Kannan Ramaswamy
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Kannan Ramaswamy has a total of 43 co-authors. Here are the top co-authors by number of shared publications:
Waseem Ahmad Wani
Department of Physics, BITS-Pilani, Hyderabad Campus, Medchal District, Hyderabad, India
7 shared publicationsB. Harihara Venkataraman
Department of Physics, BITS – Pilani Hyderabad Campus, Hyderabad, India
3 shared publicationsHarihara Venkataraman
Department of Physics, BITS-Pilani, Hyderabad Campus, Medchal District, Hyderabad, India
3 shared publications- B. Harihara Venkataraman
Department of Physics Birla Institute of Technology and Science‐Pilani Hyderabad India
2 shared publications Nilofar Naaz
2 shared publications- Sanket Goel
Department of Electrical and Electronics Engineering, Birla Institute of Technology and Science (BITS) Pilani, Hyderabad, India
2 shared publications
Latest Publications
- Open Access
- 7 August 2025
- Published by Wiley in Advanced Materials
- Vol. 37 (42) , e03852
Environmental Control of Ferroelectricity in Hafnia Films
Ferroelectricity in hafnia films has triggered significant research interest over the past decade due to its immense promise for next‐generation memory devices. However, the origin of ferroic behavior at the nanoscale and the means to control it remain an open question, with the consensus being that it deviates from conventional ferroelectrics. In this work, a novel approach is presented to tune ferroelectric properties of hafnia through environmental control using piezoresponse force microscopy (PFM). A reversible transition from non‐ferroelectric to ferroelectric behavior by modulating the surrounding atmosphere is demonstrated. Notably, the domain relaxation dynamics exhibit striking sensitivity to environmental factors, including ambient conditions, specific gas compositions (N 2 , CO 2 , O 2 ), and humidity levels. The critical role of surface water removal, gas molecule adsorption, and their interactions with near‐surface oxygen vacancies is identified and the injected charge in determining ferroelectricity in uncapped hafnia films. These insights reveal a significant strategy for stabilizing ferroic responses by carefully regulating the chemical environment, offering new possibilities for precise control in hafnia‐based films.
- 7 August 2025
- Published by Wiley in Advanced Materials
- Vol. 37 (42) , e03852
Open AccessEnvironmental Control of Ferroelectricity in Hafnia Films
Ferroelectricity in hafnia films has triggered significant research interest over the past decade due to its immense promise for next‐generation memory devices. However, the origin of ferroic behavior at the nanoscale and the means to control it remain an open question, with the consensus being that it deviates from conventional ferroelectrics. In this work, a novel approach is presented to tune ferroelectric properties of hafnia through environmental control using piezoresponse force microscopy (PFM). A reversible transition from non‐ferroelectric to ferroelectric behavior by modulating the surrounding atmosphere is demonstrated. Notably, the domain relaxation dynamics exhibit striking sensitivity to environmental factors, including ambient conditions, specific gas compositions (N 2 , CO 2 , O 2 ), and humidity levels. The critical role of surface water removal, gas molecule adsorption, and their interactions with near‐surface oxygen vacancies is identified and the injected charge in determining ferroelectricity in uncapped hafnia films. These insights reveal a significant strategy for stabilizing ferroic responses by carefully regulating the chemical environment, offering new possibilities for precise control in hafnia‐based films.
- 28 March 2025
- Published by Elsevier in Renewable Energy
- Vol. 247
Calibrating underwater photovoltaic performance: Demonstration using monocrystalline and polycrystalline silicon solar cells
- 28 March 2025
- Published by Elsevier in Renewable Energy
- Vol. 247
Calibrating underwater photovoltaic performance: Demonstration using monocrystalline and polycrystalline silicon solar cells
- Open Access
- 26 October 2024
- Published by Springer Nature in Scientific Reports
- Vol. 14 (1) , 1-12
Exploring current conduction dynamics in multiferroic BiFeO3 thin films prepared via modified chemical solution method
The current study describes current conduction mechanisms in BiFeO3 thin films prepared by using a modified chemical solution-based technique. In particular, in these films, X-ray photoelectron spectroscopy revealed that the defect causing Fe2+ ions reduced by about 18% compared to the solution-based synthesis methods reported before, indicating better film quality. The leakage current density was measured to be 1.7 × 10–6 A/cm2 at an applied voltage of 1.5 V, which is one order of magnitude less than the previously reported work in a similar system. Oxygen annealing was found to be effective in further reducing the current conduction, making these films a suitable choice for device applications. The current–voltage curves exhibited three different behaviours of current conduction mechanisms in these films. In particular, when the applied electric field was increased, a transition from Ohmic conduction to trap-filled space charge limited conduction was observed. The presented investigations demonstrate the importance of deposition methods in determining the suitability of thin films for device applications.
