Jun Wu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Jun Wu has a total of 46 co-authors. Here are the top co-authors by number of shared publications:
Junming Xu
4 shared publicationsWeiqin Sheng
3 shared publicationsWenbin Ni
Chengye Intelligent Center, Huzhou Horizontal Na Energy Technology Co., Ltd, Huzhou, China
3 shared publicationsXiaochong Zhou
Chengye Intelligent Center, Huzhou Horizontal Na Energy Technology Co., Ltd, Huzhou, China
3 shared publicationsYurong Cai
School of Materials Science and Engineering, Zhejiang Sci-Tech University, Hangzhou, China
3 shared publicationsCongxin Xu
College of Electronics and Information, Hangzhou Dianzi University, Hangzhou, China
2 shared publications
Latest Publications
- 8 May 2026
- Published by Springer Nature in Ionics
- Vol. 32 (6) , 6521-6532
Synergistic layered oxide/Prussian blue composite enabling ultrahigh-rate and long-life sodium-ion batteries
- 8 May 2026
- Published by Springer Nature in Ionics
- Vol. 32 (6) , 6521-6532
Synergistic layered oxide/Prussian blue composite enabling ultrahigh-rate and long-life sodium-ion batteries
- 8 August 2025
- Published by Springer Nature in Ionics
- Vol. 31 (10) , 10405-10416
Zn3P2@C nanosheets as self-supported anodes for high-performance sodium-ion batteries
- 8 August 2025
- Published by Springer Nature in Ionics
- Vol. 31 (10) , 10405-10416
Zn3P2@C nanosheets as self-supported anodes for high-performance sodium-ion batteries
- 19 January 2024
- Published by Springer Nature in Ionics
- Vol. 30 (3) , 1391-1402
CoS2/V2O3 heterostructure with coffee ground-derived carbon as superior composite anodes of sodium-ion batteries
- 19 January 2024
- Published by Springer Nature in Ionics
- Vol. 30 (3) , 1391-1402
CoS2/V2O3 heterostructure with coffee ground-derived carbon as superior composite anodes of sodium-ion batteries
- 18 January 2024
- Published by Elsevier in Physics Letters A
- Vol. 496
The first-principles investigation on interaction mechanism of Co9S8 with polysulfides in alkali metal-sulfur batteries
- 18 January 2024
- Published by Elsevier in Physics Letters A
- Vol. 496
The first-principles investigation on interaction mechanism of Co9S8 with polysulfides in alkali metal-sulfur batteries
- Open Access
- 16 October 2023
- Published by Springer Nature in Research Square
CoS2/V2O3 heterostructure with coffee ground derived carbon as superior composite anodes of sodium-ion batteries
The poor ion transport kinetics and serious volumetric change of transition metal sulfides hinder their electrochemical applications. In this study, we introduced a heterostructure between CoS2 and V2O3 as an anode of sodium-ion batteries (SIBs) via a feasible hydrothermal method combining with a biomass carbon derived from coffee grounds (CG). The as-prepared CoS2/V2O3-CG composite retained a reversible capacity of 464.5 mAh g-1 after 300 cycles at 0.5 A g-1, exhibited an excellent rate capability of up to 8 A g-1 and a remarkable long-cycling life of over 2,000 cycles at 2 A g-1 with a capacity decay rate of less than 0.041% per cycle. The kinetic analysis indicated that CoS2/V2O3-CG composite exhibited a superior capacitive behavior, making it a high Na+ diffusion coefficient in SIBs. The enhanced electrochemical performances of composite can be primarily attributed to the CoS2/V2O3 heterostructure and porous biomass-derived carbon, which offers a built-in electric field and a large surface area, and effectively alleviates the volumetric expansion effect.
- 16 October 2023
- Published by Springer Nature in Research Square
Open AccessCoS2/V2O3 heterostructure with coffee ground derived carbon as superior composite anodes of sodium-ion batteries
The poor ion transport kinetics and serious volumetric change of transition metal sulfides hinder their electrochemical applications. In this study, we introduced a heterostructure between CoS2 and V2O3 as an anode of sodium-ion batteries (SIBs) via a feasible hydrothermal method combining with a biomass carbon derived from coffee grounds (CG). The as-prepared CoS2/V2O3-CG composite retained a reversible capacity of 464.5 mAh g-1 after 300 cycles at 0.5 A g-1, exhibited an excellent rate capability of up to 8 A g-1 and a remarkable long-cycling life of over 2,000 cycles at 2 A g-1 with a capacity decay rate of less than 0.041% per cycle. The kinetic analysis indicated that CoS2/V2O3-CG composite exhibited a superior capacitive behavior, making it a high Na+ diffusion coefficient in SIBs. The enhanced electrochemical performances of composite can be primarily attributed to the CoS2/V2O3 heterostructure and porous biomass-derived carbon, which offers a built-in electric field and a large surface area, and effectively alleviates the volumetric expansion effect.
