Michael Hartmann
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Michael Hartmann has a total of 21 co-authors. Here are the top co-authors by number of shared publications:
- Agnieszka Operacz
Department of Sanitary Engineering and Water Management, University of Agriculture in Krakow, Mickiewicza Av. 21, 31-120 Krakow, Poland
1 shared publication - Aleksandra Kasztelewicz
Mineral and Energy Economy Research Institute, Polish Academy of Sciences,Kraków, Poland
1 shared publication - Barbara Tomaszewska
AGH University of Krakow, Poland
1 shared publication - Benedikt Riegler
Electric Drives and Machines Institute, Graz University of Technology, Graz, Austria
1 shared publication - Bum-Ki Choi
Institute of Applied Resource Strategies IARS, SRH Berlin University of Applied Sciences, Ernst-Reuter-Platz 10, 10587 Berlin, Germany
1 shared publication - Dirk Ronneberger
Universität Göttingen
1 shared publication
Latest Publications
- Open Access
- 27 January 2025
- Published by MDPI AG in Electronics
- Vol. 14 (3) , 522
Design and Implementation of 3 kW All-SiC Current Source Inverter
In this paper, the optimal design and implementation of a silicon-carbide (SiC) power semiconductor-based current source inverter (CSI) with a power rating of 3 kW focusing on high power density are discussed in detail. The proposed methodology integrates analytical and numerical techniques to optimize the design of passive components, including filter capacitors and the DC-link inductor, and provides a comprehensive analysis of power semiconductor losses. The losses in the DC-link inductor as well as in the output capacitor are strongly dependent on the modulation strategy. Semi-analytical loss models are therefore derived for the most advanced modulation strategy, which are subsequently used to increase volumetric power density. The theoretical findings are experimentally validated using an ultra-compact, high-efficiency 3 kW three-phase CSI prototype operating at up to 100 kHz switching frequency. The experimental results confirm the efficiency of the proposed design and demonstrate its potential for high-power, compact drive applications.
- 27 January 2025
- Published by MDPI AG in Electronics
- Vol. 14 (3) , 522
Open AccessDesign and Implementation of 3 kW All-SiC Current Source Inverter
In this paper, the optimal design and implementation of a silicon-carbide (SiC) power semiconductor-based current source inverter (CSI) with a power rating of 3 kW focusing on high power density are discussed in detail. The proposed methodology integrates analytical and numerical techniques to optimize the design of passive components, including filter capacitors and the DC-link inductor, and provides a comprehensive analysis of power semiconductor losses. The losses in the DC-link inductor as well as in the output capacitor are strongly dependent on the modulation strategy. Semi-analytical loss models are therefore derived for the most advanced modulation strategy, which are subsequently used to increase volumetric power density. The theoretical findings are experimentally validated using an ultra-compact, high-efficiency 3 kW three-phase CSI prototype operating at up to 100 kHz switching frequency. The experimental results confirm the efficiency of the proposed design and demonstrate its potential for high-power, compact drive applications.
- 15 June 2023
- Published by SPIE-Intl Soc Optical Eng
- Vol. 12526, 30-173
RGB and IR imagery fusion for autonomous driving
Compressed sensing theory allows for a high-resolution image recovery of sparse image data. However, image scene data from an RGB camera, captured at night-time or in fog, dust, or rainy conditions, is difficult to read. The fusion of IR camera data with RGB camera data allows us to determine the difference between objects in the scene and noise (dust, rain, fog). This paper demonstrates a compressive sensing methodology applied to the scattered image data of the RGB camera to determine objects or obstacles in a scene, which allows for low-cost solutions for the problem of autonomous driving in unfair imaging conditions.
- 15 June 2023
- Published by SPIE-Intl Soc Optical Eng
- Vol. 12526, 30-173
RGB and IR imagery fusion for autonomous driving
Compressed sensing theory allows for a high-resolution image recovery of sparse image data. However, image scene data from an RGB camera, captured at night-time or in fog, dust, or rainy conditions, is difficult to read. The fusion of IR camera data with RGB camera data allows us to determine the difference between objects in the scene and noise (dust, rain, fog). This paper demonstrates a compressive sensing methodology applied to the scattered image data of the RGB camera to determine objects or obstacles in a scene, which allows for low-cost solutions for the problem of autonomous driving in unfair imaging conditions.
- 13 January 2023
- Published by Springer Nature in e+i Elektrotechnik und Informationstechnik
- Vol. 140 (1) , 1-2
Emerging topics in power electronics
- 13 January 2023
- Published by Springer Nature in e+i Elektrotechnik und Informationstechnik
- Vol. 140 (1) , 1-2
Emerging topics in power electronics
- 15 June 2022
- Published by SAE International in SAE International Journal of Advances and Current Practices in Mobility
- Vol. 05 (2) , 810-820
Acoustic-Fluid-Structure Interaction (AFSI) in the Car Underbody
The turbulent flow around vehicles causes high amplitude pressure fluctuations at the underbody, consisting of both hydromechanic and acoustic contributions. This induces vibrations in the underbody structures, which in turn may lead to sound transmission into the passenger compartment, especially at low frequencies. To study these phenomena we present a run time fully coupled acoustic-fluid-structure interaction framework expanding a validated hybrid CFD-CAA solver. The excited and vibrating underbody is resembled by an aluminium plate in the underbody of the SAE body which allows for sound transmission into the interior.Different excitation situations are generated by placing obstacles at the underbody upstream of the aluminium plate. For this setup we carry out a fully coupled simulation of flow, acoustics and vibration of the plate. The simulation results are compared and validated with experimental results of surface microphones, acceleration measurements and sound spectra of the interior. The analysis of the results focuses on the ratio of hydromechanic and acoustic excitation in frequency space and on possible back coupling effects of the structural vibration on the results. In the outlook, one example of an application of this method in the vehicle development is given.
