Halyna Bubela
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Halyna Bubela has a total of 21 co-authors. Here are the top co-authors by number of shared publications:
- Joanna Kujawa
Nicolaus Copernicus University in Toruń, Faculty of Chemistry, 7 Gagarina Street, Toruń 87-100, Poland
3 shared publications Viktoriia Konovalova
3 shared publicationsWojciech Kujawski
2 shared publications- Wojciech Kujawski
Faculty of Chemistry, Nicolaus Copernicus University in Toruń, 7 Gagarina Street, 87-100 Torun, Poland
2 shared publications - Aleksei Palchik
V.I. Vernadsky Institute of General and Inorganic Chemistry NAS of Ukraine
1 shared publication Anatoliy Bilous
V. I. Vernadsky Institute of General and Inorganic Chemistry NAS of Ukraine Kyiv Ukraine
1 shared publication
Latest Publications
- Open Access
- 30 October 2026
- Published by Wiley in Batteries & Supercaps
- Vol. 9 (11) , e70523
Ion‐Conducting Ceramics in Lithium‐Ion Batteries: From Electrode Modification to Composite Electrolytes for Quasi‐Solid‐State Cells
The development of lithium‐based batteries requires advanced electrolyte systems capable of ensuring efficient ion transport and reliable electrode–electrolyte interfaces. In this work, inorganic lithium‐ion conductors have been investigated as components of composite polymer electrolytes and as functional modifiers of Li 4 Ti 5 O 12 anodes. Li 4 Ti 5 O 12 was modified by mechanical mixing with 1 wt% of representative ion conductors, including NASICON‐type Li 1.3 Al 0.3 Ti 1.7 (PO 4 ) 3 (LATP), garnet‐type Li 6.5 La 3 Zr 1.5 Nb 0.5 O 12 (LLZNO), and perovskite‐type Li 0.5 La 0.5 TiO 3 (LLTO), intended to distribute the ceramic particles over the LTO surface as a physical (nonbonded) coating, and evaluated in lithium‐ion cells employing either a conventional liquid electrolyte or quasi‐solid‐state composite polymer electrolytes. Electrochemical characterization by galvanostatic cycling and cyclic voltammetry demonstrated distinct electrochemical behavior depending on the incorporated ceramic phase, with LATP‐containing systems showing the most favorable rate performance and overall internal resistance among the investigated modified configurations. In the quasi‐solid‐state cells, the higher internal resistance compared with liquid‐electrolyte cells limited the rate capability at high currents, while stable cycling was observed at 1C. Furthermore, laboratory‐scale quasi‐solid‐state pouch cells employing the composite polymer electrolyte delivered a discharge capacity of 159 mAh·g −1 at C/10, comparable to that of the corresponding liquid‐electrolyte cells (148 mAh·g −1 ), with ~2% first‐cycle capacity loss.
- 30 October 2026
- Published by Wiley in Batteries & Supercaps
- Vol. 9 (11) , e70523
Open AccessIon‐Conducting Ceramics in Lithium‐Ion Batteries: From Electrode Modification to Composite Electrolytes for Quasi‐Solid‐State Cells
The development of lithium‐based batteries requires advanced electrolyte systems capable of ensuring efficient ion transport and reliable electrode–electrolyte interfaces. In this work, inorganic lithium‐ion conductors have been investigated as components of composite polymer electrolytes and as functional modifiers of Li 4 Ti 5 O 12 anodes. Li 4 Ti 5 O 12 was modified by mechanical mixing with 1 wt% of representative ion conductors, including NASICON‐type Li 1.3 Al 0.3 Ti 1.7 (PO 4 ) 3 (LATP), garnet‐type Li 6.5 La 3 Zr 1.5 Nb 0.5 O 12 (LLZNO), and perovskite‐type Li 0.5 La 0.5 TiO 3 (LLTO), intended to distribute the ceramic particles over the LTO surface as a physical (nonbonded) coating, and evaluated in lithium‐ion cells employing either a conventional liquid electrolyte or quasi‐solid‐state composite polymer electrolytes. Electrochemical characterization by galvanostatic cycling and cyclic voltammetry demonstrated distinct electrochemical behavior depending on the incorporated ceramic phase, with LATP‐containing systems showing the most favorable rate performance and overall internal resistance among the investigated modified configurations. In the quasi‐solid‐state cells, the higher internal resistance compared with liquid‐electrolyte cells limited the rate capability at high currents, while stable cycling was observed at 1C. Furthermore, laboratory‐scale quasi‐solid‐state pouch cells employing the composite polymer electrolyte delivered a discharge capacity of 159 mAh·g −1 at C/10, comparable to that of the corresponding liquid‐electrolyte cells (148 mAh·g −1 ), with ~2% first‐cycle capacity loss.
