Haoyu Hu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Haoyu Hu has a total of 15 co-authors. Here are the top co-authors by number of shared publications:
- Manabu Enoki
Department of Materials Engineering, School of Engineering, The University of Tokyo, 7-3-1 Hongo, Bunkyo-ku, Tokyo 113-8656, Japan
7 shared publications - Takayuki Shiraiwa
Department of Materials Engineering, School of Engineering, The University of Tokyo, 7-3-1 Hongo, Bunkyo-ku, Tokyo 113-8656, Japan
7 shared publications - Fabien Briffod
Research Center for Structural Materials, National Institute for Materials Science
6 shared publications Wujun Yin
4 shared publicationsFabien Briffod
3 shared publicationsKazuhiko Yamazaki
3 shared publications
Latest Publications
- 31 January 2026
- Published by Elsevier in Scripta Materialia
- Vol. 276
Origin of strain localization near prior austenite grain boundary in martensitic steel: Role of chemical and dislocation structures
- 31 January 2026
- Published by Elsevier in Scripta Materialia
- Vol. 276
Origin of strain localization near prior austenite grain boundary in martensitic steel: Role of chemical and dislocation structures
- Open Access
- 15 September 2025
- Published by Iron and Steel Institute of Japan in ISIJ International
- Vol. 65 (10) , 1481-1492
Novel Bayesian Statistical Analysis on Acoustic Emission Data during Dwell-fatigue of Ti-6Al-4V Alloys
Load hold at peak stress can drastically reduce the fatigue life of Ti-6Al-4V alloys, a phenomenon known as dwell-fatigue life debit. Unlike normal fatigue, dwell-fatigue exhibits a characteristic three-stage strain accumulation curve: an initial rapid strain increase (primary), followed by a steady strain-increase (secondary), and finally an accelerated stage leading to failure (tertiary). In the current study, flat specimens made out of three distinct microstructures of Ti-6Al-4V alloys were subjected to uniaxial fatigue load with 120-second peak stress hold and 0.1 load ratio with real-time acoustic emission (AE) measurement. The microstructures, namely, equiaxed, bimodal, and lamellar, were tailored through different heat treatment procedures. Bayesian statistical analysis of AE data enabled both the detection of stage transition points using Markov chain Monte Carlo (MCMC) simulation and the selection of strain accumulation models through replica MCMC method. The results demonstrated that two change-points detected showed strong correlation with the transitions in the creep-like three-stage curve of strain accumulation. The strain accumulation behavior was successfully predicted using AE parameters. Furthermore, average frequency proved crucial in monitoring the beginning of dwell-fatigue process.
- 15 September 2025
- Published by Iron and Steel Institute of Japan in ISIJ International
- Vol. 65 (10) , 1481-1492
Open AccessNovel Bayesian Statistical Analysis on Acoustic Emission Data during Dwell-fatigue of Ti-6Al-4V Alloys
Load hold at peak stress can drastically reduce the fatigue life of Ti-6Al-4V alloys, a phenomenon known as dwell-fatigue life debit. Unlike normal fatigue, dwell-fatigue exhibits a characteristic three-stage strain accumulation curve: an initial rapid strain increase (primary), followed by a steady strain-increase (secondary), and finally an accelerated stage leading to failure (tertiary). In the current study, flat specimens made out of three distinct microstructures of Ti-6Al-4V alloys were subjected to uniaxial fatigue load with 120-second peak stress hold and 0.1 load ratio with real-time acoustic emission (AE) measurement. The microstructures, namely, equiaxed, bimodal, and lamellar, were tailored through different heat treatment procedures. Bayesian statistical analysis of AE data enabled both the detection of stage transition points using Markov chain Monte Carlo (MCMC) simulation and the selection of strain accumulation models through replica MCMC method. The results demonstrated that two change-points detected showed strong correlation with the transitions in the creep-like three-stage curve of strain accumulation. The strain accumulation behavior was successfully predicted using AE parameters. Furthermore, average frequency proved crucial in monitoring the beginning of dwell-fatigue process.
- Open Access
- 24 September 2024
- Published by Elsevier in Acta Materialia
- Vol. 281, 120422
Role of prior austenite grain boundary and retained austenite in strain localization of medium-carbon high-strength steels
- 24 September 2024
- Published by Elsevier in Acta Materialia
- Vol. 281, 120422
Open AccessRole of prior austenite grain boundary and retained austenite in strain localization of medium-carbon high-strength steels
- 7 February 2024
- Published by Elsevier in International Journal of Fatigue
- Vol. 182
Quantitative investigation of slip band activities in a bimodal titanium alloy under pure fatigue and dwell-fatigue loadings
- 7 February 2024
- Published by Elsevier in International Journal of Fatigue
- Vol. 182
Quantitative investigation of slip band activities in a bimodal titanium alloy under pure fatigue and dwell-fatigue loadings
- 12 January 2024
- Published by Elsevier in Materialia
- Vol. 33
Effect of microstructure on the deformation of as-cast -Mg/LPSO two-phase alloys: An integrated SEM-DIC and crystal plasticity study- 12 January 2024
- Published by Elsevier in Materialia
- Vol. 33
Effect of microstructure on the deformation of as-cast -Mg/LPSO two-phase alloys: An integrated SEM-DIC and crystal plasticity study