Stéphanie Michel
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Stéphanie Michel has a total of 39 co-authors. Here are the top co-authors by number of shared publications:
- Sébastien Diliberto
Université de Lorraine, CNRS, IJL, F-54000 Nancy, France
4 shared publications - Karol Strzałkowski
Institute of Physics, Faculty of Physics, Astronomy and Informatics, Nicolaus Copernicus University, Grudziądzka 5, 87-100 Toruń, Poland
3 shared publications - Olivier Pages
Université de Lorraine LCP-A2MC UR 201019679B F-57000 Metz France
3 shared publications P. Franchetti
Université de Lorraine 1 , LCP-A2MC, UR 201019679B, F-57000 Metz
3 shared publications- Vitor J. B. Torres
Departamento de Física e I3N ORCID Universidade de Aveiro Portugal
3 shared publications A. En Naciri
Université de Lorraine, LCP-A2MC, ER 4632, F-57000 Metz, France
2 shared publications
Latest Publications
- 15 September 2025
- Published by AIP Publishing in Applied Physics Letters
- Vol. 127 (11)
Phonon-polaritons in Zn1− xMgxTe (x≤ 0.09): A Raman scattering study
Phonon-polaritons (PPs) are phonon–photon coupled modes. Using near-forward Raman scattering, the PP of the cubic Zn1−xMgxTe (x≤ 0.09) semiconductor alloy could be measured. While the PP-coupling hardly develops in pure ZnTe, minor Mg-alloying suffices to stabilize a long-lifetime PP strongly bound to the lattice, i.e., with a pronounced phonon character, and yet a fast one originating from the highly dispersive photon-like bottleneck of the PP-dispersion. By combining the advantages of a phonon and a photon, the long-lifetime PP generated by minor Mg-alloying of ZnTe marks an improvement over the PP of pristine ZnTe, which, from the Raman cross section calculation, can only achieve a balanced compromise between the two kinds of advantages, intensity and speed. The discussion of the PP-related lattice dynamics of Zn1−xMgxTe (x≤ 0.09) is grounded in a preliminary study of the lattice macro- and microstructure using x-ray diffraction and solid-state nuclear magnetic resonance, respectively, and further relies on ab initio calculations of the native phonon modes behind the PP in the Mg-dilute limit of Zn1−xMgxTe (x∼ 0), considering various Mg isotopes.
- 15 September 2025
- Published by AIP Publishing in Applied Physics Letters
- Vol. 127 (11)
Phonon-polaritons in Zn1− xMgxTe (x≤ 0.09): A Raman scattering study
Phonon-polaritons (PPs) are phonon–photon coupled modes. Using near-forward Raman scattering, the PP of the cubic Zn1−xMgxTe (x≤ 0.09) semiconductor alloy could be measured. While the PP-coupling hardly develops in pure ZnTe, minor Mg-alloying suffices to stabilize a long-lifetime PP strongly bound to the lattice, i.e., with a pronounced phonon character, and yet a fast one originating from the highly dispersive photon-like bottleneck of the PP-dispersion. By combining the advantages of a phonon and a photon, the long-lifetime PP generated by minor Mg-alloying of ZnTe marks an improvement over the PP of pristine ZnTe, which, from the Raman cross section calculation, can only achieve a balanced compromise between the two kinds of advantages, intensity and speed. The discussion of the PP-related lattice dynamics of Zn1−xMgxTe (x≤ 0.09) is grounded in a preliminary study of the lattice macro- and microstructure using x-ray diffraction and solid-state nuclear magnetic resonance, respectively, and further relies on ab initio calculations of the native phonon modes behind the PP in the Mg-dilute limit of Zn1−xMgxTe (x∼ 0), considering various Mg isotopes.
