John Hoang
Research Subjects
John Hoang has a total of 38 co-authors. Here are the top co-authors by number of shared publications:
- Jane P. Chang
Department of Chemical and Biomolecular Engineering, University of California 1 , Los Angeles, California 90095
4 shared publications - Daniel Cho
Department of Chemical and Biomolecular Engineering, University of California 1 , Los Angeles 90095
2 shared publications - Ji Zhu
Lam Research Corp. 2 , Fremont, California 94538
2 shared publications Nicholas Altieri
Lam Research Corp. 2 , Fremont 94538
2 shared publicationsSamantha Tan
Lam Research Corp. 2 , Fremont 94538
2 shared publications- Yi Chen
University of California, Los Angeles
2 shared publications
Latest Publications
- 20 June 2025
- Published by American Vacuum Society in Journal of Vacuum Science & Technology A
- Vol. 43 (4)
Kinetics model for thermal selective etching of Si1−xGex in F2/Ar
The selective etching of Si1−xGex over Si enables the fabrication of the gate-all-around field-effect transistors. While ample experimental data have confirmed such selectivity in various halogen-based chemistries, a mechanistic understanding of its origin is lacking. In this work, a kinetics model was developed to explain the volcano-shaped etch rate and selectivity in etching Si1−xGex in F2/Ar at near room temperature, as the germanium composition (Ge%) changes from 0% to 100%. The key reactions dictating this unique etch characteristic are GeF4(g) etching of Si and the formation of nonvolatile (GeF2)n. The competition and balance between these reactions successfully explained the rapid increase in etch rate/selectivity at Ge% below 20% and the decrease at higher Ge% over a wide pressure range (0.5–10 mTorr).
- 20 June 2025
- Published by American Vacuum Society in Journal of Vacuum Science & Technology A
- Vol. 43 (4)
Kinetics model for thermal selective etching of Si1−xGex in F2/Ar
The selective etching of Si1−xGex over Si enables the fabrication of the gate-all-around field-effect transistors. While ample experimental data have confirmed such selectivity in various halogen-based chemistries, a mechanistic understanding of its origin is lacking. In this work, a kinetics model was developed to explain the volcano-shaped etch rate and selectivity in etching Si1−xGex in F2/Ar at near room temperature, as the germanium composition (Ge%) changes from 0% to 100%. The key reactions dictating this unique etch characteristic are GeF4(g) etching of Si and the formation of nonvolatile (GeF2)n. The competition and balance between these reactions successfully explained the rapid increase in etch rate/selectivity at Ge% below 20% and the decrease at higher Ge% over a wide pressure range (0.5–10 mTorr).
- Open Access
- 27 February 2023
- Published by American Vacuum Society in Journal of Vacuum Science & Technology A
- Vol. 41 (2) , 023005
Dry etching in the presence of physisorption of neutrals at lower temperatures
In this article, we give an overview about the chemical and physical processes that play a role in etching at lower wafer temperatures. Conventionally, plasma etching processes rely on the formation of radicals, which readily chemisorb at the surface. Molecules adsorb via physisorption at low temperatures, but they lack enough energy to overcome the energy barrier for a chemical reaction. The density of radicals in a typical plasma used in semiconductor manufacturing is one to two orders of magnitude lower than the concentration of the neutrals. Physisorption of neutrals at low temperatures, therefore, increases the neutral concentration on the surface meaningfully and contributes to etching if they are chemically activated. The transport of neutrals in high aspect ratio features is enhanced at low temperatures because physisorbed species are mobile. The temperature window of low temperature etching is bracketed at the low end by condensation including capillary effects and diminished physisorption at the high end. The useful temperature window is chemistry dependent. Besides illuminating the fundamental effects, which make low temperature processing unique, this article illustrates its utility for semiconductor etching applications.
- 27 February 2023
- Published by American Vacuum Society in Journal of Vacuum Science & Technology A
- Vol. 41 (2) , 023005
Open AccessDry etching in the presence of physisorption of neutrals at lower temperatures
In this article, we give an overview about the chemical and physical processes that play a role in etching at lower wafer temperatures. Conventionally, plasma etching processes rely on the formation of radicals, which readily chemisorb at the surface. Molecules adsorb via physisorption at low temperatures, but they lack enough energy to overcome the energy barrier for a chemical reaction. The density of radicals in a typical plasma used in semiconductor manufacturing is one to two orders of magnitude lower than the concentration of the neutrals. Physisorption of neutrals at low temperatures, therefore, increases the neutral concentration on the surface meaningfully and contributes to etching if they are chemically activated. The transport of neutrals in high aspect ratio features is enhanced at low temperatures because physisorbed species are mobile. The temperature window of low temperature etching is bracketed at the low end by condensation including capillary effects and diminished physisorption at the high end. The useful temperature window is chemistry dependent. Besides illuminating the fundamental effects, which make low temperature processing unique, this article illustrates its utility for semiconductor etching applications.