- 18 January 2023
- Published by Elsevier in Materials Letters
- Vol. 336
Enhanced rate capability of S@Co3O4 microsphere wrapped by rGO for cathodes of lithium-sulfur batteries
- 18 January 2023
- Published by Elsevier in Materials Letters
- Vol. 336
Enhanced rate capability of S@Co3O4 microsphere wrapped by rGO for cathodes of lithium-sulfur batteries
- Open Access
- 21 October 2022
- Published by MDPI AG in Nanomaterials
- Vol. 12 (20) , 3697
Nanowires-Assembled TiO2 Nanorods Anchored on Multilayer Graphene for High-Performance Anodes of Lithium-Ion Batteries
Multilayer graphene (MLG) prepared via ultrasonic exfoliation has many advantages such as its low-cost and defect-free nature, high electronic conductivity, and large specific surface area, which make it an apt conductive substrate for TiO2 composites. To synthesize graphene/TiO2 hybrids, traditional methods that greatly depend on the chemical bond of oxygen-containing functional groups on graphene with titanium cations are not applicable due to the absence of these functional groups on MLG. In this work, a facile chemical method is developed to directly deposit TiO2 on the MLG surface without the introduction of chemically active groups. With this method, four types of TiO2 materials, that is pure anatase TiO2 nanoparticles, a mixture of anatase TiO2 nanoparticles and rutile TiO2 nanoflowers, pure rutile TiO2 nanoflowers, and pure rutile TiO2 nanorods, are homogeneously anchored on the MLG surface by controlling the amount of HCl in the reactant. Interestingly, the rutile TiO2 nanorods in the TiO2/MLG composite are assembled by many TiO2 nanowires with an ultra-small diameter and ultra-long length, which provides a better synergetic effect for high performances as LIB anodes than other composites. A specific capacity of 631.4 mAh g−1 after 100 cycles at a current density of 100 mA g−1 is delivered, indicating it to be a valuable LIB anode material with low cost and high electrochemical performances.
- 21 October 2022
- Published by MDPI AG in Nanomaterials
- Vol. 12 (20) , 3697
Open AccessNanowires-Assembled TiO2 Nanorods Anchored on Multilayer Graphene for High-Performance Anodes of Lithium-Ion Batteries
Multilayer graphene (MLG) prepared via ultrasonic exfoliation has many advantages such as its low-cost and defect-free nature, high electronic conductivity, and large specific surface area, which make it an apt conductive substrate for TiO2 composites. To synthesize graphene/TiO2 hybrids, traditional methods that greatly depend on the chemical bond of oxygen-containing functional groups on graphene with titanium cations are not applicable due to the absence of these functional groups on MLG. In this work, a facile chemical method is developed to directly deposit TiO2 on the MLG surface without the introduction of chemically active groups. With this method, four types of TiO2 materials, that is pure anatase TiO2 nanoparticles, a mixture of anatase TiO2 nanoparticles and rutile TiO2 nanoflowers, pure rutile TiO2 nanoflowers, and pure rutile TiO2 nanorods, are homogeneously anchored on the MLG surface by controlling the amount of HCl in the reactant. Interestingly, the rutile TiO2 nanorods in the TiO2/MLG composite are assembled by many TiO2 nanowires with an ultra-small diameter and ultra-long length, which provides a better synergetic effect for high performances as LIB anodes than other composites. A specific capacity of 631.4 mAh g−1 after 100 cycles at a current density of 100 mA g−1 is delivered, indicating it to be a valuable LIB anode material with low cost and high electrochemical performances.
