Chao Ling
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Chao Ling has a total of 20 co-authors. Here are the top co-authors by number of shared publications:
- Bo Yang
School of Textile Science and Engineering, State Key Laboratory of New Textile Materials and Advanced Processing Technologies, Wuhan Textile University, Wuhan, Hubei 430200, China
2 shared publications Lamei Guo
2 shared publicationsChangyu Qu
1 shared publication- Haibin Zuo
State Key Laboratory of Advanced Metallurgy, University of Science and Technology Beijing, Beijing, China
1 shared publication Haoyu Lan
Intelligent Textile Institute of Innovation, School of Textile and Fashion, Hunan Institute of Engineering Xiangtan Hunan China
1 shared publicationHui Pan
1 shared publication
Latest Publications
- 23 December 2025
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 143 (11)
Mechanically Robust, Thermally Stable, and Crosslinked Bacterial Cellulose Aerogels for Superior Oil Absorption
Frequent oil spills and industrial oily wastewater discharges necessitate the development of high‐performance, recyclable oil‐absorbing materials, as traditional options suffer from low adsorption capacity and poor reusability. To address these limitations, this study developed crosslinked bacterial cellulose (BC) aerogels using 1,2,3,4‐butanetetracarboxylic acid (BTCA) and sodium hypophosphite (SHP) as crosslinking agents. The aerogels were fabricated via freeze‐drying and brief thermal esterification. By systematically optimizing BTCA content, the 10% BTCA formulation achieved a dense 3D network without crystalline precipitation, exhibiting high porosity (99.8%), minimal shrinkage (5.9%), and reduced pore size (2.2 nm). Crosslinking preserved the cellulose I structure but reduced crystallinity, as confirmed by FTIR and XRD. Thermal stability improved significantly, with residual mass at 600°C increasing from 21.8% to 39.0%. The aerogel demonstrated superior compressive resilience and structural stability in water, with oil absorption capacities of 115.4 g/g for paraffin oil, 98 g/g for engine oil, and 96 g/g for edible oil. Recyclability tests showed 84% retention after 20 ethanol cycles. This work provides a scalable, eco‐friendly strategy for robust aerogels with multifunctional oil‐absorption capabilities.
- 23 December 2025
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 143 (11)
Mechanically Robust, Thermally Stable, and Crosslinked Bacterial Cellulose Aerogels for Superior Oil Absorption
Frequent oil spills and industrial oily wastewater discharges necessitate the development of high‐performance, recyclable oil‐absorbing materials, as traditional options suffer from low adsorption capacity and poor reusability. To address these limitations, this study developed crosslinked bacterial cellulose (BC) aerogels using 1,2,3,4‐butanetetracarboxylic acid (BTCA) and sodium hypophosphite (SHP) as crosslinking agents. The aerogels were fabricated via freeze‐drying and brief thermal esterification. By systematically optimizing BTCA content, the 10% BTCA formulation achieved a dense 3D network without crystalline precipitation, exhibiting high porosity (99.8%), minimal shrinkage (5.9%), and reduced pore size (2.2 nm). Crosslinking preserved the cellulose I structure but reduced crystallinity, as confirmed by FTIR and XRD. Thermal stability improved significantly, with residual mass at 600°C increasing from 21.8% to 39.0%. The aerogel demonstrated superior compressive resilience and structural stability in water, with oil absorption capacities of 115.4 g/g for paraffin oil, 98 g/g for engine oil, and 96 g/g for edible oil. Recyclability tests showed 84% retention after 20 ethanol cycles. This work provides a scalable, eco‐friendly strategy for robust aerogels with multifunctional oil‐absorption capabilities.