- Open Access
- 15 January 2021
- Published by Springer Nature in Scientific Reports
- Vol. 11 (1) , 1-13
Comparison of two fluorescent probes in preclinical non-invasive imaging and image-guided debridement surgery of Staphylococcal biofilm implant infections
Implant-associated infections are challenging to diagnose and treat. Fluorescent probes have been heralded as a technologic advancement that can improve our ability to non-invasively identify infecting organisms, as well as guide the inexact procedure of surgical debridement. This study’s purpose was to compare two fluorescent probes for their ability to localize Staphylococcus aureus biofilm infections on spinal implants utilizing noninvasive optical imaging, then assessing the broader applicability of the more successful probe in other infection animal models. This was followed by real-time, fluorescence image-guided surgery to facilitate debridement of infected tissue. The two probe candidates, a labelled antibiotic that targets peptidoglycan (Vanco-800CW), and the other, a labelled antibody targeting the immunodominant Staphylococcal antigen A (1D9-680), were injected into mice with spine implant infections. Mice were then imaged noninvasively with near infrared fluorescent imaging at wavelengths corresponding to the two probe candidates. Both probes localized to the infection, with the 1D9-680 probe showing greater fidelity over time. The 1D9-680 probe was then tested in mouse models of shoulder implant and allograft infection, demonstrating its broader applicability. Finally, an image-guided surgery system which superimposes fluorescent signals over analog, real-time, tissue images was employed to facilitate debridement of fluorescent-labelled bacteria.
- 15 January 2021
- Published by Springer Nature in Scientific Reports
- Vol. 11 (1) , 1-13
Open AccessComparison of two fluorescent probes in preclinical non-invasive imaging and image-guided debridement surgery of Staphylococcal biofilm implant infections
Implant-associated infections are challenging to diagnose and treat. Fluorescent probes have been heralded as a technologic advancement that can improve our ability to non-invasively identify infecting organisms, as well as guide the inexact procedure of surgical debridement. This study’s purpose was to compare two fluorescent probes for their ability to localize Staphylococcus aureus biofilm infections on spinal implants utilizing noninvasive optical imaging, then assessing the broader applicability of the more successful probe in other infection animal models. This was followed by real-time, fluorescence image-guided surgery to facilitate debridement of infected tissue. The two probe candidates, a labelled antibiotic that targets peptidoglycan (Vanco-800CW), and the other, a labelled antibody targeting the immunodominant Staphylococcal antigen A (1D9-680), were injected into mice with spine implant infections. Mice were then imaged noninvasively with near infrared fluorescent imaging at wavelengths corresponding to the two probe candidates. Both probes localized to the infection, with the 1D9-680 probe showing greater fidelity over time. The 1D9-680 probe was then tested in mouse models of shoulder implant and allograft infection, demonstrating its broader applicability. Finally, an image-guided surgery system which superimposes fluorescent signals over analog, real-time, tissue images was employed to facilitate debridement of fluorescent-labelled bacteria.
- Open Access
- 15 June 2007
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 101 (12) , 123116
Optical properties of Y2O3 thin films doped with spatially controlled Er3+ by atomic layer deposition
We report in this work the optical properties of -doped , deposited by radical enhanced atomic layer deposition. Specifically, the absorption cross section of in was measured by cavity ring-down spectroscopy to be , about two times that for in . This is consistent with the larger effective absorption cross section at , determined based on the photoluminescence yield as a function of the pump power. X-ray photoelectron spectroscopy and Rutherford backscattering spectroscopy were used to determine the film composition, which in turn was used to analyze the extended x-ray absorption fine structure data, showing that Er was locally coordinated to only O in the first shell and its second shell was a mixture of Y and Er. These results demonstrated that the optical properties of -doped are enhanced, likely due to the fully oxygen coordinated, spatially controlled, and uniformly distributed dopants in the host. These findings are likely universal in rare-earth doped oxide materials, making it possible to design materials with improved optical properties for their use in optoelectronic devices.- 15 June 2007
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 101 (12) , 123116
Open AccessOptical properties of Y2O3 thin films doped with spatially controlled Er3+ by atomic layer deposition
We report in this work the optical properties of -doped , deposited by radical enhanced atomic layer deposition. Specifically, the absorption cross section of in was measured by cavity ring-down spectroscopy to be , about two times that for in . This is consistent with the larger effective absorption cross section at , determined based on the photoluminescence yield as a function of the pump power. X-ray photoelectron spectroscopy and Rutherford backscattering spectroscopy were used to determine the film composition, which in turn was used to analyze the extended x-ray absorption fine structure data, showing that Er was locally coordinated to only O in the first shell and its second shell was a mixture of Y and Er. These results demonstrated that the optical properties of -doped are enhanced, likely due to the fully oxygen coordinated, spatially controlled, and uniformly distributed dopants in the host. These findings are likely universal in rare-earth doped oxide materials, making it possible to design materials with improved optical properties for their use in optoelectronic devices.