Hao Zhang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Hao Zhang has a total of 12 co-authors. Here are the top co-authors by number of shared publications:
- Qifei Du
National Space Science Center, Chinese Academy of Sciences (NSSC/CAS), Beijing 100190, China
3 shared publications - Cheng Liu
National Space Science Center, Beijing 100190, China
2 shared publications - Yue Ma
National Space Science Center, Beijing 100190, China
2 shared publications - Dongwei Wang
National Space Science Center, Chinese Academy of Sciences, Beijing 100190, China
1 shared publication - Jinhuan Li
Shanghai Institute of Satellite Engineering, Shanghai 200240, China
1 shared publication - Junming Xia
Beijing Key Laboratory of Space Environment Exploration, National Space Science Center, Chinese Academy of Sciences (NSSC/CAS), Beijing 100190, China
1 shared publication
Latest Publications
- Open Access
- 22 June 2026
- Published by MDPI AG in Electronics
- Vol. 15 (12) , 2734
In-Orbit Calibration of Phased Array Antennas Using GNSS Carrier-Phase Measurements
This paper proposes a passive in-orbit calibration method for phased array antennas using GNSS carrier-phase measurements. By performing synchronous observation and exploiting the short-baseline property between the positioning antenna and array elements, the first differencing operation eliminates space propagation errors and clock biases. By further utilizing receiver channel consistency, the second differencing operation cancels out the receiver channel errors, thereby extracting the relative receive-chain phase error of the element under test. Under typical operating conditions, the calibration accuracy can reach an RMS error of approximately , corresponding to a phase accuracy of in the GPS L1 band. This accuracy is close to the minimum phase step of a 6-bit digital phase shifter, and can be further improved under higher and well-controlled residual error conditions. Without requiring a dedicated GNSS band excitation signal, this method avoids co-frequency self-interference with the positioning antenna, which provides an auxiliary approach for in-orbit calibration of phased array receive chains.- 22 June 2026
- Published by MDPI AG in Electronics
- Vol. 15 (12) , 2734
Open AccessIn-Orbit Calibration of Phased Array Antennas Using GNSS Carrier-Phase Measurements
This paper proposes a passive in-orbit calibration method for phased array antennas using GNSS carrier-phase measurements. By performing synchronous observation and exploiting the short-baseline property between the positioning antenna and array elements, the first differencing operation eliminates space propagation errors and clock biases. By further utilizing receiver channel consistency, the second differencing operation cancels out the receiver channel errors, thereby extracting the relative receive-chain phase error of the element under test. Under typical operating conditions, the calibration accuracy can reach an RMS error of approximately , corresponding to a phase accuracy of in the GPS L1 band. This accuracy is close to the minimum phase step of a 6-bit digital phase shifter, and can be further improved under higher and well-controlled residual error conditions. Without requiring a dedicated GNSS band excitation signal, this method avoids co-frequency self-interference with the positioning antenna, which provides an auxiliary approach for in-orbit calibration of phased array receive chains. - Open Access
- 29 December 2023
- Published by MDPI AG in Electronics
- Vol. 13 (1) , 166
A Miniaturized Bandpass Filter with Wideband and High Stopband Rejection Using LTCC Technology
This paper designs an L-band wide stopband bandpass filter by applying low-temperature cofired ceramic (LTCC) technology to the global positioning system (GPS) frequency band. Taking the Chebyshev filter as a prototype, an equivalent collector element (capacitive and inductor) structure is adopted to fully use the three-dimensional package structure of LTCC to reduce the filter size. The filter is integrated into an eight-layer LTCC dielectric, and the series–parallel connection of the collector elements in the resonance unit is utilized to produce out-of-band transmission zeros, while the input and output ports’ capacitance is adjusted to control the bandwidth. Harmonic suppression is achieved by cascading two new compact stopband filters, while the size increase is insignificant due to LTCC technology. The simulation results are as follows: the center frequency is 1.575 GHz, 1 dB relative bandwidth is 6.3%, insertion loss in the passband is as slight as 1.6 dB, return loss is better than 30 dB, rejection bandwidth up to 16 GHz is more than 44 dB, and the volume of the whole filter is 6.2 × 3.7 × 0.78 .- 29 December 2023