- Open Access
- 8 May 2024
- Published by Royal Society of Chemistry (RSC) in Environmental Science: Advances
- Vol. 3 (6) , 875-884
Electroleaching and electrodeposition of silver in ethaline 1 : 2 and propeline 1 : 3: transport properties and electrode phenomena
In view of selectively recovering precious contents in electronic waste by combined electrochemical leaching and deposition step in the same cell, this study presents electrochemical investigations of the two reactions conducted in green deep eutectic solvents (DESs) for the case of silver. In addition to ethaline 1 : 2 formed from choline chloride and ethylene glycol, propeline 1 : 3 with less nocive propylene glycol was tested. Determination of the density, viscosity and conductivity of the two DES depending on temperature and their water content could lead to ionicity values from 0.70 to 0.90, with a negative effect of these operating parameters. Pure silver can be leached at 1 mA cm−2 with faradaic yield near 100% from the two DES, provided sufficient temperature and water content below 5 wt%. Electrodeposition was thoroughly examined by cyclic voltammetry and amperometry at transient or steady state at a rotating electrode, leading to Ag(I) diffusivity values in the two DES. Kinetic parameters of the electrodeposition reaction, modelled as irreversible, were also estimated from cyclic voltammograms. Thick silver deposits were produced in 24 h-long tests at 60 °C and 0.25 mA cm−2 in a dry atmosphere with nearly 100% current efficiency. The deposits were formed by little coalesced regular grains of size 15–20 μm and exhibiting fair adherence.
- 8 May 2024
- Published by Royal Society of Chemistry (RSC) in Environmental Science: Advances
- Vol. 3 (6) , 875-884
Open AccessElectroleaching and electrodeposition of silver in ethaline 1 : 2 and propeline 1 : 3: transport properties and electrode phenomena
In view of selectively recovering precious contents in electronic waste by combined electrochemical leaching and deposition step in the same cell, this study presents electrochemical investigations of the two reactions conducted in green deep eutectic solvents (DESs) for the case of silver. In addition to ethaline 1 : 2 formed from choline chloride and ethylene glycol, propeline 1 : 3 with less nocive propylene glycol was tested. Determination of the density, viscosity and conductivity of the two DES depending on temperature and their water content could lead to ionicity values from 0.70 to 0.90, with a negative effect of these operating parameters. Pure silver can be leached at 1 mA cm−2 with faradaic yield near 100% from the two DES, provided sufficient temperature and water content below 5 wt%. Electrodeposition was thoroughly examined by cyclic voltammetry and amperometry at transient or steady state at a rotating electrode, leading to Ag(I) diffusivity values in the two DES. Kinetic parameters of the electrodeposition reaction, modelled as irreversible, were also estimated from cyclic voltammograms. Thick silver deposits were produced in 24 h-long tests at 60 °C and 0.25 mA cm−2 in a dry atmosphere with nearly 100% current efficiency. The deposits were formed by little coalesced regular grains of size 15–20 μm and exhibiting fair adherence.
- Open Access
- 12 April 2024
- Published by Elsevier in Materials Chemistry and Physics
- Vol. 318
Wet chemical synthesis of self-standing single-crystalline copper telluride Cu7Te4 nanorods: Characterizations and mechanism
- 12 April 2024
- Published by Elsevier in Materials Chemistry and Physics
- Vol. 318
Open AccessWet chemical synthesis of self-standing single-crystalline copper telluride Cu7Te4 nanorods: Characterizations and mechanism
- 7 April 2023
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 133 (13) , 139901
Erratum: “Raman study of Cd1−xZnxTe phonons and phonon-polaritons – Experiment and ab initio calculations” [J. Appl. Phys. 133, 065701 (2023)]
- 7 April 2023
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 133 (13) , 139901
Erratum: “Raman study of Cd1−xZnxTe phonons and phonon-polaritons – Experiment and ab initio calculations” [J. Appl. Phys. 133, 065701 (2023)]
- 8 February 2023
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 133 (6) , 065701
