Attaallah Abusafia
Attaallah Abusafia has a total of 22 co-authors. Here are the top co-authors by number of shared publications:
- Heidrun Steinmetz
Chairs of Resource-Efficient Wastewater Technology and Resource Recovery from Wastewater, Department of Civil Engineering, RPTU University of Kaiserslautern-Landau, Kaiserslautern 67663, Germany
4 shared publications - Korinna Altmann
Bundesanstalt für Materialforschung und -prüfung (BAM), Unter den Eichen 87, 12205 Berlin, Germany
4 shared publications Christian Scheid
Technische Universität Kaiserslautern Kaiserslautern Germany
2 shared publicationsMaren Meurer
Bundesanstalt für Materialforschung und ‐prüfung Berlin Germany
2 shared publications- Ulrich Dittmer
Department of Urban Water Management, RPTU in Kaiserslautern, Paul-Ehrlich-Straße 14, D-67663 Kaiserslautern, Germany
2 shared publications - Ulrike Braun
German Environment Agency (UBA), Wörlitzer Platz 1, 06844 Dessau-Rosslau, Germany
2 shared publications
Latest Publications
- Open Access
- 31 October 2024
- Published by MDPI AG in Environments
- Vol. 11 (11) , 241
Removal of Organic Micropollutants and Microplastics via Ozonation Followed by Granular Activated Carbon Filtration
Discharge from Wastewater Treatment Plants (WWTPs) can result in the emission of organic micropollutants (OMPs) and microplastics (MPs) into the aquatic environment. To prevent this harmful release, a pilot plant consisting of an ozonation followed by a granular activated carbon (GAC) filter was operated at a WWTP in Germany, and its side-effects on the concentrations of nitrogen (N) and phosphorous (P) compounds were measured. Over 80% of OMPs and transformation products were removed during the operating time (around 6000 bed volumes) no matter the ozone dose (from around 0.1 to 0.5 mgO3/mgDOC), except for Diatrizoic acid, whose breakthrough appeared at 3500 BV. Formation of the oxidation by-product, NDMA, increased with higher ozone doses, but the concentration remained below 100 ng/L. Bromate was formed at a higher ozone dose (>0.4 mgO3/mgDOC) but at a low concentration—below 10 µg/L. The MP particles detected in the inflow (PE, SBR, PP, and PS) were effectively eliminated to a high degree, with a removal rate of at least 92%. Carbon parameters (COD, DOC, and SAC254) were removed further by the pilot plant, but to different extents. As expected, nitrate was formed during ozonation, while nitrite’s concentration decreased. Further, nitrite decreased and nitrate increased within the GAC filter, while ammonium was eliminated by at least 90%. Total P concentration decreased after the pilot, but the concentration of PO4-P increased.
- 31 October 2024
- Published by MDPI AG in Environments
- Vol. 11 (11) , 241
Open AccessRemoval of Organic Micropollutants and Microplastics via Ozonation Followed by Granular Activated Carbon Filtration
Discharge from Wastewater Treatment Plants (WWTPs) can result in the emission of organic micropollutants (OMPs) and microplastics (MPs) into the aquatic environment. To prevent this harmful release, a pilot plant consisting of an ozonation followed by a granular activated carbon (GAC) filter was operated at a WWTP in Germany, and its side-effects on the concentrations of nitrogen (N) and phosphorous (P) compounds were measured. Over 80% of OMPs and transformation products were removed during the operating time (around 6000 bed volumes) no matter the ozone dose (from around 0.1 to 0.5 mgO3/mgDOC), except for Diatrizoic acid, whose breakthrough appeared at 3500 BV. Formation of the oxidation by-product, NDMA, increased with higher ozone doses, but the concentration remained below 100 ng/L. Bromate was formed at a higher ozone dose (>0.4 mgO3/mgDOC) but at a low concentration—below 10 µg/L. The MP particles detected in the inflow (PE, SBR, PP, and PS) were effectively eliminated to a high degree, with a removal rate of at least 92%. Carbon parameters (COD, DOC, and SAC254) were removed further by the pilot plant, but to different extents. As expected, nitrate was formed during ozonation, while nitrite’s concentration decreased. Further, nitrite decreased and nitrate increased within the GAC filter, while ammonium was eliminated by at least 90%. Total P concentration decreased after the pilot, but the concentration of PO4-P increased.
