Dmitry Yu. Zhukov
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Dmitry Yu. Zhukov has a total of 24 co-authors. Here are the top co-authors by number of shared publications:
- Yuri A. Fionov
Department of Physical and Colloidal Chemistry RUDN University Moscow Russia
4 shared publications - Alina D. Sazonova
Department of Physical and Colloid Chemistry, Peoples Friendship University of Russia (RUDN University), 6, Miklukho-Maklaya Str., Moscow 117198, Russia
3 shared publications - Andrey N. Kharlanov
Faculty of Chemistry, Moscow State University, Moscow, Russia
3 shared publications - Anna I. Pylinina
Department of Physical and Colloid Chemistry, Peoples Friendship University of Russia (RUDN University), 6, Miklukho-Maklaya Str., Moscow 117198, Russia
3 shared publications - Diana A. Osaulenko
Department of Physical and Colloid Chemistry, Peoples Friendship University of Russia (RUDN University), 6, Miklukho-Maklaya Str., Moscow 117198, Russia
3 shared publications - Elena A. Asabina
Department of Chemistry, Lobachevsky University, Nizhny Novgorod 603950, Russia
3 shared publications
Latest Publications
- Open Access
Ethanol Dehydration Pathways on NASICON-Type A0.33M2(PO4)3 ((A = Dy, Y, Yb); M = Ti, Zr) Catalysts: The Role of Hydroxyl Group Proton Mobility in Selectivity Control
NASICON-type titanium and zirconium phosphates doped with rare-earth cations, A0.33M2(PO4)3 (M = Ti, Zr; A = Dy, Y, Yb), were synthesized using the sol–gel method and investigated as catalysts for ethanol dehydration at 300–400 °C. The catalysts were characterized via XRD, SEM, BET, and FTIR spectroscopy. The relationships between the catalyst composition, acidity and the dehydration activity were evaluated. Diethyl ether (DEE) formation is promoted by the presence of the zirconium phosphates (ZrP), while the presence of titanium phosphate (TiP) catalyzes the formation of both ethylene and diethyl ether (DEE). The application of Fourier-transform infrared (FTIR) spectroscopy to the analysis of adsorbed C6H6 has revealed the presence of hydroxyl groups exhibiting varying degrees of proton-donating mobility. This finding has enabled the correlation of the structure of the active sites with the process’s selectivity. The results underscore the key function of OH-group localization and framework geometry in the control of form-selective reactions.
Open AccessEthanol Dehydration Pathways on NASICON-Type A0.33M2(PO4)3 ((A = Dy, Y, Yb); M = Ti, Zr) Catalysts: The Role of Hydroxyl Group Proton Mobility in Selectivity Control
NASICON-type titanium and zirconium phosphates doped with rare-earth cations, A0.33M2(PO4)3 (M = Ti, Zr; A = Dy, Y, Yb), were synthesized using the sol–gel method and investigated as catalysts for ethanol dehydration at 300–400 °C. The catalysts were characterized via XRD, SEM, BET, and FTIR spectroscopy. The relationships between the catalyst composition, acidity and the dehydration activity were evaluated. Diethyl ether (DEE) formation is promoted by the presence of the zirconium phosphates (ZrP), while the presence of titanium phosphate (TiP) catalyzes the formation of both ethylene and diethyl ether (DEE). The application of Fourier-transform infrared (FTIR) spectroscopy to the analysis of adsorbed C6H6 has revealed the presence of hydroxyl groups exhibiting varying degrees of proton-donating mobility. This finding has enabled the correlation of the structure of the active sites with the process’s selectivity. The results underscore the key function of OH-group localization and framework geometry in the control of form-selective reactions.
