S. Sasi Florence
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
S. Sasi Florence has a total of 55 co-authors. Here are the top co-authors by number of shared publications:
Hala Siddiq
Department of Physical Sciences, Physics Division, College of Science, Jazan University, P.O. Box. 114, Jazan 45142, Kingdom of Saudi Arabia
6 shared publicationsNouf Alharbi
5 shared publications- Nouf Alharbi
Jazan University
3 shared publications T. Amutha
3 shared publicationsA. Suvitha
CMR Institute of Technology (VTU)
2 shared publicationsD. Thanmayalaxmi
CMR Institute of Technology (VTU)
2 shared publications
Latest Publications
- Open Access
- 27 October 2026
- Published by Chiang Mai University in Chiang Mai Journal of Science
- Vol. 53 (6) , e2026099-16
Bioinspired Synthesis of Functional Palladium Nanoparticles from Moringa oleifera Flowers for Synergistic Antimicrobial and Photocatalytic Performance
This study reports the green synthesis of palladium nanoparticles (Pd-NPs) using Moringa oleifera flower extract, with two samples (P5 and P15) prepared using different extract volumes to evaluate the effect of phytochemical concentration. XRD analysis confirmed the formation of face-centered cubic Pd, with P15 exhibiting a smaller crystallite size than P5. TEM analysis revealed predominantly spherical nanoparticles, where P15 showed smaller and more uniformly distributed particles (5.19–16.57 nm) compared to P5 (6.78–24.78 nm). FTIR results confirmed the involvement of phenolic, amide, and carboxyl functional groups in nanoparticle reduction and stabilization. A clear enhancement in biological activity was observed for P15, which exhibited higher antibacterial activity against Escherichia coli (28 mm) compared to P5 (26 mm). Photocatalytic studies further demonstrated superior performance of P15, with a higher rate constant (0.030 min-1 vs 0.027 min-1 for Congo Red) and faster degradation of both Congo Red and Crystal Violet dyes. The improved performance of P15 is attributed to its smaller particle size, better dispersion, and higher surface area. Overall, increasing extract concentration significantly improves nanoparticle characteristics, resulting in enhanced antibacterial and photocatalytic efficiency. These findings highlight the potential of M. oleifera-mediated Pd-NPs as eco-friendly and multifunctional materials for biomedical and environmental applications.
- 27 October 2026
- Published by Chiang Mai University in Chiang Mai Journal of Science
- Vol. 53 (6) , e2026099-16
Open AccessBioinspired Synthesis of Functional Palladium Nanoparticles from Moringa oleifera Flowers for Synergistic Antimicrobial and Photocatalytic Performance
This study reports the green synthesis of palladium nanoparticles (Pd-NPs) using Moringa oleifera flower extract, with two samples (P5 and P15) prepared using different extract volumes to evaluate the effect of phytochemical concentration. XRD analysis confirmed the formation of face-centered cubic Pd, with P15 exhibiting a smaller crystallite size than P5. TEM analysis revealed predominantly spherical nanoparticles, where P15 showed smaller and more uniformly distributed particles (5.19–16.57 nm) compared to P5 (6.78–24.78 nm). FTIR results confirmed the involvement of phenolic, amide, and carboxyl functional groups in nanoparticle reduction and stabilization. A clear enhancement in biological activity was observed for P15, which exhibited higher antibacterial activity against Escherichia coli (28 mm) compared to P5 (26 mm). Photocatalytic studies further demonstrated superior performance of P15, with a higher rate constant (0.030 min-1 vs 0.027 min-1 for Congo Red) and faster degradation of both Congo Red and Crystal Violet dyes. The improved performance of P15 is attributed to its smaller particle size, better dispersion, and higher surface area. Overall, increasing extract concentration significantly improves nanoparticle characteristics, resulting in enhanced antibacterial and photocatalytic efficiency. These findings highlight the potential of M. oleifera-mediated Pd-NPs as eco-friendly and multifunctional materials for biomedical and environmental applications.
