Henan Zeng
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Henan Zeng has a total of 26 co-authors. Here are the top co-authors by number of shared publications:
Jiyao Yang
National key Laboratory of Microwave Imaging, Aerospace Information Research Institute, Chinese Academy of Sciences, Beijing, China
3 shared publications- Chenyu Liu
National key Laboratory of Microwave Imaging, Aerospace Information Research Institute, Chinese Academy of Sciences, Beijing, China
2 shared publications - Jianwei Liu
University of Chinese Academy of Sciences
2 shared publications - Qinyu Xie
University of Chinese Academy of Sciences
2 shared publications - Ruoming Li
National key Laboratory of Microwave Imaging, Aerospace Information Research Institute, Chinese Academy of Sciences, Beijing, China
2 shared publications - Wangzhe Li
National key Laboratory of Microwave Imaging, Aerospace Information Research Institute, Chinese Academy of Sciences, Beijing, China
2 shared publications
Latest Publications
- 15 July 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Lightwave Technology
- Vol. 43 (18) , 8699-8710
Asynchronous Dense-Frequency-Interleaved Analog-to-Digital Conversion Breaking the Trade-Off Between Bandwidth and Dynamic Range
An analog-to-digital converter (ADC) with broad bandwidth and high dynamic range is of the utmost importance for modern radio frequency (RF) applications. However, as the bandwidth increases with the sampling rate, distortions caused by manufacturing defects are deteriorated, thereby decreasing the dynamic range. To break the trade-off, a novel photonics-assisted asynchronous dense-frequency-interleaved ADC with decoupled bandwidth and dynamic range is proposed. By employing an asynchronous photonic channelizer, densely frequency-interleaving is achieved to convert a broadband RF signal into multiple spectrum segments that are then quantized independently by sub-ADCs. The dynamic range is determined only by the sub-ADCs while the bandwidth is determined by the number of segments or frequency-interleaved channels. Thanks to the asynchrony of the frequency-interleaving, frequency-shift dithering is introduced and taken advantage of to suppress the quantization spurs, further enhancing the dynamic range. The performance requirements for both photonic and electronic components are also eased. Experimentally, a dynamic range of 79.0 dB is achieved at a bandwidth of 5.5 GHz, outperforming the state-of-the-art ADCs, and the flexibility of the method in terms of operating frequency range and bandwidth is also demonstrated. The proposed method provides a unique tool for broadband digitization and paves the way toward next-generation RF applications.
- 15 July 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Lightwave Technology
- Vol. 43 (18) , 8699-8710
Asynchronous Dense-Frequency-Interleaved Analog-to-Digital Conversion Breaking the Trade-Off Between Bandwidth and Dynamic Range
An analog-to-digital converter (ADC) with broad bandwidth and high dynamic range is of the utmost importance for modern radio frequency (RF) applications. However, as the bandwidth increases with the sampling rate, distortions caused by manufacturing defects are deteriorated, thereby decreasing the dynamic range. To break the trade-off, a novel photonics-assisted asynchronous dense-frequency-interleaved ADC with decoupled bandwidth and dynamic range is proposed. By employing an asynchronous photonic channelizer, densely frequency-interleaving is achieved to convert a broadband RF signal into multiple spectrum segments that are then quantized independently by sub-ADCs. The dynamic range is determined only by the sub-ADCs while the bandwidth is determined by the number of segments or frequency-interleaved channels. Thanks to the asynchrony of the frequency-interleaving, frequency-shift dithering is introduced and taken advantage of to suppress the quantization spurs, further enhancing the dynamic range. The performance requirements for both photonic and electronic components are also eased. Experimentally, a dynamic range of 79.0 dB is achieved at a bandwidth of 5.5 GHz, outperforming the state-of-the-art ADCs, and the flexibility of the method in terms of operating frequency range and bandwidth is also demonstrated. The proposed method provides a unique tool for broadband digitization and paves the way toward next-generation RF applications.
