Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Lorenzo Bonzi has a total of 32 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Advancing Atmometer Temporal Resolution and ET Accuracy via Solar Radiation Corrections from Reanalysis Data

    by Bonzi L., Dichio E., Hamouda F., Angela Puig-Sirera, Giovanni Rallo

    Accurate estimation of reference evapotranspiration (ET₀) is fundamental for optimizing irrigation scheduling and water resource management in agriculture. Traditional atmometers (ETgage) offer an affordable alternative to complex instruments but are limited by low temporal resolution and discrete measurement intervals. This study presents a novel approach to overcome these limitations by integrating pressure transducers into the atmometer system, enabling continuous, high-frequency monitoring of water-level changes in the reservoir.,Four pressure transducers with varying sensitivities were tested under controlled laboratory conditions using a high-precision metrology bench. The most responsive sensor, model RS-828-5708, was selected for calibration linearity and signal stability and deployed in a commercial kiwifruit orchard for field validation. The enhanced atmometer showed strong agreement with Penman-Monteith-based ET₀ estimates, particularly at the daily scale, while providing improved responsiveness to short-term fluctuations in vapour pressure deficit and other environmental drivers.,Several statistical adjustment models were developed using ground-based and satellite-derived solar radiation inputs to address observed discrepancies under high radiation and dry conditions. The pyranometer-based model exhibited the highest accuracy (R² = 0.993; RMSE = 0.0073 mm h⁻¹).,This integrated sensing system offers a cost-effective and scalable solution for real-time evapotranspiration monitoring, bridging the gap between low-cost field tools and data-intensive decision-making in precision agriculture.

  • Open Access

    Effect of irrigation uniformity on the delineation of homogeneous zones in a pear orchard

    by L. Bonzi, M. Carrara, F. Hamouda, S. Marasco, R. Massai, À. Puig-Sirera, D. Remorini, G. Rallo

  • Open Access

    Development and Validation of a Low-Cost DAQ for the Detection of Soil Bulk Electrical Conductivity and Encoding of Visual Data

    by Fatma Hamouda, Lorenzo Bonzi, Marco Carrara, Àngela Puig-Sirera, Giovanni Rallo

    Electromagnetic induction (EMI) devices have become increasingly popular for their soil bulk properties, soil nutrient status, and use in taking non-invasive soil salinity measurements. However, the high cost of data acquisition (DAQ) systems has been a significant barrier to the widespread adoption of these devices. In this study, we addressed this challenge by developing a cost-effective, easy-to-use, open-source DAQ system, transferable to the end user. This system employs a Raspberry Pi 4 model, paired with various components, to monitor the speed and position of the EM38 (Geonics Ltd, Mississauga, ON, Canada) and compare these with a proprietary CR1000 system. Through our results, we demonstrate that the low-cost DAQ system can successfully extract the analogical signal from the device, which is strongly responsive to the variation in the soil’s physical properties. This cost-effective system is characterized by increased flexibility in software processes and provides performance comparable to the proprietary system in terms of its geospatial data and ECb measurements. This was validated by the strong correlation (R2 = 0.98) observed between the data collected from both systems. With our zoning analysis, performed using the Kriging technique, we revealed not only similar patterns in the ECb data but also similar patterns to the Normalized Difference Vegetation Index (NDVI) map, suggesting that soil physical characteristics contribute to variability in crop vigor. Furthermore, the developed web application enabled real-time data monitoring and visualization. These findings highlight that the open-source DAQ system is a viable, cost-effective alternative for soil property monitoring in precision farming. Future enhancements will focus on integrating additional sensors for plant vigor and soil temperature, as well as refining the web application, supporting zone classification based on the use of multiple parameters.

  • Open Access

    Irrigatmo: no-moving parts system for feed-back and feed-forward irrigation scheduling 

    by Emanuele Dichio, Lorenzo Bonzi, Giovanni Rallo, Angela Puig-Sirera, Damiano Remorini, Roberto Di Biase, Alba Nicoletta Mininni, Rossano Massai

