Alexander S. Chernukha
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Alexander S. Chernukha has a total of 117 co-authors. Here are the top co-authors by number of shared publications:
- Denis Alexandrovich Vinnik
Laboratory of Single Crystal Growth, South Ural State University, 454080 Chelyabinsk, Russia
9 shared publications - Gleb M. Zirnik
Moscow Institute of Physics and Technology, Dolgoprudny, Russia
8 shared publications - Svetlana A. Gudkova
Laboratory of Single Crystal Growth, South Ural State University, 454080 Chelyabinsk, Russia
7 shared publications - I.A. Solizoda4 shared publications
A.V. Trukhanov
3 shared publicationsD.A. Zherebtsov
3 shared publications
Latest Publications
- Open Access
- 4 August 2026
- Published by Elsevier in SSRN Electronic Journal
Synthesis and spectral features of Ti-substituted indium-gallium-zinc oxides In6.5-2xGa1.5Zn2+xTixO14
The use of doped IGZO materials is one of the key strategies for flexible and printed electronics. In the article, a new approach to the substitution of indium in In6.5Ga1.5Zn2O14 by titanium is proposed. The synthesis of Ti-substituted indium-gallium-zinc oxides In6.5-2xGa1.5Zn2+xTixO14 (x = 0.05, 0.1, 0.2, 0.5, 0.75 and 1) by the nitrate-glycol method, their characterization and spectral features are reported. The structure of the compounds obtained is discussed based on X-ray diffraction (XRD), scanning electron microscopy (SEM), energy-dispersive X-ray spectroscopy (EDS), differential scanning calorimetry/differential thermal analysis (DSC/DTA) and thermal resistance methods, as well as UV-Vis and X-ray photoelectron spectroscopy.
- 4 August 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessSynthesis and spectral features of Ti-substituted indium-gallium-zinc oxides In6.5-2xGa1.5Zn2+xTixO14
The use of doped IGZO materials is one of the key strategies for flexible and printed electronics. In the article, a new approach to the substitution of indium in In6.5Ga1.5Zn2O14 by titanium is proposed. The synthesis of Ti-substituted indium-gallium-zinc oxides In6.5-2xGa1.5Zn2+xTixO14 (x = 0.05, 0.1, 0.2, 0.5, 0.75 and 1) by the nitrate-glycol method, their characterization and spectral features are reported. The structure of the compounds obtained is discussed based on X-ray diffraction (XRD), scanning electron microscopy (SEM), energy-dispersive X-ray spectroscopy (EDS), differential scanning calorimetry/differential thermal analysis (DSC/DTA) and thermal resistance methods, as well as UV-Vis and X-ray photoelectron spectroscopy.
- 4 November 2025
- Published by Elsevier in Journal of Solid State Chemistry
- Vol. 354
Synthesis and phase-formation kinetic of InGaZn3O6 nano-powder
- 4 November 2025
- Published by Elsevier in Journal of Solid State Chemistry
- Vol. 354
Synthesis and phase-formation kinetic of InGaZn3O6 nano-powder
- 28 February 2025
- Published by ITMO University in Nanosystems: Physics, Chemistry, Mathematics
- Vol. 16 (1)
Synthesis and characterization of InGaZn2O5 obtained by nitrate-tartrate complex decomposition method
- 28 February 2025
- Published by ITMO University in Nanosystems: Physics, Chemistry, Mathematics
- Vol. 16 (1)
Synthesis and characterization of InGaZn2O5 obtained by nitrate-tartrate complex decomposition method
- 27 January 2025
- Published by Elsevier in Ceramics International
- Vol. 51 (12) , 16189-16200
Synthesis, phase-formation, IR and terahertz spectroscopy of bulk-InGaZnO4 obtained by metal-nitrate-glycol gel decomposition method
- 27 January 2025
- Published by Elsevier in Ceramics International
- Vol. 51 (12) , 16189-16200
Synthesis, phase-formation, IR and terahertz spectroscopy of bulk-InGaZnO4 obtained by metal-nitrate-glycol gel decomposition method
- 30 December 2024
- Published by ITMO University in Nanosystems: Physics, Chemistry, Mathematics
- Vol. 15 (6) , 806-813
Synthesis and research of physical and chemical properties of InGaZn2O5 prepared by nitrate-glycolate gel decomposition method
- 30 December 2024
- Published by ITMO University in Nanosystems: Physics, Chemistry, Mathematics
- Vol. 15 (6) , 806-813
Synthesis and research of physical and chemical properties of InGaZn2O5 prepared by nitrate-glycolate gel decomposition method
- Open Access
- 1 January 2024
- Published by FSAEIHE South Ural State University (National Research University) in Bulletin of the South Ural State University Series "Chemistry"
- Vol. 16 (3) , 161-170
Optimal composition of paste composite electrodes based on glassy carbon matrix and iron oxides.
The article considers the influence of the powder-oil ratio in the composition of paste electrodes, made of composites based on glassy carbon, on their behavior in a solution (0.1 M KCl, 0.005 M K3[Fe(CN)6], 0.005 M K4[Fe(CN)6). The obtained composite nanomaterials were studied by X-ray phase analysis, transmission and scanning electron microscopy, and X-ray spectral analysis. X-ray phase analysis showed that the sample contained graphite, magnetite Fe3O4, and cementite Fe3C. The results of scanning electron microscopy showed that particles of crystalline phases formed agglomerates ranging in size from 0.1 to 3 μm. Carbon composites were crushed and sifted through a 0.05 mm sieve, after which a paste for the electrode was prepared from the resulting powder with the ratios of the composite to vacuum oil (in mg): 80 : 5, 80 : 10, 80 : 15, 80 : 20, 80 : 25, 80 : 30. Then it was stirred into a homogeneous mass and stuffed into a tubular electrode with the 3 mm diameter. Based on a comparison of the impedance spectra and voltammograms, it has been shown that the ratio of the composite to oil that is optimal for the electrode performance is 80:10 (mass). A significant drift of the properties of freshly prepared pastes has been discovered, which is excluded by keeping them for a day before use. The decisive influence of a fresh surface before each measurement has been shown.