Raman study of Cd1−xZnxTe phonons and phonon–polaritons—Experiment andab initiocalculations
Backward/near-forward Raman scattering and ab initio Raman/phonon calculations are combined, together with x-ray diffraction and ellipsometry measurements to further inform the debate on the compact phonon behavior of the II–VI Cd1−xZnxTe alloy. The compacity favors the coupling of polar optic modes in both the transverse and longitudinal symmetries via the related long-wave electric fields. The -coupling achieves maximum in the Zn-dilute limit, which enhances the (upper) ZnTe-like (impurity) mode at the expense of the (lower) CdTe-like (matrix-like) one, leaving the impression of a unique {Cd-Te,Zn−Te}-mixed longitudinal optic (LO) phonon across most of the composition domain. However, the purely mechanical (non-polar) transverse optic (PM-TO) phonons, that hardly couple, reveal an underlying three-mode {1 × (Cd-Te),2 × (Zn-Te)} fine structure that distinguishes between Zn–Te vibrations in Zn- and Cd-like environments up to second neighbors. Further refinement arises by exploring the phonon–polariton (i.e., polar-TO) regime at large Zn content. On reducing the scattering angle, the -coupling develops into a sequential softening of phonon–polaritons from ZnTe- down to CdTe-like ones, which transiently unveils a bimodal pattern behind the Cd–Te signal. Altogether, this results in a (rare) canonical four-mode {2 × (Cd-Te),2 × (Zn-Te)} percolation pattern for Cd1−xZnxTe, i.e., a close II–VI replica of the twin III−V In1−xGaxAs one—yet differing by two apparent LO modes and a sensitivity of bond vibrations limited to first-neighbors. Retrospectively, the difference in sensitivity of bond vibrations to the local environment between In1−xGaxAs (limited to first neighbors) and Cd1−xZnxTe (extending up to second neighbors) emerges as a rule throughout common (covalent) III–V and (ionic) II–VI semiconductor alloys.- 8 February 2023
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 133 (6) , 065701
Raman study of Cd1−xZnxTe phonons and phonon–polaritons—Experiment andab initiocalculations
Backward/near-forward Raman scattering and ab initio Raman/phonon calculations are combined, together with x-ray diffraction and ellipsometry measurements to further inform the debate on the compact phonon behavior of the II–VI Cd1−xZnxTe alloy. The compacity favors the coupling of polar optic modes in both the transverse and longitudinal symmetries via the related long-wave electric fields. The -coupling achieves maximum in the Zn-dilute limit, which enhances the (upper) ZnTe-like (impurity) mode at the expense of the (lower) CdTe-like (matrix-like) one, leaving the impression of a unique {Cd-Te,Zn−Te}-mixed longitudinal optic (LO) phonon across most of the composition domain. However, the purely mechanical (non-polar) transverse optic (PM-TO) phonons, that hardly couple, reveal an underlying three-mode {1 × (Cd-Te),2 × (Zn-Te)} fine structure that distinguishes between Zn–Te vibrations in Zn- and Cd-like environments up to second neighbors. Further refinement arises by exploring the phonon–polariton (i.e., polar-TO) regime at large Zn content. On reducing the scattering angle, the -coupling develops into a sequential softening of phonon–polaritons from ZnTe- down to CdTe-like ones, which transiently unveils a bimodal pattern behind the Cd–Te signal. Altogether, this results in a (rare) canonical four-mode {2 × (Cd-Te),2 × (Zn-Te)} percolation pattern for Cd1−xZnxTe, i.e., a close II–VI replica of the twin III−V In1−xGaxAs one—yet differing by two apparent LO modes and a sensitivity of bond vibrations limited to first-neighbors. Retrospectively, the difference in sensitivity of bond vibrations to the local environment between In1−xGaxAs (limited to first neighbors) and Cd1−xZnxTe (extending up to second neighbors) emerges as a rule throughout common (covalent) III–V and (ionic) II–VI semiconductor alloys.- 1 January 2003
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 661-664
A technology for a device prototyping based on electrodeposited thermoelectric V-VI layers
- 1 January 2003
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 661-664
A technology for a device prototyping based on electrodeposited thermoelectric V-VI layers