- Open Access
- 7 February 2025
- Published by Elsevier in Results in Engineering
- Vol. 25
Modified polyvinylidene fluoride membranes for effective removal of iron ions (Fe2+) from water
- 7 February 2025
- Published by Elsevier in Results in Engineering
- Vol. 25
Open AccessModified polyvinylidene fluoride membranes for effective removal of iron ions (Fe2+) from water
- Open Access
- 27 September 2024
- Published by V.I. Vernadsky Institute of General and Inorganic Chemistry in Ukrainian Chemistry Journal
- Vol. 90 (8) , 43-55
NANOPOR POLYMER-INORGANIC FLAT MEMBRANES FOR PESTICIDE CONCENTRATION
Industrial pesticide plants wastewater poses a danger to the environment due to of the exceed of threshold limit value of concentration. It causes to fines and the loss of valuable commercial products. This work proposes a problem solution comprising the removal of pesticides from water by the baromembrane method. The advantages of this approach are obtaining a concentrate of pesticides by the non-destructive method. Polymer-inorganic membranes have been developed to remove pesticides from water. They were obtained by modifying the active layer of commercial micro- and ultrafiltration membranes with nanoparticles of hydrated zirconium dioxide (HZD) with size 10−100 nm. Modification changes the porous structure of active layer due to the formation of gaps between the incorporated nanoparticles as well the polymers hydrolysis. It was established the pore with size 4−33 nm determines the separation properties of the modified membranes. The modifier nanoparticles are located in the active layer. They provide secondary porosity that prevents irreversible contamination of the obtained materials. The membranes were tested with aqueous solutions of commercial pesticides that active ingredient are benzoic acid derivatives and sulfonylurea. It was found sequential filtration under low pressure (up to 2 atm) through polymer-inorganic membranes with larger and smaller pores and following adsorption by biochar reduces the content of pesticides in water below the threshold limit value concentrations. For example, the final content of the sulfonylurea derivative was 0.0005 g dm-3. The obtained concentrate can be used as a commercial product.
- 27 September 2024
- Published by V.I. Vernadsky Institute of General and Inorganic Chemistry in Ukrainian Chemistry Journal
- Vol. 90 (8) , 43-55
Open AccessNANOPOR POLYMER-INORGANIC FLAT MEMBRANES FOR PESTICIDE CONCENTRATION
Industrial pesticide plants wastewater poses a danger to the environment due to of the exceed of threshold limit value of concentration. It causes to fines and the loss of valuable commercial products. This work proposes a problem solution comprising the removal of pesticides from water by the baromembrane method. The advantages of this approach are obtaining a concentrate of pesticides by the non-destructive method. Polymer-inorganic membranes have been developed to remove pesticides from water. They were obtained by modifying the active layer of commercial micro- and ultrafiltration membranes with nanoparticles of hydrated zirconium dioxide (HZD) with size 10−100 nm. Modification changes the porous structure of active layer due to the formation of gaps between the incorporated nanoparticles as well the polymers hydrolysis. It was established the pore with size 4−33 nm determines the separation properties of the modified membranes. The modifier nanoparticles are located in the active layer. They provide secondary porosity that prevents irreversible contamination of the obtained materials. The membranes were tested with aqueous solutions of commercial pesticides that active ingredient are benzoic acid derivatives and sulfonylurea. It was found sequential filtration under low pressure (up to 2 atm) through polymer-inorganic membranes with larger and smaller pores and following adsorption by biochar reduces the content of pesticides in water below the threshold limit value concentrations. For example, the final content of the sulfonylurea derivative was 0.0005 g dm-3. The obtained concentrate can be used as a commercial product.
- 5 January 2023
- Published by Elsevier in Colloids and Surfaces A: Physicochemical and Engineering Aspects
- Vol. 661
Preparation of chitosan water-in-oil emulsions by stirred cell membrane emulsification
- 5 January 2023
- Published by Elsevier in Colloids and Surfaces A: Physicochemical and Engineering Aspects
- Vol. 661
Preparation of chitosan water-in-oil emulsions by stirred cell membrane emulsification