- 25 April 2026
- Published by Elsevier in Optical Materials
- Vol. 176
Enhanced photocatalytic and antibacterial performance of Ni-doped Fe–Ce oxide nanocomposites under sunlight irradiation
- 25 April 2026
- Published by Elsevier in Optical Materials
- Vol. 176
Enhanced photocatalytic and antibacterial performance of Ni-doped Fe–Ce oxide nanocomposites under sunlight irradiation
- 17 March 2026
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 143 (20)
Development of an Electrochemical Sensor for Dopamine Using Poly(4,4′‐Diaminodiphenyl Sulfone)/ TiO 2 /Clay Nanocomposite‐Modified Glassy Carbon as Working Electrode
Structurally engineered ternary nanocomposites based on poly(4,4′‐diaminodiphenyl sulfone) (PDDS), titanium dioxide (TiO 2 ), and layered clay were successfully synthesized via in situ oxidative polymerization to develop intelligent electrochemical biosensor interfaces. Comprehensive physicochemical characterization using UV–Vis spectroscopy, X‐ray diffraction (XRD), and FE‐SEM/EDS confirmed the effective incorporation and uniform dispersion of TiO 2 nanoparticles and clay within the PDDS matrix. Structural analyses revealed enhanced semicrystallinity, modified surface morphology, and improved interfacial interactions in the ternary PDDS/TiO 2 /clay (PDDSTC) system compared to pristine PDDS and binary composites. Electrochemical investigations demonstrated significantly reduced charge‐transfer resistance ( R ct = 83.44 Ω cm 2 ) and markedly increased double‐layer capacitance ( C dl = 31.78 μF cm −2 ), indicating improved electron transport and interfacial charge storage. The PDDSTC nanocomposite exhibited superior electrocatalytic activity with wide linear detection ranges (3.81 × 10 −11 to 4.76 × 10 −6 M), excellent correlation coefficients ( R 2 = 0.997), and ultra‐low detection limits in the nanomolar range (0.0381 nM in DPV and 0.041 nM in SWV). The synergistic integration of TiO 2 and clay within the sulfone‐based conducting polymer matrix generates an optimized ternary architecture that significantly improves conductivity, adsorption capability, and electrochemical responsiveness. These findings demonstrate that structurally tuned PDDSTC nanocomposites provide a promising platform for next‐generation high‐sensitivity neurotransmitter biosensors.
- 17 March 2026
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 143 (20)
Development of an Electrochemical Sensor for Dopamine Using Poly(4,4′‐Diaminodiphenyl Sulfone)/ TiO 2 /Clay Nanocomposite‐Modified Glassy Carbon as Working Electrode
Structurally engineered ternary nanocomposites based on poly(4,4′‐diaminodiphenyl sulfone) (PDDS), titanium dioxide (TiO 2 ), and layered clay were successfully synthesized via in situ oxidative polymerization to develop intelligent electrochemical biosensor interfaces. Comprehensive physicochemical characterization using UV–Vis spectroscopy, X‐ray diffraction (XRD), and FE‐SEM/EDS confirmed the effective incorporation and uniform dispersion of TiO 2 nanoparticles and clay within the PDDS matrix. Structural analyses revealed enhanced semicrystallinity, modified surface morphology, and improved interfacial interactions in the ternary PDDS/TiO 2 /clay (PDDSTC) system compared to pristine PDDS and binary composites. Electrochemical investigations demonstrated significantly reduced charge‐transfer resistance ( R ct = 83.44 Ω cm 2 ) and markedly increased double‐layer capacitance ( C dl = 31.78 μF cm −2 ), indicating improved electron transport and interfacial charge storage. The PDDSTC nanocomposite exhibited superior electrocatalytic activity with wide linear detection ranges (3.81 × 10 −11 to 4.76 × 10 −6 M), excellent correlation coefficients ( R 2 = 0.997), and ultra‐low detection limits in the nanomolar range (0.0381 nM in DPV and 0.041 nM in SWV). The synergistic integration of TiO 2 and clay within the sulfone‐based conducting polymer matrix generates an optimized ternary architecture that significantly improves conductivity, adsorption capability, and electrochemical responsiveness. These findings demonstrate that structurally tuned PDDSTC nanocomposites provide a promising platform for next‐generation high‐sensitivity neurotransmitter biosensors.