- 25 September 2021
- Published by Springer Nature in Ionics
- Vol. 27 (12) , 5137-5145
Flower-like Ni/NiO microspheres decorated by sericin-derived carbon for high-rate lithium-sulfur batteries
- 25 September 2021
- Published by Springer Nature in Ionics
- Vol. 27 (12) , 5137-5145
Flower-like Ni/NiO microspheres decorated by sericin-derived carbon for high-rate lithium-sulfur batteries
- Open Access
- 24 June 2021
- Published by MDPI AG in Nanomaterials
- Vol. 11 (7) , 1662
Standing and Lying Ni(OH)2 Nanosheets on Multilayer Graphene for High-Performance Supercapacitors
For conventional synthesis of Ni(OH)2/graphene hybrids, oxygen-containing functional groups should be firstly introduced on graphene to serve as active sites for the anchoring of Ni(OH)2. In this work, a method for growing Ni(OH)2 nanosheets on multilayer graphene (MLG) with molecular connection is developed which does not need any pre-activation treatments. Moreover, Ni(OH)2 nanosheets can be controlled to stand or lie on the surface of MLG. The prepared hybrids were characterized by X-ray diffraction (XRD), scanning electron microscopy (SEM), transmission electron microscopy (TEM) and X-ray photoelectron spectroscopy (XPS). The growth processes are suggested according to their morphologies at different growth stages. The enhanced electrochemical performances as supercapacitor electrode materials were confirmed by cyclic voltammetry (CV) and galvanostatic charge-discharge (GCD) techniques. Ni(OH)2 nanosheets standing and lying on MLG show specific capacities of 204.4 mAh g−1 and 131.7 mAh g−1, respectively, at 1 A g−1 based on the total mass of the hybrids and 81.5% and 92.8% capacity retention at a high current density of 10 A g−1, respectively. Hybrid supercapacitors with as-prepared hybrids as cathodes and activated carbon as anode were fabricated and tested.
- 24 June 2021
- Published by MDPI AG in Nanomaterials
- Vol. 11 (7) , 1662
Open AccessStanding and Lying Ni(OH)2 Nanosheets on Multilayer Graphene for High-Performance Supercapacitors
For conventional synthesis of Ni(OH)2/graphene hybrids, oxygen-containing functional groups should be firstly introduced on graphene to serve as active sites for the anchoring of Ni(OH)2. In this work, a method for growing Ni(OH)2 nanosheets on multilayer graphene (MLG) with molecular connection is developed which does not need any pre-activation treatments. Moreover, Ni(OH)2 nanosheets can be controlled to stand or lie on the surface of MLG. The prepared hybrids were characterized by X-ray diffraction (XRD), scanning electron microscopy (SEM), transmission electron microscopy (TEM) and X-ray photoelectron spectroscopy (XPS). The growth processes are suggested according to their morphologies at different growth stages. The enhanced electrochemical performances as supercapacitor electrode materials were confirmed by cyclic voltammetry (CV) and galvanostatic charge-discharge (GCD) techniques. Ni(OH)2 nanosheets standing and lying on MLG show specific capacities of 204.4 mAh g−1 and 131.7 mAh g−1, respectively, at 1 A g−1 based on the total mass of the hybrids and 81.5% and 92.8% capacity retention at a high current density of 10 A g−1, respectively. Hybrid supercapacitors with as-prepared hybrids as cathodes and activated carbon as anode were fabricated and tested.
- 16 April 2019
- Published by IOP Publishing in Materials Research Express
- Vol. 6 (8) , 086301
Using Si textured structure to build vertical graphene sharp edges for electron field emission
The Vertically-orientated graphene (GP) sharp edges can provide a high density of individual field emission sites and a high field emission enhancement factor. In this report, we used a Si textured structure to build the vertical GP field emission edges. Relying on the periodical textured arrays of the Si surface, a large number of vertical sharp edges of GP are formed on the Si substrate during the electrophoretic deposition process. The vertical GP edges on the textured structure of Si shows a low turn-on electric field of 0.43V/μm, a high enhancement factor of 9450, excellent stability behavior and a uniform luminance intensity image. The excellent field emission properties for the vertical edges are explored and discussed in detail. This investigation of the vertical GP edges on a textured Si surface suggests a potential prospect in application in future field electron emission devices.
- 16 April 2019
- Published by IOP Publishing in Materials Research Express
- Vol. 6 (8) , 086301
Using Si textured structure to build vertical graphene sharp edges for electron field emission
The Vertically-orientated graphene (GP) sharp edges can provide a high density of individual field emission sites and a high field emission enhancement factor. In this report, we used a Si textured structure to build the vertical GP field emission edges. Relying on the periodical textured arrays of the Si surface, a large number of vertical sharp edges of GP are formed on the Si substrate during the electrophoretic deposition process. The vertical GP edges on the textured structure of Si shows a low turn-on electric field of 0.43V/μm, a high enhancement factor of 9450, excellent stability behavior and a uniform luminance intensity image. The excellent field emission properties for the vertical edges are explored and discussed in detail. This investigation of the vertical GP edges on a textured Si surface suggests a potential prospect in application in future field electron emission devices.