Fariborz Taghipour
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Fariborz Taghipour has a total of 47 co-authors. Here are the top co-authors by number of shared publications:
Madjid Mohseni
Department of Chemical and Biological Engineering, The University of British Columbia, 2360 East Mall, Vancouver, BC V6T 1Z3, Canada
6 shared publications- Babak Adeli
Chemical & Biological Engineering Department The University of British Columbia Vancouver British Columbia V6T 1Z4 Canada
4 shared publications Babak Adeli
Chemical and Biological Engineering Department University of British Columbia Vancouver V6T 1Z3 British Columbia Canada
3 shared publicationsEhsan Espid
Department of Chemical and Biological Engineering, University of British Columbia, Vancouver, BC, Canada
3 shared publications- José Esteban Durán Herrera
Universidad de Costa Rica
3 shared publications Muersha Wusiman
Chemical and Biological Engineering, University of British Columbia, Vancouver, Canada
3 shared publications
Latest Publications
- Open Access
- 31 March 2026
- Published by Elsevier in Analytica Chimica Acta
- Vol. 1405, 345457
High performance H2S gas sensor with UV-activated CuO nanosheets
- 31 March 2026
- Published by Elsevier in Analytica Chimica Acta
- Vol. 1405, 345457
Open AccessHigh performance H2S gas sensor with UV-activated CuO nanosheets
- Open Access
- 25 February 2026
- Published by Elsevier in Analytica Chimica Acta
- Vol. 1399, 345299
UV-activated biosensor based on molecularly imprinted polymer and carbon quantum dots for lactate measurement
- 25 February 2026
- Published by Elsevier in Analytica Chimica Acta
- Vol. 1399, 345299
Open AccessUV-activated biosensor based on molecularly imprinted polymer and carbon quantum dots for lactate measurement
- Open Access
- 5 November 2025
- Published by Elsevier in Sensors and Actuators Reports
- Vol. 10
Photo-induced chemiresistive sensor for lactate and glucose monitoring
- 5 November 2025
- Published by Elsevier in Sensors and Actuators Reports
- Vol. 10
Open AccessPhoto-induced chemiresistive sensor for lactate and glucose monitoring
- Open Access
- 14 May 2025
- Published by Elsevier in Journal of Environmental Management
- Vol. 386, 125678
Ultraviolet light-emitting diode (UV-LED) water disinfection photoreactors: A review
- 14 May 2025
- Published by Elsevier in Journal of Environmental Management
- Vol. 386, 125678
Open AccessUltraviolet light-emitting diode (UV-LED) water disinfection photoreactors: A review
- Open Access
- 25 November 2024
- Published by Springer Nature in Microsystems & Nanoengineering
- Vol. 10 (1) , 1-13
Molecularly imprinted fluorescence sensor chip for lactate measurement
Lactate measurements provide an opportunity to conveniently evaluate bodily functions and sports performance. A molecularly imprinted fluorescence biochip provides an innovative way to achieve lactate measurement and overcomes the limitations of enzyme-based sensors. To realize this goal, ZnO quantum dots (QDs), a biocompatible sensing material, were combined with selective receptors comprised of molecularly imprinted polymers (MIPs). The lactate-selective imprinted polymers were formed using 3-aminopropyltriethoxysilane (APTES) and 5-indolyl boronic acid monomers. Furthermore, a new solid-phase sensing platform that overcomes the limitations of liquid-based sensors was developed to detect lactate in real-time. The platform consists of the biosensor chip with a thin-film sensing layer, an ultraviolet (UV) excitation source, and a portable light detector. The final sensor has a sensitivity of 0.0217 mmol L-1 for 0–30 mmol L-1 of lactate in phosphate-buffered saline (PBS) with a correlation coefficient of 0.97. The high sensor sensitivity and selectivity demonstrates the applicability of the ZnO QDs and synthetic receptors for sweat analysis.
- 25 November 2024
- Published by Springer Nature in Microsystems & Nanoengineering
- Vol. 10 (1) , 1-13
Open AccessMolecularly imprinted fluorescence sensor chip for lactate measurement
Lactate measurements provide an opportunity to conveniently evaluate bodily functions and sports performance. A molecularly imprinted fluorescence biochip provides an innovative way to achieve lactate measurement and overcomes the limitations of enzyme-based sensors. To realize this goal, ZnO quantum dots (QDs), a biocompatible sensing material, were combined with selective receptors comprised of molecularly imprinted polymers (MIPs). The lactate-selective imprinted polymers were formed using 3-aminopropyltriethoxysilane (APTES) and 5-indolyl boronic acid monomers. Furthermore, a new solid-phase sensing platform that overcomes the limitations of liquid-based sensors was developed to detect lactate in real-time. The platform consists of the biosensor chip with a thin-film sensing layer, an ultraviolet (UV) excitation source, and a portable light detector. The final sensor has a sensitivity of 0.0217 mmol L-1 for 0–30 mmol L-1 of lactate in phosphate-buffered saline (PBS) with a correlation coefficient of 0.97. The high sensor sensitivity and selectivity demonstrates the applicability of the ZnO QDs and synthetic receptors for sweat analysis.
