Mohamed Abid
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Mohamed Abid has a total of 22 co-authors. Here are the top co-authors by number of shared publications:
- Abdel Ghani Aissaoui
University Tahri Mohamed of Bechar
3 shared publications - H. Lassri
Université Hassan II de Casablanca
3 shared publications - Reda Moubah
Université Hassan II de Casablanca - Faculté des Sciences Ain Chock
2 shared publications - Youcef Bakou
Unité de Recherche en Energies Renouvelables en Milieu Saharien (URERMS) Centre de Développement Des Energies Renouvelables (CDER)
2 shared publications A. Harrouz
LDDI Laboratory, University Ahmed Draia,Department of Hydrocarbon and renewable energy,Adrar,Algeria,01000
1 shared publication- A. Saadi
LBGM, ENS de Casablanca, Université Hassan II de Casablanca, Casablanca, Morocco
1 shared publication
Latest Publications
- Open Access
- 1 February 2023
- Published by Institute of Advanced Engineering and Science in Bulletin of Electrical Engineering and Informatics
- Vol. 12 (1) , 10-20
Hybrid sliding neural network controller of a direct driven vertical axis wind turbine
This study aims to propose a robust hybrid sliding mode artificial neural network control (SM-ANN) scheme for controlling the stator power (active/reactive) of a doubly fed induction generator (DFIG)-based direct drive vertical axis wind turbine (VAWT) power system under a real-world scenario wind speed that will be installed in the Adrar region (Saharan zone) of Algeria. The SM-ANN scheme will control the stator power of the direct drive VAWT power. The chattering phenomenon is the most significant disadvantage associated with sliding mode control (SMC). In order to find a solution to this issue, the artificial neural network (ANN) method was applied to pick the appealing part of the SMC. MATLAB/Simulink is used to do an evaluation, after which the SM-ANN controller being suggested is compared to both traditional sliding mode (SM) and proportional-integral (PI) controllers. The results of the simulation demonstrated that the recommended SM-ANN controller has good performance in terms of enhancing the quality of energy that is delivered to the power network. This is in comparison to the traditional SM and PI controllers, which both have a long history of use. Notwithstanding the fact that there is DFIG parameter fluctuation present.
- 1 February 2023
- Published by Institute of Advanced Engineering and Science in Bulletin of Electrical Engineering and Informatics
- Vol. 12 (1) , 10-20
Open AccessHybrid sliding neural network controller of a direct driven vertical axis wind turbine
This study aims to propose a robust hybrid sliding mode artificial neural network control (SM-ANN) scheme for controlling the stator power (active/reactive) of a doubly fed induction generator (DFIG)-based direct drive vertical axis wind turbine (VAWT) power system under a real-world scenario wind speed that will be installed in the Adrar region (Saharan zone) of Algeria. The SM-ANN scheme will control the stator power of the direct drive VAWT power. The chattering phenomenon is the most significant disadvantage associated with sliding mode control (SMC). In order to find a solution to this issue, the artificial neural network (ANN) method was applied to pick the appealing part of the SMC. MATLAB/Simulink is used to do an evaluation, after which the SM-ANN controller being suggested is compared to both traditional sliding mode (SM) and proportional-integral (PI) controllers. The results of the simulation demonstrated that the recommended SM-ANN controller has good performance in terms of enhancing the quality of energy that is delivered to the power network. This is in comparison to the traditional SM and PI controllers, which both have a long history of use. Notwithstanding the fact that there is DFIG parameter fluctuation present.
- 1 November 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 910-915
DTC Control of the DFIG, Application to the Production of Electrical Energy
This paper presents a study of modelling and control of doubly fed induction generator for use on wind power system, the object is controlling and keeping decoupling between active and reactive power of DFIG, through to applied the DTC control at the torque and flux loop in order to achieve a better quality of energy and to make the system insensitive to disturbances
- 1 November 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 910-915
DTC Control of the DFIG, Application to the Production of Electrical Energy
This paper presents a study of modelling and control of doubly fed induction generator for use on wind power system, the object is controlling and keeping decoupling between active and reactive power of DFIG, through to applied the DTC control at the torque and flux loop in order to achieve a better quality of energy and to make the system insensitive to disturbances
- 28 October 2019
- Published by Springer Nature in Journal of Low Temperature Physics
- Vol. 198 (1-2) , 11-17
Enhanced Magnetization at the Interface in Fe83Tb17/Pt Multilayers
- 28 October 2019
- Published by Springer Nature in Journal of Low Temperature Physics
- Vol. 198 (1-2) , 11-17
Enhanced Magnetization at the Interface in Fe83Tb17/Pt Multilayers
- 19 January 2019
- Published by Springer Nature in Journal of Superconductivity and Novel Magnetism
- Vol. 32 (8) , 2633-2637
Magnetic Properties and Electronic Structure of Ni/C Multilayer Films
- 19 January 2019
- Published by Springer Nature in Journal of Superconductivity and Novel Magnetism
- Vol. 32 (8) , 2633-2637
Magnetic Properties and Electronic Structure of Ni/C Multilayer Films
- 1 January 2014
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-6
Wind energy conversion system based on a Double-Fed Induction Generator using fuzzy logic and sliding mode control
In this paper, a decoupling control strategy has been applied to control the active and reactive powers generated by a Double Feed Induction Generator (DFIG). We propose new control strategies based on fuzzy logic and sliding mode in order to control the power of the wind turbine transmitted to the grid and to make the wind turbine adaptable to different constraints. The results obtained by simulation prove the effectiveness of the control strategies in terms of decoupling, robustness and dynamic performance for different operating conditions.
- 1 January 2014
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-6
Wind energy conversion system based on a Double-Fed Induction Generator using fuzzy logic and sliding mode control
In this paper, a decoupling control strategy has been applied to control the active and reactive powers generated by a Double Feed Induction Generator (DFIG). We propose new control strategies based on fuzzy logic and sliding mode in order to control the power of the wind turbine transmitted to the grid and to make the wind turbine adaptable to different constraints. The results obtained by simulation prove the effectiveness of the control strategies in terms of decoupling, robustness and dynamic performance for different operating conditions.
- 17 December 2009
- Published by Elsevier in Physica B: Condensed Matter
- Vol. 405 (5) , 1312-1315
Magnetic studies of spin wave excitations in Ni/Au multilayers
- 17 December 2009
- Published by Elsevier in Physica B: Condensed Matter
- Vol. 405 (5) , 1312-1315
Magnetic studies of spin wave excitations in Ni/Au multilayers