- 10 July 2023
- Published by Elsevier in Water Research
- Vol. 243, 120334
The role of stormwater infrastructure in regional methane emissions
- 10 July 2023
- Published by Elsevier in Water Research
- Vol. 243, 120334
The role of stormwater infrastructure in regional methane emissions
- Open Access
- 15 January 2023
- Published by Wiley in Applied Research
- Vol. 2 (5)
Identification of microplastic pathways within a typical European urban wastewater system
In recent years, thermoextraction/desorption‐gas chromatography/mass spectrometry (TED‐GC/MS) has been developed as a rapid detection method for the determination of microplastics (MP) mass contents in numerous environmentally relevant matrices and, in particular, for the measurement of polymers in water samples without time‐consuming sample preparation. The TED‐GC/MS method was applied to investigate a typical European municipal wastewater system for possible MP masses. Such investigations are important in view of the recent revision of the Urban Wastewater Treatment Directive. Four different representative sampling sites were selected: greywater (domestic wastewater without toilet), combined sewer, and influent and effluent of a wastewater treatment plant (WWTP). All samples were collected by fractional filtration. Filtration was carried out over mesh sizes of 500, 100, 50, and in some cases, 5 µm. Polyethylene (PE), polypropylene (PP), and polystyrene (PS) were detected in all samples, with the PE fraction dominating in all cases. Styrene‐butadiene rubber which serves as an indication of tire abrasion, was only found in the influent of the WWTP. The highest MP mass contents were found in the combined sewer, so MP can become a source of pollution during heavy rain events when the capacity limits of the effluent are reached, and the polluted effluent is released uncontrolled into the environment. Based on the studies, MP retention from the WWTP could be estimated to be approximately 96%. Few trends in polymer type or mass contents were detected within the different fractions of the samples or when comparing samples to each other.
- 15 January 2023
- Published by Wiley in Applied Research
- Vol. 2 (5)
Open AccessIdentification of microplastic pathways within a typical European urban wastewater system
In recent years, thermoextraction/desorption‐gas chromatography/mass spectrometry (TED‐GC/MS) has been developed as a rapid detection method for the determination of microplastics (MP) mass contents in numerous environmentally relevant matrices and, in particular, for the measurement of polymers in water samples without time‐consuming sample preparation. The TED‐GC/MS method was applied to investigate a typical European municipal wastewater system for possible MP masses. Such investigations are important in view of the recent revision of the Urban Wastewater Treatment Directive. Four different representative sampling sites were selected: greywater (domestic wastewater without toilet), combined sewer, and influent and effluent of a wastewater treatment plant (WWTP). All samples were collected by fractional filtration. Filtration was carried out over mesh sizes of 500, 100, 50, and in some cases, 5 µm. Polyethylene (PE), polypropylene (PP), and polystyrene (PS) were detected in all samples, with the PE fraction dominating in all cases. Styrene‐butadiene rubber which serves as an indication of tire abrasion, was only found in the influent of the WWTP. The highest MP mass contents were found in the combined sewer, so MP can become a source of pollution during heavy rain events when the capacity limits of the effluent are reached, and the polluted effluent is released uncontrolled into the environment. Based on the studies, MP retention from the WWTP could be estimated to be approximately 96%. Few trends in polymer type or mass contents were detected within the different fractions of the samples or when comparing samples to each other.