- Open Access
- 1 January 2026
- Published by Wiley in Journal of Chemistry
- Vol. 2026 (1)
A Novel Macrocyclic Binuclear Copper (II) Complex: Structural Clarification, Biomolecular Interactions, and Nucleic Acid Cleavage Activity
A novel cationic binuclear copper (II) complex, [Cu 2 L(H 2 O) 2 ](ClO 4 ) 2 , has been synthesized, and its structure is described. It is formed from a symmetrical macrocyclic Schiff‐base ligand. The distorted square‐pyramidal geometries adopted by both Cu (II) centers and their bridging phenoxide oxygen atoms are confirmed by single‐crystal X‐ray diffraction. Molecular docking experiments, viscosity tests, circular dichroism, fluorescence spectroscopy, and UV–Vis absorption were used to examine the complex’s DNA‐ and protein‐binding capabilities. Both hydrodynamic and spectroscopic results show a strong static quenching interaction with bovine serum albumin and an intercalative binding mode toward calf thymus DNA. Effective oxidative cleavage of the pBR322 plasmid DNA is demonstrated by agarose gel electrophoresis, indicating the involvement of reactive oxygen species. Additionally, both Gram‐positive and Gram‐negative pathogens are susceptible to the complex’s strong antibacterial action. Stable binding interactions with DNA and DNA gyrase are further supported by docking experiments. These results demonstrate the binuclear Cu (II) complex’s biological potential for use in bioinorganic and pharmaceutical chemistry.
- 1 January 2026
- Published by Wiley in Journal of Chemistry
- Vol. 2026 (1)
Open AccessA Novel Macrocyclic Binuclear Copper (II) Complex: Structural Clarification, Biomolecular Interactions, and Nucleic Acid Cleavage Activity
A novel cationic binuclear copper (II) complex, [Cu 2 L(H 2 O) 2 ](ClO 4 ) 2 , has been synthesized, and its structure is described. It is formed from a symmetrical macrocyclic Schiff‐base ligand. The distorted square‐pyramidal geometries adopted by both Cu (II) centers and their bridging phenoxide oxygen atoms are confirmed by single‐crystal X‐ray diffraction. Molecular docking experiments, viscosity tests, circular dichroism, fluorescence spectroscopy, and UV–Vis absorption were used to examine the complex’s DNA‐ and protein‐binding capabilities. Both hydrodynamic and spectroscopic results show a strong static quenching interaction with bovine serum albumin and an intercalative binding mode toward calf thymus DNA. Effective oxidative cleavage of the pBR322 plasmid DNA is demonstrated by agarose gel electrophoresis, indicating the involvement of reactive oxygen species. Additionally, both Gram‐positive and Gram‐negative pathogens are susceptible to the complex’s strong antibacterial action. Stable binding interactions with DNA and DNA gyrase are further supported by docking experiments. These results demonstrate the binuclear Cu (II) complex’s biological potential for use in bioinorganic and pharmaceutical chemistry.
- 4 November 2025
- Published by World Scientific Pub Co Pte Ltd in International Journal of Modern Physics B
- Vol. 39 (31)
All optical logic switching devices via a combined Hirota and Lakshmanan–Porsezian–Daniel equation under the competing inhomogeneities in an optical fiber
We arrive at the soliton solutions by means of Darboux transformation for variable coefficient nonlinear Schrödinger equation with Hirota and LPD terms. For the first time, we control the soliton solutions through appropriately selecting the profiles of Hirota and LPD coefficients. Particularly, we attain the switching characteristics via inelastic collisions among multi-optical solitons in an inhomogeneous optical fiber system. These results provide some insights into the generalized variable coefficient NLS equation with Hirota and LPD for some real problems in the context of a fiber optic system. Results found through this paper have potential applications in the design of all-optical logic switching devices (AOLSD) for ultrafast switching.
- 4 November 2025
- Published by World Scientific Pub Co Pte Ltd in International Journal of Modern Physics B
- Vol. 39 (31)
All optical logic switching devices via a combined Hirota and Lakshmanan–Porsezian–Daniel equation under the competing inhomogeneities in an optical fiber
We arrive at the soliton solutions by means of Darboux transformation for variable coefficient nonlinear Schrödinger equation with Hirota and LPD terms. For the first time, we control the soliton solutions through appropriately selecting the profiles of Hirota and LPD coefficients. Particularly, we attain the switching characteristics via inelastic collisions among multi-optical solitons in an inhomogeneous optical fiber system. These results provide some insights into the generalized variable coefficient NLS equation with Hirota and LPD for some real problems in the context of a fiber optic system. Results found through this paper have potential applications in the design of all-optical logic switching devices (AOLSD) for ultrafast switching.
- 6 May 2025
- Published by Springer Nature in Journal of Materials Science: Materials in Electronics
- Vol. 36 (13) , 1-11
Effects of pH on the synthesis of PANI-Tin oxide nanocomposite as counter electrode in DSSC applications
- 6 May 2025
- Published by Springer Nature in Journal of Materials Science: Materials in Electronics
- Vol. 36 (13) , 1-11
Effects of pH on the synthesis of PANI-Tin oxide nanocomposite as counter electrode in DSSC applications