated resonant peaks with the simulation results. The aim of this paper is to exhibit a systematic study on graphene-based THz metamaterial absorbers, including the simulation and experiments. By comparing the simulation and experimental results, it is useful to clarify the relevant theories and manufacturing processes. The work will provide a further step in the development of high-performance terahertz devices, including tunable absorbers, sensors, and electro-optic switches.
Open AccessPatterned Graphene-Based Metamaterials for Terahertz Wave Absorption
Graphene-based metamaterials have been widely applied in optoelectronic devices, optical modulators, and chemical sensors due to the outstanding tunability and optical response in the terahertz (THz) region. Here, tunable THz metamaterial absorbers based on patterned graphene are designed, fabricated, and modulated. The proposed metamaterial absorbers are constructed by the top layer of patterned graphene arrays and the aluminum (Al) film separated by polyimide (PI). The different THz absorption spectra can be acquired by changing the patterns of graphene. In order to verify the simulation results, a series of tests were conducted by THz time-domain spectrometer (THz-TDS) systems. The proposed absorbers are able to be insensitive to the angle of the incident wave. Besides, chemical doping is applied to turn the Fermi level of graphene and the absorption performance is promoted with the increase of the Fermi level. The experimental results have been demonstrated to have associated resonant peaks with the simulation results. The aim of this paper is to exhibit a systematic study on graphene-based THz metamaterial absorbers, including the simulation and experiments. By comparing the simulation and experimental results, it is useful to clarify the relevant theories and manufacturing processes. The work will provide a further step in the development of high-performance terahertz devices, including tunable absorbers, sensors, and electro-optic switches.