- 28 November 2025
- Published by Elsevier in Polymer Degradation and Stability
- Vol. 244
Adaptive crosslinking of guar gum-polyborate network to impart efficient flame retardancy to cotton fabrics
- 28 November 2025
- Published by Elsevier in Polymer Degradation and Stability
- Vol. 244
Adaptive crosslinking of guar gum-polyborate network to impart efficient flame retardancy to cotton fabrics
- 11 November 2024
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 142 (5)
A facile and sustainable preparation of effective biomass macromolecular flame retardants for epoxy resins with improved flame retardation, smoke suppression, and mechanical performance
The preparation of biomass flame retardants with efficient flame‐retardant properties is conducive to the realization of sustainable development and is of great practical significance. In this work, a green and sustainable biomass flame retardant PATAPEI was prepared by using phytic acid (PA), tannic acid (TA), and polyethyleneimine (PEI) as reactants via a one‐step method to develop biomass flame retardants that can synchronize enhanced flame retardation, smoke suppression, and mechanical performance of epoxy resin (EP). The EP with only a 3% PATAPEI (EP/3PTP) has a LOI value of 28.5% with a UL‐94 V‐0 classification. The peak heat release rate (PHRR), total heat release (THR), and total smoke release (TSR) of EP/3PTP were decreased by 29.72%, 25.80%, and 21.16%, respectively, in comparison with the ones of pure EP. Additionally, the tensile and impact strengths of EP/3PTP are higher than the ones of pure EP. PATAPEI on heating decomposes to produce phosphorus‐containing acids and biphenyltriol‐containing compounds, which promote to form a good char layer with the aromatic structures during the combustion of EP/3PTP. Therefore, PATAPEI has prospects of wide application in the development of sustainable biomass flame retardant EP.
- 11 November 2024
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 142 (5)
A facile and sustainable preparation of effective biomass macromolecular flame retardants for epoxy resins with improved flame retardation, smoke suppression, and mechanical performance
The preparation of biomass flame retardants with efficient flame‐retardant properties is conducive to the realization of sustainable development and is of great practical significance. In this work, a green and sustainable biomass flame retardant PATAPEI was prepared by using phytic acid (PA), tannic acid (TA), and polyethyleneimine (PEI) as reactants via a one‐step method to develop biomass flame retardants that can synchronize enhanced flame retardation, smoke suppression, and mechanical performance of epoxy resin (EP). The EP with only a 3% PATAPEI (EP/3PTP) has a LOI value of 28.5% with a UL‐94 V‐0 classification. The peak heat release rate (PHRR), total heat release (THR), and total smoke release (TSR) of EP/3PTP were decreased by 29.72%, 25.80%, and 21.16%, respectively, in comparison with the ones of pure EP. Additionally, the tensile and impact strengths of EP/3PTP are higher than the ones of pure EP. PATAPEI on heating decomposes to produce phosphorus‐containing acids and biphenyltriol‐containing compounds, which promote to form a good char layer with the aromatic structures during the combustion of EP/3PTP. Therefore, PATAPEI has prospects of wide application in the development of sustainable biomass flame retardant EP.
- Top Cited Papers
- 21 January 2023
- Published by Elsevier in Industrial Crops and Products
- Vol. 194
A review on the state of flame-retardant cotton fabric: Mechanisms and applications
- 21 January 2023
- Published by Elsevier in Industrial Crops and Products
- Vol. 194
Top Cited PapersA review on the state of flame-retardant cotton fabric: Mechanisms and applications
- 26 December 2022
- Published by Elsevier in Journal of Analytical and Applied Pyrolysis
- Vol. 169, 105842
Recent developments and applications of hyperbranched polymers as flame retardants
- 26 December 2022
- Published by Elsevier in Journal of Analytical and Applied Pyrolysis
- Vol. 169, 105842
Recent developments and applications of hyperbranched polymers as flame retardants
- 19 December 2019
- Published by Springer Nature in Cellulose
- Vol. 27 (4) , 2357-2368
A novel, eco-friendly and durable flame-retardant cotton-based hyperbranched polyester derivative
- 19 December 2019
- Published by Springer Nature in Cellulose
- Vol. 27 (4) , 2357-2368
A novel, eco-friendly and durable flame-retardant cotton-based hyperbranched polyester derivative
- 27 September 2019
- Published by Springer Nature in Journal of Iron and Steel Research International
- Vol. 27 (7) , 743-754
Microstructure evolution of coke under CO2 and H2O atmospheres
- 27 September 2019
- Published by Springer Nature in Journal of Iron and Steel Research International
- Vol. 27 (7) , 743-754
Microstructure evolution of coke under CO2 and H2O atmospheres