HÁHumberto Ávila-Pérez

Humberto Ávila-Pérez

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Humberto Ávila-Pérez has a total of 15 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Artificial Intelligence Based on Acoustic Analysis for COPD Detection with Clinical Validation: A Systematic Review

    by Franco- Ríos, Jorge Janeman, Iván Gallardo-Bernal, Humberto Ávila-Pérez, Leopoldo Rodríguez-Matías, Rodríguez- Matías, Jossué Manuel, Zambrano- Dávila, Juana Inés

  • Open Access

    Quality Assessment of Quercus scytophylla Liebm Charcoal Produced in a Metal Kiln in the Cordón Grande Ejido, Guerrero, Mexico

    by José Navarro-Martínez, Humberto Ávila-Pérez, Ma. Amparo Máxima Borja de la Rosa, Iván Gallardo-Bernal, José Luis Rosas-Acevedo, Lorena Inés Bernal-Mendoza, María Guzmán-Martínez

    The present study evaluates the quality of charcoal produced from Quercus scytophylla Liebm. in Guerrero, Mexico, using a portable metal oven, namely, the Guadiana Valley Experimental Field (CEVAG) type. A 2×3 factorial design was employed to analyse the influence of wood heterogeneity (sapwood vs. heartwood) and position within the oven (low, medium, high) on the yield and physicochemical properties of the charcoal. The mean yield of the process was found to be 20.0–26.7%. The characteristics of six properties were determined: moisture content, volatile matter, ash content, fixed carbon, basic density, and calorific value. The charcoal exhibited a low moisture content (1.49–3.56%) and ash content (2.18–2.52%), meeting international standards. Volatile matter was higher in heartwood (22%). Fixed carbon (73.73–74.05%) was close to the optimal parameters of international standards. The calorific value exhibited marked variations in accordance with the position during the process of carbonisation, with elevated values observed in the lower section (6751–7508 cal g−1). The basic density of the wood was higher in the sapwood, with a maximum value of 0.57 g cm−3 observed in the upper section. A positive linear relationship was identified between the basic density and calorific value, although the coefficient of determination was small (R2=0.67) and therefore inconclusive. The analysis showed the type of relationship that can be established between these two variables. The upper part of the kiln exhibited the optimal physicochemical properties, with the levels deemed acceptable. The utilisation of this oak for charcoal production fosters sustainable forest management and engenders direct economic benefits for rural communities. In conclusion, the research provides a viable technical model for sustainable wood energy production in forestry regions and underscores the need to evaluate other timber species with this potential.

  • Open Access

    Study of the Spatial Distribution of the Bark Beetle in the Ejido Tixtlancingo

    by Humberto Avila-Pérez, María Guzmán-Martínez, José L. Rosas-Acevedo, José Navarro-Martínez, Iván Gallardo-Bernal

    The spatial distribution of Dendroctonus frontalis Zimmermann, 1868, and Dendroctonus mexicanus Hopkins, 1905, was determined from 2020 to 2021 in the Tixtlancingo ejido. The information came from two surveys because, despite the abundant forested areas in this geographical area of the state of Guerrero, Mexico, economic resources for pest biomonitoring are limited. However, it was possible to identify the presence of 76 outbreaks affecting 1117.697 hectares and 95,078 trees, totaling 14,223.8 m3 of standing timber volume. In 2020, 28 outbreaks were reported, with the eastern spatial distribution showing the most damage from bark beetles, particularly in outbreaks 7 and 14 of the surveyed area. The most affected conifers were Pinus maximinoi H. E. Moore (44.71%), Pinus oocarpa Schiede ex Schltdl. (39.93%), and Pinus pseudostrobus Lindl. (15.36%). The affected timber volume was observed in diameter categories of 30 cm for the three pine species, with infestation of 90,549 trees (13,497.6 m3 t.t.v. (total tree volume)) across 1057.64 hectares. In 2021, 48 outbreaks were recorded, with the northeastern and southern parts of the surveyed area showing the most damage from the bark beetle. The trees most affected by the bark beetle were P. oocarpa (59.17%), P. maximinoi (33.94%), and P. pseudostrobus (6.89%). It was observed that the affected volume occurred in trees with diameter categories of 50 cm for the three pine species, affecting 4529 trees (726.214 m3 t.t.v.) distributed over 60.06 hectares. The contribution of this work lies in establishing a baseline for monitoring damage caused by this beetle, which affects forest resources and diminishes the possibility of maintaining carbon capture areas in the medium and long term, thus impacting the Sustainable Development Goals (SDGs) of the 2030 agenda, specifically Goals 11, 13, and 15.


  • Open Access

    Comparative Analysis of Water Quality Applying Statistic and Machine Learning Method: A Case Study in Coyuca Lagoon and Tecpan River, Mexico

    by Humberto Avila-Perez, Enrique J. Flores-Munguía, José L. Rosas-Acevedo, Iván Gallardo-Bernal, Tania A. Ramirez-Delreal

    The water quality monitoring of lotic and lentic ecosystems allows for informing the possible use in human activities and the consumption of the vital liquid. This work measures the biochemical parameters in Coyuca Lagoon and Tecpan River, localized in Guerrero, Mexico. A comparative statistical analysis of six physicochemical factors in lentic and lotic ecosystems was carried out, finding individual pH values slightly higher for the lagoon ecosystem and lower for the river. For electrical conductivity, we find river sites with parameters lower than 500 μS/cm ideal for human use and consumption. On the contrary, in sites of the lagoon system, the conductivity was higher. As for the total hardness of the river, the values are within the Mexican standard; however, for the lagoon ecosystem, the water has a higher amount of calcium and magnesium salts and is not recommended for human consumption. For chlorides, the lagoon system exceeds the limits of regulations for human consumption; otherwise, it happens with the lotic system. The values of total alkalinity and total dissolved solids are higher for the lentic system than for the lotic one. Finally, the machine learning method shows the importance of measuring other parameters to determine the water quality, especially the salinity and calcium hardness.