- 25 February 2025
- Published by Elsevier in Neurocomputing
- Vol. 633
LAR-Pose: Lightweight human pose estimation with adaptive regression loss
- 25 February 2025
- Published by Elsevier in Neurocomputing
- Vol. 633
LAR-Pose: Lightweight human pose estimation with adaptive regression loss
- 28 January 2025
- Published by Optica Publishing Group in Photonics Research
- Vol. 13 (2) , 395
Photonic-frequency-interleaving-enabled broadband receiver with high reconfigurability and scalability
The photonic frequency-interleaving (PFI) technique has shown great potential for broadband signal acquisition, effectively overcoming the challenges of clock jitter and channel mismatch in the conventional time-interleaving paradigm. However, current comb-based PFI schemes have complex system architectures and face challenges in achieving large bandwidth, dense channelization, and flexible reconfigurability simultaneously, which impedes practical applications. In this work, we propose and demonstrate a broadband PFI scheme with high reconfigurability and scalability by exploiting multiple free-running lasers for dense spectral slicing with high crosstalk suppression. A dedicated system model is developed through a comprehensive analysis of the system non-idealities, and a cross-channel signal reconstruction algorithm is developed for distortion-free signal reconstruction, based on precise calibrations of intra- and inter-channel impairments. The system performance is validated through the reception of multi-format broadband signals, both digital and analog, with a detailed evaluation of signal reconstruction quality, achieving inter-channel phase differences of less than 2°. The reconfigurability and scalability of the scheme are demonstrated through a dual-band radar imaging experiment and a three-channel interleaving implementation with a maximum acquisition bandwidth of 4 GHz. To the best of our knowledge, this is the first demonstration of a practical radio-frequency (RF) application enabled by PFI. Our work provides an innovative solution for next-generation software-defined broadband RF receivers.
- 28 January 2025
- Published by Optica Publishing Group in Photonics Research
- Vol. 13 (2) , 395
Photonic-frequency-interleaving-enabled broadband receiver with high reconfigurability and scalability
The photonic frequency-interleaving (PFI) technique has shown great potential for broadband signal acquisition, effectively overcoming the challenges of clock jitter and channel mismatch in the conventional time-interleaving paradigm. However, current comb-based PFI schemes have complex system architectures and face challenges in achieving large bandwidth, dense channelization, and flexible reconfigurability simultaneously, which impedes practical applications. In this work, we propose and demonstrate a broadband PFI scheme with high reconfigurability and scalability by exploiting multiple free-running lasers for dense spectral slicing with high crosstalk suppression. A dedicated system model is developed through a comprehensive analysis of the system non-idealities, and a cross-channel signal reconstruction algorithm is developed for distortion-free signal reconstruction, based on precise calibrations of intra- and inter-channel impairments. The system performance is validated through the reception of multi-format broadband signals, both digital and analog, with a detailed evaluation of signal reconstruction quality, achieving inter-channel phase differences of less than 2°. The reconfigurability and scalability of the scheme are demonstrated through a dual-band radar imaging experiment and a three-channel interleaving implementation with a maximum acquisition bandwidth of 4 GHz. To the best of our knowledge, this is the first demonstration of a practical radio-frequency (RF) application enabled by PFI. Our work provides an innovative solution for next-generation software-defined broadband RF receivers.
- 26 January 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Aerospace and Electronic Systems
- Vol. 59 (4) , 4333-4346
PFDIR – A Wideband Photonic-Assisted SAR System
The next generation of synthetic aperture radar (SAR) systems will need transmit and receive analog signals over a wide frequency range with large bandwidth to fulfil the increasing demands. Since the performance of the digital microwave component is deteriorated at increasing frequency, radio frequency (RF) front-end with the capability of frequency conversion is needed for frequency beyond a few gigahertz. However, for the widely employed RF mixers, the inherent imperfect of I-V characteristics of nonlinear devices, generates many undesired mixing spurs which restricts on the instantaneous bandwidth and the spurious-free dynamic range (SFDR). At Aerospace Information Research Institute Chinese Academy of Sciences, a photonic-assisted front-end with functions of signal generation and deramp processing has been conceived and implemented in an experimental deramp-on-receive CW SAR system. The system is called PFDIR (Photonic-Assisted Front-End Deramp-on-Receive Imaging Radar) and is envisaged to obtain SAR imaging at high resolution. In current stage, the Ku-band system with a bandwidth of 5.72 GHz, corresponding to a relative bandwidth of 37.8%, operates well with a fixed two-horn antenna. The configuration of the photonic front-end and the system design are described. Ground-based tests and airborne imaging results with geometrical resolution down to 5 cm are presented.