- 1 January 2024
- Published by FSAEIHE South Ural State University (National Research University) in Bulletin of the South Ural State University Series "Chemistry"
- Vol. 16 (3) , 161-170
Open AccessOptimal composition of paste composite electrodes based on glassy carbon matrix and iron oxides.
The article considers the influence of the powder-oil ratio in the composition of paste electrodes, made of composites based on glassy carbon, on their behavior in a solution (0.1 M KCl, 0.005 M K3[Fe(CN)6], 0.005 M K4[Fe(CN)6). The obtained composite nanomaterials were studied by X-ray phase analysis, transmission and scanning electron microscopy, and X-ray spectral analysis. X-ray phase analysis showed that the sample contained graphite, magnetite Fe3O4, and cementite Fe3C. The results of scanning electron microscopy showed that particles of crystalline phases formed agglomerates ranging in size from 0.1 to 3 μm. Carbon composites were crushed and sifted through a 0.05 mm sieve, after which a paste for the electrode was prepared from the resulting powder with the ratios of the composite to vacuum oil (in mg): 80 : 5, 80 : 10, 80 : 15, 80 : 20, 80 : 25, 80 : 30. Then it was stirred into a homogeneous mass and stuffed into a tubular electrode with the 3 mm diameter. Based on a comparison of the impedance spectra and voltammograms, it has been shown that the ratio of the composite to oil that is optimal for the electrode performance is 80:10 (mass). A significant drift of the properties of freshly prepared pastes has been discovered, which is excluded by keeping them for a day before use. The decisive influence of a fresh surface before each measurement has been shown.
- Open Access
- 22 September 2023
- Published by MDPI AG in Biosensors
- Vol. 13 (10) , 901
The Effect of Rare-Earth Elements on the Morphological Aspect of Borate and Electrocatalytic Sensing of Biological Compounds
Adjusting the morphological characteristics of a material can result in improved electrocatalytic capabilities of the material itself. An example of this is the introduction of rare-earth elements into the borate structure, which gives a new perspective on the possibilities of this type of material in the field of (bio)sensing. In this paper, we present the preparation of borates including La, Nd and Dy and their application for the modification of a glassy carbon electrode, which is used for the non-enzymatic detection of a biologically relevant molecule, vitamin B6 (pyridoxine). Compared with the others, dysprosium borate has the best electrocatalytic performance, showing the highest current and the lowest impedance, respectively, as determined using cyclic voltammetry and impedance tests. Quantitative testing of B6 was performed in DPV mode in a Britton–Robinson buffer solution with a pH of 6 and an oxidation potential of about +0.8 V. The calibration graph for the evaluation of B6 has a linear range from 1 to 100 μM, with a correlation coefficient of 0.9985 and a detection limit of 0.051 μM. The DyBO3-modified electrode can be used repeatedly, retaining more than 90% of the initial signal level after six cycles. The satisfactory selectivity offered a potential practical application of the chosen method for the monitoring of pyridoxine in artificially prepared biological fluids with acceptable recovery. In light of all the obtained results, this paper shows an important approach for the successful design of electrocatalysts with tuned architecture and opens new strategies for the development of materials for the needs of electrochemical (bio)sensing.
- 22 September 2023
- Published by MDPI AG in Biosensors
- Vol. 13 (10) , 901
Open AccessThe Effect of Rare-Earth Elements on the Morphological Aspect of Borate and Electrocatalytic Sensing of Biological Compounds
Adjusting the morphological characteristics of a material can result in improved electrocatalytic capabilities of the material itself. An example of this is the introduction of rare-earth elements into the borate structure, which gives a new perspective on the possibilities of this type of material in the field of (bio)sensing. In this paper, we present the preparation of borates including La, Nd and Dy and their application for the modification of a glassy carbon electrode, which is used for the non-enzymatic detection of a biologically relevant molecule, vitamin B6 (pyridoxine). Compared with the others, dysprosium borate has the best electrocatalytic performance, showing the highest current and the lowest impedance, respectively, as determined using cyclic voltammetry and impedance tests. Quantitative testing of B6 was performed in DPV mode in a Britton–Robinson buffer solution with a pH of 6 and an oxidation potential of about +0.8 V. The calibration graph for the evaluation of B6 has a linear range from 1 to 100 μM, with a correlation coefficient of 0.9985 and a detection limit of 0.051 μM. The DyBO3-modified electrode can be used repeatedly, retaining more than 90% of the initial signal level after six cycles. The satisfactory selectivity offered a potential practical application of the chosen method for the monitoring of pyridoxine in artificially prepared biological fluids with acceptable recovery. In light of all the obtained results, this paper shows an important approach for the successful design of electrocatalysts with tuned architecture and opens new strategies for the development of materials for the needs of electrochemical (bio)sensing.
- 29 December 2022
- Published by American Chemical Society (ACS) in ACS Applied Polymer Materials
- Vol. 5 (1) , 892-898
Nickel(II)-Polysiloxane “Sandwiches” as Electrical Breakdown Protective Materials
- 29 December 2022
- Published by American Chemical Society (ACS) in ACS Applied Polymer Materials
- Vol. 5 (1) , 892-898
Nickel(II)-Polysiloxane “Sandwiches” as Electrical Breakdown Protective Materials