- Open Access
- 30 April 2025
- Published by MDPI AG in Preprints.org
Ethanol Dehydration Pathways on NASICON-Type A₀.₃₃M₂(PO₄)₃ (A=Dy, Y, Yb); M = Ti, Zr) catalysts: The Role of Hydroxyl Group Proton Mobility in Selectivity Control
The effects of NASICON-type phosphates composition on the dehydration of oxygen-containing molecules were probed in reactions of ethanol over double Ti- and Zr-phosphates with rare earth cations A0.33M2(PO4)3 (M – Ti4+, Zr4+; A – Dy3+, Y3+, Yb3+) at low temperatures (300 − 400℃). The catalysts were characterised via XRD, SEM, BET, and FTIR spectroscopy. Ethylene production was observed on Ti-phosphate, while the formation of diethyl ether (DEE) was observed on Zr-phosphate. The difference in the selectivity of ethanol dehydration is due to the presence of various types of hydroxyl groups characterised by different proton donor mobility depending on the composition of the Ti- and Zr-containing phosphates, which was determined by FTIR analysis of C6H6 adsorption. This work provides a strategy to design highly selective catalysts with framework structure for form-selective reactions with oxygenates considering the location of OH−groups as well as the pore size available for surface intermediates.
- 30 April 2025
- Published by MDPI AG in Preprints.org
Open AccessEthanol Dehydration Pathways on NASICON-Type A₀.₃₃M₂(PO₄)₃ (A=Dy, Y, Yb); M = Ti, Zr) catalysts: The Role of Hydroxyl Group Proton Mobility in Selectivity Control
The effects of NASICON-type phosphates composition on the dehydration of oxygen-containing molecules were probed in reactions of ethanol over double Ti- and Zr-phosphates with rare earth cations A0.33M2(PO4)3 (M – Ti4+, Zr4+; A – Dy3+, Y3+, Yb3+) at low temperatures (300 − 400℃). The catalysts were characterised via XRD, SEM, BET, and FTIR spectroscopy. Ethylene production was observed on Ti-phosphate, while the formation of diethyl ether (DEE) was observed on Zr-phosphate. The difference in the selectivity of ethanol dehydration is due to the presence of various types of hydroxyl groups characterised by different proton donor mobility depending on the composition of the Ti- and Zr-containing phosphates, which was determined by FTIR analysis of C6H6 adsorption. This work provides a strategy to design highly selective catalysts with framework structure for form-selective reactions with oxygenates considering the location of OH−groups as well as the pore size available for surface intermediates.
- 24 November 2023
- Published by Springer Nature in Research on Chemical Intermediates
- Vol. 50 (3) , 1331-1354
Enhanced ethanol dehydrogenation over Ni-containing zirconia-alumina catalysts with microwave-assisted synthesis
- 24 November 2023
- Published by Springer Nature in Research on Chemical Intermediates
- Vol. 50 (3) , 1331-1354
Enhanced ethanol dehydrogenation over Ni-containing zirconia-alumina catalysts with microwave-assisted synthesis
- 18 August 2023
- Published by Ore and Metals Publishing House in Chernye Metally
- No. 8,p. 26-30
Corundum-mullite material for refractory melting crucibles
The technology of obtaining corundum-mullite material for the manufacture of melting crucibles by the method of vibrocasting highly concentrated binder suspensions based on aqueous corundum slip and coarse-grained powders of electrocorundum and mullite into gypsum molds is considered. Corundum slip is prepared by wet grinding white electrocorundum 25A fractions F22, F36 in a ball mill to obtain a suspension with density of 2.7–2.9 g/cm3,conditional viscosity of 20–30 °E, and a content of ~90 % (wt.) of particles up to 10 μm in size. As a filler, a combination of coarse-grained electrocorundum powders with fractions of 0.5–0.6 (16–18 % (wt.)) and 0.125–0.150 (24–26 % (wt.)) mm, as well as electrofused mullite with fractions of 0.4–1.6 (14–16 % (wt.)) and 1.6–3.0 (42–44 % (wt.)) mm. When the filler is mixed with slip in the ratio (61–63):(37–39), % (wt.), a sedimentation-resistant mixture is formed, from which crucibles are formed by vibration casting into plaster molds. Corundum-mullite material after firing at 1550°C has a sufficiently high density (3.0–3.1 g/cm3), compressive strength (140–160 MPa) and a low coefficient of thermal expansion (65∙10–7 K-1 at 1400 °C). Refractory melting crucibles have a homogeneous structure: material density variation throughout the entire volume of articles does not exceed 3%. The service life of crucibles in the conditions of melting nickel alloys is at least 25 melts.The researches were carried out using D. Mendeleev Center for collective use of scientific equipment, within the framework of the project No. 075-15-2021-688.