- 26 January 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Aerospace and Electronic Systems
- Vol. 59 (4) , 4333-4346
PFDIR – A Wideband Photonic-Assisted SAR System
The next generation of synthetic aperture radar (SAR) systems will need transmit and receive analog signals over a wide frequency range with large bandwidth to fulfil the increasing demands. Since the performance of the digital microwave component is deteriorated at increasing frequency, radio frequency (RF) front-end with the capability of frequency conversion is needed for frequency beyond a few gigahertz. However, for the widely employed RF mixers, the inherent imperfect of I-V characteristics of nonlinear devices, generates many undesired mixing spurs which restricts on the instantaneous bandwidth and the spurious-free dynamic range (SFDR). At Aerospace Information Research Institute Chinese Academy of Sciences, a photonic-assisted front-end with functions of signal generation and deramp processing has been conceived and implemented in an experimental deramp-on-receive CW SAR system. The system is called PFDIR (Photonic-Assisted Front-End Deramp-on-Receive Imaging Radar) and is envisaged to obtain SAR imaging at high resolution. In current stage, the Ku-band system with a bandwidth of 5.72 GHz, corresponding to a relative bandwidth of 37.8%, operates well with a fixed two-horn antenna. The configuration of the photonic front-end and the system design are described. Ground-based tests and airborne imaging results with geometrical resolution down to 5 cm are presented.
- 20 January 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Lightwave Technology
- Vol. PP (07338724) , 1-7
A Photonic Microwave Frequency Quadrupler With Decoupled Bandwidth and Carrier Frequency for Multi-Octave LFM Signal Generation
A photonic microwave frequency quadrupler with decoupled bandwidth and carrier frequency for multi-octave linear frequency modulated (LFM) signal generation is proposed and experimentally demonstrated. The frequency quadrupler contains two phase-correlated photonic mixers incorporated in a single hardware, which has four input ports and an output port. An intermediate frequency (IF) LFM signal, is frequency doubled and up-converted to a radio frequency (RF) LFM signal which has a flipped frequency slope and doubled bandwidth in one photonic mixer. Then the generated RF LFM is heterodyned with the IF LFM in the other photonic mixer. At the output port, a frequency-quadrupled LFM signal, of which the carrier frequency is independent of the IF LFM and tunable, is obtained. Since the bandwidth and the center frequency of the generated signal are decoupled, a multi-octave signal is generated from a sub-octave signal with the proposed photonic-assisted frequency quadrupler.
- 20 January 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Lightwave Technology
- Vol. PP (07338724) , 1-7
A Photonic Microwave Frequency Quadrupler With Decoupled Bandwidth and Carrier Frequency for Multi-Octave LFM Signal Generation
A photonic microwave frequency quadrupler with decoupled bandwidth and carrier frequency for multi-octave linear frequency modulated (LFM) signal generation is proposed and experimentally demonstrated. The frequency quadrupler contains two phase-correlated photonic mixers incorporated in a single hardware, which has four input ports and an output port. An intermediate frequency (IF) LFM signal, is frequency doubled and up-converted to a radio frequency (RF) LFM signal which has a flipped frequency slope and doubled bandwidth in one photonic mixer. Then the generated RF LFM is heterodyned with the IF LFM in the other photonic mixer. At the output port, a frequency-quadrupled LFM signal, of which the carrier frequency is independent of the IF LFM and tunable, is obtained. Since the bandwidth and the center frequency of the generated signal are decoupled, a multi-octave signal is generated from a sub-octave signal with the proposed photonic-assisted frequency quadrupler.