Di Hu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Di Hu has a total of 15 co-authors. Here are the top co-authors by number of shared publications:
- An Quan Jiang
Fudan University
5 shared publications - Jie Sun
College of Integrated Circuits and Micro/Nano Electronics Innovation, Fudan University - Shanghai 200433, China
3 shared publications Yi Ming Li
School of Microelectronics, Fudan University , Shanghai 200433, China
2 shared publicationsBo Wen Shen
State Key Laboratory of ASIC and System, Fudan University, Shanghai, China
1 shared publicationBo Yang Zhang
College of Integrated Circuits and Micro/Nano Electronics Innovation, Fudan University , Shanghai 200433
1 shared publication- Bowen Shen
School of Integrated Circuits Beijing Advanced Innovation Center for Integrated Circuits BNRist Tsinghua University Beijing China
1 shared publication
Latest Publications
- 1 December 2025
- Published by AIP Publishing in Applied Physics Letters
- Vol. 127 (22)
Improved electrical performance of LiNbO3 domain wall memories after thinning of interfacial layers at low temperatures
A nonvolatile ferroelectric LiNbO3 single-crystal memory utilizing erasable conducting domain walls inherits the advantages of commercial ferroelectric 1T1C/2T2C memories by avoiding destructive read operations. But its high-frequency domain switching hysteresis loop is typically asymmetric at room temperature, which can lead to retention issues. In this study, we show that this asymmetry is linked to the presence of interfacial layers near electrodes where the domains are volatile. During cooling of the device below 150 K, the loops become more symmetric when the interfacial domains become nonvolatile. The volatile-to-nonvolatile domain transition changes the domain switching mechanism and enables an energy-efficient non-superconducting cryogenic memory with improved operations.
- 1 December 2025
- Published by AIP Publishing in Applied Physics Letters
- Vol. 127 (22)
Improved electrical performance of LiNbO3 domain wall memories after thinning of interfacial layers at low temperatures
A nonvolatile ferroelectric LiNbO3 single-crystal memory utilizing erasable conducting domain walls inherits the advantages of commercial ferroelectric 1T1C/2T2C memories by avoiding destructive read operations. But its high-frequency domain switching hysteresis loop is typically asymmetric at room temperature, which can lead to retention issues. In this study, we show that this asymmetry is linked to the presence of interfacial layers near electrodes where the domains are volatile. During cooling of the device below 150 K, the loops become more symmetric when the interfacial domains become nonvolatile. The volatile-to-nonvolatile domain transition changes the domain switching mechanism and enables an energy-efficient non-superconducting cryogenic memory with improved operations.
- 15 July 2024
- Published by AIP Publishing in Applied Physics Letters
- Vol. 125 (3)
Ultralow electric-field poling of LiNbO3 single-crystal devices
The LiNbO3 (LNO) single crystal receives wide applications in nonvolatile memories, surface acoustic wave devices, and electro-optic modulators. However, engineering of antiparallel domain patterns within micrometer-sized devices generally requires a poling voltage more than a few thousands of volts. The high poling voltage could invoke dielectric breakdown. Here, we found an effective method to increase the local electric field significantly for domain nucleation at the interfaces of an etched LNO mesa in contact to two concave side electrodes, while the electric field across the protruding intra-electrode area can be lower by 10 times after the metal diffusion at the surface. Subsequent piezoresponse force microscopy mapping shows the nucleating domains to grow up through the entire intra-electrode area. This method is universal and analogous to other ferroelectric devices for the realization of low-voltage operations.
- 15 July 2024
- Published by AIP Publishing in Applied Physics Letters
- Vol. 125 (3)
Ultralow electric-field poling of LiNbO3 single-crystal devices
The LiNbO3 (LNO) single crystal receives wide applications in nonvolatile memories, surface acoustic wave devices, and electro-optic modulators. However, engineering of antiparallel domain patterns within micrometer-sized devices generally requires a poling voltage more than a few thousands of volts. The high poling voltage could invoke dielectric breakdown. Here, we found an effective method to increase the local electric field significantly for domain nucleation at the interfaces of an etched LNO mesa in contact to two concave side electrodes, while the electric field across the protruding intra-electrode area can be lower by 10 times after the metal diffusion at the surface. Subsequent piezoresponse force microscopy mapping shows the nucleating domains to grow up through the entire intra-electrode area. This method is universal and analogous to other ferroelectric devices for the realization of low-voltage operations.
- 2 April 2024
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 16 (15) , 19691-19698
Ferroelectric Domain Wall Delayer and Low-Dropout Regulator
A switching-type power converter providing an accurate and stable switching output voltage against line/load variations and power supply ripple is mostly complicated in system-on-chip power management integrated circuits (PMICs) within a limited occupation area. Here we fabricated domain wall (DW) nanodevices using an X-cut LiNbO3 thin film on silicon. The domain switching event occurs after a delay time predicted by Merz's law under the applied voltage. But the output current is irrespective of the applied voltage and can be adjusted by conducting wall width as well as input resistance in the circuit. The regulating currents appear repetitively across the volatile interfacial domains between the nanodevice and electrode under intermittently applied voltages. A wall-current-limited domain switching model is developed to explain the phenomenon. The multifunctional DW nanodevices with smaller occupation areas can serve as compact low-dropout regulators in PMICs, time-domain delayers in energy-efficient neural network systems, and on-chip electrostatic discharge protection besides nonvolatile memories and selectors.