- 18 August 2023
- Published by Ore and Metals Publishing House in Chernye Metally
- No. 8,p. 26-30
Corundum-mullite material for refractory melting crucibles
The technology of obtaining corundum-mullite material for the manufacture of melting crucibles by the method of vibrocasting highly concentrated binder suspensions based on aqueous corundum slip and coarse-grained powders of electrocorundum and mullite into gypsum molds is considered. Corundum slip is prepared by wet grinding white electrocorundum 25A fractions F22, F36 in a ball mill to obtain a suspension with density of 2.7–2.9 g/cm3,conditional viscosity of 20–30 °E, and a content of ~90 % (wt.) of particles up to 10 μm in size. As a filler, a combination of coarse-grained electrocorundum powders with fractions of 0.5–0.6 (16–18 % (wt.)) and 0.125–0.150 (24–26 % (wt.)) mm, as well as electrofused mullite with fractions of 0.4–1.6 (14–16 % (wt.)) and 1.6–3.0 (42–44 % (wt.)) mm. When the filler is mixed with slip in the ratio (61–63):(37–39), % (wt.), a sedimentation-resistant mixture is formed, from which crucibles are formed by vibration casting into plaster molds. Corundum-mullite material after firing at 1550°C has a sufficiently high density (3.0–3.1 g/cm3), compressive strength (140–160 MPa) and a low coefficient of thermal expansion (65∙10–7 K-1 at 1400 °C). Refractory melting crucibles have a homogeneous structure: material density variation throughout the entire volume of articles does not exceed 3%. The service life of crucibles in the conditions of melting nickel alloys is at least 25 melts.The researches were carried out using D. Mendeleev Center for collective use of scientific equipment, within the framework of the project No. 075-15-2021-688.
- Open Access
Novel Complex Titanium NASICON-Type Phosphates as Acidic Catalysts for Ethanol Dehydration
The conversion of ethanol towards ethylene and diethyl ether in the presence of catalysts requires special consideration from the perspective of green chemistry. Ethanol dehydration was studied on a complex titanium phosphate MAlTiP (M0.5(1+x)AlxTi2-x(PO4)3 with M = Ni, Mn (x = 0; 0.2)) catalysts, alongside a NASICON-type structure synthesized by the sol–gel method. The initial catalysts were characterized by N2 gas sorption, SEM, XRD and spectroscopic methods (Raman and DRIFT of adsorbed CO and C6H6). The results revealed that all catalysts exhibited high activity and selectivity at 300–420 °C. The conversion of ethanol increases with the reaction temperature, reaching 67–80% at 420 °C. The MnAlTiP exhibited the highest ethylene selectivity among other catalysts, with 87% at 420 °C. The aluminum modification improved the acid properties of the catalysts, due to the appearance of Lewis acid sites (LAS) and the strength moderate Brønsted acid sites (BAS). It was shown that the activity of complex phosphates in ethanol dehydration increases with the strength of the Brønsted acid sites (BAS).
Open AccessNovel Complex Titanium NASICON-Type Phosphates as Acidic Catalysts for Ethanol Dehydration
The conversion of ethanol towards ethylene and diethyl ether in the presence of catalysts requires special consideration from the perspective of green chemistry. Ethanol dehydration was studied on a complex titanium phosphate MAlTiP (M0.5(1+x)AlxTi2-x(PO4)3 with M = Ni, Mn (x = 0; 0.2)) catalysts, alongside a NASICON-type structure synthesized by the sol–gel method. The initial catalysts were characterized by N2 gas sorption, SEM, XRD and spectroscopic methods (Raman and DRIFT of adsorbed CO and C6H6). The results revealed that all catalysts exhibited high activity and selectivity at 300–420 °C. The conversion of ethanol increases with the reaction temperature, reaching 67–80% at 420 °C. The MnAlTiP exhibited the highest ethylene selectivity among other catalysts, with 87% at 420 °C. The aluminum modification improved the acid properties of the catalysts, due to the appearance of Lewis acid sites (LAS) and the strength moderate Brønsted acid sites (BAS). It was shown that the activity of complex phosphates in ethanol dehydration increases with the strength of the Brønsted acid sites (BAS).