- Published by MDPI AG in Electronics
- Vol. 13 (1) , 166
Open AccessA Miniaturized Bandpass Filter with Wideband and High Stopband Rejection Using LTCC Technology
This paper designs an L-band wide stopband bandpass filter by applying low-temperature cofired ceramic (LTCC) technology to the global positioning system (GPS) frequency band. Taking the Chebyshev filter as a prototype, an equivalent collector element (capacitive and inductor) structure is adopted to fully use the three-dimensional package structure of LTCC to reduce the filter size. The filter is integrated into an eight-layer LTCC dielectric, and the series–parallel connection of the collector elements in the resonance unit is utilized to produce out-of-band transmission zeros, while the input and output ports’ capacitance is adjusted to control the bandwidth. Harmonic suppression is achieved by cascading two new compact stopband filters, while the size increase is insignificant due to LTCC technology. The simulation results are as follows: the center frequency is 1.575 GHz, 1 dB relative bandwidth is 6.3%, insertion loss in the passband is as slight as 1.6 dB, return loss is better than 30 dB, rejection bandwidth up to 16 GHz is more than 44 dB, and the volume of the whole filter is 6.2 × 3.7 × 0.78 . - Open Access
- 2 January 2023
- Published by MDPI AG in Electronics
- Vol. 12 (1) , 224
A Low Phase Noise Frequency Synthesizer with a Fourth-Order RLC Loop Filter
The current work employs the HMC830 phase-locked loop chip to design a frequency synthesizer operating in the L-band. The frequency synthesizer can provide a local oscillation signal for the RF receiver front end. This article employs the phase-locked synthesis technique to describe the design scheme. Due to the advantages of the passive loop filters, such as simplicity, low cost, and low phase noise, a passive fourth-order RLC loop filter is proposed to improve the output signal quality and reduce phase noise. The performance of this loop filter is compared with the passive fourth-order RC loop filter. The effects of these two loop filters on phase noise, loop capture time, and spur suppression are analyzed. Subsequently, the design scheme, simulation analysis, and test results of the frequency synthesizer are presented under these two loop filters. The test results indicate that the passive fourth-order RLC loop filter outperforms the passive fourth-order RC loop filter; its output signal phase noise is higher than −100 dBc/Hz@1 kHz, loop capture time is less than 100 us, and spur suppression is better than 60 dBc. This frequency synthesizer can provide high-performance local oscillation signals for wireless communication equipment such as transmitters and receivers. It meets the application requirements of many radio communication circuit structures and has good application prospects.
- 2 January 2023
- Published by MDPI AG in Electronics
- Vol. 12 (1) , 224
Open AccessA Low Phase Noise Frequency Synthesizer with a Fourth-Order RLC Loop Filter
The current work employs the HMC830 phase-locked loop chip to design a frequency synthesizer operating in the L-band. The frequency synthesizer can provide a local oscillation signal for the RF receiver front end. This article employs the phase-locked synthesis technique to describe the design scheme. Due to the advantages of the passive loop filters, such as simplicity, low cost, and low phase noise, a passive fourth-order RLC loop filter is proposed to improve the output signal quality and reduce phase noise. The performance of this loop filter is compared with the passive fourth-order RC loop filter. The effects of these two loop filters on phase noise, loop capture time, and spur suppression are analyzed. Subsequently, the design scheme, simulation analysis, and test results of the frequency synthesizer are presented under these two loop filters. The test results indicate that the passive fourth-order RLC loop filter outperforms the passive fourth-order RC loop filter; its output signal phase noise is higher than −100 dBc/Hz@1 kHz, loop capture time is less than 100 us, and spur suppression is better than 60 dBc. This frequency synthesizer can provide high-performance local oscillation signals for wireless communication equipment such as transmitters and receivers. It meets the application requirements of many radio communication circuit structures and has good application prospects.