- 2 April 2024
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 16 (15) , 19691-19698
Ferroelectric Domain Wall Delayer and Low-Dropout Regulator
A switching-type power converter providing an accurate and stable switching output voltage against line/load variations and power supply ripple is mostly complicated in system-on-chip power management integrated circuits (PMICs) within a limited occupation area. Here we fabricated domain wall (DW) nanodevices using an X-cut LiNbO3 thin film on silicon. The domain switching event occurs after a delay time predicted by Merz's law under the applied voltage. But the output current is irrespective of the applied voltage and can be adjusted by conducting wall width as well as input resistance in the circuit. The regulating currents appear repetitively across the volatile interfacial domains between the nanodevice and electrode under intermittently applied voltages. A wall-current-limited domain switching model is developed to explain the phenomenon. The multifunctional DW nanodevices with smaller occupation areas can serve as compact low-dropout regulators in PMICs, time-domain delayers in energy-efficient neural network systems, and on-chip electrostatic discharge protection besides nonvolatile memories and selectors.
- 25 December 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Electron Device Letters
- Vol. 45 (3) , 380-383
Cryogenic Ferroelectric LiNbO3 Domain Wall Memory
Non-volatile memory devices have become crucial components in emerging fields like integrated circuits and quantum computing. However, their cryogenic use remains a challenge today. Here we fabricated ferroelectric domain wall memory devices using an X-cut LiNbO 3 (LNO) thin film on silicon, and their on/off currents after the creation and erasure of conducting domain walls between two antiparallel/parallel domains were investigated at low temperatures. The readout current is sufficiently larger than 10 μA, though the domain wall current decreases nearly by a half upon cooling of the device from 300 to 120 K. The cryogenic memory has a large on/off ratio (>10 4 ), long retention time (>10 years) and high endurance cycles (>10 9 ), and can be applied at extremely harsh environments.
- 25 December 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Electron Device Letters
- Vol. 45 (3) , 380-383
Cryogenic Ferroelectric LiNbO3 Domain Wall Memory
Non-volatile memory devices have become crucial components in emerging fields like integrated circuits and quantum computing. However, their cryogenic use remains a challenge today. Here we fabricated ferroelectric domain wall memory devices using an X-cut LiNbO 3 (LNO) thin film on silicon, and their on/off currents after the creation and erasure of conducting domain walls between two antiparallel/parallel domains were investigated at low temperatures. The readout current is sufficiently larger than 10 μA, though the domain wall current decreases nearly by a half upon cooling of the device from 300 to 120 K. The cryogenic memory has a large on/off ratio (>10 4 ), long retention time (>10 years) and high endurance cycles (>10 9 ), and can be applied at extremely harsh environments.
- 30 January 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Electron Device Letters
- Vol. 44 (3) , 420-423
Nonvolatile Ferroelectric LiNbO3 Domain Wall Crossbar Memory
High-density domain wall memory based on crossbar architecture is a strong contender among next-generation high performance versatile memories due to its ultra-fast operation speed and excellent size scalability. Herein, we report 4 $\times $ 4 domain wall crossbar memory arrays fabricated on a LiNbO3 single crystal. Reversible creation and erasure of conducting domain walls between two antiparallel/parallel domains at bipolar write voltages enable the storage of digital “0” and “1” information. At the crosspoint of each word and bit lines, the memory cell can be accurately accessed, programmed and erased. The diode-like rectification of readout currents exhibited by all memory cells can inhibit read and write crosstalk. The electrical testing results in the crossbar memory array demonstrated the good stability of on/off currents and good uniformity of operating voltages, which can be reflected by the fact that the distribution of the coercive voltages is within 2.9 V and the “on”/ “off” current ratio is around 100 at a reading voltage of 3 V. Good data retention and fatigue resistance are also exhibited, making it possible to integrate domain wall random access memories in high density and reliability.
- 30 January 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Electron Device Letters
- Vol. 44 (3) , 420-423
Nonvolatile Ferroelectric LiNbO3 Domain Wall Crossbar Memory
High-density domain wall memory based on crossbar architecture is a strong contender among next-generation high performance versatile memories due to its ultra-fast operation speed and excellent size scalability. Herein, we report 4 $\times $ 4 domain wall crossbar memory arrays fabricated on a LiNbO3 single crystal. Reversible creation and erasure of conducting domain walls between two antiparallel/parallel domains at bipolar write voltages enable the storage of digital “0” and “1” information. At the crosspoint of each word and bit lines, the memory cell can be accurately accessed, programmed and erased. The diode-like rectification of readout currents exhibited by all memory cells can inhibit read and write crosstalk. The electrical testing results in the crossbar memory array demonstrated the good stability of on/off currents and good uniformity of operating voltages, which can be reflected by the fact that the distribution of the coercive voltages is within 2.9 V and the “on”/ “off” current ratio is around 100 at a reading voltage of 3 V. Good data retention and fatigue resistance are also exhibited, making it possible to integrate domain wall random access memories in high density and reliability.