Matthias Mersch
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Matthias Mersch has a total of 54 co-authors. Here are the top co-authors by number of shared publications:
- Christos N. Markides
Clean Energy Processes (CEP) Laboratory, Department of Chemical Engineering, Imperial College London, London SW7 2AZ, UK
8 shared publications - Andreas V. Olympios
PHAETHON Centre of Excellence for Intelligent, Efficient and Sustainable Energy Solutions, Nicosia, Cyprus
3 shared publications - Christian Vering
E.ON Energieforschungszentrum, Lehrstuhl für Gebäude- und Raumklimatechnik, RWTH Aachen University, Aachen, Deutschland
3 shared publications Christos N. Markides
3 shared publications- Antonio Marco Pantaleo
EISMEA, European Commission, Bd Simon Bolivar 34, 1000 Bruxelles, Belgium
2 shared publications - Dirk Müller
RWTH Aachen University, Aachen, Germany
2 shared publications
Latest Publications
- Open Access
- 29 October 2026
- Published by Elsevier in Energy and Buildings
- Vol. 374
Adaptive heating curves using data-driven methods to improve the energy efficiency of buildings
- 29 October 2026
- Published by Elsevier in Energy and Buildings
- Vol. 374
Open AccessAdaptive heating curves using data-driven methods to improve the energy efficiency of buildings
- Open Access
- 26 August 2026
- Published by Elsevier in SSRN Electronic Journal
Experimental characterisation of part-load behaviour and loss mechanisms of a variable-speed R290 heat pump
Real-world operation of variable-speed heat pumps is dominated by fluctuating heating loads and ambient temperatures. Therefore, understanding part-load behaviour is essential to maximise the efficiency through targeted design and control strategies. However, linking system-level efficiency to component-level loss mechanisms across a broad operating envelope remains challenging due to a lack of open-source experimental datasets, particularly for natural refrigerants like propane (R290). This study presents an experimental performance characterization and componentwise exergy analysis of a brine-to-water heat pump equipped with a variable-speed twin rolling piston compressor operating across a broad frequency range (20 – 100 Hz) under systematically varied source (-3 to 12 °C) and sink (35 to 65 °C) temperatures. The compressor represents the primary source of irreversibility, accounting for 56.5% to 62.6% of total exergy losses. At the baseline operating point (B7W35), the coefficient of performance exhibits a non-linear trend over compressor frequency, peaking at a value of 5.2 between 30 and 40 Hz and dropping by 17.3% at 100 Hz, despite constant source and sink temperatures. This behaviour is driven by shifting loss mechanisms: inverter,heat, and volumetric losses dominate at low speeds, whereas friction and flow losses dominate at high speeds. Increasing the sink temperature shifts the optimal compressor speed from 40 Hz to 80 Hz, whereas varying the source temperature does not affect the optimal compressor speed. These findings demonstrate the importance of consideringpart-load behaviour in the optimal design and control. All experimental data are made publicly available.
- 26 August 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessExperimental characterisation of part-load behaviour and loss mechanisms of a variable-speed R290 heat pump
Real-world operation of variable-speed heat pumps is dominated by fluctuating heating loads and ambient temperatures. Therefore, understanding part-load behaviour is essential to maximise the efficiency through targeted design and control strategies. However, linking system-level efficiency to component-level loss mechanisms across a broad operating envelope remains challenging due to a lack of open-source experimental datasets, particularly for natural refrigerants like propane (R290). This study presents an experimental performance characterization and componentwise exergy analysis of a brine-to-water heat pump equipped with a variable-speed twin rolling piston compressor operating across a broad frequency range (20 – 100 Hz) under systematically varied source (-3 to 12 °C) and sink (35 to 65 °C) temperatures. The compressor represents the primary source of irreversibility, accounting for 56.5% to 62.6% of total exergy losses. At the baseline operating point (B7W35), the coefficient of performance exhibits a non-linear trend over compressor frequency, peaking at a value of 5.2 between 30 and 40 Hz and dropping by 17.3% at 100 Hz, despite constant source and sink temperatures. This behaviour is driven by shifting loss mechanisms: inverter,heat, and volumetric losses dominate at low speeds, whereas friction and flow losses dominate at high speeds. Increasing the sink temperature shifts the optimal compressor speed from 40 Hz to 80 Hz, whereas varying the source temperature does not affect the optimal compressor speed. These findings demonstrate the importance of consideringpart-load behaviour in the optimal design and control. All experimental data are made publicly available.