- Open Access
- 24 February 2024
- Published by Elsevier in Journal of Photochemistry and Photobiology A: Chemistry
- Vol. 451
UV-activated semiconductor gas sensor response measurement for formaldehyde detection
- 24 February 2024
- Published by Elsevier in Journal of Photochemistry and Photobiology A: Chemistry
- Vol. 451
Open AccessUV-activated semiconductor gas sensor response measurement for formaldehyde detection
Enhanced Photocatalytic CO2 Reduction by Amine Functionalization of Graphitic Carbon Nitride
Graphitic carbon nitride (g‐CN) is a promising photocatalyst for solar fuel generation, but its charge carrier mobility, charge recombination, and CO2 reduction/H2 evolution efficacy and selectivity are a strong function of the synthesis and postsynthesis techniques employed. Protonation and phosphorous doping of g‐CN yield promise visible light activities, promoting enhanced CO2 reduction and hydrogen evolution. However, the amine‐functionalized surface chemistry of g‐CN gains little attention in open literature. Herein, g‐CN and phosphorus‐doped g‐CN are synthesized via facile one‐pot pyrolysis and subjected to protonation postsynthesis to quantify the influence of common strategies on surface amine content and photocatalyst activity for H2 evolution and CO2 reduction. Material characterization confirms the exfoliation of the photocatalyst and change in the amine functionalization of the surface. The amorphous phosphorus‐doped g‐CN material exhibits a high number of surface amine groups, increasing the adsorption prior to reduction and enhancing selectivity for CO2 reduction.
Enhanced Photocatalytic CO2 Reduction by Amine Functionalization of Graphitic Carbon Nitride
Graphitic carbon nitride (g‐CN) is a promising photocatalyst for solar fuel generation, but its charge carrier mobility, charge recombination, and CO2 reduction/H2 evolution efficacy and selectivity are a strong function of the synthesis and postsynthesis techniques employed. Protonation and phosphorous doping of g‐CN yield promise visible light activities, promoting enhanced CO2 reduction and hydrogen evolution. However, the amine‐functionalized surface chemistry of g‐CN gains little attention in open literature. Herein, g‐CN and phosphorus‐doped g‐CN are synthesized via facile one‐pot pyrolysis and subjected to protonation postsynthesis to quantify the influence of common strategies on surface amine content and photocatalyst activity for H2 evolution and CO2 reduction. Material characterization confirms the exfoliation of the photocatalyst and change in the amine functionalization of the surface. The amorphous phosphorus‐doped g‐CN material exhibits a high number of surface amine groups, increasing the adsorption prior to reduction and enhancing selectivity for CO2 reduction.
- Open Access
Solar Fuel Generation by 2D Self‐Assembled g‐C3N4/BiVO4 Z‐Scheme
Graphitic carbon nitride (g‐CN) is a promising photocatalyst for solar fuel generation due to its medium band gap and facile synthesis from earth‐abundant materials. However, low charge carrier mobility and high charge recombination have hampered the observed rate of H2 evolution and CO2 reduction. Herein, an electrostatically self‐assembled 2D Z‐scheme heterojunction between g‐CN and bismuth vanadate (BiVO4) is investigated with and without reduced graphene oxide (rGO) acting as an electron transfer mediator to speed charge carrier mobility and hamper charge recombination. Protonation of the g‐CN surface allow for self‐assembly between 2D sheets of g‐CN, rGO, and BiVO4. The mass ratio between g‐CN and BiVO4 is incrementally adjusted to optimize synergistic charge transportation effects versus shadowing effects of multicomponent photocatalysts. Further, a selectivity effect is observed across mass ratios of photocatalyst constituents, allowing tuning of photocatalyst yield.
Open AccessSolar Fuel Generation by 2D Self‐Assembled g‐C3N4/BiVO4 Z‐Scheme
Graphitic carbon nitride (g‐CN) is a promising photocatalyst for solar fuel generation due to its medium band gap and facile synthesis from earth‐abundant materials. However, low charge carrier mobility and high charge recombination have hampered the observed rate of H2 evolution and CO2 reduction. Herein, an electrostatically self‐assembled 2D Z‐scheme heterojunction between g‐CN and bismuth vanadate (BiVO4) is investigated with and without reduced graphene oxide (rGO) acting as an electron transfer mediator to speed charge carrier mobility and hamper charge recombination. Protonation of the g‐CN surface allow for self‐assembly between 2D sheets of g‐CN, rGO, and BiVO4. The mass ratio between g‐CN and BiVO4 is incrementally adjusted to optimize synergistic charge transportation effects versus shadowing effects of multicomponent photocatalysts. Further, a selectivity effect is observed across mass ratios of photocatalyst constituents, allowing tuning of photocatalyst yield.
- 5 December 2023
- Published by Elsevier in Water Research
- Vol. 249, 120972
A solid-phase fluorescence sensor for measuring chemical species in water
- 5 December 2023
- Published by Elsevier in Water Research
- Vol. 249, 120972
A solid-phase fluorescence sensor for measuring chemical species in water