- 26 October 2024
- Published by Springer Nature in Scientific Reports
- Vol. 14 (1) , 1-12
Open AccessExploring current conduction dynamics in multiferroic BiFeO3 thin films prepared via modified chemical solution method
The current study describes current conduction mechanisms in BiFeO3 thin films prepared by using a modified chemical solution-based technique. In particular, in these films, X-ray photoelectron spectroscopy revealed that the defect causing Fe2+ ions reduced by about 18% compared to the solution-based synthesis methods reported before, indicating better film quality. The leakage current density was measured to be 1.7 × 10–6 A/cm2 at an applied voltage of 1.5 V, which is one order of magnitude less than the previously reported work in a similar system. Oxygen annealing was found to be effective in further reducing the current conduction, making these films a suitable choice for device applications. The current–voltage curves exhibited three different behaviours of current conduction mechanisms in these films. In particular, when the applied electric field was increased, a transition from Ohmic conduction to trap-filled space charge limited conduction was observed. The presented investigations demonstrate the importance of deposition methods in determining the suitability of thin films for device applications.
- 22 February 2024
- Published by Wiley in Progress in Photovoltaics: Research and Applications
- Vol. 32 (8) , 556-568
Photon upconversion assisted ferroelectric photovoltaics: Device configuration with multifaceted influence in augmenting the photovoltaic response of BiFeO3 thin‐film solar cells
This work presents a novel paradigm for upconversion‐assisted ferroelectric photovoltaic devices. The system comprises a ferroelectric active layer (BiFeO3), an upconverter layer (Yb; Er‐doped ZnO), a conductive ITO‐coated glass substrate, and a reflective coating (Al) at the rear end of the glass substrate. The photovoltaic efficiency of the single‐layer BFO was found to be 0.71%. With the prescribed device model, the total solar efficiency of BiFeO3 improved significantly and touched solar conversion efficiency of 2.21%. This model's projection widens the future perspectives of device performance in emerging photovoltaic technology, mainly perovskite‐based solar cells.
- 22 February 2024
- Published by Wiley in Progress in Photovoltaics: Research and Applications
- Vol. 32 (8) , 556-568
Photon upconversion assisted ferroelectric photovoltaics: Device configuration with multifaceted influence in augmenting the photovoltaic response of BiFeO3 thin‐film solar cells
This work presents a novel paradigm for upconversion‐assisted ferroelectric photovoltaic devices. The system comprises a ferroelectric active layer (BiFeO3), an upconverter layer (Yb; Er‐doped ZnO), a conductive ITO‐coated glass substrate, and a reflective coating (Al) at the rear end of the glass substrate. The photovoltaic efficiency of the single‐layer BFO was found to be 0.71%. With the prescribed device model, the total solar efficiency of BiFeO3 improved significantly and touched solar conversion efficiency of 2.21%. This model's projection widens the future perspectives of device performance in emerging photovoltaic technology, mainly perovskite‐based solar cells.
- 10 May 2023
- Published by Springer Nature in Journal of Electronic Materials
- Vol. 52 (8) , 5388-5395
Defect-Induced Control on Current Conduction of Cobalt-Doped BiFeO3 Thin-Film Devices
- 10 May 2023
- Published by Springer Nature in Journal of Electronic Materials
- Vol. 52 (8) , 5388-5395
Defect-Induced Control on Current Conduction of Cobalt-Doped BiFeO3 Thin-Film Devices
- 7 February 2023
- Published by Elsevier in Materials Chemistry and Physics
- Vol. 298
Connecting electrical current conduction and Urbach energy in doped BiFeO3 thin-films
- 7 February 2023
- Published by Elsevier in Materials Chemistry and Physics
- Vol. 298
Connecting electrical current conduction and Urbach energy in doped BiFeO3 thin-films
- 3 October 2022
- Published by Taylor & Francis in Ferroelectrics
- Vol. 598 (1) , 159-168
Role of molybdenum doping in reducing leakage current density of BiFeO3 based thin film devices
Leakage current properties of pure and Mo-doped BiFeO` (BFO) thin films have been studied in order to identify the cause of high leakage currents. Interestingly, it was observed that the leakage current density reduced by more than two orders of magnitude upon Mo doping at Fe site of BFO. According to J-V characteristics, the leakage current density decreased from 1.101 × 10-6 A/cm2 to 9.4 × 10-8 A/cm2 at an applied bias voltage of 2.75 V with Mo substitution. These findings suggest that oxygen vacancies, rather than Fe2+ ions, are the primary cause of BFO's high conductivity.
