Yunlei Zhao

Steel truss–arch composite bridge systems are widely used in bridge engineering to provide sufficient space for double lanes. However, a lack of research exists on their mechanical performance throughout their lifespan, resulting in uncertainties regarding bearing capacity and the risk of bridge failure. This paper conducts a numerical study of the structural mechanical performance of a flexible arch composite bridge with steel truss beams throughout its lifespan to determine the critical components and their mechanical behavior. Critical vehicle loads are used to assess the bridge’s mechanical performance. The results show that the mechanical performance of the bridge changes significantly when the temporary piers and the bridge deck pavement are removed, substantially influencing the effects of the vehicle loads on the service life. The compressive axial force of the diagonal bar significantly increases to 33,101 kN near the supports during the two construction stages, and the axial force in the upper chord of the midspan increases by 4.1 times under a critical load. Moreover, the suspender tensions and maximum vertical displacement are probably larger than the limit of this bridge system in the service stage, and this is caused by the insufficient longitudinal bending stiffness of truss beams. Therefore, monitoring and inspection of critical members are necessary during the removal of temporary piers and bridge deck paving, and an appropriate design in steel truss beams is required to improve the life cycle assessment of this bridge system.

The existing literature mainly focuses on the research of reinforced concrete (RC) beams under a single load such as blast or impact. In this paper, the slab–rib–slab RC beam, a new type of structure widely used in bridge structures, was taken as the research object. The explicit dynamic analysis software LS-DYNA was used to numerically analyze the dynamic response and failure behavior of I-shaped RC beams under combined blast and impact loads. For this reason, an effective numerical analysis model was obtained by carrying out experiments on I-shaped RC beams under contact explosion. The key factors affecting the dynamic response of the structure under combined loads were numerically analyzed. Numerical results showed that different load application sequences have important effects on the dynamic response of the structure. When the impact load was first applied to the structure, more severe concrete damage and deformation occured in the depth direction of the beam. However, when the blast load was first applied to the structure, the concrete at the lower flange was damaged in the span direction of the beam due to tension, and no large-scale concrete spallation occurred in the depth direction. This was mainly due to the different mechanisms of blast and impact loads. In addition, the vulnerability of the I-shaped RC beams varied with some structural parameters, including span, depth, and configuration of reinforcement. At the same time, the results showed that the structure is more sensitive to changes in structural parameters when it is first subjected to impact loads.