- Open Access
- 20 April 2026
- Published by Elsevier in Green Energy and Resources
- Vol. 4 (2)
Comparative life cycle assessment of Rankine-based Carnot batteries and lithium-ion batteries for grid-scale energy storage
- 20 April 2026
- Published by Elsevier in Green Energy and Resources
- Vol. 4 (2)
Open AccessComparative life cycle assessment of Rankine-based Carnot batteries and lithium-ion batteries for grid-scale energy storage
- Open Access
- 10 February 2026
- Published by Elsevier in SSRN Electronic Journal
Understanding preferences for low-carbon technologies, retrofit and ownership models for domestic heating in the UK
Despite advancements in renewable energy technology adoption, the uptake of low-carbon heating technologies in the UK and many other countries remains insufficient to align with governmental objectives and targets. This has been attributed mainly to high capital costs, limited consumer awareness, and unclear economic and environmental benefits. This study aims to understand these challenges and analyse ways to overcome them by exploring consumer willingness to support the transition to low-carbon heating, using data from a two-wave survey of over 1,000 UK households conducted in 2023 – 2024. The first wave assesses current household contexts, which inform three stated-preference scenarios in the second wave: (1) choosing between gas boilers, hydrogen-ready boilers, and air-source electric heat pumps, with varying costs, emissions, and support schemes; (2) deciding on retrofit levels (none, minor, major) characterised by costs, savings, and support; and (3) selecting between ownership and operation models (full ownership, shared ownership, service-based heating), each with different costs, contract lengths, and flexibility features. By using discrete choice modelling, the analysis provides insights into how different consumer segments, defined by sociodemographic and attitudinal factors, respond to attributes such as capital and operational costs, as well as the impact of support schemes. The study estimates willingness to pay for reduced nuisance or emissions, and the compensations required for participation in flexible pricing or demand-side response, offering guidance for policies that encourage low-carbon heating adoption across diverse user groups.
- 10 February 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessUnderstanding preferences for low-carbon technologies, retrofit and ownership models for domestic heating in the UK
Despite advancements in renewable energy technology adoption, the uptake of low-carbon heating technologies in the UK and many other countries remains insufficient to align with governmental objectives and targets. This has been attributed mainly to high capital costs, limited consumer awareness, and unclear economic and environmental benefits. This study aims to understand these challenges and analyse ways to overcome them by exploring consumer willingness to support the transition to low-carbon heating, using data from a two-wave survey of over 1,000 UK households conducted in 2023 – 2024. The first wave assesses current household contexts, which inform three stated-preference scenarios in the second wave: (1) choosing between gas boilers, hydrogen-ready boilers, and air-source electric heat pumps, with varying costs, emissions, and support schemes; (2) deciding on retrofit levels (none, minor, major) characterised by costs, savings, and support; and (3) selecting between ownership and operation models (full ownership, shared ownership, service-based heating), each with different costs, contract lengths, and flexibility features. By using discrete choice modelling, the analysis provides insights into how different consumer segments, defined by sociodemographic and attitudinal factors, respond to attributes such as capital and operational costs, as well as the impact of support schemes. The study estimates willingness to pay for reduced nuisance or emissions, and the compensations required for participation in flexible pricing or demand-side response, offering guidance for policies that encourage low-carbon heating adoption across diverse user groups.
- Open Access
- 9 December 2025
- Published by Elsevier in International Journal of Electrical Power & Energy Systems
- Vol. 173
How can energy-system models inform technology development? Insights for emerging energy-storage technologies
- 9 December 2025
- Published by Elsevier in International Journal of Electrical Power & Energy Systems
- Vol. 173
Open AccessHow can energy-system models inform technology development? Insights for emerging energy-storage technologies
- Open Access
- 25 June 2025
- Published by Elsevier in Applied Thermal Engineering
- Vol. 278
A stochastic optimisation framework for integrating photovoltaic systems, heat pumps, and energy storage in buildings
- 25 June 2025
- Published by Elsevier in Applied Thermal Engineering
- Vol. 278
Open AccessA stochastic optimisation framework for integrating photovoltaic systems, heat pumps, and energy storage in buildings
- Open Access
- 14 April 2025
- Published by Elsevier in Computers & Chemical Engineering
- Vol. 199
Integrated thermo-economic organic Rankine cycle and working fluid design – On the accuracy of molecular-based computer-aided methodologies
- 14 April 2025
- Published by Elsevier in Computers & Chemical Engineering
- Vol. 199
Open AccessIntegrated thermo-economic organic Rankine cycle and working fluid design – On the accuracy of molecular-based computer-aided methodologies
- Open Access
- 18 October 2024
- Published by Elsevier in Cell Reports Sustainability
- Vol. 1 (10)
Energy import security in optimal decarbonization pathways for the UK energy system
- 18 October 2024
- Published by Elsevier in Cell Reports Sustainability
- Vol. 1 (10)
Open AccessEnergy import security in optimal decarbonization pathways for the UK energy system