Ju Sung Kim
Ju Sung Kim has a total of 8 co-authors. Here are the top co-authors by number of shared publications:
Bo Woo Nam
1 shared publication- Bo Woo Nam
Associate Professor, Department of Naval Architecture and Ocean Engineering, Seoul National University, Seoul, Republic of Korea
1 shared publication - Gisu Song
Korea Maritime & Ocean Univ, Div Naval Architecture & Ocean Syst Engn, Busan, South Korea
1 shared publication - Hyo-Jin Park
Department of Naval Architecture and Ocean Engineering, Seoul National University, Seoul, Republic of Korea
1 shared publication - Jae Min Jeon
Graduate student Department of Naval Architecture and Ocean Engineering Seoul National University Seoul Korea
1 shared publication - Jeong-Seok Kim
Korea Research Institute of Ships and Ocean Engineering (KRISO), 1312-32 Yuseong-daero, Yuseong-gu, Daejeon 34103, Korea
1 shared publication
Latest Publications
- Open Access
- 28 February 2026
- Published by The Korean Society of Ocean Engineers in Journal of Ocean Engineering and Technology
- Vol. 40 (1) , 9-23
CFD Simulation for Green Water Events on KFPSO Using Design Wave Methods
Under extreme environmental conditions, large relative motions of a floating production storage and offloading unit (FPSO) can lead to green water events, which poses a significant risk of structural damage to topside equipment and deck structures. In this study, the green water height was quantitatively evaluated under design wave conditions using computational fluid dynamics (CFD) simulations. First, the CFD simulation setup was validated by comparing the relative wave elevations obtained from both experimental and CFD results. Subsequently, three types of design waves – regular design wave, New Wave, and most likely extreme response (MLER) wave - were employed to investigate the characteristics of green water at 71 deck positions through local motion response and wave pattern analysis. The maximum height of green water on the deck was observed when the relative wave motion exceeded the deck level through the bow flare, with the highest values occurring under the regular design wave condition, followed by the MLER and then New Wave conditions. It is concluded that the MLER method, based on the relative wave motion RAOs, offers a superior design wave approach for green water estimation compared to the regular design wave and New Wave methods.
- 28 February 2026
- Published by The Korean Society of Ocean Engineers in Journal of Ocean Engineering and Technology
- Vol. 40 (1) , 9-23
Open AccessCFD Simulation for Green Water Events on KFPSO Using Design Wave Methods
Under extreme environmental conditions, large relative motions of a floating production storage and offloading unit (FPSO) can lead to green water events, which poses a significant risk of structural damage to topside equipment and deck structures. In this study, the green water height was quantitatively evaluated under design wave conditions using computational fluid dynamics (CFD) simulations. First, the CFD simulation setup was validated by comparing the relative wave elevations obtained from both experimental and CFD results. Subsequently, three types of design waves – regular design wave, New Wave, and most likely extreme response (MLER) wave - were employed to investigate the characteristics of green water at 71 deck positions through local motion response and wave pattern analysis. The maximum height of green water on the deck was observed when the relative wave motion exceeded the deck level through the bow flare, with the highest values occurring under the regular design wave condition, followed by the MLER and then New Wave conditions. It is concluded that the MLER method, based on the relative wave motion RAOs, offers a superior design wave approach for green water estimation compared to the regular design wave and New Wave methods.
- 3 December 2023
- Published by Elsevier in Ocean Engineering
- Vol. 291
ANN-based prediction models for green water events around a FPSO in irregular waves
- 3 December 2023
- Published by Elsevier in Ocean Engineering
- Vol. 291
ANN-based prediction models for green water events around a FPSO in irregular waves
- Open Access
- 31 December 2022
- Published by The Korean Society of Ocean Engineers in Journal of Ocean Engineering and Technology
- Vol. 36 (6) , 353-363
Designation of the Boundary Conditions for Estimating the Thrust Loss due to Thruster-Hull Interactions
The azimuth thruster is mainly installed on a vessel that requires a dynamic positioning (DP) function for special purposes. When the azimuth thruster on a vessel operates for DP, the thrust loss is induced by the thruster-hull interaction. This study examined the influence of boundary conditions in numerical simulations for predicting thrust loss. Wind turbine installation vessels (WTIV) and floating production storage and offloading (FPSO) were chosen as a target vessels. In this study, two types of boundaries were defined. The first consideration is that the boundary condition was assigned with consideration of the azimuth angle of the thruster, whereas it is fixed regardless azimuth angle of the thruster. The predicted thrust loss according to these boundary conditions showed a difference. This observation originated from the current load of the vessel. Therefore, the boundary conditions for which the current load is not induced need to be designated to obtain a realistic thrust loss in a numerical simulation.
- 31 December 2022
- Published by The Korean Society of Ocean Engineers in Journal of Ocean Engineering and Technology
- Vol. 36 (6) , 353-363
Open AccessDesignation of the Boundary Conditions for Estimating the Thrust Loss due to Thruster-Hull Interactions
The azimuth thruster is mainly installed on a vessel that requires a dynamic positioning (DP) function for special purposes. When the azimuth thruster on a vessel operates for DP, the thrust loss is induced by the thruster-hull interaction. This study examined the influence of boundary conditions in numerical simulations for predicting thrust loss. Wind turbine installation vessels (WTIV) and floating production storage and offloading (FPSO) were chosen as a target vessels. In this study, two types of boundaries were defined. The first consideration is that the boundary condition was assigned with consideration of the azimuth angle of the thruster, whereas it is fixed regardless azimuth angle of the thruster. The predicted thrust loss according to these boundary conditions showed a difference. This observation originated from the current load of the vessel. Therefore, the boundary conditions for which the current load is not induced need to be designated to obtain a realistic thrust loss in a numerical simulation.