Prachum Utaprom
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Prachum Utaprom has a total of 9 co-authors. Here are the top co-authors by number of shared publications:
- Phuachat Sukruan
Rajamangala University of Technology Suvarnabhumi
3 shared publications - Wasakorn Traiphat
Department of Electrical Engineering, Faculty of Industrial Education, Rajamangala University of Technology Suvarnabhumi, Phra Nakhon Si Ayutthaya 13000, Thailand
3 shared publications - Wichai Nramat
Department of Electronics Engineering and Telecommunication, Faculty of Industrial Education, Rajamangala University of Technology Suvarnabhumi, Phra Nakhon Si Ayutthaya 13000, Thailand
3 shared publications - Pitichon Piamboriboon
Rajamangala University of Technology Suvarnabhumi
2 shared publications - Sutep Naramat
Ubon Ratchathani Rajabhat University
2 shared publications - Luedate Phatedoung
Rajamangala University of Technology Suvarnabhumi
1 shared publication
Latest Publications
- Open Access
- 31 January 2025
- Published by OU Scientific Route in EUREKA: Physics and Engineering
- No. 1,p. 66-74
Experiments comparing the efficency between watering vegetable crops with traditional methods and automatic watering systems
This article experiments comparing the efficiency between watering vegetable crops with traditional methods and automatic watering systems. Objectives: 1. To study the operation of sensors, including temperature and relative humidity sensors and soil moisture sensors. 2. To compare the conventional irrigation of crops with automatic irrigation and to assess the satisfaction of 5 farmers. This is to be used as information to support farmers' decisions. In smart agriculture that is on the rise around the world. Install 1 Relative Temperature and Humidity Sensor (AM2315 I2C) to measure air temperature and humidity values converted into digital signals. Transmit via Wi-Fi signal to the WeMos Arduno UNoR3+ microcontroller ESP8266, and 1 capacitive moisture sensor that sends an analog signal to the WeMos Arduno UNoR3+ESP8266 microcontroller. Experiments are carried out in greenhouses for growing vegetables measuring 6x3 meters. Results: 1. Automatic irrigation of the house with sensors. By experimenting with growing white cabbage, it was found that the temperature control was at an average of 37 degrees Celsius. Average relative humidity inside greenhouses 52.3 %, average soil moisture retention 55 %. 2. The results of the questionnaire of 5 farmers showed that the conventional irrigation of crops had an average value of 1.68 and an S.D value of 0.42. Irrigation with automation. The average value is 4.84 and the S.D value is 0.29, which shows that the irrigation system is automated. Efficient work shortening the working time can solve the problem of changing global climate conditions. This makes it easy for farmers to make decisions when choosing to use the automation system.
- 31 January 2025
- Published by OU Scientific Route in EUREKA: Physics and Engineering
- No. 1,p. 66-74
Open AccessExperiments comparing the efficency between watering vegetable crops with traditional methods and automatic watering systems
This article experiments comparing the efficiency between watering vegetable crops with traditional methods and automatic watering systems. Objectives: 1. To study the operation of sensors, including temperature and relative humidity sensors and soil moisture sensors. 2. To compare the conventional irrigation of crops with automatic irrigation and to assess the satisfaction of 5 farmers. This is to be used as information to support farmers' decisions. In smart agriculture that is on the rise around the world. Install 1 Relative Temperature and Humidity Sensor (AM2315 I2C) to measure air temperature and humidity values converted into digital signals. Transmit via Wi-Fi signal to the WeMos Arduno UNoR3+ microcontroller ESP8266, and 1 capacitive moisture sensor that sends an analog signal to the WeMos Arduno UNoR3+ESP8266 microcontroller. Experiments are carried out in greenhouses for growing vegetables measuring 6x3 meters. Results: 1. Automatic irrigation of the house with sensors. By experimenting with growing white cabbage, it was found that the temperature control was at an average of 37 degrees Celsius. Average relative humidity inside greenhouses 52.3 %, average soil moisture retention 55 %. 2. The results of the questionnaire of 5 farmers showed that the conventional irrigation of crops had an average value of 1.68 and an S.D value of 0.42. Irrigation with automation. The average value is 4.84 and the S.D value is 0.29, which shows that the irrigation system is automated. Efficient work shortening the working time can solve the problem of changing global climate conditions. This makes it easy for farmers to make decisions when choosing to use the automation system.
