Lixin Du
Research Subjects
Lixin Du has a total of 12 co-authors. Here are the top co-authors by number of shared publications:
- Ming Wang
School of Chemical and Printing-dyeing Engineering, Henan University of Engineering, Zhengzhou 450007, China
3 shared publications - Dongyi Chen
School of Automation Engineering, University of Electronic Science and Technology of China, Chengdu 611731, China
2 shared publications - Fan Xiong
Zhongyuan University of Technology
2 shared publications - Hongying Yang
College of Intelligent Textile and Fabric Electronics, Zhongyuan University of Technology, Zhengzhou 450007, China
2 shared publications - Jinli Zhou
College of Textile, Zhongyuan University of Technology, Zhengzhou 450007, China
2 shared publications - Qingxia Liu
College of Textile, Zhongyuan University of Technology, Zhengzhou 450007, China
2 shared publications
Latest Publications
- Open Access
Study of [Bmim]Cl/LiCl Co-Solvent Dissolution of Waste Wool
Waste wool was subjected to dissolution using an ionic liquid solvent, 1-butyl-3-methylimidazole chloride salt ([Bmim]Cl), with lithium chloride (LiCl) as an additive. This study’s objective was to examine the impact of LiCl on keratin’s solubility in [Bmim]Cl and characterise the structure and properties of keratin post-dissolution and regeneration. The results indicated that LiCl exhibits efficient solubility in [Bmim]Cl, enhancing keratin dissolution. Investigations employing Infrared, XRD and small-angle X-scattering spectroscopy, along with SDS-PAGE, demonstrated a degradation of the α-helical keratin structure during the dissolution process. This was accompanied by a reduction in molecular weight; however, keratin retained its protein nature. Atomic force microscopy (AFM) results revealed that keratin could proliferate on the slide surface or establish a continuous film. An integrative analysis suggested that wool protein macromolecules could be deconstructed by [Bmim]Cl and LiCl actions, inducing minor structural alterations in wool. This study proposes a groundwork for future research into keratin’s adsorption behaviour on textile materials, without significantly modifying the wool keratin structure or function.
Open AccessStudy of [Bmim]Cl/LiCl Co-Solvent Dissolution of Waste Wool
Waste wool was subjected to dissolution using an ionic liquid solvent, 1-butyl-3-methylimidazole chloride salt ([Bmim]Cl), with lithium chloride (LiCl) as an additive. This study’s objective was to examine the impact of LiCl on keratin’s solubility in [Bmim]Cl and characterise the structure and properties of keratin post-dissolution and regeneration. The results indicated that LiCl exhibits efficient solubility in [Bmim]Cl, enhancing keratin dissolution. Investigations employing Infrared, XRD and small-angle X-scattering spectroscopy, along with SDS-PAGE, demonstrated a degradation of the α-helical keratin structure during the dissolution process. This was accompanied by a reduction in molecular weight; however, keratin retained its protein nature. Atomic force microscopy (AFM) results revealed that keratin could proliferate on the slide surface or establish a continuous film. An integrative analysis suggested that wool protein macromolecules could be deconstructed by [Bmim]Cl and LiCl actions, inducing minor structural alterations in wool. This study proposes a groundwork for future research into keratin’s adsorption behaviour on textile materials, without significantly modifying the wool keratin structure or function.
- Open Access
Fabric Electrode Monitoring of Dynamic and Static ECG Signal and Comfort Performance
To monitor dynamic ECG for a long time, fabric electrodes must have excellent comfort and electrical properties. In addition, the quality of the collected ECG should be as free as possible from interference by motion artifacts due to dry skin and body movement. This study explores the comfort of four different materials and structures of silver-plated fabric electrodes, analyzing the acquisition effect of ECG signals under dynamic and static conditions. To obtain fabric electrodes with good comfort levels and stable ECG signal monitoring under dynamic and static conditions, four kinds of electroless silver-plated conductive fabrics were selected and assembled into fabric electrodes. Permeability, electrochemical impedance spectrum, static opening voltage, and dynamic static electrocardiogram were tested and evaluated for each of the four fabric electrodes; additionally, the comfort of the four fabric electrodes and the mass of ECG monitored under dynamic and static conditions were assessed. The results showed that the highly hygroscopic knitted fabric electrode showed better comfort than the other three samples. The electrochemical impedance spectrum curve of the highly hygroscopic knitted fabric electrode was relatively smooth and stable, and it had lower impedance than the other electrodes; moreover, the static open-circuit voltage changed more stably with the increase of processing time compared to the other samples. The four kinds of fabric electrodes all collected clear and stable ECG in the resting state. However, in dynamic conditions, only the highly hygroscopic knitted fabric electrodes collected stable ECG under the conditions of seven daily life actions, clearly distinguishing between the P-wave, QRS wave group, and T-wave. The knitted fabric electrode has a high correlation with the ECG measured by a disposable gel electrode, meeting the standards needed to monitor ECG during the human body’s daily activities.