- Open Access
- 15 January 2023
- Published by Wiley in Applied Research
- Vol. 2 (5)
Microplastic sampling strategies in urban drainage systems for quantification of urban emissions based on transport pathways
Tracking waterborne microplastic (MP) in urban areas is a challenging task because of the various sources and transport pathways involved. Since MP occurs in low concentrations in most wastewater and stormwater streams, large sample volumes need to be captured, prepared, and carefully analyzed. The recent research in urban areas focused mainly on MP emissions at wastewater treatment plants (WWTPs), as obvious entry points into receiving waters. However, important transport pathways under wet‐weather conditions are yet not been investigated thoroughly. In addition, the lack of comprehensive and comparable sampling strategies complicated the attempts for a deeper understanding of occurrence and sources. The goal of this paper is to (i) introduce and describe sampling strategies for MP at different locations in a municipal catchment area under dry and wet‐weather conditions, (ii) quantify MP emissions from the entire catchment and two other smaller ones within the bigger catchment, and (iii) compare the emissions under dry and wet‐weather conditions. WWTP has a high removal rate of MP (>96%), with an estimated emission rate of 189 kg/a or 0.94 g/[population equivalents (PEQ · a)], and polyethylene (PE) as the most abundant MP. The specific dry‐weather emissions at a subcatchment were ≈30 g/(PEQ · a) higher than in the influent of WWTP with 23 g/(PEQ · a). Specific wet‐weather emissions from large sub‐catchment with higher traffic and population densities were 1952 g/(ha · a) higher than the emissions from smaller catchment (796 g/[ha · a]) with less population and traffic. The results suggest that wet‐weather transport pathways are likely responsible for 2–4 times more MP emissions into receiving waters compared to dry‐weather ones due to tire abrasion entered from streets through gullies. However, more investigations of wet‐weather MP need to be carried out considering additional catchment attributes and storm event characteristics.
- 15 January 2023
- Published by Wiley in Applied Research
- Vol. 2 (5)
Open AccessMicroplastic sampling strategies in urban drainage systems for quantification of urban emissions based on transport pathways
Tracking waterborne microplastic (MP) in urban areas is a challenging task because of the various sources and transport pathways involved. Since MP occurs in low concentrations in most wastewater and stormwater streams, large sample volumes need to be captured, prepared, and carefully analyzed. The recent research in urban areas focused mainly on MP emissions at wastewater treatment plants (WWTPs), as obvious entry points into receiving waters. However, important transport pathways under wet‐weather conditions are yet not been investigated thoroughly. In addition, the lack of comprehensive and comparable sampling strategies complicated the attempts for a deeper understanding of occurrence and sources. The goal of this paper is to (i) introduce and describe sampling strategies for MP at different locations in a municipal catchment area under dry and wet‐weather conditions, (ii) quantify MP emissions from the entire catchment and two other smaller ones within the bigger catchment, and (iii) compare the emissions under dry and wet‐weather conditions. WWTP has a high removal rate of MP (>96%), with an estimated emission rate of 189 kg/a or 0.94 g/[population equivalents (PEQ · a)], and polyethylene (PE) as the most abundant MP. The specific dry‐weather emissions at a subcatchment were ≈30 g/(PEQ · a) higher than in the influent of WWTP with 23 g/(PEQ · a). Specific wet‐weather emissions from large sub‐catchment with higher traffic and population densities were 1952 g/(ha · a) higher than the emissions from smaller catchment (796 g/[ha · a]) with less population and traffic. The results suggest that wet‐weather transport pathways are likely responsible for 2–4 times more MP emissions into receiving waters compared to dry‐weather ones due to tire abrasion entered from streets through gullies. However, more investigations of wet‐weather MP need to be carried out considering additional catchment attributes and storm event characteristics.
- Open Access
- 21 November 2022
- Published by University of the Aegean
Sampling Strategies of Microplastic in Stormwater Runoff from Separate Drainage Systems
- 21 November 2022
- Published by University of the Aegean
Open AccessSampling Strategies of Microplastic in Stormwater Runoff from Separate Drainage Systems