MSMinghao Song

Minghao Song

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Minghao Song has a total of 6 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Adaptive robust steering strategy for electro-hydraulic hybrid steering system based on backstepping method

    by Guobiao Shi, Minghao Song, Chengyun Ju, Shuai Wang, Pengfei Qiao

    Aiming at the angle tracking problem of electro-hydraulic hybrid steering (EHHS) system of heavy commercial vehicles in intelligent driving mode, the dynamic model of the system is established. In order to weaken the influence of nonlinear disturbance and parameters, an adaptive robust controller based on backstepping method is designed, a linear extended state observer is established to predict the disturbance. Triangular programming and trapezoidal programming are introduced into the upper level planning of steering angle position to improve the performance, so as to realize the tracking control of steering angle. In order to verify the effectiveness of the control algorithm, the designed controller is compared with DRC control. The results show that the controller used in this paper has higher servo accuracy, smaller error, and better robustness to interference. And to verify the improvement of the speed planning algorithm, the simulation is compared with the non-planning algorithm. The results show that adding the planning algorithm can reduce the control effect error and avoid the response oscillation to a certain extent. Finally, HIL bench test shows that the control strategies under various working conditions have good effect, and meet the steering angle tracking requirements of commercial vehicles in intelligent driving mode.


  • Synchronous and fault-tolerance control for dual-motor steer-by-wire system of commercial vehicle

    by Guobiao Shi, Pengfei Qiao, Donggang Sang, Shuai Wang, Minghao Song

    In order to meet the high safety requirement of high-level automatic steering mechanism for commercial vehicle, a kind of steer-by-wire (SBW) system with redundant motors is studied in this paper, and the structure principle and control strategy of the system are studied. Commercial vehicles have the characteristics of large steering resistance moment, which is accompanied by impact and vibration during steering, so the synchronous control of dual motors is the key and difficult problem. Based on the circulating ball steering gear for commercial vehicle, dual-motor synchronous control architecture is designed and the dual-motor global-fast-terminal-sliding-mode (nonsingular-GFTSM) synchronous control is formulated. Compared with the sliding-mode control, the simulation results show that the dual-motor actuator based on nonsingular-GFTSM can better realize the synchronous operation in angle, speed and torque. In addition, a real-time motor fault-diagnosis method based on sliding mode observer and a fault-tolerant control strategy based on smooth switching system are designed, which can achieve fast fault-isolation and smooth torque switching in case of actuator failure in dual-motor system. A Hardware-in-the-Loop (HIL) test bench is built to further verify the effectiveness of the synchronous and fault-tolerance control strategy for dual motors.