    Abstract The weather-based approach quantifies the crop water requirements (CWR) using a simplified agrohydrological model coupled with meteorological sensors. The FAO56 model (Allen et al., 1998) is one of the most used bucket models for CWR. In this model, the daily ET0 is usually estimated by the FAO-Penman-Monteith (PM), which needs as inputs standard atmosphere forcings acquired from weather stations, that often are equipped with ordinary mechatronics sensors that require regular maintenance. An atmometer (ETgage) is an accurate sensor with no moving parts that continuously measures the ET0 based on a physical analogy of the crop reference. This study aims to design and validate an expert system, named Irrigatmo, to manage irrigation based on the combined application of the feedforward- (FFc) and feedback- (FBc) control irrigation scheduling protocols. The FFc protocol comprises a Kc-based mass balance model with a modified atmometer and FDR sensors for sub-hourly ET0 and soil water content (SWC) measurements. At the same time, the FBc protocol uses the SWC to quantify the critical condition and the crop stress coefficient to adjust the Kcb value used in the bucket model. The system was implemented in proprietary logic (CR300, Campbell Scientific Inc.) and open-source logic (Arduino Mega 2560, Arduino). The core of the system implements a weather-based water balance model, trained by a modified atmometer and soil moisture sensor for sub-hourly scale ET0 and SWC, as well as an infrared thermometer and a contact thermocouple for quantifying the crop water stress index (CWSI). The ETgage was modified by integrating a pressure transducer sensor, calibrated to measure the water level inside the atmometer tank continuously. The results showed that Irrigatmo accurately and rapidly detected the changes in atmospheric and soil water conditions. The system can directly calculate the evapotranspiration reduction factor (Ks), estimating the CWSI based on canopy temperature measurements. This could overcome the uncertainty in the models associated with the water stress function based solely on the soil moisture. The system was built and calibrated within the AgrHySMo laboratory of DiSAAA-a and validated on a commercial kiwifruit orchard of Actinidia chinensis var. chinensis 'Zesy002'. The field testing made it possible to validate the system's ability to model the water stress functions of the crop and the sensitivity to identify the critical water status conditions that mark the transition to a limiting condition. Irrigatmo could manage irrigation autonomously, activating or turning off the solenoid valves, and returning to our field the amount of water lost during the evapotranspiration processes. Future perspectives consider the implementation of the proposed system in a wireless sensor network (WSN) and at the interfacing of the WSN nodes with aerial platforms where the edge-computing systems specialized also in the control of IoT-irrigation actuators will be located.

  • Open Access

    Comparison of EM38 and Syscal Pro measurements for soil mapping in an agroforestry system

    by Marco Carrara, Lorenzo Bonzi, Fatma Hamouda, Mino Sportelli, Angela Puig Sirera, Daniele Antichi, Lorenzo Gabriele Tramacere, Silvia Pampana, Giovanni Rallo

    This study aimed to assess and compare the performance of EM38 (Geonics Limited) and Syscal-Pro (Iris instruments) EMI tools in soil spatial heterogeneity mapping. Mainly, the two tools were evaluated for their ability to explain the spatial variability of the soil resistivity, which strongly correlates with the soil’s physical status properties. Moreover, the effect of two surface soil roughness caused by two different tillage modalities has been studied.The experimental plot (30 m width x 100 m length) consisted of an agroforestry system located in San Piero a Grado (Pisa, Italy, (, 43°41’07” N, 10°20’32” E). Two 100-meters length deep open drains were located on the edges. The soil texture is loam, with clay content values from 7.64% to 15.14% and sand content ranging from 22.36% to 49.37%. The intercropping system consisted of wheat (Triticum aestivum L) and pea (Pisum Sativum L) in the inner part of the field, and two rows of poplar (Populus x euramericana Dode Guiner) on the edges experimental plot.Data were acquired before seed-bed preparation by pulling the two tools over the soil. For the Syscal-pro, 13 cylindrical stainless-steel electrodes were pulled by a tractor, allowing soil resistivity data acquisition according to the reciprocal Wenner-Schlumberger array (Telford, 1976). A total of five transects with 5 m spacing were spanned to the inner field zone, whereas four additional transects allowed to detail the resistivity gradients closed the two deep open drains.Regarding the EM38 tool, a preliminary laboratory activity allowed the development of a specific data acquisition (DAQ) system for continuous monitoring of the resistivity data recording and spatializing. This DAQ system is based on a CR1000 Data logger (Campbell Scientific, United States), which allows collecting the speed and position of the EM-38 device by carrying it on a specifically designed sled system.Two Garmin’s GPS (model 79S/SC for Syscal Pro and model GPS16X-HVS for the EM38) enabled georeferencing the collected data.Preliminary results have shown a range of electrical conductivity values between 30 mS/m and 45 mS/m, spatially distributed according to the pattern obtained by Syscal-Pro. Further investigation is required to better understand the relationship between EM38 and Syscal-Pro measurements, after which the vertical domain explored has been standardised between the two methods.Keywords: Agroforestry system, EM38, Syscal, soil bulk resistivity, soil bulk conductivity, spatial variability.