- 3 October 2022
- Published by Taylor & Francis in Ferroelectrics
- Vol. 598 (1) , 159-168
Role of molybdenum doping in reducing leakage current density of BiFeO3 based thin film devices
Leakage current properties of pure and Mo-doped BiFeO` (BFO) thin films have been studied in order to identify the cause of high leakage currents. Interestingly, it was observed that the leakage current density reduced by more than two orders of magnitude upon Mo doping at Fe site of BFO. According to J-V characteristics, the leakage current density decreased from 1.101 × 10-6 A/cm2 to 9.4 × 10-8 A/cm2 at an applied bias voltage of 2.75 V with Mo substitution. These findings suggest that oxygen vacancies, rather than Fe2+ ions, are the primary cause of BFO's high conductivity.
- 1 August 2022
- Published by Academy of Management in Academy of Management Proceedings
- Vol. 2022 (1)
Political Relations and CSR-Firm Performance: Evidence From India (WITHDRAWN)
The impact of corporate social responsibility (CSR) on performance is gaining increasing attention and has generated an ongoing debate. We contribute to this critical topic by proposing that this r...
- 1 August 2022
- Published by Academy of Management in Academy of Management Proceedings
- Vol. 2022 (1)
Political Relations and CSR-Firm Performance: Evidence From India (WITHDRAWN)
The impact of corporate social responsibility (CSR) on performance is gaining increasing attention and has generated an ongoing debate. We contribute to this critical topic by proposing that this r...
- Open Access
- 1 November 2021
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 2070 (1) , 012088
Significantly reduced leakage current density in Mn-doped BiFeO3 thin films deposited using spin coating technique
BiFeO3 (BFO) and Mn-doped BFO thin films are prepared on indium tin oxide/glass substrates using wet chemical deposition technique. The role of Mn defects (3% to 10%) on the leakage current density and other physical properties of BFO thin film devices is investigated. The X-ray diffraction patterns confirm the single-phase formation of rhombohedrally distorted BFO thin films. The scanning electron microscopy images approve uniform and crack-free film depositions, which is of great importance to the practical device applications of such materials. The oxidation states are determined by X-ray photoelectron spectroscopy (XPS). These XPS results reveal the presence of multiple valence states of Fe ions (Fe2+, Fe3+) and Mn (Mn3+, Mn4+) ions, which play a decisive role in determining the leakage current density. However, the Mn-doping at the Fe site in BFO reduces oxygen vacancies and Fe2+ states, hence suppressing the leakage current density. The leakage current density is reduced by three orders of magnitude (10−4 – 10−7) A/cm2, upon Mn-doping as clearly demonstrated by J-V characteristics. These results indicate that the primary contributors to the conduction in BFO based thin films are oxygen vacancies and the Fe2+ states in these devices.
- 1 November 2021
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 2070 (1) , 012088
Open AccessSignificantly reduced leakage current density in Mn-doped BiFeO3 thin films deposited using spin coating technique
BiFeO3 (BFO) and Mn-doped BFO thin films are prepared on indium tin oxide/glass substrates using wet chemical deposition technique. The role of Mn defects (3% to 10%) on the leakage current density and other physical properties of BFO thin film devices is investigated. The X-ray diffraction patterns confirm the single-phase formation of rhombohedrally distorted BFO thin films. The scanning electron microscopy images approve uniform and crack-free film depositions, which is of great importance to the practical device applications of such materials. The oxidation states are determined by X-ray photoelectron spectroscopy (XPS). These XPS results reveal the presence of multiple valence states of Fe ions (Fe2+, Fe3+) and Mn (Mn3+, Mn4+) ions, which play a decisive role in determining the leakage current density. However, the Mn-doping at the Fe site in BFO reduces oxygen vacancies and Fe2+ states, hence suppressing the leakage current density. The leakage current density is reduced by three orders of magnitude (10−4 – 10−7) A/cm2, upon Mn-doping as clearly demonstrated by J-V characteristics. These results indicate that the primary contributors to the conduction in BFO based thin films are oxygen vacancies and the Fe2+ states in these devices.