Open AccessFabric Electrode Monitoring of Dynamic and Static ECG Signal and Comfort Performance
To monitor dynamic ECG for a long time, fabric electrodes must have excellent comfort and electrical properties. In addition, the quality of the collected ECG should be as free as possible from interference by motion artifacts due to dry skin and body movement. This study explores the comfort of four different materials and structures of silver-plated fabric electrodes, analyzing the acquisition effect of ECG signals under dynamic and static conditions. To obtain fabric electrodes with good comfort levels and stable ECG signal monitoring under dynamic and static conditions, four kinds of electroless silver-plated conductive fabrics were selected and assembled into fabric electrodes. Permeability, electrochemical impedance spectrum, static opening voltage, and dynamic static electrocardiogram were tested and evaluated for each of the four fabric electrodes; additionally, the comfort of the four fabric electrodes and the mass of ECG monitored under dynamic and static conditions were assessed. The results showed that the highly hygroscopic knitted fabric electrode showed better comfort than the other three samples. The electrochemical impedance spectrum curve of the highly hygroscopic knitted fabric electrode was relatively smooth and stable, and it had lower impedance than the other electrodes; moreover, the static open-circuit voltage changed more stably with the increase of processing time compared to the other samples. The four kinds of fabric electrodes all collected clear and stable ECG in the resting state. However, in dynamic conditions, only the highly hygroscopic knitted fabric electrodes collected stable ECG under the conditions of seven daily life actions, clearly distinguishing between the P-wave, QRS wave group, and T-wave. The knitted fabric electrode has a high correlation with the ECG measured by a disposable gel electrode, meeting the standards needed to monitor ECG during the human body’s daily activities.
- Open Access
Effect of Fabric Electrode Surface Coating Medium on ECG Signal Quality under Dynamic and Static Conditions
This study intends to explore the influence of a fabric electrode skin interface filling medium on ECG signals under dynamic and static conditions, so as to be able to better monitor both stable and dynamic ECG signals. In this paper, cotton fabric electrodes were prepared using electroless silver-plated conductive cotton fabric, and then the electrodes were integrated into a physiotherapy-grade elastic bandage to assemble the fabric ECG tape. The electrode impedance tester and the BIOPAC physiological recorder were used to measure the fabric electrode-skin impedance and electrocardiogram under dynamic and static conditions, respectively. Later, the influence of the fabric electrode coated medium on the acquisition effect of an electrocardiogram signal under dynamic and static conditions is discussed. The results show that in the absence of a dielectric reagent coating, the cotton fabric electrode is easily disturbed by external noise which leads to large electrode-skin contact impedance. However, the electrode-skin contact impedance is greatly reduced after coating the fabric electrode with the dielectric reagent. At the same time, after applying the conducive paste coating, the corresponding change curve of the fabric electrode became more stable, and the impedance value was less than 0.005 MΩ·cm2, which meets the standard requirement for textile dry electrode skin impedance. In a state of rest, a clear and stable ECG can be collected regardless of whether the medium reagent is coated or not. However, only after applying the conductive paste can a stable ECG signal be collected under the three motion modes, or can a P wave, QRS wave group, or T wave be clearly distinguished. In addition, there is a high correlation with the disposable gel electrode, which can satisfy the requirements of the long-term monitoring of ECG signals under dynamic conditions.
Open AccessEffect of Fabric Electrode Surface Coating Medium on ECG Signal Quality under Dynamic and Static Conditions
This study intends to explore the influence of a fabric electrode skin interface filling medium on ECG signals under dynamic and static conditions, so as to be able to better monitor both stable and dynamic ECG signals. In this paper, cotton fabric electrodes were prepared using electroless silver-plated conductive cotton fabric, and then the electrodes were integrated into a physiotherapy-grade elastic bandage to assemble the fabric ECG tape. The electrode impedance tester and the BIOPAC physiological recorder were used to measure the fabric electrode-skin impedance and electrocardiogram under dynamic and static conditions, respectively. Later, the influence of the fabric electrode coated medium on the acquisition effect of an electrocardiogram signal under dynamic and static conditions is discussed. The results show that in the absence of a dielectric reagent coating, the cotton fabric electrode is easily disturbed by external noise which leads to large electrode-skin contact impedance. However, the electrode-skin contact impedance is greatly reduced after coating the fabric electrode with the dielectric reagent. At the same time, after applying the conducive paste coating, the corresponding change curve of the fabric electrode became more stable, and the impedance value was less than 0.005 MΩ·cm2, which meets the standard requirement for textile dry electrode skin impedance. In a state of rest, a clear and stable ECG can be collected regardless of whether the medium reagent is coated or not. However, only after applying the conductive paste can a stable ECG signal be collected under the three motion modes, or can a P wave, QRS wave group, or T wave be clearly distinguished. In addition, there is a high correlation with the disposable gel electrode, which can satisfy the requirements of the long-term monitoring of ECG signals under dynamic conditions.