- Open Access
- 28 November 2024
- Published by OU Scientific Route in EUREKA: Physics and Engineering
- No. 6,p. 93-103
Drying of andrographis paniculata with hot air controlled with artificial intelligence
This article presents the development of drying Andrographis paniculata with hot air controlled by artificial intelligence system together with infrared rays. The tools used in the research are Andrographis paniculata drying cabinet with hot air controlled by artificial intelligence system together with infrared rays. The part consists of an oven with a width of 1204 millimeters and a length of 380 millimeters. A 65-watt blower fan serves to blow air to move heat evenly into the dryer. The source of heat release uses a heating coil, Fin Heater/fin heater. Voltage size 220 V 1,000 W, length 450 mm, metal weave size 11 mm, fin size 31 mm. Heat with a thermocouple was checked to compare with the temperature set. In the event that the temperature in the Andrographis paniculata dryer has not decreased, the thermal camera will turn on the ventilation fan to carry the heat outside. and ordered to reduce the temperature of the heater. The measured temperature data will be saved to the Raspberry Pi server. Research found that the machine can dry Andrographis paniculata according to the machine's operating conditions. And can dry Andrographis paniculata at a temperature of 40 °C according to the value specified in drying. The humidity before drying was 100 % and after drying – 0.73 %. The weight before drying was – 30g and after drying – 8.1g. The drying rate was 1.37 and the average temperature – 60 °C according to the value specified in drying. Moisture before drying was 100 % and after drying – 0.79 %. Weight before drying was 60g and after drying – 12.6g. Drying rate was 1.27. The system also uses a low heat source with a power of 1 kW. Electrical voltage – 220 V
- 28 November 2024
- Published by OU Scientific Route in EUREKA: Physics and Engineering
- No. 6,p. 93-103
Open AccessDrying of andrographis paniculata with hot air controlled with artificial intelligence
This article presents the development of drying Andrographis paniculata with hot air controlled by artificial intelligence system together with infrared rays. The tools used in the research are Andrographis paniculata drying cabinet with hot air controlled by artificial intelligence system together with infrared rays. The part consists of an oven with a width of 1204 millimeters and a length of 380 millimeters. A 65-watt blower fan serves to blow air to move heat evenly into the dryer. The source of heat release uses a heating coil, Fin Heater/fin heater. Voltage size 220 V 1,000 W, length 450 mm, metal weave size 11 mm, fin size 31 mm. Heat with a thermocouple was checked to compare with the temperature set. In the event that the temperature in the Andrographis paniculata dryer has not decreased, the thermal camera will turn on the ventilation fan to carry the heat outside. and ordered to reduce the temperature of the heater. The measured temperature data will be saved to the Raspberry Pi server. Research found that the machine can dry Andrographis paniculata according to the machine's operating conditions. And can dry Andrographis paniculata at a temperature of 40 °C according to the value specified in drying. The humidity before drying was 100 % and after drying – 0.73 %. The weight before drying was – 30g and after drying – 8.1g. The drying rate was 1.37 and the average temperature – 60 °C according to the value specified in drying. Moisture before drying was 100 % and after drying – 0.79 %. Weight before drying was 60g and after drying – 12.6g. Drying rate was 1.27. The system also uses a low heat source with a power of 1 kW. Electrical voltage – 220 V
- Open Access
- 19 January 2023
- Published by OU Scientific Route in EUREKA: Physics and Engineering
- No. 1,p. 54-66
Developing a prototype centre using agricultural smart sensors to promote agrarian production with technology
This article presents the development of a model center using agricultural intelligent center technology. The goal of this research is 1. To develop a wireless sensor network. 2. To be a source of learning on the use of sensor technology in agriculture. For local and nearby farmers Using the Sufficiency Economy Learning Center, according to King's Science. The Rajamangala University of Technology Suvarnabhumi is a research area. With the problems faced in farming today. It found that the world's climate change whether it's drought. Rains leave ranges and toxic airborne particulate matter caused by farming to match current problem conditions. The researchers then designed a two-part system: 1. Node Moisture Sensor that measures soil moisture and commands the opening – It also controls on-off with a manual switch. Wind speed and wind direction sensors, light intensity sensors, temperature, and humidity sensors, and Particulate Matters Sensor 1.0, 2.5, 10 with environmental reports within the growing area via Wi-F signals to (Sever) Raspberry Pi record real-time data. Every 30 seconds According to research, node moisture sensors can measure soil moisture and record results, and the station measures the environment within the growing area via a Wi-F signal to (Sever) Raspberry Pi. Rainfall values measured by local rainfall sensors measuring up to 35.3 mm are within the threshold of heavy rain. The maximum wind speed measured is 8.5 km/h, the maximum temperature of 35.8 degrees Celsius, and the maximum humidity of 99.9 percent, the light intensity is up to 58,002 Lux, and the Final Particles, with pm 1.0 up to 40.1 microns, PM 2.5 up to 51.3 microns and PM 10 up to 63.5 microns. Apply agriculture to 50 interested farmers after receiving knowledge transfer of smart sensor technology. The expansion has resulted in 3 farmers and will continue to expand in the future. Promote the use of agricultural technology. Intensifying communities and supporting global climate change
- 19 January 2023
- Published by OU Scientific Route in EUREKA: Physics and Engineering
- No. 1,p. 54-66
Open AccessDeveloping a prototype centre using agricultural smart sensors to promote agrarian production with technology
This article presents the development of a model center using agricultural intelligent center technology. The goal of this research is 1. To develop a wireless sensor network. 2. To be a source of learning on the use of sensor technology in agriculture. For local and nearby farmers Using the Sufficiency Economy Learning Center, according to King's Science. The Rajamangala University of Technology Suvarnabhumi is a research area. With the problems faced in farming today. It found that the world's climate change whether it's drought. Rains leave ranges and toxic airborne particulate matter caused by farming to match current problem conditions. The researchers then designed a two-part system: 1. Node Moisture Sensor that measures soil moisture and commands the opening – It also controls on-off with a manual switch. Wind speed and wind direction sensors, light intensity sensors, temperature, and humidity sensors, and Particulate Matters Sensor 1.0, 2.5, 10 with environmental reports within the growing area via Wi-F signals to (Sever) Raspberry Pi record real-time data. Every 30 seconds According to research, node moisture sensors can measure soil moisture and record results, and the station measures the environment within the growing area via a Wi-F signal to (Sever) Raspberry Pi. Rainfall values measured by local rainfall sensors measuring up to 35.3 mm are within the threshold of heavy rain. The maximum wind speed measured is 8.5 km/h, the maximum temperature of 35.8 degrees Celsius, and the maximum humidity of 99.9 percent, the light intensity is up to 58,002 Lux, and the Final Particles, with pm 1.0 up to 40.1 microns, PM 2.5 up to 51.3 microns and PM 10 up to 63.5 microns. Apply agriculture to 50 interested farmers after receiving knowledge transfer of smart sensor technology. The expansion has resulted in 3 farmers and will continue to expand in the future. Promote the use of agricultural technology. Intensifying communities and supporting global climate change