Maria Clara Murta
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Maria Clara Murta has a total of 9 co-authors. Here are the top co-authors by number of shared publications:
Antônio Gilberto Costa
1 shared publication- Antônio Gilberto Costa
Universidade Federal de Minas Gerais
1 shared publication Dave Kuentz
Department of Geology & Environmental Earth Science, Miami University, Oxford, USA
1 shared publicationElisabeth Widom
Department of Geology & Environmental Earth Science, Miami University, Oxford, USA
1 shared publicationFábio Soares de Oliveira
1 shared publicationGreg A. Valentine
Department of Earth Sciences, University at Buffalo, Buffalo, USA
1 shared publication
Latest Publications
- Open Access
- 15 May 2026
- Published by Springer Nature in Bulletin of Volcanology
- Vol. 88 (6) , 64
Santa Clara scoria cone and its leaky plumbing system (southwest Utah, USA)
Estimating magma overpressure from intrusion geometry remains a challenge especially when dikes are not directly exposed. Santa Clara volcano (~27 ka; USA) is an example of a small scoria cone (~ 0.01 km 3 ) with an associated lava field (~0.2 km 3 ) without a direct exposure of its feeder dike. The ~145 m high cone was built at the end of a northeast-trending, ~350 m wide sandstone ridge that rises ~115 m above the surrounding terrain. Its crater floor lies ~100 m above the cone base. Lava leaked from the western ridge side at ~90 m height, forming a ~1.5-m-thick `a`ā lava flow. On the eastern ridge side, at ~95 m height, a 50-m-long, 0.4–0.8-m-thick sill transitions laterally into a vent for agglomerates. The similar elevations of the crater floor, sill, and lava vent suggest concurrent venting under hydrostatic equilibrium during the final eruptive stages. We infer that a vertical dike propagated beneath and parallel to the ridge axis, forming the main vent where it first intersected the surface on the ridge base. The cone grew until its vent reached a height determined by magma overpressure in the dike at ridge-base level, at which point, instead of continuing upward growth, magma moved laterally within the ridge to form the sill and lava leak. This scenario implies a magma overpressure of 1–3 MPa at the base of the ridge. We compare two dike-length scenarios and combine the inferred overpressure estimates with elastic theory. These calculations indicate that dike thickness is likely underestimated, suggesting that inelastic deformation is important in accommodating dikes in the upper crust, and that combining observed dike geometries and elastic theory might overestimate magma overpressures.
- 15 May 2026
- Published by Springer Nature in Bulletin of Volcanology
- Vol. 88 (6) , 64
Open AccessSanta Clara scoria cone and its leaky plumbing system (southwest Utah, USA)
Estimating magma overpressure from intrusion geometry remains a challenge especially when dikes are not directly exposed. Santa Clara volcano (~27 ka; USA) is an example of a small scoria cone (~ 0.01 km 3 ) with an associated lava field (~0.2 km 3 ) without a direct exposure of its feeder dike. The ~145 m high cone was built at the end of a northeast-trending, ~350 m wide sandstone ridge that rises ~115 m above the surrounding terrain. Its crater floor lies ~100 m above the cone base. Lava leaked from the western ridge side at ~90 m height, forming a ~1.5-m-thick `a`ā lava flow. On the eastern ridge side, at ~95 m height, a 50-m-long, 0.4–0.8-m-thick sill transitions laterally into a vent for agglomerates. The similar elevations of the crater floor, sill, and lava vent suggest concurrent venting under hydrostatic equilibrium during the final eruptive stages. We infer that a vertical dike propagated beneath and parallel to the ridge axis, forming the main vent where it first intersected the surface on the ridge base. The cone grew until its vent reached a height determined by magma overpressure in the dike at ridge-base level, at which point, instead of continuing upward growth, magma moved laterally within the ridge to form the sill and lava leak. This scenario implies a magma overpressure of 1–3 MPa at the base of the ridge. We compare two dike-length scenarios and combine the inferred overpressure estimates with elastic theory. These calculations indicate that dike thickness is likely underestimated, suggesting that inelastic deformation is important in accommodating dikes in the upper crust, and that combining observed dike geometries and elastic theory might overestimate magma overpressures.
- 24 February 2024
- Published by Elsevier in Journal of South American Earth Sciences
- Vol. 137
Lithofacies association and stratigraphy of the Quixaba and Remédios formations, Fernando de Noronha archipelago, Brazil
- 24 February 2024
- Published by Elsevier in Journal of South American Earth Sciences
- Vol. 137
Lithofacies association and stratigraphy of the Quixaba and Remédios formations, Fernando de Noronha archipelago, Brazil
- 9 February 2023
- Published by Springer Nature in Geoheritage
- Vol. 15 (1) , 1-18
Geological Trails for the Fernando de Noronha Archipelago, Brazil: a Geodiversity Approach
- 9 February 2023
- Published by Springer Nature in Geoheritage
- Vol. 15 (1) , 1-18
Geological Trails for the Fernando de Noronha Archipelago, Brazil: a Geodiversity Approach