  • Open Access

    Automation of the Atmometer (ETgage) recording by pressure transducers sensors

    by Lorenzo Bonzi, Àngela Puig Sirera, Emanuele Dichio, Fatma Hamouda, Andrea Sbrana, Damiano Remorini, Giovanni Rallo

    In precision irrigation, it has become imperative to accurately evaluate the crop irrigation needs and return the right amount of water. Concerning to the application of thermodynamic-based models, the crop transpiration can be determined with the original Penman-Monteith equation (Monteith, 1965) through the so-called "big leaf" approach. According to what was suggested by Jarvis and McNaughton (1986), for its evaluation through sensors, one valid option is the atmometer. This instrument is used to measure the quantity of water evapotranspired in a reference system (ET0), and the actual transpiration (Tc act), is calculated according to the weather-based approach (Allen et al., 1998). The ET0 in the atmometer is evaluated from the variation in the water level of the distilled water source placed inside the instrument tank, hydraulically connected to a porous ceramic capsule covered with a green fabric (green canvas) which simulates the radiative and resistive behaviour of the reference culture. The most advanced model at present is the model-E with an electronic component for the automatic measurement of ET0 measures. In this model, the evaporated water is based on the emptying of a glass ampoule, with a capacity of 0.25 mm of water, filled automatically through a solenoid valve. Each emptying corresponds to 0.25 mm of evaporated and generates an electrical signal (count) detected by the data logger.In our study, the atmometer (ETgage) was modified in the device for measuring the relative water level. The modification of the atmometer consists in the insertion of an RS-828-5708 piezoresistive pressure transducer. The pressure transducer returns an analog output in the 4-20 domain (mA) as a function of the hydrostatic head H (cm). The sensor was calibrated on the test bench of the DiSAAA-a AgrHySMo laboratory with paired measurements of hydrostatic head H(cm) and electrical signal read by the datalogger (mV). Therefore, the linear calibration equation between the two measurements was obtained with a slope of 0.3029 m/mV and an intercept of 10.804 m. Finally, the data series were improved thanks to a smoothing process, performed using a 3rd-4th order polynomial function (Savitzky and Golay, 1964) on data clusters equal to 17 points. The improved water level measurement system allows flow measurement at the sub-hourly scale. In open filed, the temporal dynamics of the atmometer were compared with the reference evapotranspiration calculated with the Penman-Monteith. The atmometer measurement showed an improvement compared to the respective estimated with the mathematical analogy, reducing the RMSE from 1.65 to 0.30 mm/day. The first results have demonstrated an accurate performance of the modified atmometer in estimating hourly reference evapotranspiration and its ability for precise irrigation planning based on hourly water consumption.Keywords. Atmometer, field-instrumentation, sensor and model design, crop water status, precision irrigation.

  • Open Access

    Design and validation of a soil moisture-based wireless sensors network for the smart irrigation of a pear orchard

    by Fatma Hamouda, Àngela Puig-Sirera, Lorenzo Bonzi, Damiano Remorini, Rossano Massai, Giovanni Rallo


  • Open Access

    Design, development, and assessment of a High-Throughput Screening (HTS) system for the macroscopic root water uptake modeling

    by Àngela Puig-Sirera, Lorenzo Bonzi, Lorenzo Cotrozzi, Fatma Hamouda, Alessandra Marchica, Giuseppe Provenzano, Damiano Remorini, Giovanni Rallo


  • Productive Response of a Pear Orchard (Pyrus Communis, L.) to the Precision Irrigation Conducted Through a Decision Support System (DSS)

    by Fatma Hamouda, Àngela Puig-Sirera, Lorenzo Bonzi, Damiano Remorini, Giuseppe Provenzano, Giovanni Rallo

  • Macroscopic Root Water Uptake Modelling Using High-Throughput Screening (HTS) Systems: Design and Validation

    by Lorenzo Bonzi, Fatma Hamouda, Àngela Puig-Sirera, Andrea Sbrana, Damiano Remorini, Lorenzo Cotrozzi, Giovanni Rallo