- 15 June 2022
- Published by SAE International in SAE International Journal of Advances and Current Practices in Mobility
- Vol. 05 (2) , 810-820
Acoustic-Fluid-Structure Interaction (AFSI) in the Car Underbody
The turbulent flow around vehicles causes high amplitude pressure fluctuations at the underbody, consisting of both hydromechanic and acoustic contributions. This induces vibrations in the underbody structures, which in turn may lead to sound transmission into the passenger compartment, especially at low frequencies. To study these phenomena we present a run time fully coupled acoustic-fluid-structure interaction framework expanding a validated hybrid CFD-CAA solver. The excited and vibrating underbody is resembled by an aluminium plate in the underbody of the SAE body which allows for sound transmission into the interior.Different excitation situations are generated by placing obstacles at the underbody upstream of the aluminium plate. For this setup we carry out a fully coupled simulation of flow, acoustics and vibration of the plate. The simulation results are compared and validated with experimental results of surface microphones, acceleration measurements and sound spectra of the interior. The analysis of the results focuses on the ratio of hydromechanic and acoustic excitation in frequency space and on possible back coupling effects of the structural vibration on the results. In the outlook, one example of an application of this method in the vehicle development is given.
- 18 June 2021
- Published by Society for Imaging Science & Technology in Electronic Imaging
- Vol. 33 (3) , 144-1
Optical determination of filter effectiveness in potentially aerosol contaminated classrooms during the COVID-19 pandemic
Fast track article for IS&T International Symposium on Electronic Imaging 2021: Mobile Devices and Multimedia: Enabling Technologies, Algorithms, and Applications 2021 proceedings.
- 18 June 2021
- Published by Society for Imaging Science & Technology in Electronic Imaging
- Vol. 33 (3) , 144-1
Optical determination of filter effectiveness in potentially aerosol contaminated classrooms during the COVID-19 pandemic
Fast track article for IS&T International Symposium on Electronic Imaging 2021: Mobile Devices and Multimedia: Enabling Technologies, Algorithms, and Applications 2021 proceedings.
- Open Access
- 26 November 2018
- Published by EDP Sciences in E3S Web of Conferences
- Vol. 66, 03004
Study on national activities and funding opportunities of furthering education programs for unemployed academics
The joint German - Hungarian - Polish - Romanian Project EUBILD-UNAKLIM 2016-1-DE02-KA204-003254 in the ERASMUS + Scheme KA2 (Strategic Partnerships) designs an international adult-learning furthering education course. It took place in the participating countries Germany, Hungary, Poland and Romania. Environmental and cross-sector topics were addressed. A “green” job search and a questionnaire among employers, financing and educational institutions and NGOs was performed across the partner countries in 2017. The objectives were to find differences in employers’ opinions on staff skills and the training topics provided by the furthering education organizations. In case differences were found, the course could close these gaps and will be adapted to the employers’ needs, bringing more course participants into employment. Statistical evaluation compared countries, institution types, employers and furthering educationand financing institutions. The results were visualized in pie charts, histograms, and - where applicable - trend lines. Preliminary results show clear ranking of the new “green” job categories with differences in countries and institutions. The questionnaire results show differences in topic selection between employers and furthering education bodies. The results form the base for the course curriculum design closing the gaps between employers’ expectations for “green” job topics and existing training curricula.
- 26 November 2018
- Published by EDP Sciences in E3S Web of Conferences
- Vol. 66, 03004
Open AccessStudy on national activities and funding opportunities of furthering education programs for unemployed academics
The joint German - Hungarian - Polish - Romanian Project EUBILD-UNAKLIM 2016-1-DE02-KA204-003254 in the ERASMUS + Scheme KA2 (Strategic Partnerships) designs an international adult-learning furthering education course. It took place in the participating countries Germany, Hungary, Poland and Romania. Environmental and cross-sector topics were addressed. A “green” job search and a questionnaire among employers, financing and educational institutions and NGOs was performed across the partner countries in 2017. The objectives were to find differences in employers’ opinions on staff skills and the training topics provided by the furthering education organizations. In case differences were found, the course could close these gaps and will be adapted to the employers’ needs, bringing more course participants into employment. Statistical evaluation compared countries, institution types, employers and furthering educationand financing institutions. The results were visualized in pie charts, histograms, and - where applicable - trend lines. Preliminary results show clear ranking of the new “green” job categories with differences in countries and institutions. The questionnaire results show differences in topic selection between employers and furthering education bodies. The results form the base for the course curriculum design closing the gaps between employers’ expectations for “green” job topics and existing training curricula.
- 1 January 1998
- Published by Springer Nature
- p. 187-190
Rapidly Distorted Turbulent Channel Flow